Having problems with your Dewalt 499697-24 Battery and Motor ?

499697-24 BATTERY & MOTOR

\015 How to test if battery pack is bad\015

Answers :

Repair Help & Product Troubleshooting for Dewalt 499697-24 Battery and Motor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dyson DC-31 stopped working all of a sudden. Changing battery didntvresolve the problem - even the diode doesnt light. Any tries to combine the motor of 31 with the body from 35 were not success. Please, tell me if there are any hidden ways to check or diagnose the motor?

... Vacuums

WST 1600A I purchased this vaccum about four months ago from Heartland America. Up to this point it's worked fine. After cleaning it this time when I went to start vaccuming again it runa for about 10 seconds and cuts off. I've changed the battery, taken everything that can be removed out checked it and replaced it. THe motor sounds like it's straining. I have not taken the housing off the motor to see what's going on with that. I misplaced my manual.

It sounds like there is a clog. If there is no air flow it could be overheating. ... Westinghouse WST1600 Upright Vacuum

My son and I are trying to build a small motor for a school project. we have a 6volt battery 2 wires that we are hooking up to a spool of wire. We have two aposing magnets on each side of the spool of wire. the spool of wire is on a shaft and should turn when we touch it with the 2 wires from the battery. It just does not work. What are we missing here? Thankyou

Hello\015\012Please refer to the PDF document on how to build a small hobby DC motor.\015\012Go to the link below. Thanks\015\012 ... Vacuums

Electrolux 2 in 1 Ergorapido stick Vacuum. Motor runs then cuts out after 3 - 4 seconds. Sometimes it will run properly for 10 minutes so batteries are good. Why does it cut our usually?

If the hand held is working correctly (By itself) try pulling up a little bit on the 4 metal connection tabs on the wand. The connection tabs were not making a proper connection on my unit. ... Electrolux Pronto 2-In-1 Stick/Hand Vacuum - Cayenne

My dyson dc31 sucks intermittently and it sounds as though the motor is straining to provide suction. I have checked the filter and the battery is also holding its charge

Hi Ed,I'm sorry to hear you're having difficulty with your DC31. From what you've described, it sounds as if you may have a blockage in the inlet. To remove this, please follow the steps in our online Support guide: ... Dyson DC31 Animal Bagless Handheld Cyclonic Vacuum

499697-24 BATTERY & MOTOR

... Dewalt 499697-24 Battery and Motor

How do I know if my Shark Sweeper V1700Z needs battery replacement or if the motor is burned out?

... Shark 10" Cordless All-Surface Power Sweeper, V1700Z

Battery is charged motor won't start

Hi there,I am sorry to hear you are having difficulty with your DC35. Based on the details you provided we would appreciate the opportunity to trouble shoot with you and we may be able to resolve this issue over the phone. At your ear ... Dyson DC35 Handheld Vacuum

My DC500 works fine running on battery power, but the motor hesitates for a moment or two when the unit is switched on with ac power. After this it works fine. What might be wrong?

May be the carbon brushes are short or motor connectors have become bad connection by moisture and dirt by use temporay a wrong filter sometimes its a very light and simple motor johnson motor with hammer brushes \012 ... Dewalt Vacuums

My Dyson Root 6 made a loud banging sound, and now its motor emits a strong burning smell every time it's switched on. It runs for a second or two, making a lot of noise, and then stops. (Just bought a new battery for it, too - what a drag...) It's off warranty, and Dyson wants almost as much to fix it as a new one would cost. Is my Root 6 e-waste, or is there anything that can be done for it?

... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum


... Hoover 5416-900 WindTunnel Bagged Upright Vacuum

Suction, after cleaning every part/filter, is virtually non-existant, other than the motor (which works very well) when reassembled various times, I get a big 0 for performance. PO'd in Tx. DC-07 seemes to be a waste of my $$$$.

