Having problems with your Bissell Vacuums ?

My water valve leaks on my bissell 1970 model. How do I fix it?

\015 Model 1970\015

Answers :

I had clean solution dripping onto the floor from the wheels of the \012unit. I had to disassemble it to find the problem which turned out to \012be a leaky seam on the edge of the black plastic valve assembly. This \012is the part that the solution tank plugs into. It appears the glue \012holding the valve together let go. I sealed it with 'Seal-All' sealant \012and that resolved the problem.
Repair Help & Product Troubleshooting for Bissell Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My water valve leaks on my bissell 1970 model. How do I fix it?


I had clean solution dripping onto the floor from the wheels of the \012unit. I had to disassemble it to find the problem which turned out to \012be a leaky seam on the edge of the black plastic valve assembly. This \012is the part that the solutio ... Bissell Vacuums

We have an American Home AH2O-550F water dispenser. The hot water valve is leaking water. Is the repair covered under warenty? Where do I bring for repair or how should I fix.


... Vacuums

My Bissell ProHeat 2x is pouring water out of the bottom anytime it's turned on. I had it in the shop for no water, took it back again for the same problem, took it back again because it had no suction, finally took it apart and found the problem with the suction and fixed it myself. Worked fine for a day and now it is constantly leaking water, if it's turned on, and is useless for anything except for making a mess.


Took the unit apart and discovered my heater had small pinholes in the metal and they had put in silicone, instead of a gasket, which didn't seal. So much for the place I took it to "saving" my heater for me. I repaired it myself by getting a few o ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

The Lower body of the Bissell QuickSteamer, water pours out from the body. Solution: I took apart the machine and there is a spring loaded valve with a rubber washer at the bottom. Think of the letter T upside down with the rubber washer on it. The washer stretches over the bottom and the spring creates a leakproof plug and won't allow water to pass till the button on the handle is pressed. This old washer came partially off and allowed water to leak. I purchased from the plumbing dept. a mi


... Bissell Vacuums

My Bissel pro heat 2x is pouring water all over the floor when ever I turn it on. I checked the water tank itself and it is not leaking. Is there a way to fix it? It also leaves soap in streaks on the rug.


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

How do I fix Bissell Quicksteamer leaking from water tank through wheels? After I place the filled Clean/Solution tank on the Lower body of the QuickSteamer, water pours out from the body of the machine through the wheels even before I turn the power switch on. I checked the tank and there are no holes in the plastic tank.


I have the same problem... seems to be because of a bad, or worn, rubber gasket. ... Bissell Vacuums

I HAVE A BISSEL 5200 FLIP IT AND WHEN CLEAN WATER TANK IS ON THE MACHINE AND IT IS BEING USED AS DRY VAC ALL THE SOLUTION LEAKS OUT. I TRIED TIGHTENING THE CAP , I CHECKED FOR CROSS THREADING , I HAVE TRIED EVERYTHING I COULD THINK OF THAT IT COULD BE NOTHING FIXED IT. MY FRIEND HAS ONE AS WELL AND HERS DOES THE SAME THING. IS IT A MANUFACTUER DEFECT?


Yes, they pretty much all leak, that can be chalked up to lousy manufacturing. Sorry. ... Vacuums

Bissell Proheat Clearview Force carpet cleaner keeps leaking water from both tanks. What can I do to fix it?


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 8910 ProHeat Clear View Upright Vacuum

I have a Bissell 1690 carpet cleaner and it is leaking water very quickly out the back. How can I fix this problem?


I had the same problem with my bissell proheat carpet cleaner. My cleaner would leak water out the back when i turned it on. I opened up the cleaner and found there was a broken tee connector. The tee connector was a small black plastic three way con ... Vacuums

I have a sta rite (pentair) cristal high rate sand filter model T-200-BP-1....its leaking water thru the top of the valve, where the valve cover screws on the valve body assembly. it leaks water out where they go together around the screws. Also when i vacuum it, everything that i vacuum gets washed back in the pool when its on the filter position. Also the backwash leaks when its turned 2 the filter position, does it supposed to do that?...the only way i have gotten it to stop is to put a seper


... Vacuums

My Delonghi DSS50 steam floor cleaner water reservoir has a broken valve on the bottom where it fits into the steam unit. It leaks water rather than producing steam. I would like to find the valve and replace it or buy a new water reservoir with the valve in it. I cannot find the part I need. Can you help me?


