Having problems with your Bosch Vacuums ?

What is the approximate years of manufacture of the Vorwerk ET340 vacuum cleaner?


Answers :

Repair Help & Product Troubleshooting for Bosch Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

What is the approximate years of manufacture of the Vorwerk ET340 vacuum cleaner?


... Bosch Vacuums

I have a Kenmore canister vacuum - model 25614506. Some time ago, I was not able to turn the vacuum off with the on/off switch, but could still use the vacuum. Turned if off/on by pulling the plug. The other day when I went to plug it in, I heard a pop. Now the sweeper runs but the vacuum cleaner does not **** - no air flow. What could be the problem. The cleaner is only 4 years old.


The motor has an inline fuse ... Kenmore 25614 / 25615 Progressive Bagged Canister Vacuum

Hi. We have a Riccar N2100 vacuum cleaner, which has served us well for many, many years. I'd like to attempt a repair on this unit, and looking for advice and/or a parts diagram to proceed. The unit makes a groaning sound when shut off. The sound tapers off in pitch as the motor and beater bar come to a stop. The sound only happens when the vacuum cleaner is turned off in the normal upright position. The sound does not happen when the lower unit and main housing are both laying flat. I took


... Vacuums

Hot cord the cord on my vacuum cleaner has been getting very hot the heat is from one end to the other incuding the plug and also where the cord exits the back of the canister please help I love this vacuum cleaner it has been faithful to me for over 15 years!


Likely after all these years that the motor is starting to go bad and draw more amps thasn it should. a new motor at a vac dealer is your best bet. it was likely made by panasonic, so a new panasonic is your best bet, and less $$$than the kenmore for ... Kenmore 23313 Whispertone Bagged Canister Vacuum

I have a Kirby G4 Vacuum Cleaner - MOdel G4 D. I have never had any problems or repairs done to it in the past ten plus years that I've had it. This is an upright vacuum. I was vacuuming the carpet floor and was not having any trouble at all. I switched the vacuum off and moved it into a different room. When I tried to turn on the vacuum, it would not turn on. I checked with different outlets, used both front attachment and hose attachment. Checked the front part of the motor/ spiral case. This


Hello,\015\012My educated guess is that it's either the switch or the power cord. Here are a couple of guides to help with diagnosis and repair...\015\012\015\012 ... Kirby G4 Bagged Upright Vacuum

Dyson animal We bought a Dyson Animal from Sears a few years ago along with a service contract. We took it each year to be serviced. One year I took it because it lost it's suction. They sent it to the factory, but it came back still not working right. We did the same procedure over ands over many times than I can remember. I now have the cleaner in my garage and am using my old vacuum because I just can't seem to get anywhere with Sears. Please help me. We paid almost $600.00 and now it can't b


As someone who works for Sears, let me just say right now.. The service contract you bought sucks.. and does not really do anything for you. it was just a wast of money ( they have a new one now.. thats so much better because you get your money back ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I have a Dyson vacuum cleaner ...upright....all of a sudden my vacuum started making this awful sound...like a loud buzz...but only when I have it on carpet....when I have it on "floor" mode it's fine....sometimes(although seldom) it has worked without buzzing...and it's LOUD!!....I have only had this vacuum for a year....and no...I have never picked up any coins or hard stuff.only use it for 2 rooms.the rest of the house is wood floors.......what shall I do? Thanks......Gloria


It may just be, that on carbet the brushes make noise that you dont hear on woodfloors.\015\012If there is a hights adjustment, set it higher for shaggy carpet and lower for berber. ... Vacuums

I was given a Kenmore progressive hepa filter 22313 Bagged Canister Vacuum recently, but don't have the manual. We used it once to vacuum the house and it worked beautifully. Then we used it 5-6 days later and it started whining and getting hot. What year was this vacuum manufactured? Where can I download an owners manual?? Help!


Http://www.managemylife.com/mmh/owner_manuals/5461/KENMORE-Vacuum-Canister-L0809572 ... Kenmore 22313 Bagged Canister Vacuum

Model 116 Kenmore vacuum cleaner. 20+ years old,


Greetings,\015\012\015\012I believe that this is probably a Kenmore Canister vacuum cleaner, but I can't be positive. The model number 116 is just the first part, and all Sears vacuum cleaners start with model 116. There is a . after t ... Vacuums

I have a nearly 9 year old Electrolux Excellio Z5228 vacuum cleaner. It has recently started cutting out during operation. I cleaned the micro filter (between bag & motor) via brush & hitting against wall & seems / looks quite clean. I washed the gore filter (output from motor to clean the exhaust air) as per instructions, then let to dry. It was very clogged but now very clean. The vacuum clearner still cuts out often. Even after a long rest (say overnight) it still won't start, then ano


... Electrolux Vacuums

My cleaner ( Oreck 40th Anniversary, XL2 Ultra) several years old, and I love it. My questin, is there a reset button? Vacuum just quit....no noise, sputtering, smell, nothing, just stopped while running cleaner. New bag, new belt. Any ideas?


... Oreck Vacuums

Suction problems My Hoover elite vacuum (which is less than a year old) is not sucking up properly. Also, when I detach the tube that goes to the vacuum cleaner so I can add my attachments, it blows OUT dirt through that opening. HELP!


