Having problems with your Bosch Vacuums ?

Bosch Vacuum Cleaner: I changed bag. Cleaned out all suction hose and hepa filters, however, my 1450 w 12 amp upright vacuum cleaner will die after five minute run - overheating. Please advise.


Answers :

Greetings from GoVacuum.com,

It sounds like you may have a bad thermal switch inside the machine. Most vacuum cleaners have a switch connected to the motor, so if the vacuum cleaner is running hot, it will shut off to prevent any damage to your motor. You did all the right things by checking the bag, making sure the hose was NOT clogged, and replacing HEPA filter.

Most of the time on canister vacuums, the reason is caused by a clog in the hose, or somewhere in the powerhead. If you're sure that there is no clog anywhere, it is going to be the thermal switch on the motor.

Here's a link to the parts schematic for the Bosch upright vacuum. I hope it helps you in determining how to access the thermal switch. A word of warning to you before you try it, this is a very tough vacuum cleaner to work on, you may want to bring it in to a vacuum repair shop, as this is not an easy repair.

Here's the link;
http://www.essco.net/Customer/SchematicFrame.asp?FileName=Turbo%20jet%20upright.pdf

Please let me know if you have any other questions,

Chris Jones
GoVacuum.com
1-866-468-2288
[email protected]
Repair Help & Product Troubleshooting for Bosch Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bosch Vacuum Cleaner: I changed bag. Cleaned out all suction hose and hepa filters, however, my 1450 w 12 amp upright vacuum cleaner will die after five minute run - overheating. Please advise.


Greetings from GoVacuum.com,It sounds like you may have a bad thermal switch inside the machine. Most vacuum cleaners have a switch connected to the motor, so if the vacuum cleaner is running hot, it will shut off to prevent any damage ... Bosch Vacuums

Hi good day, I have a Kenmore Grab n Go 12.0AMPS Vacuum cleaner, Model# 116.34722402 & serial#T53601507. The vacuum is now having a problem whereby the rolling brush underneath is not spinning when the vac is on. This has caused it to stop sucking up dust. Could you please advise as to what might be the problem. Thanks in advance for your kind assistance. regards, Clarance


... Kenmore 34722 Grab-N-Go Upright Vacuum

No manual. I have no manual or instructions for filter changes for the Hoover DM4494 Upright Bagless Vacuum Cleaner. Please advise. Thank you.


The manual is located here: http://www.hoover.com/pdfs/manuals/U5194900.pdf ... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

Durt Devil upright 12 amp Vision Vacuum Cleaner


If there no blockages in the hoses, then the next thing to check would be any filters in the vacuum. When these get clogged, you will experience this problem.\015\012\015\012Dave ... Vacuums

Hello, I have a problem with my Eureka Powerline bagged upright vacuum. It has a 12 amp motor and is model #4352, Type D. It was probably bought new in 1998. My problem is, while vacuuming today the motor seemed to slow down all of the sudden and then began smelling like burning rubber. I shut the vacuum off to check for blockages but could not find anything blocked. When I then turned it on again it runs but seems to only be running at 1/2 the motor speed and still has the rubber buring smell.


It sounds like a rubber sealing in the motor has come loose and is being constantly rubbed against the walls of the motor with would cause the smell and loss of motor speed caused by the fricton of rubber against the rod so if you can get to the moto ... Vacuums

My bissell 3595-2 vacuum cleaner started turning off the power automatically. Now I can not get it to turn on. This vacuum cleaner is still in real good condition, as I have hardly used it. Please advise what could be wrong. I was thinking maybe a loose connection with the on-off switc.


... Bissell Vacuums

Shark Pursuit Euro-pro X vacuum cleaner, 12 amp, upright model


This vacum cleaner is equipped for auto shut off when it gets hot , It gets hot when it gets clogged either the little sponge filter is to dirty or the the round white filter in the dust collecting container. ... Euro-Pro UV209 Upright Vacuum

Suction problem I have a Hoover Widepath Fold Away, 12 amp motor vacuum cleaner and the problem I am having is every time I vacuum, the vacuum gets clogged up with carpet. I am probably only able to do one stroke then it gets clogged and I have to stop and unclog it or it spits it out on the carpet. This is very frustrating and I don't get much vacuuming done. Please can you help me. Thank you. Gwen email is [email protected]


Get rid of the carpet its shredding and falling apart.no sence in vacuuming old rotten carpet.or try using a vacuum without a brush roller and just suction ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

The Electrolux Prolux upright vacuuum cleaner vacuum motor is not running and the brush is working well. What is the problem and how to open up the cleaner


... Electrolux EL5010A Bagged Upright Vacuum

I have a Zanussi 1700W bagless upright vacuum cleaner which keeps cutting out after about 5/10 mins use. I had to replace the rubber drive belt which snapped not long after purchasing and it was fine for a while, but now its just keeps cutting out after a small amount of use. Nothing wrong with belt which is still intact so we don't know what the problem is. It's a great cleaner otherwise - but it's driving us mad!! Please help!


