Having problems with your Bosch BUC11700UC Cyclone Jet Bagless Upright Vacuum ?

Bosch Vacuum upright

\015 My vacuum has no power when I plug it in\015

Answers :

Press safty button and wait for 2 minutes.
Its a problem with the power switch you can wire nut the wires together but I have been looking for parts myself.
Repair Help & Product Troubleshooting for Bosch BUC11700UC Cyclone Jet Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where can I buy a Bosch Turbo Jet Upright Vacuum (BUH11700UC) light bulb?


... Bosch Turbo Jet Bagged Upright Vacuum

Bosch Vacuum Cleaner: I changed bag. Cleaned out all suction hose and hepa filters, however, my 1450 w 12 amp upright vacuum cleaner will die after five minute run - overheating. Please advise.


Greetings from GoVacuum.com,It sounds like you may have a bad thermal switch inside the machine. Most vacuum cleaners have a switch connected to the motor, so if the vacuum cleaner is running hot, it will shut off to prevent any damage ... Bosch Vacuums

Who to replace switch on bosch BUC11700UC - Bosch BUC11700UC Cyclone Jet Bagless Upright Vacuum


... Bosch BUC11700UC Cyclone Jet Bagless Upright Vacuum

Bosch BUC11700UC Cyclone Jet - Bosch BUC11700UC Cyclone Jet Bagless Upright Vacuum


... Bosch BUC11700UC Cyclone Jet Bagless Upright Vacuum

Bosch Vacuum upright


Press safty button and wait for 2 minutes. ... Bosch BUC11700UC Cyclone Jet Bagless Upright Vacuum

How do I clean canister - Bosch BUC11700UC Cyclone Jet Bagless Upright Vacuum


Best to check the instruction book, if your having trouble finding your instructions check out http://talkappliance.co.uk/downloads/ ... Bosch BUC11700UC Cyclone Jet Bagless Upright Vacuum

Where can I find an instruction manual for my upright Bosch Vacuum (BUC11700UC)? Thanks!


Click here for the manualGood luck.Please do rate my solution if accepted.Thank you. ... Bosch Turbo Jet Bagged Upright Vacuum

Vacuum cleaner I am needing to buy a vacuum cleaner - the flooring in our house is mainly oregon pine with loose rugs. I suffer from back problems and find the cylinder vacuums cause a great deal of back strain. I have been told that an upright vacuum is not suitable for wooden floors - I would appreciate any advice, particularly if u know of an upright vacuum cleaner that works well on wooden floors Thank you


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=517227&thid=728380\015\012Vacuum cleaner\015\012Posted by che9 on Jul 01, 2008\015\012I need to buy a vacuum clea ... Electrolux EL7055A Bagless Canister Vacuum

I removed the brush from bottom of the vacuum to remove hair from the bristles. When I re-assembled the vacuum, there was no longer suction. Also, the vacuum no longer stands upright when not in use. It's like something is blocking the upright portion from locking.


... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a DC 17. In the middle of vacuuming the vacuum stopped working when it was in the upright position. It only works when the head is down and i am using the bar. I can not use the extension bar, becasue when I put the vacuum upright it shuts off. Where is the problem?


Hi there, it's Jack at Dyson.\012 \012 Like most Dyson vacuums, DC17's main suction motor is protected by a thermostat which shuts the machine down if it starts to overheat. This could be due to a blockage, and the filter may also need a wash ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My Oreck vacuum cleaner will only stay on in the upright position. If I try to recline it to vacuum, it shuts off...put it back up and it turns back on. Of course I can't vacuum in the upright position...what do I do?


