Having problems with your Black & Decker 15.6 Volt DustBuster Vacuum ?

My 15.6v Dustbuster will not hold a charge. What to do?

\015 It was great for about one month. Now this, very disappointed.\015

Answers :

Did you check a dust bag for full of greaze?
Repair Help & Product Troubleshooting for Black & Decker 15.6 Volt DustBuster Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I change the battery for my B&D Dustbuster 15.6V It will not hold a charge very long now.


... Black & Decker V9610 DustBuster Handheld Vacuum

We have a B&D Companion wet/dry dustbuster. It has a model # 997721 nicad 4.5 volt rechageable battery.It will no longer hold a charge. Where can we get a replacement?


This will probably be hard to find and you will see that it may also be cheaper to just pick up a new one. a batt pack will most likely be $25 to $30. when its such a throw away society many companies dont put out much for replacement parts. ... Black & Decker Vacuums

Our dustbuster doesn't hold a charge very long any more.


... Black & Decker Vacuums

My 15.6v Dustbuster will not hold a charge. What to do?


Did you check a dust bag for full of greaze? ... Black & Decker 15.6 Volt DustBuster Vacuum

Dustbuster v4810 battery not charging - but I can't find new one!


... Black & Decker V4810 DustBuster Bagless Handheld Vacuum

Flair S2220 Removed the four screws holding bottom cover but still unable to remove cover. Is there something else holding cover? The cover on the srew end will seperate but something appears to be holding cover on beater bar end.


Pop out the two little rollers underneath, at the front. you will find two little screws holding it on. Unfortunately, I found after I broke it off! ... Hoover S2220 Flair Bagless Upright Vacuum

I have a bissell proheat 2x and it leaks water around the wheel it holds dirty water but doesnt hold clean water.......and how do i remove the wheel on my bissell


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a Kirby Heritage II Turbo and I need a user's manual, but can't find one anywhere. I have to replace the fill tube in the bag and can see the cable tie on top that holds it in place, but don't know how it's attached to the mini-emtor. If I can't replace the fill tube, will tape fix it? If I just taped it; will it hold? Thanks.


Taping usually just causes a mess. The mini-emptor has coarse threads on it that the fill tube screws on to. Occasionally there is a cable tie on the bottom which is not really necessary. If you cut the tube near the bottom, you can get hold of it's ... Kirby Heritage II Vacuum

My wall mounted dustbuster never reaches full charge. Each time I use it to pick up a small pile of debris that I have swept up in the kitchen, it starts losing power before I finish.....within 30 seconds or so. I have had the same problem with the last 2 dustbusters that I have owned.


... Black & Decker AV1200 DustBuster Handheld Vacuum

We have several SGC-60D 1.5 Gal coffee urns and the front piece broke off. ( the tall rectangular piece that hold the tube on the front on) We've tried a couple of things but the new front piece won't connect to the screw to hold the tube on. Any suggestions?


... Vacuums

I need a black and decker dustbuster manual to know what kind of batteries to buy. I recently got this dustbuster at a garage sale. The charge/wall mount says it is a 9.6volt FVE9610 Type 1. Help? Joan in Florida


I have bad news. That part is no longer available; check out the info here:http://www.ereplacementparts.c ... Vacuums

Looking for clips for the bissell 1631, need the clips that hold top to tank and clips that fit on wand and hold hose to wand. [email protected]


You can try to order the parts from Hesco. you can google Hesco in the search engine and look up your model number. here are 2 that i have found. some of the parts that you are looking for are no longer avaliable. \015\012\015\012BI-21355 ... Vacuums

I have a Shark Euro Sweeper, and it doesn't hold it's charge. I only use it a matter of a few minutes and already the green light turns to orange. I was told it would hold a charge for 30 minutes. So what's the deal?


