Having problems with your Broan-NuTone VX475 Bagged Central System Vacuum ?

The suction has dramatically decreased

\015 How do you locate and remove a possible obstruction in the pipe?\015

Answers :

IF you have a nutone VX series tank contact NuTone. your tank may be bad they will more than likely replace the whole tank under warrenty.
Use an electricians fish tape or plumbers snake
Repair Help & Product Troubleshooting for Broan-NuTone VX475 Bagged Central System Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The suction has dramatically decreased


IF you have a nutone VX series tank contact NuTone. your tank may be bad they will more than likely replace the whole tank under warrenty. ... Broan-NuTone VX475 Bagged Central System Vacuum

Dyson Clogged? I have a DC07 and i've noticed that the suction as decreased dramatically. Any suggestions on whats the problem? ty


Check the filter and look into doing this:\015\012\015\012http://www.fixya.com/support/t2936439-dyson_suffers_from_lack_suction ... Electrolux Guardian Bagged Canister Vacuum

Decreased suction was using to vaccuum carpet and suction decreased..nothing plugging hose....suction remain at unit canister and exhaust is fine....suggestions??


You might have a clog, to try and unclog the lines, you need to unplug the unit, and remove the bag compartment. Then take a shop vac using the hose attachment hold it into the attachment door where there is low suction and try to draw the clog out t ... Broan-NuTone CV353 Central Vacuum

EF 1750 has lost suction power. There is a noticable decrease in suction power even at the power unit inlet.


Disconnect the actual pipe where it meets the vac. Then test the intake for suction. If you have poor suction still, check the intake itself from inside the vac body for blockage, then check the gasket on the pail for mis-alignement.If yo ... Easy Flo EF1750 Central System Vacuum

My vacuum makes a wierd sucking and blocking sound when turned on and when you put the extension tube on the suction decreases...but when just the wand handloe is on the suction is excellent...we replaced the barrel thinking it was broken but that hasnt fixed the problem


You did not list the make and model of your unit, so it is difficult to hunt for problems.\015\012\015\012Check to see if any of the tube vents might be open. They should be closed when in use.\015\012Also check to see there are no holes in th ... Vacuums

The model is Miele S538, but I did not see it on the list. The suction power button( ) increasing the power does not work. The suction power button (-) decreasing the power does work.


... Miele Leo S5381 Canister HEPA Vacuum Cleaner Bagged Vacuum

I have bought a shark cordless vacuum sv779z 14 from walmart, at first it worked well, but lately the suction is ok when i switch it on, and them immediately decrease until there is almost no suction. I don't know if its the battery or what i need to replace. When i call the customer care number listed on the instruction manual, they say that they don't have the model number on file and that i should call back in 7 days, which i have done several times, what should i do?


... Vacuums

Decreased suction and high pitch whine in motor


Clean out suction tubes ther is something caught in them ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Decreased hose suction with Windtunnel


There are very few things left to check. First verify that the filter is installed properly, in the dirt cup. second check to make sure the dirt cup lid is on and secure. Did you use water on the round dirt cup filter? if you have you will need to re ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

The suction has decreased by about 50%. The brush


Check that there is nothing blocking the hose and that there are no obstructions around any of the filters, clean and replace filters too if possible. If you still find you have less than optimum suction , you may need to replace your motor. But it s ... Hoover Windtunnel Supreme U5280-900 Upright Vacuum

Decrease in suction


Check to make sure the round gasket seal, under the hood, is in place. It is a rubber seal that sits on the plastic pipe, under the corner of the recovery tank, when the tank is placed in to the foot. It seals the vacuum from the motor, to the tank ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Decreased suction at hose end


Yes, the "door" on the angle hose might not closing properly\015\012when the vacuum is in the upright position (if you look at the vacuum\015\012from the back, this hose connects the back to the bottom of the vacuum\015\012and it has a "door" at the ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Decreased wand suction


The blockage could be in the wand itself or in the entry duct of the machine. Take the wand off, look through it and if you can't see light coming through the other end, there is something stuck in the wand - take it out with a long object like a met ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

Motor is turning but making a whining noise and suction has decreased


... Rainbow E series Canister Wet/Dry Vacuum

Bad smell after using my windtunnel for a couple of minutes i noticed an odd smell. i turned it over and checked, the belts are fine but i cleaned out the hair anyway. after doing that the self propel seems to struggle and it is hard to push. when i look through the window on the top i can see the brush spinning freely but then when i push it, it slows down dramatically and then picks up again. the suction is fine. what do you recommend?


