Having problems with your Dirt Devil Featherlite Bagless Vacuum M085845Vacuum ?

Dirt Devil Feather lite bagless does not have suction from the base but the hose does

Answers :

Based on your description the problem is a blockage in the lower section of the vac
Repair Help & Product Troubleshooting for Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dirt Devil Feather lite bagless does not have suction from the base but the hose does

Based on your description the problem is a blockage in the lower section of the vac ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

My eureka optima upright bagless vaccum has VERY low suction using the floor part. the hose has excellent suction. i removed the little translucent door underneath and there were no blockages, i cleaned the brushroll thoroughly and that hasnt helped either. i know this probably isnt recommended but i turned it on to the floor setting with the brushroll off and stuck my fingers up the intake as far as i could, the suction was good further up but it just seems to stop down at the base. because i s

I will try and help here. Is the sole plate on the bottom of the vacuum complety on and there are no visible cracks along the seam where it meets the body? This is the usual cause for this. Onc you take of the plate to access the roller and brushes, ... Eureka 431A Optima Bagless Upright Vacuum

Bissell 2x has suction coming out of the "base" part(when I put my had over the rubber ring that leads from base to the handle part there's suction), but there's no suction coming out of the hose. I'm not certain if there's a clog, 'cause I can't get the hose off.

... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Blocked suction The FLOOR suction line (Hose) is clogged. I Can vaceum the floor, but it will not pick up anything because the hose to the bagless canister is blocked. I can switch from floor to hose and can vaceum furniture. it will not pick up off the floor. I have tried running a wire down/up the hose. I Can feel the blockage, but I cannot get it out. I am afraid to pull the flem hose out as I do not know how it is attached at each end.

Hi,Here is a tip that I wrote about my Bissel ... the hose should just pull out... it is just stuck in there tightly...\015\012Bissell Bagless Upright Vacuum ... Royal 088500 Featherlite Upright Vacuum

Lost suction my DCO7 lost suction in the hose I started taking it apart and cleaning it and looking for clogs (probably more than I should have) and when I put it back together it has awesome suction in the hose but no suction in the base. It just pulls the pine needles up (christmas tree) but they never appear in the "bag" compartment and when I look they are just all gathered in a clump in the bottom by the brush.

Hi.\015\012\015\012Remove the sole plate turn the 3 plastic screws to unlock & lift off.\015\012\015\012Now remove the blockages that have accumilated from the oppening of short clear hose.\015\012Check you can turn ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

No suction. I have followed the detachable parts no suction. I have followed the detachable parts and it seems to have suction through to the base but doesn't pick up anything significant. I have looked through the hose connecting the base but I can not see anything obstructing it.

Poor suction can be caused by obstructions, poor air flow or a compomise in the air flow (hole in the hose). Since you have started with that I would next look at all filters and clean them. First check for suction at the motor, then at accessory hos ... Vacuums

No suction Own a Bissell Easy vac (bagless). Only just over a month old & it lost suction from the brush roller & hose. We've cleaned all filters & checked hose for clogging. Any recommendations?

Http://www.fixya.com/support/t1845597-debris_getting_stuck_in_vacuum_hose ... Black & Decker Vacuums

I have a Dirt Devil MVP and it has no suction, I have checked all the hoses and they are NOT clogged, There is no suction at the 1st hose attachment at the base of the vacuum

... Dirt Devil SwivelGlide Bagged Upright Vacuum

No suction Just received my refurb. dyson animal bagless. Finally figured out how to get it all together, turned it on and there is no suction coming up thru the beater bar. The hair is just collecting around the bar and not going up into the canister. It appears all the suction is going thru the open red end of the attachment hose, which has a vented cover piece. Am I missing a piece or is there a switch to turn of the attachment suction?

So the red hose isn't connected to a part on the vaccum so like it is connected to the connester but not to an opening just above the beater bar, this is the only idea i can supply you with. good luck, maybe i got lucky and helped you out. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Bissell lift off pet-no suction through base (hose is fine)

I had a similar problem with mine. When you take the collector container out, if you reach your hand up, you will fill a round, plastic piece. Gently turn it and the piece pulls out. On the outside of the piece is a foam filter that may be plugged ... Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum

Won't switch from hose to base suction

Hi There, Alec from VacuumSpot here. The problem is relatively common, there is a fault in the part that is called the undercarriage. It is a bit of a tricky one to fix bu ... Dyson Slim DC18 All Floors HEPA Bagless Upright Vacuum - Iron/Titanium/Yellow

Can the suction hose fitting where it attatches to the base be reattatched, it has torn away from the snap-on fitting or do I have to replace the complete hose unit, the model is F5878-900.The existing hose is screwed into this fitting and glued.