I assume you've had the cleaner for a while and your battery is dying. Batteries can only be recharged a finite number of times and they also suffer from "memory loss" due to not being fully discharged before recharging.\015\012\015\012Ba ... Vacuums

On-off switch My problem is finding a source for an on-off switch for an electrolux vacuum sweeper model 2100. I have replaced the broken toggle and now the sweeper turns on but only as long as the outside button is depressed. It appears that the on-off switch itself is broken as the switch does not ''hold'' when the toggle is activated. It seems to return to it's ''off'' setting as soon as the toggle is released. What ''holds'' the switch in its ''on'' position? Does it depend only on the on-


Hi Hugh. The 2100 has a rocker switch under neath the button. it is probably broken, or the button has a worn detent spring. If you would like, I could send you a switch kit with the rocker, button, and detent spring enclosed for around 20 dollars ... Vacuums

My Mom has a Dirt Devil Featherlite and the belt falls off all the time. I put it on three times today and it falls off within a few minutes. The belt post I put it on doesn't have anything to hold the belt on. Is there supposed to be something holding the belt?


It sounds like the belt is too worn and loose to stay on. Buy a new belt specified for that model of vacuum and install. Ensure that there is only a slight amount of give in the belt when you press the middle. ... Dirt Devil CE6100 Featherlite Upright Vacuum

When we turn on the vacuum, the canister falls open. The clips holding the canister in place do not seem to hold the canister tightly which I'm sure that it did in the past. The clips do not look bent, but every time we turn on the vacuum the intense pressure blows the canister open only remaining attached the the rest of the vacuum by one clip


Check filter and make sure it is kept clean at regular intervals. Possibly worn out clip retainers on cannister side due to excessive pressure build up. Do not force closure unless pressure is back to normal. May crack cannister or damage unit beyond ... Hayden Industries SuperVac 6000 Central System Vacuum

My Euro-Pro UV617 never holds the charge as described from day one. I never it plugged in all the time and it dies after use for 5 mins. Is there a cheaper source to buy replacement battery? Should I spend another $27 for replacement battery or is there a bettter cordless vacuum out there which holds the charge as promised?


I'm going to try this source for a battery: $11.99 ea.+ $6.96 SH or 3/$32.42 + $7.95 SH\015\012\015\012http://store.yahoo.com/buyitnow64/shvacl ... Vacuums

My Roomba 530 does not speak when I hold down the dock button. The manual says it will talk me through a demo if I hold down the dock button but it does not speak at all, ever. Any ideas what I can do? Is it faulty? I bought it 3 days ago.


If it were human, i'd say its bashful, but in this case you may need a new rom pack. Call the service dept and describe this problem in detail.iRobot Service & Support\012Find answers to frequently asked questions. Need further help? Please ... iRobot Roomba 530 Robotic Vacuum

Roller not turning, belt not working no water . The belt on my Bissell Proheat is not getting water (although there is plenty in the holding tank). It seems the belt is not turning and there fore the water is prevented from leaving the holding tank.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

My Error light will not go off. I just bought new batterie, as I thought that was the problem. If I hold down the power button and the play button on the vacuum it will run. When released it stops. The remote will work for the unit if I am holding down the power button on the vacuum.


... Infinuvo QQ1 CleanMate 365 Robotic Vacuum

My Dyson is not picking up on the carpet as good as it use to. The brush doesn't seem to engage on the carpet unless I hold the angle upright. It's very uncomfortable to hold it at that angle. What would correct this problem?


Brushes do wear out. Compare the length of the bristles on you brush with a new one. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I am looking for a specific part for a Nostalgia Electrics RIC-100 portable ice maker and I am finding it very hard to find what I am looking for if I could get some help that would be great. The part I am looking for is the the tray that the ice maker puts the water into and holds to freeze the water to make the ice before it is dumped into the holding tray for the rest of the ice


... Vacuums

Dirt devil kone won't hold a charge. Its constantly on the charger but yet won't hold a charge long enough to do anything


... Dirt Devil KONE Hand Vacuum MO213BLU Vacuum

I have a Kenmore Progressive Canister Model # 29612992. I was replacing the sweeper bag, when I opened the lip, the plastic arms was pull out of joint and will not close. I removed the 2 screws under the lid to put back it in place but there I can't remove the plastic molding because there are still screws holding somewhere. Are there tabs instead of screws still hold the molding?


... Kenmore 25512/ 25513 Progressive Canister Vacuum

Progressive 38613890 The slot on the belt side of frame where the beater bar fits down into a U shaped area that holds it in place has worn and stretched out and does not hold the beater bar in place. Can this be repaired somehow?


... Kenmore Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0186 seconds