Having problems with your Bissell Vacuums ?

Lost manual. don't remember how to do anything,like which tube do you put water an whivh do tou empty i just need a few answers on thin gs so i don't tear it up.


Answers :

Search for your information on your model at this site:
\012
\012http://canada.bissell.com/Product_Search.aspx
\012
\012Enter your model number and press enter. When you find the information page on your model you should also find a link to your User Guide on the right hand side of the page.
\012
\012If you have problems locating, reply with your model number and will see if I can assist.
Repair Help & Product Troubleshooting for Bissell Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Lost manual. don't remember how to do anything,like which tube do you put water an whivh do tou empty i just need a few answers on thin gs so i don't tear it up.


Search for your information on your model at this site:\012\012http://canada.bissell.com/Product_Search.aspx\012\012Enter ... Bissell Vacuums

D.d vaccum i have a dirt devil dynamite...i bought a new for it i put it on and not even 1 minute of using it the belt broke again!!!!i dont know whats going on do i have 2 put it on a certain way does it need grease or what!


Did you check the brush roll, if the ends aren't turning freely, then it needs to be replaced also. ... Dirt Devil M084600 Dynamite Bagless Upright Vacuum

I have emptied the bagless container. How do I put it back together? I need to look at a picture


The below site contains a downloadable manual for the Whirlwind Plus, which should be similar to yours. The information you need is on page 4.\015\012\015\012 ... Eureka Whirlwind 410 Bagless Upright Cyclonic Vacuum

Oreck vaccum when i put a new belt on, the belt rubs the side of the wall of the vacuum gets real hot and busts. is there any type of washer fitting that goes on the vacuum to hold the belt in place? i dont know i need help thank you. you can reach me at [email protected]


The belt must not be running true to the pulley. You may need a brush roll, but also check the motor to make sure it isn't moving inward after the belt is put on. ... Oreck XL Ultra Bagged Upright Vacuum

Need technical help for my miele s2180 momentum canister vacuum .Bought a display open box at fure shop..Came with a filter bag..there are no tears in the bag...Perhaps they put the wrong bag..Anyway after 30 minutes of use..The motor stopped working ..so I opened up the unit only to see,.the dirt was everywhere inside the vacuum...only a little was in the bag itself..can you hepl..Dave


... Vacuums

I just got a new machine (new to me anyway) new home hf106 model. i need to thread the bobbin on the new thead i am using and am not sure where to put the empty bobbin and how to thread it. help!


Janome New Home? Unfortunately, Janome doesn't put the manuals for older machines on their website. Your best bet is to contact your local Janome sewing machine dealer and ask for a "copy" of the manual from them. A photo copy should b ... Vacuums

Need instructions how to use Hoover Steam Vac Spin Scrub. I borrowed it from my Sister and she left it with no instruction book or letting me know how to operate it. I put water & cleaner in top tank. That's all I know to do. Do I put any water in bottom tank? I figured not, since that is probably where the water goes when sucked up by vac. Do I leave lid on bottom tank? I usually use a commercial cleaner, and this is very different. I need to know NOW, as I must return it to her today, and I'm


I did have a solution in just a few minutes. Someone responded with a solution that gave me the website where I could go and print the manual in pdf, so did that, and checking instructions I was able to clean my carpets and get the shampooer back to ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Dont know how to put the shampoo system together on my kirby g6..


Http://reviews.ebay.com/KIRBY-CARPET-SHAMPOOER-INSTRUCTIONS-MANUAL-DIRECTIONS_W0QQugidZ1000000000459499 ... Kirby G6 Bagged Upright Vacuum

Bag is empty but it vaccuum still says bag needs to be checked?


You need to blow out the insides some how like with an air compresser ... Hoover U5227-930 Elite Upright Vacuum

I completely took my Bissell 7901 steam heat apart to clean out the hose and i dont remember how it goes back.i dont need the manual it has nothing i need in it


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I need to know how to put together a Hoover Slider vaccum. I had to take it apart and now i need to put it back together.


