Having problems with your Bosch BSG71360UC Bagged Canister Vacuum ?

Bosch cannister vac: Cord is stuck--won't rewind

\015 I can't figure out how to get to the rewind. The cord must be tangled up inside the vac because it is very short.\015

Answers :

It probably is, these cords are usually 15-25' long ;-)
What you can asssume is that the cord is simply twisted upon itself and doubled up so cannot easily come out, and will not go in... therefore.
Pull gently on the cord and twist in a clockwise direction. Does the cord seem to get a bit longer? If not, or if it gets tighter, try counterclockwise. If you keep trying eventually it will loosen and you can fully extend the cord. Compare this to holding a piece of string between your hands by the thumb and index fingers. Hold one end still and twist the other 20 times (twisting the string). then relax the string between your hands. See how it immediately forms a loop? That is the problem with your cordreel too. There is a loop in there that we need to undo. Now pull a bit so you can still see the loop, and then start untwisting to see what happens. You can also do this with a YoYo ;-)

Be patient, observe, sensitize your tactile senses and see if you can figure out which direction loosens your cord - and get it out ;-)

Good Luck
Hopefully you wont have to take it all apart. that cordreel spring is very strong. Be careful if you do go in there.
Repair Help & Product Troubleshooting for Bosch BSG71360UC Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bosch cannister vac: Cord is stuck--won't rewind

It probably is, these cords are usually 15-25' long ;-)What you can asssume is that the cord is simply twisted upon itself and doubled up so cannot easily come out, and will not go in... therefore.Pull gently on the cord and twist in a ... Bosch BSG71360UC Bagged Canister Vacuum

Bosch canister vac BSG81313. Took cover off to remove lots of hair, dirt etc from running without bag in place. Everything went back together OK, but cord reel spring went zip when cover was removed. How do I rewind the spring so there is tension when the cord is pulled out ? Wound cord back onto reel, but reel just clicks ever revolution etc...no tension when cord is pulled out of vac. Bob

The spring inside the hub of the cord wheel has escaped from the locking tab. You must completely dismantle the vacuum to access the cord wheel - take it out, reattach the spring and reassemble the unit. All you need is a phillips screwdriver, a pai ... Vacuums

Kenmore canister model 116.25513506 wont turn on. when handle switch is turned to floor. vac motor does not turn on. When switch is turned to carpet, floor nozzle works but vac motor does not. I checked fuse, all o.k. checked continuity for plug, o.k. removed wires for bag full switch...motor wont run. I wired motor directly power cord...motor runs. Thinking it must be the circuit board, how do I bypass it or test it?

... Vacuums

The cord rewind button for my electrolux vacuum cleaner is stuck so it always rewind the cord. how to fix it?

... Electrolux Vacuums

Barrel Dyson DC08 Origin cord rewind button is stuck.

... Dyson Vacuums

I have a bissell bagless easy vac. When I vacuum the debris keeps getting stuck in the hose (also going into the filter area and the apparatus above the cannister with none of it going into the cannister. I have made sure the cannister is properly placed and the lock is pushed in all the way.

... Bissell 3102-0 EasyVac Upright Vacuum

Hoover UH70120 WindTunnel TSeries problems with the cord. im a tech savy guy and have been trying to fix a cord after it was pulled to far out and now wont auto retract, but just cant find a way to pull the cord rewind mechanism out to work on it. Any advice

You will probably have to replace the cord winding mechanism. I have never had any luck trying to repair one. Cord retracters are great when they work but it seems like they always go bad before too long. On many units you can't even replace the cord ... Hoover UH70120 WindTunnel TSeries Rewind Bagless Upright Vacuum Cleaner

Hoover rewind cord stuck

... Hoover WindTunnel Pet Rewind Upright Vacuum

The roller brush will not stay on-& the cord rewind is stuck on

The wiring connections in the wand are burned   this can happen when disconnecting while machine is running      try by eliminating one of the wands! ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Vax mach 7 electric cord wont rewind