You must replace the whole hose unit. its not very cheap either ... Hoover F5878-900 SteamVac Upright Vacuum

Hi, my Dyson slim does not have any suction in the wand/hose. The vacuum itself works, just not the hose. I have unattached the hose, by unclipping it at the base, to make sure there are no rips or

Your changeover valve arm is more then likely broken or cracked. If so you will have to change out your under carriage assy. it's a pretty big job. I would recommend having an authorized Dyson service center change this for you as pretty much the who ... Dyson Slim DC18 All Floors HEPA Bagless Upright Vacuum - Iron/Titanium/Yellow

I have a dirt devil featherlite bagless vacuum; model #088600. It has suction through the hose but not through the floor mode. I think there is a blockage in the hose area but cannot seem to take it apart enough to find it.

There are 3 screws 2 on the left side behind the hose and 1 on the right back by the wheel.that will take the cover off.if you need to get into the bottom there is a screw on the bottom plate in the area where it looks like the belt travels.is the br ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

We have lost suction power from our dc07 but only from the base the hose still has decent suction

It sounds like a clog. I have had vacuum cleaners that i had to take almost all the way apart just to get the clog totally cleaned. Vacuums do need some maintenance due to the fact the amount of dust and hair they collect can easily clog them. You ca ... Dyson DC07 Allergy Blue/Turquoise Bagless Upright Cyclonic Vacuum

When I disconnect the hose attachment from the vacuum to use it, the dust shoots up from the hole. Where is there something to make the hose have suction instead of the base of the vacuum?

Da house is stop up ... Vacuums

Suction power level drops to zero, need to constantly readjust suction power from zero to normal operating level Appears to be some type of loose connection between hose coupler and base unit

Ok, so where as both of the solutions above are good, they will not solve your problem with the hose cutting off to 0, then having to turn it back on. \015\012\015\012This problem is caused by the static electricity which causes the hose ... Miele s558 Silver Moon Vacuum

I have a windtunnel bagless 27.0 upright. there has never been good suction when the hosE and attachmnts are used. its as if the dirt is still working to clean up the dirt. is there something i can do? the hose is good.

Check this procedure like a reference guide about how to repair a Vacuum Cleaner...Vacuum cleaners typically last 8 to 12 years, depending on their quality, frequency of use, and general maintenance. By maintaining and repairing your vacu ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

My electrolux oxygen canister cuts on and off. I have to open and close the vacuum, or take the base of the hose off and then re-insert. I have to do all these things before it will start up again. I sometimes shake the hose around, then it will come back on. If I try to dust with the dust brush (like a lamp shade or shelf) and the suction pulls against the object, the vacuum goes off for awhile. Sometimes I'll have to reset the vacuum by unplugging the electric cord. I never get to finis

Maybe you should have taken it back to that shop, it appartently isn't fixed. I would have replace that board, don't believe in modifing, you usually end up with other problems, like you have. One thing to check is maybe you have a partial clog in ... Vacuums

Hi.My model 116 36933502 only works as suction hose. When I use the bottom, a loud "flapping" noise and no suction. Everything is clean. Seems like a broken diphragm or filter? Sears Kenmore Progressive Bagless Intelliclean 5 years. Thanks Kate

... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

Hoover z400 I accidentally vacuumed a fairly large object through the hose attachment. Suction is now limited and I do not know how to clear the hose (obviously at the base).

Take off thebottom plate and brush roll, then you can check the inlet from the bottom. If it is clear, then it is probably in the hose. Remove the hose and try to fish it out. ... Vacuums

Problems with Dyson DC14 Animal Bagless Vacuum very little suction coming from the hose. cleaned filter and suction has not improved. Please help. Thanks

Two possible solutions come to mind. First off, there is a clog in your hose. If you have another vacuum, try using the hose on that one to **** it out.\015\012If that doesn't work, you may need to have the clutch replaced. Check your warran ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My sebo 1.1 has a red light flashing, indicating bag needs emptied or clog. There is plenty suction with the hose attachments, and I cannot see any blockages in hoses etc. Some of the dirt seems to be collecting in the small flap in the base of the hoover. Any tips as to what could be the problem would be gratefully received

... Sebo Automatic X1 Bagged Upright Vacuum

Eureka bagless has no suction. Filters washed with each use and canister empty. Some hose suction when covered but runs right over lint and crumbs

Check to see if the hose is clogged ... Eureka 2961AVZ Bagless Upright Vacuum

Not alot of suction but when using the hose alot of suction is it a motor problem how do i fix it plz bagless up rite

It could be your belt, if it is loose it will not turn the roter at its max power which means less suction. ... Dyson DCO3 Absolute Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.5540 seconds