Having problems with your Craftsman 17026 Wet/Dry Vacuum ?

Seems to **** up the dirt/dust and simply blow it out instead of capturing it inside

Answers :

Most of these have an suction hose and a blow port. One blows air, one sucks air. Make sure the suction hose is on the correct port. Also, a dirty air filter will cause the same effects. The filter must be good to prevent the dirt and dust being blow around.
Repair Help & Product Troubleshooting for Craftsman 17026 Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Seems to **** up the dirt/dust and simply blow it out instead of capturing it inside

Most of these have an suction hose and a blow port. One blows air, one sucks air. Make sure the suction hose is on the correct port. Also, a dirty air filter will cause the same effects. The filter must be good to prevent the dirt and dust being blow ... Craftsman 17026 Wet/Dry Vacuum

Modeol116.30012000, changed hepa filter, bag. vacuum seems to be blowing air instead of sucking dirt up. The bag collapses when turned on instead of blowing up with air. any ideas as to what is wrong? Thank you

... Kenmore Vacuums

Not sucking i have a KIRBY G3 that was working great. One day there was a strong smell and the brush roller belt broke so I replaced it. The fan looks good. Now the vacuum does not **** up dirt but instead seems to very gently blow air forward. I took the (new) bag off and it is blowing hard int the bag. I am stumped!

Belt is not connect to the drive pulley, see manual for fitting or see utube for video ... Kirby Generation 3 Bagged Upright Vacuum

Blowing out? I have checked all hoses for clogs, I have even taken it all apart, but it seems to be blowing out? The bag inside the canister is sucked in? Can the motor reverse on itself, I'm baffled!!

Did you check the inlet down by the brush roll? ... Bissell 3522 PowerForce Bagged Upright Vacuum

It seems to blow air out instead of sucking up

Remove the bag on top and the plate on the bottom. Clean out the air passages, top and bottom, looking for a clog. When it seems clear, turn on the vacuum to see if air is moving through. Don't allow a full bag to remain in place Check the brush on t ... Hoover Tempo Widepath Upright Vacuum - Blue

The vacuum does not **** in dirt. It is blowing air instead. Yet when I disconnect the vacuum from the cannister, the suction seems very strong. I took it to a vacuum repairman, and he said that Kenmore sucks and I might as well get rid of it. (He wanted to sell me another one) It is 10 years old, but if I can fix it I would like to try.

... Kenmore 22613 Bagged Canister Vacuum

No suction the unit seems to be blowing air instead

Hi,Here is a tip that I wrote about my Bissel but I bet you have the same problem and the hose is clogged...Bissell Bagless Upright Vacuum not work ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

My Oreck XL upright is blowing out instead of sucking in. I changed the bag and cleaned the brushes; I also cleaned out the main "pipe." I looked for a place to change settings and couldn't find any, so I know I didn't inadvertently switch something. The brushes seem to be spinning at the correct speed. Thank you, Julia Byrem

... Oreck XL2200 Bagged Upright Vacuum

I cannot keep the bag attached to the handle inside the cover on my Oreck XL Vaccuum. When it comes off dust blows out into the cover instead of the bag which makes it very hard to unzip the cover.

There should be a spring ring that slides up over the bag on the handle if thats missing try and use a couple of heavy duty rubber bands. however i do suggest you order the correct part. ... Oreck XL Ultra Bagged Upright Vacuum

My Bissell bagless vacuum does not seem to work anymore. It will start to with a suction and then instead of picking up the dirt, it appears to blow the dirt out almost in a cloud of dust and debris from the front.

This is caused by a dirty air filter and/or a blocked vacume hose ( most of the time the blockage is at the bend where the hose enters the floor sweeper area ) ---\015\012remove and tap out and brush the filter ( or use a air compressor to blow ... Bissell 6595 Lift Off Bagless Upright Vacuum

Brushes at bottom of vacuum are not sucking up anything. It seems like its blowing out instead of sucking on the bottom.

Blockage somewear ... Dirt Devil Vacuums

Hello, we have a Miele cat and dog turbo 5000 vacuum cleaner which we bought in December. It has just started blowing air out of the grid on the top of the cleaner instead of sucking from the tube. The whole top section which is opened to change the bags doesn't seem to want to clip down properly either. Do you have any ideas> I'm gutted as it was so good until this happened. Thanks Michelle.