It may be the roller bearings? ... Hoover U5450-900 Windtunnel Supreme Bagged Upright Vacuum

My 8 yr old kenmore vacuum works well - however the hose has worn under the handle where there is a hole (resulting in decreased suction power). I'd like instructions on opening the handle and bypassing the worn piece of tubing rather than replacing it for $129. Some of the handle screws remove easily but the last one doesn't loosen easily.


Hi,Have you tried spraying the stubborn screw with WD40 and let it soaked for a while? Other than these screws holding the handle together, there would no other way of opening it up. Hope this be of initial help/idea. ... Kenmore Vacuums

Low suction on Nilfisk King


... Nilfisk Family Vac Bagged Canister Vacuum

Nilfisk A300 Suction problem


Mate - don't know if this will help - I had the same symptoms - saw your question through google - no answers, then I moved the red slider button on the top of the vacuum and hey presto! It has adjustable power. Man I felt like an idiot! ... Vacuums

Little suction on Bosch formula hygenix hoover


... Vacuums

Performance indicator light is on and suction is not strong


You do have a clog! trust me. Check the wand and the yoke which is on the brush assembly. its the part that connects with the wand.if thats not it then it has to be in the hose. the only way to get it out of the hose is to take one or both ends ... Kenmore 25614 / 25615 Progressive Bagged Canister Vacuum

Dyson 18 losing suction


Check the HEPA filter if it has one. This bit of foam gets clogged over time and significantly reduces the suction especially if you've been vacuuming a lot of very dusty areas i.e. dust from building work etc. Just wash the filter with lots of water ... Dyson Slim DC18 All Floors HEPA Bagless Upright Vacuum - Iron/Titanium/Yellow

No suction Just received my refurb. dyson animal bagless. Finally figured out how to get it all together, turned it on and there is no suction coming up thru the beater bar. The hair is just collecting around the bar and not going up into the canister. It appears all the suction is going thru the open red end of the attachment hose, which has a vented cover piece. Am I missing a piece or is there a switch to turn of the attachment suction?


So the red hose isn't connected to a part on the vaccum so like it is connected to the connester but not to an opening just above the beater bar, this is the only idea i can supply you with. good luck, maybe i got lucky and helped you out. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

No suction I am getting no suction on my central vac at the vac. I do not believe that the piping is plugged up, the vacuum is not creating suction. What are the causes of no suction at the vacuum and how do I take the top half of the Nutone central vac off?


Use the guide at builtinvacuum.com/flowchrt.html to find the issue and solution. Most likely you need to test it without any filter and be sure the bottom of the unit is attached :) To get access to the motors you need to unbolt the very top sides. ... Broan-NuTone CV350 Performance Bagged Central System Vacuum

Hi my dyson dc18 has great suction from wand but when you got to use the vac for floors little suction but wand still got suction even while vacuming floors is it suposed to stop suction from wand


My Dyson dc18 had the same symptoms. The wand worked well and the floor bar had no suction. After removing pieces & shoving my fingers into the machine (no blockage) I found the suction pipe rotates between two positions (floor and wand). It look ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

Suction Cover The suction cover of my Eureka Deep Steam 2575A is broken - the tabs snapped off of the cover so I am unable to screw the suction cover back on. I need to purchase a new suction cover but can't find one anywhere. Anyone know what I can do? thanks


The exact same thing happened to me. i just called and ordered it from eureka. the number is 1-800-282-2886. the cover cost 13.07 and the s ... Eureka 2576A Steam Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0272 seconds