Having problems with your Bosch Vacuums ?

My Bosch Tassimo T20 will not brew properly. The water flows very slow and does not run a full cycle. The descale light is not on, but I ran a descale program anyways. The cycle took over an hour vs. the 20 min it should take.....Help!


Answers :

Repair Help & Product Troubleshooting for Bosch Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Bosch Tassimo T20 will not brew properly. The water flows very slow and does not run a full cycle. The descale light is not on, but I ran a descale program anyways. The cycle took over an hour vs. the 20 min it should take.....Help!


... Bosch Vacuums

UPM Model ET170 Electronic Timer Programming: A. Is it required to associate one program number with each day of the week? B. Can two programs run during the same day? C. Can each week day run a different program number? D. What is the shortest ON time one must program for the RANDOM function to provide two ON-OFF cycles? E. How do I end the programming mode and start the timing sequence. The instructions with the timer are not clear to me. Thanks for your help.


A. It is required to program each day of the week.B. No. Either it is programmed to be on or off.C. Yes. Each day can run a different program.D.Short random is for 1-2 hours. Long Random is 2-3 hours.E. Once you are done progr ... Vacuums

Scooba will not start clean cycle...the battery is fully charges and the power light is on but the clean light will not come on and it will not start cleaning...scooba also does not make any noise or beeps. what is wrong and how can i fix this?


Hi,\015\012\015\012Visit to the given link and download the manul. Manual gives the solutions, which can be applied at home... (Especially go through manual's page no 21)...\015\012\015\012 ... iRobot 5900 Scooba Robotic Wet/Dry Vacuum

Dirt finder I have a Hoover U6439-900.  After the cleaner was used a few times, the dirt finder light cycles between green and red on the regular setting and will not go to green.  On the sensitive setting, the red light stays on most of the time.  I have tried to run the cleaner to remove any dirt but have not solved the problem.


The sensor may be bad, or it may be coated over with dirt. Re,ove the hose at the back of the vacuum, the head of the sensor is down inside that opening, reach in there and clean it off and see it that corrects the problem, if not replace the sensor ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

I have the IROBOT discovery that just got a new battery. IT ran great! As the battery was dying, I put it into the home base. The "brick" is green, the home base has two green lights and the on/off pulsates red. It never charges though. Eventually the red light stops pulsating. Customer service said to reset it, clean the metal, and nothing works! They told me to just buy another one. The problem is that I know it was working! Help!


The best thing that you can do is take the charger into somewhere that can test it for the proper output voltage. It should be somewhere very close to 22 volts with no fluctuation. The charger is the easiest thing to test in this case. ... iRobot Roomba 4210 Bagless Robotic Vacuum

I have a littermaid elite automatic litter disposal system. It stopped cycling and both lights are flashing. Nothing is stuck, it just made several passes at some point overnight without successfully getting to the receptacle due to heavy litter. The box was clear and moving before we went to bed. This morning the lights were flashing. I unplugged, emptied, etc and it will not work. what now? It does not have the reset button at the receptacle button that the old models did. Is there one?


... Vacuums

Sharp TC-4650 vacuum motor does not come on but the light does. waited a day and it ran again but when i unpluged it and plugged it into another receptial themotor did not run but the light can on


... Sharp Twin Energy EC-T4660 Vacuum

I hooked up my honeywell econoswitch RPLS740B timer and it appears to be operable and programable, and even switches to on when it hits the programed time, but simply doesn;t turn on the lights. I can't manually turn it on either. Any solutions?


... Vacuums

I have a Mr Coffee PSTX Series coffeemaker, the clean light came on and I started the cleaning process, about 20 minutes into it, an alarm went off, the cleaning light was blinking and I can not clear the alarm. It has not finished going through the cleaning cycle and is frozen on with the alarm. I can not clear it. Please advise.


... Vacuums

I have a Bissell Proheat 2x cleaner which has worked perfectly on every occasion. Today I filled the machine as usual with water and formula and switched on, the motor ran, the lights were on and the brushes rotated but upon pressing the spray trigger no water or formula was released. I have cleaned the jets underneath and also followed instructions to release any airlock. It still wont release the water/formula. What else can I do? Thanks Charles


Please check the following with liquid in both tanks.\015\012 \015\012- Check to see if the machine will spray through the hose with the setting on tools. If it does, the pump is fine. Continue troubleshooting.\015\012- ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Our Winsdor Sensor XP12 does not show any power or lights, I did check the handle connection, it was fine. The power cord has been repaired with duct tape 3-4 x where someone has sucked up the cord, this may be the cause yet it ran fine last time it was used! so I am at a loss, please help if possible.08/31/2010 Steve


Any time the cord has been damaged badly enough to require taping, the possibility or intermittent "opens" exist. This means the wires are in contact much of the time, but will losed contact periodically. Even if it worked fine seconds ago, jigglin ... Windsor SR12 Sensor Bagged Upright Vacuum

How do i program the light on a aquadecor 303? Thanks


... Vacuums

Shark s3325 stopped working while steaming; thinking the unit had ran out of water I allowed unit to cool before refilling, however unit over flowed with only 700ml water added. When I plugged unit back into outlet it would not turn on (red light was not on) but I hear a click upon plugging in unit, when turning unit power button on and when turning on the handle switch. Please advise how to resolve this problem.