... Vacuums

On an old upright prolux plus, I just replaced the belt and cleaned out the brush motor, ran the vacuum for a bit, then the vacuum motor died...it's always run great. any suggestions of what to check?


... Electrolux Vacuums

I have a kenmore vacuum cleaner model # 116.23612. When the hose is attached to the canister it runs, but if you remove the head to just use the hose the unit stops working. Is the motor dead or is there some type of reset or fuse. Could you please tell me how to test this. If so could you please send me instructions on how to replace the motor. Thank you in advance for your help, Tony


... Kenmore Vacuums

I have the Bissell upright cleanview bagless vacuum cleaner. My belt broke and someone else took it off. I bought a new belt but do not know where it goes on the cleaner. Please help


Easy to do. Unplug the vac. Turn the vacuum over and look for three finger latches on the bottom behind the brushes. Unlatch these and pull the faceplate off. Then, grab one side of the brush and pull straight up (they just sit in grooves on the ... Bissell CleanView 3596 Bagless Upright Vacuum

My dyson DC16 constantly shuts off even when battery is fully charged. I cleaned the filters to see if that was the problem. It only runs for a few seconds before it shuts off. It will run intermittently for about 10 minutes before dying completely. Please advise


Hi its Darran at Dyson. From your description of the problem, it sounds as though there is a problem with the battery. Your DC16 will have been supplied with a 2 year guarantee. If it still within this period, please contact ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

Please advise the type of bags used for the Shark Euro-ProX vacuum cleaner as it does not say anywhere on the unit. Kindly advise. Email [email protected] Thank you.


That is a bagless vacuum. It does not require any bags, but you do have to clean the filters every so often. There are three filters in the top canister, and one in the base by the motor. Press the black button on the front of the canister and pull o ... Euro-Pro UV209 Upright Vacuum

Electrolux Prolux Plus Commercial Heavy Duty Upright Vacuum Cleaner brush didn't run


... Electrolux Vacuums

Electrolux Prolux Plus Commercial Heavy Duty Upright Vacuum Cleaner brush didn't run


... Electrolux Vacuums

Vacuum cleaner I am needing to buy a vacuum cleaner - the flooring in our house is mainly oregon pine with loose rugs. I suffer from back problems and find the cylinder vacuums cause a great deal of back strain. I have been told that an upright vacuum is not suitable for wooden floors - I would appreciate any advice, particularly if u know of an upright vacuum cleaner that works well on wooden floors Thank you


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=517227&thid=728380\015\012Vacuum cleaner\015\012Posted by che9 on Jul 01, 2008\015\012I need to buy a vacuum clea ... Electrolux EL7055A Bagless Canister Vacuum

I have been given a Sanyo upright vacuum cleaner. It is a Performax 10.0 amps, Model SC-A102. I cannot locate bags for it. I live in Houston, Texas


Two solutions come to mind---1) Find a local vac store, NOT a department or big box store, and bring the bag to them.Sometimes on the bag is an identifying letter or number and on many you need to remove the bag to see it. Also bring your make/model ... Sanyo Vacuums

I just bought a good Sears Kenmore Progressive 300 upright vacuum (116.38812891) today at a garage sale for five bucks. I left my relic Electrolux with the new owners of my former home during a recent relocation. In the interim I bought a Bissel 3750H which I do not care for, and borrowed a Eureka 7685 AU which performs somewhat better. I cleaned up the Kenmore, and though it seems to run well, noticed the drive belt is showing signs of degeneration. I would like to replace it, but was unable t


... Vacuums

DYson DC07 not sucking properly when in upright mode. I have tried cleaning out pipes etc and even tried an old motor section I had in garage (replaced once under warranty as kept cutting out and they left old motor section here). Even the old motor section had same prob so this suggests its something in the rest of the vacuum cleaner (whats left after you have lifted off the green motor section and dust collection area if you see what I mean? Any advice weclome please.


Blocked filters ... Dyson DC07 Bagless Upright Cyclonic Vacuum

When I plugged in my Riccar Vacuum cleaner - it made a pop sound. The breaker had not been moved - there was no smoke or apparent damage. I tried to depress the restart button and nothing happens. Is there a technique about pushing the restart button. Please advise.


Check the cord where it goes into the machine on back. most likely blew out at machine ... Riccar 8955 Upright Vacuum

My Bissell 5570 is not staying on. When I push the on botton it goes on but as soon as I remove my finger the machine turns off. The Vacuum is in the upright position and there are no cuts in the electric cord, the canister is properly attached. Please advise. Thank you


... Bissell Healthy Home HEPA Bagless Upright Vacuum - Metallic Blue

I have a hoover pure power 1700 vacuum cleaner and the handle will not stay upright it keeps falling back can you help please


... Hoover Vacuums

Dyson vacuum cleaner - nothing coming into the chamber. shuts off in upright position. I already cleaned the fuzz out of the chamber next to the chamber. Please help. Only 2 months old Thanks, L. Gordon


... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1058 seconds