Having problems with your Broan-NuTone CV350 Performance Bagged Central System Vacuum ?

Nutone 350 won't turn on at any plug-in opening. there is electricity at box where connected

Answers :

You may have a bag hose. Try plugging your hose in sideways. This will bypass the switch on the hose. Does the switch on the unit work?
Repair Help & Product Troubleshooting for Broan-NuTone CV350 Performance Bagged Central System Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Nutone 350 won't turn on at any plug-in opening. there is electricity at box where connected

You may have a bag hose. Try plugging your hose in sideways. This will bypass the switch on the hose. Does the switch on the unit work? ... Broan-NuTone CV350 Performance Bagged Central System Vacuum

The Vaccum is not turning on when i plug the hose into the wall. The hoover system will turn on when i turn the switch on at the base and wont go off till i turn the switch off. But it will not come on automatically when i put the hose in to the wall connections. Many Thanks Linda

You can test this out by taking a small metal spoon and with the bottom side of the spoon insert it into the vac outlet on the wall. you want to touch the two metal pins inside the vac outlet to test if the unit is the problem or the hose is the prob ... Beam Industries Vacuums

Nutone Broan CV556 runs continuously and will not shut off until I unplug it.. I disconnected the low voltage wires and it still runs when I plug it in. Inside the top of the vacuum are 3 electrical devices - one looks like a transformer wire -- one is a rectangular electronic black box. The third is an on off rocker switch. Which piece it likely to be shorted out? It is about 8 years old.

... Broan-NuTone CV556 Cyclonic Bagless Central System Vacuum

Kenmore canister model 116.25513506 wont turn on. when handle switch is turned to floor. vac motor does not turn on. When switch is turned to carpet, floor nozzle works but vac motor does not. I checked fuse, all o.k. checked continuity for plug, o.k. removed wires for bag full switch...motor wont run. I wired motor directly power cord...motor runs. Thinking it must be the circuit board, how do I bypass it or test it?

... Vacuums

Hooked everything up per directions. I plugged it in to the closest electrical outlet and nothing happened. The lights did not light up, the connected wall control and sensors leds do not light up. It appears the unit doesn't have power. The electrical outlet socket is fine as everything else I plug into it works fine. I have tried every other electrical outlet available. The unit won't power on from any outlet, and all of those outlets run other things, like power tools an refrigerators

Dear Davehibshman,Firstly; dismantle the plug and replace the fuse with the same rating as the one you have just taken out. Replace the plug cover, put the plug into the socket and try again. If this doesnt work, there may be a problem wi ... Vacuums

I had plugged it in to use it, turned it on and instantly it made a pop sound, smelled of electrical, and would not turn on after. i even waited for a while let the smell go away and tried a different plug in the house and still no operation of any kind. Is there an internal fuse that i could check on this? where is it located?

Sorry there is no fuse in the vacuum. It sounds like there is a short somewhere when they manufactured it. There is no way to fix yourself you will need to take to a repair shop\015\012\015\012Good luck ... Vacuums

Hello, I've had my purple Dyson for several years. Now however the area to turn on and off won't work. I plug it in to run it then unplug it to turn it off. However I see electricity at the plug and that is scary. Help

The switch must have failed and melted. take the switch cover off and inspect the switch. You will probably need to replace it. I have a video of how to do this. let me know if you need it and ill send you the link to my adrive.com account so you can ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My bissell proheat carpet cleaner wont turn on. Its plugged in and everything but wont turn on. I've had it for a few years but its always worked before. Do they have to heat up if I haven't used it in a while?

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

I have to rewire the plug on a Pfaff Dorina 75 sewwing machine (foot pedal & electrical input. I cannot get it right - anyone can tell me what to connect to which of the three connections in the plug ?

The colour of the wires differ depending on where you are. If you're in the USA and using 120V system the wiring isBlack (the hot wire) goes to the brass connector, The White goes to the Silver connector and the green goes to the Earth connec ... Vacuums

My kirby is shorting out when i plug it in and turn it on it wont turn on and then after a little bit it will turnon but twhen you move it it will turn back off.. and there were sparks from the cord.... i was wondering if i still have a warrant to get another one ive never had a problem with my kirby i love it but am dissapointed that i cant use it

... Kirby G5 Bagged Upright Vacuum

The power wand electrical connection on the power unit itself seems to be corroded. I think I need a new two wire plug to plug into the wand. the model is a Eureka 6984 A. I am able to disassemble the power unit if necessary and replace the wire and plug if one is available

Try hesco inc they have a on line store with all the vacs parts diagrams and fast shipping. ... Eureka Vacuums