... Euro-Pro S3325 Handheld Steam Vacuum

My CJX Series decided not to brew! I checked the manual's troubleshooting, (The coffee is not brewing) everything is correct! The unit has power and the light comes on, will not start brewing cycle.


Heating elements in coffee makers have an internal thermal protection device to locate it access the bottom cover find the wires leading to the element you will find on one of the wires a silver bullet shaped device this is the culprit, you can check ... Vacuums

Sharp microwave carousel R330J 1100 watt. When the heating cycle is started the microwave light flickers on and off and there is a clicking sound. Initially high voltage fuse blown. replaced fuse and diode, checked capacitor. Fault still present even after disconnecting power to magnetron.


Hi and welcome to FixYa. I am Kelly. \012\0121st the model number appears to be incomplete. Not an issue at this point but will be if you need parts. \012\012You most likely have an interlock problem with one of the 2 door s ... Vacuums

Karcher sc1402 bought july 2010 the water will not auto fill and red light keeps coming on because water not reaching tank machine works for a brief time when manually filled by unscrewing plug at top and filling it that way, once water level reduces machine wants more water and this doesn't happen i have descaled


... Karcher DE4002 Steam Vacuum

De Scale light is on mu Bosch Tassimo Coffee Maker. Can I mix my own descaling solution using commonly available household items?


... Vacuums

HOOVER STEAMVAC Model# F5842-9RM 120v 12 amp Carpet Cleanerworks well. Hooked up upholstrey attachment, used it. Reassembled to standard operation, the aggitator brushes do not work. I dis assembled brush insert verything good. ran cleaner and the square hole that the bushes insert into did not rotate with cleaner on. turned off lightly tried to turn mechinism in machine no luck. Reassembled aganin, reinserted cleaning tool, then disconnected it. agitator still doesn't work. toggled switch


... Hoover Vacuums

My irobot Dirt Dog won't go into a cleaning cycle. It is charged, but when i hit the clean button it does nothing. new battery installed a week ago. the LED lights under the "clean" button are flashing in sequence, "Green, Green+Red, Green". Then the sequence immediately stars over. Can someone help me?


Hi, A very common problem with the I robot is the wheels on the underside become clogged with dust and dirt. Turn the device over, and remove the bottom cover that is covering the wheels. At this time, remove the dirt and blockage from the wheels, an ... iRobot 1100 Dirt Dog Bagless Robotic Vacuum

I have Nutone VX550C. Motor runs intermittently (cycles on and off rapidly--the light on the handle is blinking furiously) when I use the on/off switch on the hose. This happens at all of the wall connectors, so suggests a hose contact problem. Motor runs continuously when I turn it on at the switch on the wall unit.


The unit does have a switchs the PVC outlets, and it sounds like the hose mech to operate the switches is broken, and intermittently making contact. A replacement hose would likely fix the problem. Looked them up on the net, and they're not che ... Broan-NuTone VX550 Bagged Central System Vacuum

Just purchased online Ran fine for about 5 minutes and then quit completely. Lights are on in control handle but nothing works.


Please reply with the make and model number for more exact help.Thanks!! ... Vacuums

Hello. My scooba 5800 had a check tank light on. I used a straw on the valve and that fixed the problem. Now the scooba runs like nothing is wrong, but there is no actual cleaning going on! It goes the full cycle, but no liquid comes out. The vac part seems to be working b/c there is fluff in the vac when it's done. Please help!


Hello, Take the battery out and hold the switch down for 30 seconds, to reset the curcuit board, then charge back up for 12 hours. this should take care of it. If I can help future please call @ 1561-848-3387 Thank you, Teresa. Clean Sweep Vacuums ... iRobot 5800 Scooba Vacuum

I have lost my instructins on how to program this power center for my aquarium lights and need some help gettign anouther set of instructions


May I get the make and model # of the power center for the aquarium. ... Vacuums

Karcher sc1402 bought july 2010 the water will not auto fill and red light keeps coming on because water not reaching tank machine works for a brief time when manually filled by unscrewing plug at top and filling it that way, once water level reduces machine wants more water and this doesn't happen i have descaled


... Karcher DE4002 Steam Vacuum

I have replaced the battery in my 4210 and reset the charge cycle. It has supposedly been charging for about 55 hours now and I plan to let it charge the full 72. Is it normal for the power light to become VERY pale?


The power light changes color and on some models goes dim to indicate charge level. It will be ready to go when the light is at maximum illumination. ... iRobot Roomba 4210 Bagless Robotic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0271 seconds