The lid not closing properly is almost certainly the cause of your problem. Without that lid sealed tight to the body you will get no suction through the hose. So, the question is: why isn't the lid clipping down properly? Did you just change the bag ... Vacuums

Vorwerk VK121 vacuum cleaner - smell of burning from housing enclosing motor. How do I get into the housing to inspect the motor? After tilting the bag sideways, there are two screws holding the housing visible, but there seems to be a thrid fixing inside the point where the handle shaft is attached - is the handle simply clipped in place? Thanks

Yes the handle is clipped in place and should come out when the button in front is pushed. Remove the screws you wrote about. After that the puzzle begins. At the bottom of the vacuum where the head is attached, remove the head by pressing the but ... Vacuums

Vacuum seems to blow out air...not good suction ..how to fix?

... Eureka Boss SuperLite Bagless Upright Vacuum, 405AVacuum

I have my Emerson FR966T wine coller set for 60 degrees, but my cooler never seems to get the high. It always hovers around 58-59. When I heat my house up (never above 68) my cooler seems to warm up to 60 (inside). Whats up? Why does the outside temp. affect the inside. The manual says it works best when the ambient temp. is 77 or lower.

... Vacuums

Oreck 9100 Xl blowing out dirt instead of sucking in. Took apart,cleaned & checked belt

... Oreck XL Ultra Bagged Upright Vacuum

I cleaned out my brush in the bottom front, cleaned out the small tubing going into the canister, and the canister itself. I also changed the filter.I snapped everything back into place, but Since then, it doesn't seem to have any suction and there seems to be a space between the canister and the bottom of the vacumm where the canister sits. At that area, you can feel air coming out when trying to vacumm and it just doesn't pick up, it seems to be just blowing stuff around.

You need to really look at it some thing is out of line you shooed not have\015\012any spaces in the top or bottom\015\012pull the canister back out and look at the pins that you lined up with the\015\012to ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Dysin vacuum blows air instead of sucking it!

If it is blowing air, then it is still clogged up somewhere, you didn't give your model number, but some of these have removable covers on each side and on the back. Also make sure that all covers are back on securely. ... Vacuums

I have a Dyson DC22 that seems to have lost a lot of suction. I can't peer right inside the wand, but it seems that hose may have disconnected from the telescoping handle allowing a huge leak. How can I take the handle apart to inspect/fix this?

... Dyson DC22 Motorhead Canister Vacuum Bagless Cyclonic Vacuum

I have a Eureka The Boss Power sweeper but can't find my Owners Manual. It seems to have lost some vacuum power. It doesn't pick up cleanly, leaves a streek of residue behind and seems to be blowing air out of the right side. How can I correct that? Thank you for you anticipated reply and assistance. D.J.POtts

... Eureka 1934 Bagged Upright Vacuum

How do I clean the inside of the cyclone in my DC28 Dyson? It has alot of built up dust on the inside, it seems like there should be a way of getting it out...? Thanks, Veronica

... Dyson DC28 Animal Bagless Upright Vacuum

I have a Tetratec IN600 Plus aquarium filter which does not seem to be pumping air bubbles through the water. I have checked inside and everything looks as if it should work. The pump system seems to be working as the filter is vibrating when on, but no bubbles! Please help!

... Tetra Vacuums

Am attempting to get 'inside' the vacuum to troubleshoot why it suddenly stopped running. Suspect it may electrical, and have already checked the obvious (visible cord and plug.) However, there doesn't seem to be an obvious way to get inside the canister without destroying something. Thanks!

Hi There,\015\012\015\012Here's a link to a repair solution that I've done explaining how to diagnosis the cord reel, and open up the machine. The model this is done on is not the same exact model as yours, but the repair will be almost ... Miele S251 Flamenco II Bagged Canister Vacuum

The brush on my hoover windtunnel will not turn.. I checked the v belt and it seems like its intact .. is it suppose to be inside the groove or just on the grove..it seems loose laying on the grove

Thats why the brushes wont turn,, the belt is slipping put a new belt on then try again,,, ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

How do I get my vacuum cleaner to blow air instead of **** air? I want to use it to blow up an air bed - Nilfisk King 240

... Nilfisk Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.2780 seconds