... Hoover S2105 Slider Bagless Stick Vacuum

Need to open rotating brush part of vacumm as motor functioning but roller not turning...perhaps belt broken put need to get into ..inside brush box ...Need help need instruction with diagrams Thanks for help Robert


... Panasonic MC-V9638 Bagged Canister Vacuum

Need to find the belt for the brush. Every sight leads me to drive belts and I dont need that. I need a model number prefferably


Unscrew both bolts that are in plain sight on top of vac above the brush, then remove housing and belt is right there ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I just got this euro pro shark steam mop. I dont have a manual for it so i dont know much about it. I put water in it and it heats up but when you start to use it. It makes a gurgling kind of sound and steam comes out, but not very much i dont think and on the floor you can't hardly tell where you went over the floor at cuz it's not very wet at all. So is it suppose to make a gurgling sound and should'nt the floor be alittle wetter?


Call Shark. They have good cust. support. ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I lost the instruction manual and dont know how to put the string in or how to put anything together can u please explain to me how to put the brother xl3750 sewing machine together


Here is a link to your manual:homeappliance.manualsonline.com/manuals/mfg/brother/xl3750.htmlAll you have to do is ... Vacuums

Keurig model B40 How do I empty the resevoir , I can empty the cold watet tank. We are moving so need to completely empty all water.


Hi,The water reservoir lifts out. There are two tabs on the side which lock it in place. You may have to pres on them to remove it. If you are wanting to completely empty the entire machine, I have found an instruction manual and have ins ... Vacuums

Need to replace motor brushes on Kenmore canister vacuum 116.25914503 - Getting lots of arcing at brush ends. Need tear-down steps to get at the brushes.


If you can see the arcing you are likely in the motor housing. The brushes are specific to the motor depending on RPM. Most brushes and motors in Sears units are supplied by AMTEK Lamb. The color on the plastic housing and stamped model # on motor w ... Vacuums

I have an electrolux epic series 2500 SR that is in pieces and I need to put it back together, I need to get a diagram to make sure it goes together correctly.


... Electrolux Vacuums

Cleaning Solution It really isn't a mechanical problem. I would like to know what kind of solution I need to put into my machine. I bought it used and if didn't have a manual and I can't recall what I was told to put into the machine. I hope someone can answer my question. Thank you in advance Phyllis Woodall.


Most any brand name carpet cleaning solution will work. I like ZEP from the Home Depot. Nice fragrance, low foam and economical vs. Bissell, Hoover, other appliance brand names. ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I've cleaned a few areas and now the blue nozzle part with the dirt needs to be emptied. I do not have an instruction manual and can't figure out how to open or detach the blue nozzle part to empty it & clean it out.


Release the handle under by the front wheels. It will then pull out. Once you pull it out,on the frame there is a diagram showing out it comes apart. ... Sharper Image SI570 Steam Wizard Handheld Wet/Dry Vacuum

I HAVE A NEW BELT I NEED TO PUT ON MY VACUM CLEANER BUT I CANT FIGURE OUT HOW TO PUT IT ON?


You need to take the bottom cover off to expose the motor's pulley, and the beater bar. take the beater barr off by just pulling it off, and follow the marks on the plastic where the belt goes. ... Dirt Devil Vacuums

I took my durabrand toaster oven model t0-80 apart and i need the wire diagram to put wires back on it cause it needed cleaning.


... Vacuums

I need to know what compartments to put the water in, and to put the cleaning solution in.


Hi There,The Larger compartment is for the clean water, and the secondary tank attached to the larger tank in the back of it is where the shampoo goes. This machine is handy as it will automatically mix the two solution tanks together f ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Need Help On which side do i put the soap and on which side to i put the water?


Facing the machine, the tank on the right is the solution tank, the tank on the left is the recovery tank. The solution tank is where you mix the solution and water to do your shampooing. The recovery tank is where the dirty water will vacuum to. ... Bissell 1720-5 Little Green Turbobrush Canister Vacuum

I have a new aw131 meat therm. I have put the probe in the roast and need to put it in the oven shortly. But it is not reading out the current temp of the meat. Is something wrong?


... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0872 seconds