I have a Eureka Boss Power Plus and the beater bar is rolling, the belt is turning, but after vacuuming up around the litter box (not a lot of litter), when I turn the vacuum off, the litter, or even household dirt, falls out. When I hold the vacuum back to turn it off so that it doesn't fall on the floor, it's sitting in the cubby where the wheels are. The bag is empty, the hose is not plugged, the hose is securely fitted on both ends of the unit. This vacuum was purchased in July and is being

Even though the brush is spinning, you probably need to replace the belt because it is s ... Eureka Vacuums

Wont turn on when pluged in and the plugs that

Tighten the center screw in the back that holds the top handle assy on. this always comes loose and causes the vacuum to not recieve power. let me know if this doesnt fix the problem ... Bissell 5770 Healthy Home Bagless Upright Cyclonic Vacuum

I was trying to repair my wife's kitchenaid mixer and took part of it apart, including the back part, where the electrical connections are. The original problem was the plastic gear was damaged -- I finally had the good sense to find the solution for that problem on the internet and replaced the damaged part. But now the mixer just won't turn on. I don't think I damaged anything in the electrical section, but I suspect I either blew a fuse or somehow disconnected something.

Do you have a model number? Is the voltage getting to the motor from the switch? ... Vacuums

MY Devant 2GB MP4 player wont turn on, but when i plug it to a computer it turns on and charges then after an hour i tried pressing the on button, it does not work

... Vacuums

Reinstalling a hampton bay ceiling fan model-HL52QV P 3LC14 and I do not recall how to wire it to the house electric. A black wire and a blue wire are tied together and a white wire are present fromthe fan. Whichone is connected tothe hot wire in my fan electric box inthe ceiling.

The black and blue wire should conncect to the black wire in the electric box and the white wire should connect to the white wire in the box. This assumes the wiring was correctly installed.Jim ... Vacuums

My i-P23 quicksilver alarm clock speaker, won't turn on. I press the button and it wont play music. I even tried a new outlet plug, and it still won't turn on.

... Vacuums

My electrolux canister oygen vacuum cleaner will not turn on when plugged in. it quit working when I disconnected the hose while running? It does not have power when plugged in to the electrical outlet

This is often caused by a failure of a fuse on the Sumo board, or\015\012occasionally by a failure of the cord reel. Here are some instructions on how to check these things as a\015\012response to a different thread, but I will repost them here: ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Plugged in the charger to my model AV-701B electric broom after not using for a few months. Charging lamp went green as soon as I plugged it in. Unplugged the unit but it will not turn on.

The same happened to me. The battery will no longer take a charge. Oreck store was of no help. Do NOT buy the new model it is poorly designed. you can find other brands in the same category at half the price and much better brands for about the same ... Oreck ElectrikBroom AV-701B Handheld Vacuum

Hover windtunnel It will start when you plug it in and wont turn off with the switch you have to plug it in and unplug it to get it to work.

I had the same problem with the Hover windtunnel. All I had to do was remove the two screws holding on the handle and then pull the handle off pulling horizontal to the ground. Then I manually turned to swith off. Check it to make sure the switch ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

The Shark steam cleaner wont turn on when plugged in. Is there somewhere on the machine where maybe a fuse was blown or shorted out and needs to have a switch turned back on?

... Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum

Oreck Upright Hi Redev, I'm not sure what model I have (about 6 years old...upright, looks like the one in the picture). I changed the belt (which was torn) and then the next time I used it, it cut off on me. Now if won't turn on at all. (I turn the switch on and off and nothing happens as if it is not plugged in but it is!). I noticed at the top where the power cord enters the handle, it is all frayed. Could the electrical wires have detached? Anything you think I should check before taking it

The cord could be bad and will ahve to be replaced. It would have to have a problem inside the handle or down by the motor. ... Oreck XL2600 Vacuum

I have a 3 year old NuTone CV 353W central vac system and recently the switch on the hose handle does not turn the system on from any outlet in the house. I have to plug the hose into the outlet and then turn the unit on from the switch on the cannister. Any help would be greatly appreciated. Thanks

A great way to check if your switch in the hose is bad would be to turn the hose sideways in the inlet. If the unit turns on you most likely need a new switch. ... Broan-NuTone CV450 Central Bagged Central System Vacuum

I have a kennmore 2005 electric range model 790.9661* the stove top is ok but no power to the over no erro message just completely blank I tunr off the oven from the electrical box to try to reset it but now it is still black and wont stop beeping!! any ideas??

... Kenmore Kennmore/Pannasonic Canister Vacuum Cleaner Cord Reel Rewind Assembly For MC-V9658 AC99NBEEZV07

The microwave will not turn on. No power. Checked fuse box and power outlet...not the problem. Unit just wont turn on? Is there a reset button or another option.?

Remove the cover and locate the internal fuse you will find near the power cord entry. Replace with the same. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1096 seconds