Having problems with your Black & Decker SPV1800 Handheld Vacuum ?

Battery will not charge

\015 Spv1800 battery will not charge\015

Answers :

Rechargeable batteries (usually Ni-Cd) have a finite life and after a certain number of recharge cycles (usually 500 times under optimum conditions) will loose their capacity to retain a charge as one or more cells will become 'worn'. Unless your appliance has a 'smart' charger circuit, leaving the appliance always plug-in will greatly reduced the batteries pack life due to overheating/overcgarging.
Unless you can test and replace as required the individual batteries, it may not be a cost effective solution to replace the batteries.
Hope it helps.
Repair Help & Product Troubleshooting for Black & Decker SPV1800 Handheld Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have iRobot Roomba 4210 and I have a problem with charge battery. The battery is new. When I charging a battery in other iRobot Roomba the battery was full charged. When I charging in my iRobot Roomba the battery was empty. My fast charger is OK.

The charging circuit on the main board is fried. This is a common issue. You need some good electronic repair skills, and equipment, to replace the problem components ... iRobot Roomba 4210 Bagless Robotic Vacuum

I purchased a brand new P113 Ryobi charger about 2 years ago. It has never worked. If I put a P104 battery in for a charge, it looks like it works correctly. I push the battery tester on the battery itself, and it says full charge, but when I go to use the bateery, it dies right away. I have tried three new P104 batteries. The batteries charge on my charger at work with no problem. The funny thing is, I don't need a battery in the charger and the charger does the same thing, It runs the test

If you have your receipt, check with Ryobi to see if it is still under warranty. It comes with either a 2 or 3 year warranty, depending on when it was purchased. If it is still covered, get it replaced/repaired. If it is not, buy the P117 charger. $3 ... Ryobi P113 18 Volt One Charger 140501001

Battery charge I just purchased a new battery pack insert for my Roomba, Replacement was a breeze and it now works great. My question is; The last battery I bought ( not from you) was a full cased roomba battery pack that didn't last a year. Roomba says leave the r Roomba charging all the time so it's ready when you need it, and that's nice but I feel that leaving it charging like that it will kill the battery faster as it is always warm to the touch. These battery's should last at least 5

Dave you are correct. You should never over-charge anything like a Roomba, Cel Phone, etc. That will kill a bettery very quickly. ... Roomba Robotic Floor Bagless Vacuum

The battery will not charge in the sweeper. I can remove the battery and wire it to the power supply for charging and it will charge up and run the sweeper. So the power supply and the battery are both good. Obviously there is a circuit failure in the on board charging control. Anyone know a fix or a likely faulty component? I had a shark handheld about 8 years ago and it developed the same problem. I examined the little circuit board inside but saw no visible indications that would isolate t

... Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray

I am currently unsure, it my Dyson DC16 battery is charging as it should. I read all the posts about Powersupply voltage of 28V and defective PCBs. I now need to know from someone who's DC16 is working properly what voltage the battery should have when it is charged. I currently only measure 24.2V in mine. Supposing there are 6 batteries in there with nominal 3.6 voltage each, which would add up to 21.6, I supposed one could charge with up to 25.2V (4.2*6) and once reach lower the voltage ke

Does it stop working real fast ? ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

My robot will not charge. Tried multiple resets and new battery from irobot.com (both suggested by Irobot customer service) but got nowhere. The vacuum did work for a short time (until the new partially charged battery ran out). If I bypass the internal charging circuits and charge directly from the charger (with jumpers) the robot seems to work fine. Unfortunatey, there is no mechanism to turn off the charge cycle, so this is not practical.

Replace the battery charger ... iRobot Roomba 4210 Bagless Robotic Vacuum

My Roomba Discovery 4210 seems to be dead. Specifically, with or without a battery, and whether on the charging station or plugged directly into the charging unit, I see no lights on the display whatsoever. This unit has a history of killing batteries, but now seems like it is completely dead. I understand that the batteries themselves contain fuses; is there some way to bypass the battery (for now) to verify whether the unit itself is completely dead? I should also note that this is the sec

Hello,I will advice you remove the batteries from your Roomba Discovery 4210, after removing the batteries, plug the Roomba Discovery 4210 directly with the charger to an AC outlet, see if charges, if it does, it means the batteries are d ... Vacuums

Brum M0414 does not charge. "Charging light" doesn't go on when charging unit is plugged in. Voltmeter check on charging unit (unloaded) shows 19.5V. How do I dissassemble Brum to check battery and battery connections?

... Dirt Devil BRUM M0414 Bagless Vacuum

After charging overnight, Roomba only runs about 25 minutes before shutting down with a red light.At this point the battery measures 15.13 volts ( about 1.26 volts per cell ) My hobby experience is that a ni/cad or ni/mh battery nominal charged voltage is about 1.2 volts per cell, and that the recommended end point voltage should be about 1.0 volts per cell. Seems like the battery is ok, butsome kind of voltage regulator is shutting things down prematurely. Is this happening, and , if so, how ca

Reset the Roomba by removing it from the charger, then holding "spot" and "dock" for about twelve seconds. When you let go, the unit will play an ascending series of notes. Then recharge it overnight. If the run time is still short, give Customer Sup ... iRobot Roomba 560 Robotic Vacuum

I have a miele S4210 vacuum. It has a SAB100 accu nova battery brush which will not work. After charging the battery, light comes on saying not charged and now the power head brush won't turn. I had problems with my first powerhead so I purchased another and it worked for a short time and now I have the same problem again. I have four batteries I use interchangeably but nothing seems to work. I spent a fortune on this vacuum and to tell you the truth I hate it! Contacted Miele after 1st year of

... Miele S300 Bagged Canister Vacuum

My Infinuvo Cleanmate QQ2 will not accept a full charge. It runs for 10 - 15 minutes and then says "battery low". I have a new battery and charger. I have charged it directly without the home base and have left it charging for days. Any suggestions? Thanks, Linda

... Infinuvo QQ1 CleanMate 365 Robotic Vacuum

I have a Roomba Discovery. In the past, I had to replace the charging dock. Then the battery died so I did not use it for two years. I finally bought a new battery and used the Roomba. It worked great. It did not find the docking station, and died. I have been charging it and the red light pulsates, but after 16 hours, it still is not charged...any ideas?