... DeLonghi DSS50 Scopa Upright Steam Vacuum

We have a Bissell Proheat 2X (model 8920). The problem we are having is when water/soap is initially released (all settings) it continues to leak out the front water spray nozzles unit the water containers are empty. The vacuum works but can't keep up with the continuous water leaking out. Do you have any idea what is sticking open to allow the continued release of water when the machine is running? Thanks Rick


Return it. It is faulty and should not do that. Mine does not. Does require changing water about evrery 10 minutes but one can see the filth in the water. Also re-clean with plain water over areas that were cleaned to remove all cleaner. Old cleaner ... Bissell 8920 ProHeat 2XTM Upright Vacuum

Bissell proheat My Bissell won't dispense cleaning formula but it sprays water and sucks up the water. The attachments spray water but not the soap also. how to fix?


First is the smart mix valve turning like it should? If it is then replace the soap dispensor. Also is the gasket on the valve at the bottom of the bottle? ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

I have a bissell proheat 2x and it leaks water around the wheel it holds dirty water but doesnt hold clean water.......and how do i remove the wheel on my bissell


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Hoover Steam Vac clean water tank valve leaks


A) make sure that there is not a place for a stair attachment. If\015\012there is make sure air is not leaking through where the attachment goes\015\012on because of damaged or misplaced fitting.\015\012\015\012b) some steam ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I have the Hoover SteamVac Dual Model F7246-900 Serial AA12.0. In the Clean Water Tank the small black plastic check valve leaks water as machine is in use even when the on-off switch is not on. Can I purchase a new valve?


... Hoover Vacuums

Water tank valve is leaking out of the bottom of the tank. The water leaks on the floor.


It could be a cheap fix. There should be a rubber o ring that's worn or ate away by chemicals.\015\012I'm hoping the tank isn't cracked.\015\012Remove o ring. Contact repair place. O ring shouldn't be more than 5.00. ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

My Eureka Atlantis Express is brand new - never used. I took it out of the box, read the manual, filled the soap and clean water tanks, put them in. I lifted the machine off the counter to take into the living room but all the water came running out of the bottom all over the kitchen floor. I can see where the little white plastic piece sticks up into the water release valve and lets the water out. How do you stop this? Can it be fixed?


... Eureka 2553A Atlantis Handheld Wet/Dry Vacuum

My Bissell Pro Heat Pet will spray water but not pick it up when cleaning the carpet. Is there anything I can do to fix it? The furniture attachment hose picks up water well. It seems like it could be a bit more powerful of a draw on water. I don't know it that has something to do with why the floor cleaning sucktion doesn't work. Thank you for your time. Jenn


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Bissell Vacuums

Water Leakage We have a Bissell Proheat (Pro Tech). I don't think it is the 2X model. When releasing the water with the knob on the handle, water comes out the side of the housing at the lower part of the unit. Is their a seal that my be worn out or broken. Can you give us some ideas before we take it to an expensive repair man to fix


Check the water bottle. Ours has been doing the same but putting a bit of j cloth between what they call the o ring and the cap fixed it. Really you need a new bottle assembly ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

I have the Bissell 2x proheat. There is no water being sucked up from the bladder and the cleaning solution is not being sucked in either in order to get to the carpet. On water rinse the carpet gets wet but I'm not seeing any water going through the clear front piece. I live in Harvest Alabama. Where can I take it to get fixed if it needs it?


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell ProHeat 2X Select Upright Deep Cleaner not pumping water to floor. Water is not flowing out of the pouch area into the carpet. Water does not come out of the blater, I have checked the line & valve and they are clear how do I check the pump


Make sure you have soap in the soap container or the water will not pump. Sounds strange I know. Even if you have the soap mixture selector turned off, it seems that these machines won't pump clear water unless the soap resovior has fluid in it. D ... Vacuums

I have a 9300-1 bissell carpet cleaner and when i used it today the vacuum was not sucking the water up. i know its working because when i take the water tank off i can feel the suction from the valve that connects to the water tank. any suggestions...


... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

Bissell ProHeat 2x Upright Carpet cleaner-water tank valve


Www.usavacuum.com/category-s/387.htmYou can find the parts you need here ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

No water comes out of my bissell shampooer. How can I fix it?


Look in your bottom where the water comes out it might be clogged there you should try vacuuming it out ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0900 seconds