Hi,Did you dry the filter for 12 hours before reinstalling and giving a go? Most suction problems are from a blockage of some kind. The Dyson website seems to think it's the filter.Here is a website which has instructions on washin ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I got this sewing machine , can anyone tell me what this control box is used for ?. It is mounted under the table in front of the motor,It says Control Box on the front and two push button number settings with can be adjusted up or down from ( 0 to 9 ) ,Next to these settings are two toggle switches. One is marked start with on and off and the other switch is marked end with on and off. Above these switches it it says Back Track . The tag on the box says ( Type LE -BB -24 - 110 - 220, 2

Still struggling with your model number. I understand from the added comment this is a Brother sewing machine. I was hoping to find a manual that would be of assistance. Here is a couple of websites that lists available manuals for Brother sewing ... Vacuums

No user manual/guidelines found in carton. Need some explanation of how best to use the canister, and clarification of the battery compartment 0 to 48 hours sliding switch functionality. Thank you.

You were supposed to be issued with all the pertinent manuals for the machine. Go back to the dealer and demand your manuals. ... Vacuums

Manual A friend of mine just cleaned out her garage and gave me a Westinghouse WST1600 vacuum that was rarely used. I purchased new #25 fuses and have had the battery pack plugged in for over 10 hours and when I put in into the vacuum and press the on button a green light flashes, but the motor does not start. Can I get this vacuum to work?

Here is a copy of the manual for your vacuumwww.thinkvacuums.com/pdf/uprights/Westinghouse-WST1600A.pdfWhat could be the problem is the battery could be shot after not being used for so many years that the life of the battery ... Westinghouse WST1600 Upright Vacuum

I have a Fast Track motorized tie rack missing battery cover. where can i get one?

... Vacuums

Our wet/dry vac is losing power, could it be the battery (not taking charge) or the motor??

It is cordless / rechargeable ?\015\012\015\012The batteries are good for around a year or so..\015\012\015\012Please dont forget to rate well ;o) ... Vacuums

Hoover linx motor makes a lot of noise when running

... Hoover Platinum LiNX Cordless Stick Vacuum

Is there a cheap battery replacement Black and Decker PHV1800

Hi pwolft... \012Amazon offers pretty large number of black decker replacement batteries, click here Finally charging for our multi device world and pick one (which fits). \ ... Black & Decker PHV1800 Bagless Handheld Cyclonic Vacuum

Motor stops running after a few minutes

One thing you could have a bad motor control, part #05408630, mounted by the motor, the other could be a bad variable speed control, part #05412914, it is on top near the back. ... Miele s558 Silver Moon Vacuum

Model 533 sounds like motor is running but wheels don't spin

... iRobot 530 Roomba Vacuuming Robot, White Vacuum

Battery charge I just purchased a new battery pack insert for my Roomba, Replacement was a breeze and it now works great. My question is; The last battery I bought ( not from you) was a full cased roomba battery pack that didn't last a year. Roomba says leave the r Roomba charging all the time so it's ready when you need it, and that's nice but I feel that leaving it charging like that it will kill the battery faster as it is always warm to the touch. These battery's should last at least 5

Dave you are correct. You should never over-charge anything like a Roomba, Cel Phone, etc. That will kill a bettery very quickly. ... Roomba Robotic Floor Bagless Vacuum

Battery replacement I would like to replace the battery on my handheld Black and Decker 9 volt battery Dust Buster. But where is the battery? How do I remove the old battery so I can replace with a new battery?

... Black & Decker CHV9600 Handheld Vacuum

I purchased a brand new P113 Ryobi charger about 2 years ago. It has never worked. If I put a P104 battery in for a charge, it looks like it works correctly. I push the battery tester on the battery itself, and it says full charge, but when I go to use the bateery, it dies right away. I have tried three new P104 batteries. The batteries charge on my charger at work with no problem. The funny thing is, I don't need a battery in the charger and the charger does the same thing, It runs the test

If you have your receipt, check with Ryobi to see if it is still under warranty. It comes with either a 2 or 3 year warranty, depending on when it was purchased. If it is still covered, get it replaced/repaired. If it is not, buy the P117 charger. $3 ... Ryobi P113 18 Volt One Charger 140501001

Motor wiring My Vax VS19TL motor died and I have managed to get hold of a new Vax 006 Turboforce motor which is the same size . My problem is that the original motor had two wires (black and white) which ran to the PCB switch. The new motor has three wires (black, white and yellow). I have ordered the PCB wiring loom for the 006 motor but I can't find any documentation that tells me where each wire goes. Can anyone help?

... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0321 seconds