It sound as if you have a short in the cord or it has come loose from the motor you can take it part by removing the four screws in the buttom of the base plate to see if any of the wires are loose. ... Oreck Vacuums

Bosch vacuum cleaner bsg71810gb - Bosch BSG71310UC Bagged Canister Vacuum


... Bosch BSG71310UC Bagged Canister Vacuum

Vacuum stands upright but won't lean back - Dyson DC28 Animal Bagless Upright Vacuum


... Dyson DC28 Animal Bagless Upright Vacuum

Panasonic upright vacuum brushes dont turn - Panasonic Bagless Upright Vacuum Cleaner MCUL915


This may be too obvious, but do you have the Carpet switch turned on (bottom left of vac). Agitator brush does not go around if Floor/Tools is switched on, ... Panasonic Bagless Upright Vacuum Cleaner MCUL915

Eureka4701bagless upright vacuum - Eureka 4700A Maxima Bagless Upright Vacuum


Dont know what the problem is but this link is for the manualhttp://dl.owneriq.net/b/b7517422-db37-404e-9da2-d898185942e5.pdf ... Eureka 4700A Maxima Bagless Upright Vacuum

Vacuum has a high pitched whine - Bissell 82G71 Momentum Bagless Upright Vacuum UPRIGHT VAC NEW MOMENTUM BORDEUX PEARL 82G71


... Bissell 82G71 Momentum Bagless Upright Vacuum UPRIGHT VAC NEW MOMENTUM BORDEUX PEARL 82G71

Kenmore upright vacuums Model 11635922502 - Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum


What is the issue or problem? ... Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum

Now that I just fixed my Lux Legacy canister vacuum, I need help on my other Electrolux Regency Series upright! The vacuum works fine but the rotating brush does not work and the brush motor does not turn on. Tried cleaning the brush and hitting hte reset button to no avail. This upright has a triple setting switch and I checked the each of the wires seem to be attached. Tried rotating the brush by hand and it would not budge. Was going to "encourage" the brush to turn with a set of articula


There are a couple rectangular holes on the bottom of the power nozzle, beside the wheels. These have tabs in them that need released with a standard screwdriver. \015\012 ... Vacuums

Bosch vacuum cleaner burning smell - Bosch Vacuums


... Bosch Vacuums

Vacuum will not go completely upright - Dyson DC07 Bagless Upright Cyclonic Vacuum


This is something I've been seeing a lot lately, so don't feel like you're the only one with this problem.here's a link to a fix you can try that might solve your issue: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a Dyson DC14 upright vacuum cleaner that after cleaning out I am unable to stand the vacuum upright so that I can use the tools any idea of the problem?


Normal\012 0\012 \012 \012 false\012 false\012 false\012 \012 \012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012 \012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-s ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

The plastic piece with a small spring that holds the vacuum upright broke. Now the vacuum won't stand upright by itself. I don't think if I glue it, it will be strong enough and can't find the part.


... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

I have a bissell healthy home vacuum and the roller bar on the base of it is not working. I have checked it for obstructions and it is clear. I have also tried reseating the canister and just about everything I can think of. It's almost like the switch that deterrmines whether or not the vacuum is in the upright position is broken and always says it is upright... any way to fix that? Thanks, Scott Hammersley


... Bissell Vacuums

The original belt on my upright Kenmore Progressive broke and I replaced it with the spare that was in the vacuum. The vacuum and spare belt are about 10 years old. Then the spare broke after one vacuuming session and there was a burning smell coming from the vacuum. I ordered new belts and replaced it with the new belt. It seems to be working fine with no smell. I checked the belt after I vacuumed the family room and although it was in tact, the belt was very hot. Is that normal? Should t


The belt heats up due to the friction, as well as being in contact with the shaft of a hot motor. It is normal. ... Kenmore Progressive 35922 Bagged Upright Vacuum

I have a Kirby G4 Vacuum Cleaner - MOdel G4 D. I have never had any problems or repairs done to it in the past ten plus years that I've had it. This is an upright vacuum. I was vacuuming the carpet floor and was not having any trouble at all. I switched the vacuum off and moved it into a different room. When I tried to turn on the vacuum, it would not turn on. I checked with different outlets, used both front attachment and hose attachment. Checked the front part of the motor/ spiral case. This


Hello,\015\012My educated guess is that it's either the switch or the power cord. Here are a couple of guides to help with diagnosis and repair...\015\012\015\012 ... Kirby G4 Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0928 seconds