Having problems with your Black & Decker V9610 DustBuster Handheld Vacuum ?

How do i change the battery in my dust buster15.6v

Answers :

Repair Help & Product Troubleshooting for Black & Decker V9610 DustBuster Handheld Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do i change the battery in my dust buster15.6v

... Black & Decker V9610 DustBuster Handheld Vacuum

Clean n light hand held caution says do not atempt to change the battery!stopped working can I change the battery---

... Bissell 3040 Clean 'n Light H Vac Vacuum

I changed the batteries in my window thermometer (the one with suction cups) and it is still giving me the change battery alert.

Remove the batteries and using an emory board or fine sandpaper scratch up the metal pieces where the battery ends make contact inside the unit.\015\012It could be that the metal pieces have corroded a bit and need to be cleaned to make proper contac ... Vacuums

Battery replacement I would like to replace the battery on my handheld Black and Decker 9 volt battery Dust Buster. But where is the battery? How do I remove the old battery so I can replace with a new battery?

... Black & Decker CHV9600 Handheld Vacuum

I have a Howard Miller Westminster Chime Mantle Clock. It has always worked fine. It stopped working and my husband took the battery out to change it and when the new battery is in it will not work. It is Model 613-=103 movt 354201J dial 272142J. The part you put the battery in almost looks too big for one double A but I can't see how two would fit. I am afraid the battery is just not in right. Can you help me with how many batteries go in this clock or if it is one what the problem could be.

... Vacuums

I have cleaned the filters on my dust buster. The vacuum works for a minute then the battery seems to wear out and the power weakens until it stops. How do I replace the battery on this vacuum? Do I need just one 9.6V battery? What screws do I loosen to insert the battery? I can't find my instruction booklet. Tank you for your help.

... Black & Decker 15.6 Volt DustBuster Vacuum

I hve a lacrosse satellite clock (battery driven). It hasn't changed with the spring time change and has not ability to change later than the EST. Will it eventually change??

Replace the battery from the clock and check.if the battery is gone weak it will not help the clock to change time.\015\012check out with new battery and see.\015\012keep updated.this will help.thanks. ... Vacuums

I think I need to replace the main battery in my small floor vac - the one that can be hand held like a dust buster or work like a small floor vac. I need to know how to remove the battery and replace it with what kind of new battery..

I see my sense of humor is not appreciated...it was only a joke. Anyway, here is what you do: First, slide the battery cover off the bottom of the hand held unit. Remove the battery from the motor housing by pressing the tab on connector “A&rdq ... Vacuums

I have a Tomy Up Down Change Around Roller Coaster that does not power up. I disassembled it and it has a small unmarked rechargeable battery. The coaster car is supposed to hook into a unit that holds one "D" size battery and has two metal prongs that press into the side of the car. Any advice on what the battery type might be or how to find out?

... Vacuums

Change dust bag indicator frequently turns on

... Bosch BSG81360UC Premium Health Guard Bagged Canister Vacuum

I have a Miele Vacuum cleaner MedicAir 5000 Plus. Recently the Dust Bag Indicator bar is full during normal cleaning and consequently the suction power is much less. I replaced the dust bag, engine pre-filter and Hepa filter but no change. When i remove the hose, the Indicator is normal, but when i attach the hose, wand, head, the indicator is full. I checked the hose, wand, head but can't see any blockage and when i blow with my mouth it seems fine. Can anybody help? thanks!

... Miele Vacuums

Dust bag was full and have changed it but not getting proper suction since bag change - why?

The extension tube is probably blocked.\012Check for suction with all the tubes off - if there is suction now then the tubes are blocked - be carefull not to damage them if you poke things in the unblock them. ... Miele Revolution 600 Bagged Canister Vacuum

Just properly installed a Hampton Bay ceiling fan - Midili, 44inch Model #44-MDL. Loaded the remote control with a 9 volt battery and the remote is EXTREMELY HOT. Changed out the battery with another brand and the same thing happened again. It is so hot you cannot even hold the remote! Help...! I want to use my new fan.