Hello. Turn your robot over and clean the charging contacts with the eraser end of a common pencil. Then Charge it and you should be up and running again. Regards, Joe ... Vacuums

My braun 's 5510 charging light was blinking and never reach fully charged(steady green).I was able to use it as long as its pluged in. but now, no green light at all.and completly dead. is my battery dead ? or the charging circuitry bad ? i do have the skill to solder a pair of batteries on to it.

... Vacuums

My Prosine 2.0 display panel displays Panel Fault: Memory error and the display error as well as all LEDs are off. The unit looks as if it has no power to it. I reset (power off.power on) the Prosine and all LEDs on the display (except for the back lit display) turn on for about 3 seconds then all go off again. I am able to use 120v RV Resort power and all 120v equip works. The Coach batteries do not charge and were low. I charged the Coach batteries with an external charger. The charge works ye

... Vacuums

I have a 2 year old Electrolux ergorapido cleaner that gets used daily for about 2/3 min, the blue light on the stand comes on when the cleaner is put on to charge but fades after about 5 min & the batteries dont charge, would this be a faulty ac adaptor or worn out batteries

No, not worn out batteries.For my experience, if the batteries were worn, they would charge with the blue led being on and after that, the vacuum wouldn't hold his charge. just that.This is a different problem. Check the contacts between the ... Electrolux Vacuums

I have charged batter for over 24 hrs and still doesn't hold charge, can u replace the batteries? or do u have to get a new battery pack

You need a new battery pack. Visit www.hoover.com or fixYa.com advertiser. Other places you may check is www.batt ... Hoover H3030 FloorMate SpinScrub 500 Upright Wet/Dry Vacuum

The hand held dyson does not appear to charge. does the battery come away from the unit as I can't seem to release it? Would there be any point in buying a new battery as I don't know if this is the problem. The red light stays lit all the time it is on charge and when I take it off the machine does not respond at all.

The battery is located at the bottom of the handle. To release it, press and hold down the button on top of the battery case (it has 3 ridges on it). That releases a catch and you can then slide the battery out to the rear. This can be quite ha ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

Our roomba 560 wont charge have replaced the battery Tested the charing unit with another roomba that all seems ok put the uncharged battery into another Roomba but im guessing it now has a memory as this wont charge in the other hoover. Any ideas what may be wrong

Try cleaning the battery contacts with a little rubbing alcohol or contact cleaner on a foam swab, or a bit of paper towel. Take a litle time, it doesn't always dissolve instantly. (Don't use a pink pencil eraser, it would scrub off the plating that ... iRobot Roomba 560 Robotic Vacuum

We ran our Platinum Series 18 volt hand vac until it stopped -- charged the battery overnight but it did not charge. is there a problem with the battery charger or what could cause this?

Most problems with what you have stated have to do with bad contacts between the hand held unit and the battery charger.\015\012With the charger unplugged, make sure the contacts on both the charger and hand held unit are clean and not bent.\015\012C ... Black & Decker CHV1500 Bagless Handheld Cyclonic Vacuum

My Euro-Pro UV617 never holds the charge as described from day one. I never it plugged in all the time and it dies after use for 5 mins. Is there a cheaper source to buy replacement battery? Should I spend another $27 for replacement battery or is there a bettter cordless vacuum out there which holds the charge as promised?

I'm going to try this source for a battery: $11.99 ea.+ $6.96 SH or 3/$32.42 + $7.95 SH\015\012\015\012http://store.yahoo.com/buyitnow64/shvacl ... Vacuums

Miele power head battery charging problem - does not fully charge. I have had a new battery and charger - problem persists

... Miele Vacuums

The battery charger flashes red when the battery is inserted for a charge - does this mean the battery is no good? If so, where can I purchase a new battery and at what cost? Thanks in advance.

Blinking red means it is charging. it will stop blinking when it is fully charged. ... Oreck TEK100 Handheld Vacuum

My 400 series Discovery Roomba will no longer charge. It shows a green "charged" light, but when I hit clean, all lights/vacuum, etc just go out and it stops. Irobot says that the entire unit needs to be replaced, but it has to have something to do with the charging mechanism. Any Ideas? I've tried the system reset, and removing/replacing the battery. No effect. The robot doesn't give me the "uh-oh" beeps to be charged. It just stops and goes dead.

... Roomba Robotic Floor Bagless Vacuum

I have replaced the battery in my 4210 and reset the charge cycle. It has supposedly been charging for about 55 hours now and I plan to let it charge the full 72. Is it normal for the power light to become VERY pale?

The power light changes color and on some models goes dim to indicate charge level. It will be ready to go when the light is at maximum illumination. ... iRobot Roomba 4210 Bagless Robotic Vacuum

Roomba Red shows pulsing red charging light, turns green, measured battery voltage - only shows about 5.5 volts. Borrowed and used neighbor's charging unit - same thing happened. It seems that the charging system inside the Roomba Red is not functioning. WShat else can I try?

... iRobot Roomba Red 4100 Bagless Robotic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0266 seconds