Having problems with your dirt devil dynamite ll cyclonic quick path ?

overheated

was vacumning and it shut off and wont turn back on

Answers :

Repair Help & Product Troubleshooting for dirt devil dynamite ll cyclonic quick path

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

New morphy richards vacuum overheating. cleaned filters, replaced belt but still overheating


... Vacuums

Vacuum overheating vacuum runs for a while, then turns itself off because overheated


... Oreck Vacuums

Overheating Hoover My Hoover cyclonic 1800w keeps overheating and turning itself off, not sure if it's the filter, I've cleaned it but it didn't look very dirty.


Most likely caused by a lack of airflow. Check to see if you have airflow at the end of the hose. If not, Remove all of the hoses and ensure that they are not clogged. If there is airflow through the hose; check the air inlet immediately aft of the b ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

Keeps overheating My vacuum keeps overheating and shutting off.


... Oreck Super-Deluxe BB870AD Bagged Canister Vacuum

Overheating Our Bissel bagless upright is about 1-1/2 yrs. old and is overheating.


Check filters and for blockage - poor air flow then will overheat ... Bissell 6594 PowerForce Bagless Upright Vacuum

Vacume Overheating My vacum is overheating and then shuts down for awhile but doesn't start again untill the vacum has cooled down.. Are there any heat-relays or something like that that could cause the problem ?


There will be a filter between the cylinder/bag and the engine. If your vacuum has a HEPA filter there will be one on the other side of the engine. Remove both of these and clean them out with water, allow to dry and replace. ... AEG Vacuums

Miele red velvet overheating


... Miele S558 Red Velvet Bagged Canister Vacuum

My filter queen majestic was overheating,.. needs new motor insulation.


... Vacuums

Shop Vac Quiet Plus Series Wet Dry Vac stopped and will not turn on. No smoke, smell, doesn't appear to have overheated


... Vacuums

Belt tensioner overheated and doesn't keep belt tight enough


Looking at the owner manual, there is no tensioner assembly.If the motor is fixed in place and not loose, then you either have the wrong belt, or the brush roller is not properly installed, or the brush roller is worn out where the belt goes ar ... Eureka Smartvac 4870 Bagged Upright Vacuum

Bissell PowerForce Turbo: The motor spindle becomes very hot while spinning, causing the new belt to burn and break. Is this because the motor is overheating?


Something is preventing the brush roller from turning even though it seeems to be OK when not in contact with the floor. The motor shaft is spinning on one spot of the belt, causing the heating, the smell, and eventual belt failure. I have had brush ... Bissell 6594 PowerForce Bagless Upright Vacuum

Overheating Electrolux super cyclone


... Electrolux Vacuums

Tristar vacuum overheating


... Tristar Vacuums

The vacuum keeps overheating


... Dirt Devil Easy Lite Quick Vacuum

Hoover Sensory 2200W Overheating and Shut-Down


Hi,\012\012Did you ever get to the bottom of your overheating and shut-down problem? Just got the same problem :(\012\012regards, ... Hoover Vacuums

My vacuum cleaner is not sucking. It's overheated and stopped


In this case it is motor problem, you can sort out only by calling the technician. Call the customer care and check out the cost for repair, if it is very high you can go for a new one and be in peace of mind.Thank you. ... Sanyo Performax SC-U126 Vacuum

Vax 2400 perfomance pet overheating??


Take it in to get looked at! it could be a elec. short which might cause an accident(ie. fire, shocking, explode....) ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Vax 2400 performance pet overheating


Unfortunately there is no permanent solution.It is a terrible vacuum cleaner and im getting rid of mine today. I have been maintaining it for 6 months cleaning filters , swapping filters, swapping carbon brushes all to no avail.Dump it. it would'nt * ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Overheating indicator comes on straight away


You could have a bad heat relay. ... Vacuums

Vax V-064TB Astrata Overheating


... VAX Appliances 2000 Canister Vacuum

My Nilfisk vacuum cleaner overheating and stopping


Its probably clogged..\015\012Remove the hose,, straghten it out so you can look into it..\015\012Could be clogged where the hose connects inside the unit.. ... Vacuums

Need to replace Belt overheated and melted onto shaft


Here is a link to the belts you need and to a manual tou can view:Bissell 1697 Belt and Manual ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

Motor cut out - overheated


Should reset after an hour or so, clean filters and make sure dry first ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Turning off / overheating?


Reading of another poster's similar issue caused me to realize there was indeed a third filter in this bagless vacuum cleaner. It was saturated with thick dust that was difficult to remove. Cleaning it cured the problem and I will know better next ... Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum

Electrolux c151d overheated when bag was full


... Electrolux Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0159 seconds