... Vacuums

How to open a electrolux ultra one vacumn cleaner model z8871p to change the dust bag

Canker Sores Vs. Cold Sores http://www.youtube.com/watch?v=iJ4mg3xrPDM ... Electrolux Vacuums

How do I change a belt on a Hoover Dust Manager

... Hoover Vacuums


... LG Vacuums

Over heating? My 10 gallon 4HP shop vac has started shutting off after about 30 sec. after I turn it on to use. It smells real hot after I shut it off. I have changed the filter and the bag, which did not solve the problem. Any suggestions on what the problem could be? It's only about 31/2 years old and I really don't use it all that much, mainly for getting up dust and cob-webs from my garage.

It sounds like you need to replace the motor in it . thank you for using fixya ... Shop Vac ShopVac 3 HP 2 Stage 10 Gallon--Automotive Wet/Dry Vacuum Vacuum

Suction is not good. It is more hassle to empty. You have to take apart top filter & pull out everything stuck uptop. I end up with more dust on the outside when I change. I miss my bags. No dirt to deal with.

Yeah i agree with you...Sometimes you have to disconnect the primary vacuum hose at both ends and clear the debris in it..Then take the plastic top off the motor houseing and clean it out aswell...Its a pain rest assured :) ... Eureka 5849A Boss Bagless Upright Cyclonic Vacuum

I have a Napoleon Pellet stove insert Model NPI40. When the fire burn rate is extremely low it seems to operate normally. However, when I turn the heat up even a little I eventually get a high pitched noise that seems to be coming from the convection blower. Changing the speed of the blower has no effect on the noise level. I cleaned the blower but did not remove it. There was very little dust on it. Cleaning had no effect on the volum or pitch of the noise.

My theory is based upon 1st hand knowledge with a newer EPA compliant freestanding wood burner, with the air-tight and high efficiency ratings.its possible that its just the high rate of air moving through the air chambers , similar to a o ... Kenmore Whispertone 23312 Bagged Canister Vacuum

Dirt is coming out the bottom of my Kenmore Progressive Upright Vacuum. My husband found a large dust bunny in the drive belt and removed it. He also changed the bag. Why is dirt coming out the bottom? Thanks.

Its still clogged, you gotta dig deeper ... Vacuums

My son used it to vacuum up needles from Xmas tree. It is now spitting out dust and not picking up. I changed the bag but does not help

I could not find the manual for the vacuum. I went to the Oreck site and found an online manual for my machine. I was able to take the hose apart and clean out the blockage. Also when I turned the base upside down and rotated the roller, I was abl ... Oreck XL2000 Bagged Upright Vacuum

I have a Eureka Altima vacuum. The model number is 2996. I don't think my vacumm is sucking any dust. Plus, it smells like a burning leather. What should I do? I have tried to get help from others and they tell me that I should change the belt. But, I don't know where it is. Please help.

Sounds like the belt for sure. Here is a link with the owners manual. It shows how to get to and change the belt. http://www.eureka.com/index.php?option=com_productdisplay&view=productdisplay&task=getproducts&productid=2&produ ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Dirt smell I seem to have a smell of dust when I vac. I have changed the bag and checked all areas where dirt collects and nothing is plugged. Seems to be puffing out from bottom and behind the unit

Orecks do have a lot of leaks in the airdut system of their machines. Most likely the smell however, is coming from the outer bag itself. That get so coated with fine dust that eventually it will start to smell like dust. Only by replacing the out ... Oreck XL Ultra Bagged Upright Vacuum

Ive changed the filter and checked the hoses but vacuum doesnt pick up ...when its on the dust is being blown out the bottom of the vacuum....i took the canister off to test the suction its fine...also cleaned the filter ...help!

Have you check the roller brush and drive belt? It may be your belt has broke or is slipping and therefore not turning the brush.\015\012Turn on machine and power head see if brush is turning if it is put a small amount of pressure on the rol ... Kenmore Vacuums

I just notice when I went to change bag in my Kirby G4 that the whose inside was split open, which made all the dust fill up in the bag. How do I get a replacement part for this and what is that part called. Do I need to buy the whole outer bag?

You do not need a whole bag. The bag fill tube is replaceable. can be temp fixed with duct tape and new one installed at home. vacuum inside with another vac and you will be set to replace ... Kirby G4 Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0492 seconds