Sounds like a clog right near the front ... Hoover Elite U5061-900 Bagged Upright Vacuum

My Morphy Richards vacuum cleaner (2 years old) will not pick up properly and also cuts out about vacuuming one carpet but then starts again later. Will I need to call our repair service?


Here are a few tips to try before you call a repair service.\015\012\015\012Most people think that putting their vacuum on the lowest setting picks up the most dirt. If you have medium to shag carpet, putting it on the lowest setting wil ... Vacuums

Vorwerk vk121 vacuum cleaner - Vacuums


... Vacuums

Hi I’ve got a Panasonic vacuum cleaner MC E468 1600W a few years old now but works well up to recent problem. Not picking up I checked the obvious things and found excessive air being sucked in around the hose housing at the back of the vacuum (as it enters the waste bag) On inspection it appears to me as if there should be some sort of gasket that may have perished and been sucked in, however I can’t identify any such part. Any thoughts on what the problem/solution may be will be appreciate


The hose on the back might be loose - check to see that the hose is not obstructing anything where it screws in at the back - or indeed the screws may be loose themselves; some of the MCE 468 models had an additional ring washer that sits between the ... Panasonic Vacuums

I purchased the bissell proheat 2x steam cleaner approximately 2 years ago.... used it approximately 5 times... now the sprayer will not spray.... i have checked the spray nozzles and there is not an interference... what do i need to do... my mom bought one the same time and it too is doing the same.


Too much different washing liquid mixing procreant bulkhead in the water pipe hose\015\012\015\012try use clean water cleaning\015\012\015\012\015\012 ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Hi I have a delonghi TW15E wet / dry vacuum cylinder vacuum cleaner ( around 4- 5 years old now ) , and have lost the instruction manual...can you advise how to use it for carpet cleaning / and or how to get another copy of instructions


... DeLonghi XM5080 Wet/Dry Vacuum

The Vacuum canister is working but the tip did not havesuction power. Should I change it? Where can I finf the repair shp in my vicinity. My area is Ravenna, Ohio 44266. My Vacuum cleaner is about 10 years old similar to Ultralux 2000.


Try checking for blockages first, turn the foot of the vaccuum over and check the inlet tube, there may be a little flap that needs to be pulled forward for you to see if there is a blockage. ... Electrolux Vacuums

Motor My vacuum cut out as I was using it. After some experimenting I found that the circuit reset had gone off. When I tried a second time while near the motor , there was a flash and again the motor shut off. At this time I am guessing that the motor is faulty. The central vacuuming is approximately 12 years old.


If it tripped the reset again, I would probably agree with you. Check out centralvacuum.com for another motor. They aren't the cheapest, but they have excellent support. Good Luck!! ... Easy Flo EF1400 Central System Vacuum

Kirby Vacuum Hi Bruce, In my opinion, yes the Kirby would be worth it, as long as you are not replacing the motor. The switch would be the most expensive part besides the motor that would need to be replaced. The switch costs USD 49.99, the cord is roughly $39.99, and the carbon brushes are $29.99. I can easily walk you through any of these repairs should you need help. Kirby's are great vacuum cleaners, that usually last 30+ years. Brand new these machines sell in the US for $1600 or more,


You can get better prices from Goodvac.com ... Kirby Generation 3 Bagged Upright Vacuum

My electrolux oxygen vacuum cleaner shut off and will not turn back on. It's less than a year old, but I bought it off Craig's list--they were the orginal owner and they said they bought it in May of 2008. I've only used it a few times and it worked fine except for the last time when it suddenly just shut off. I thought maybe it had come unplugged and I didn't really worry about it because I was finished vacuuming. But, I went to use it tonight and it would not turn on at all--no lights, nothing


No..Electrolux is really great about warranty service. They will help you even though you are not the original owner. ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

I HAVE A FANTOM VACUUM CLEANER MOD.#F1205400. I PURCHASED IT ABOUT 6 OR SO YEARS AGO.IT WORKS PERFECT,AS FAR AS SUCTION, THE ONLY PROBLEM IS ABOUT 2 MONTHS AGO,SOMETHING HAPPENED TO IT AND IT GOT VERY LOUD, KIND OF LIKE A CAR WITHOUT MUFFLER. I TOOK IT APART,AND FOUND NOTHING OBVIOUS. CAN YOU GIVE ME SOME IDEA OF WHAT I CAN CHECK TO RESOLVE THIS PROBLEM. AS I SAID BEFORE IT STILL VACUUMS GREAT. THANK YOU, VINCE


You probably have a bad motor bearing. I don't know if the motor is available now or, these older Fantom's are obsolete along with most of their parts. ... Vacuums

I have a Miele vacuum cleaner, model S434i that is about 12 years old. The vacuum is great but the handpiece/hose/elbow has worn out. Any idea where I can get replacement parts in New Zealand?


... Miele Vacuums

I bought an Electrolux Accelerator vacuum cleaner with a HEPA washable filter last year, and now it won't **** strongly. I think its the hose pipe. I clean the filter every time we use it. I am really frustrated! Any ideas?


Check the suction port it is probably stopped up or take the filter out and crank it up see what happens ... Vacuums

The top of the vacuum cleaner gets very! hot with little use of hand wand. it is a majestic model with chrome top about 6 years old


The exhaust is from the top so it will normally get pretty hot. If the machine shuts off, then there is a clog, or a full bag. Most of your machine is actually plastic, so examine it closely for warping or any discoloring. Also if it sounds funny yo ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0901 seconds