... Vacuums

Bosch Formula vacuum cord stuck

You need to take apart the reel. The cord is wound over itself and kinked. Be careful taking apart because if it gets away from you, you will have to wind the spring by hand and it is difficult to do and frustrating.Good luck ... Bosch BSG71360UC Bagged Canister Vacuum

I have a Hoover Elite Rewind vacuum. Actually,this is my second one. However, after about 4 months of use, it emits a "sour" smell when I'm using it. I empty the cannister before each use and clean out the filter monthly. My house has mainly hardwood floors, so I typically only use it on area rugs and 2 small carpeted rooms. Is there any way that I can get rid of the smell? I've tried putting a dryer sheet in the cannister, but this gets stuck in the filter mechanism. Also, carpet fresh clogs th

Does it smell like an electrical burning odor? could very possibly be the motor going bad already. ive seen it happen. but if not try freshwave odor absorbing pearls. i carry it in my store and we do have shipping. Truly the only thing you should use ... Hoover U5507900 Elite Rewind Bagless Upright Vacuum

My 2001 miele stopped working Black cannister. I believe cleaning ladies overheated it as the bag was very full and the vac felt warm to touch. I replaced bag and let cool down but it will not start. This has happened before and the vac store said they replaced the cord because it tends to go when it over heats. I have not taken in for and estimate but I fugure it will be at least $150 to repair. Is the another option.

... Miele S548 Bagged Canister Vacuum

Cord stuck wont come out

Click on this link for fixhttp://www.youtube.com/watch?v=wO_dqcAxB7A ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

Pwr cord rewind reel

You have to pop the grey button off for the cord rewind. There is one more screw under there. You have to be very careful, because you can break one of the tabs that hold the button on. In fact, it is almost a garuntee. There are three tabs that stic ... Hoover S1361 Bagged Canister Vacuum

I have Royal Precision 3050 cannister vac and the cord will not retract every time any help appreciated

... Panasonic MC-V9634 Canister Vacuum

Replace the power cord on a miele black jewel cannister vac

... Miele S514 Solaris Electro Plus Vacuum

I have bosch forumla vaccum and cord got stuck. It is very hard for me to see the screws to open it. Could somebody help me how to open this safely.

This problem is solved easily after I found the third screw to open the top cover. You will find the third screw under the top cover where the variable regulator is. But be patience, your small mistake can screw up whole system. You will need a torx ... Bosch BSG71360UC Bagged Canister Vacuum

Replace the power cord on a miele s514 cannister vac

Greetings from GoVacuum,\015\012\015\012Ok, so you need to replace the cord reel on a Miele S514 Solaris, no problem! I'll attempt to try and walk you through this repair with a detailed explanation of it, and along with some pictures to ... Miele S514 Solaris Electro Plus Vacuum

Cord rewind hoover s3765

Remove the 5 Phillips-head screws carefully without stripping the heads. There are 2 at the front bottom, 2 at the top back (above the wheels), and 1 at the back beneath the dustbin. After the screws are loosened/removed, you can remove the top cov ... Hoover S3765-040 WindTunnel Bagless Canister Vacuum

For Hoover canister cleaner model S1361, the power cord got stuck inside and cannot be pulled out or rewind, need help. What can we do? We live in Springfield Drive, Richmond BC V7E 1Z1. Thank You!

... Vacuums

My Hoover steam vac is stuck on the tools setting and wont stop leaking water from the tools hose

... Hoover Vacuums

Vacuum won't start unless I press down on the cord rewind area

... Hoover UH70120 WindTunnel TSeries Rewind Bagless Upright Vacuum Cleaner

THE ELECTRICAL CORD DOES NOT REWIND COMPLETELY ... WHEN REWINDING IT LEAVES ~ 3FT OUT OF THE CANISTER ... I have cleaned the cord & made certain that the cord is not kinked or twistedc

I have the same problem but i dont know how to open it i see no screws only the rubber band that goes around it unless theres a way how to do it ... Kenmore Magic Blue 24195 Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0664 seconds