Having problems with your Dirt Devil Hoover Uh70085 Pet Cyclonic? Upright Vacuum ?

My Hoover Pet Cyclonic power cord is stuck. No going in or out. How do i access this area so i can repair it?


Answers :

Repair Help & Product Troubleshooting for Dirt Devil Hoover Uh70085 Pet Cyclonic? Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Hoover Pet Cyclonic power cord is stuck. No going in or out. How do i access this area so i can repair it?


... Dirt Devil Hoover Uh70085 Pet Cyclonic? Upright Vacuum

My Dyson Animal vacuum sounds like the motor is going? It has also lost suction power and I have cleaned all areas and washed the filter. Is there anything I can do to fix the problem? Where is the closest repair center? My zip code is 17972


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I have a Russell Hobbs Power Cyclonic Pets 2000W vacuum and having cleaned out all the parts I can find the suction is almost nothing. It has happened once before but cleared after emptying out all the filter areas. This time it won't. I have only had the cleaner for approximately 4 months so pretty disappointed. can you suggest anything?


I have exactly the same problem, has anyone given you advice? ... Vacuums

Hoover Vacuum My Hoover cannister model s3614 "runabout powermax" suddenly lost power to the agitator roller in the rug brush. Where the wire cord enters the power brush, the covering has rubbed off exposing the wires which are not bare but still have their own covering. For a while the power came and went as I manipulated the wires but finally died. Is this something I can fix myself or is it going to be an expensive professional repair? (Warrantee has elapsed.) Thanks.


Our Hoover upright vacuum cleaner makes a very loud noise when it is running. What causes this? ... Hoover S3614 Vacuum

When vacuuming carpet with the electric power brush it will ocassionly , go to zero suction mode and shut off the brush. I have tried to cause it to happen by playing with the joint areas ( handle to tube and tube to power brush) without sucess. When the problem does occur I just turn the suction back on and power up the brush again at the handle controls.


You gave a good start to giving us good information to help you with solving this problem-- But I need a little more information:It sounds like you have the Electric Motor driven Power nozzle/ Floo ... Miele Blue Moon Bagged Canister Vacuum

Polti Repairs I have a Polti Vaporetto Eco 3000 steam cleaner, no power to unit. Fuse and power socket all ok. Was going then just stoped.


... Polti Eco Pro 3000 Canister Steam Vacuum

My Hoover Turbo has the power and motor works well but there is no suction power. I have taken all steps to ensure that there is no blockage in the pipes. I live in the Benoni area and would like someone trustworthy to repair my machine as it is only just about 1 year and 9mnths old.


Remove the screws from the funny looking thing on the back (about 10 philips head screws) and remove the blockage from the big hose. Don;t stop working on it until you are absolutely certain there is no blockage. You may need a long screw driver an ... Hoover U5396-900 Turbo Power Vacuum

The power head of my DC 21 keeps cutting off as soon as I start moving the hose around. The only way to get it going again is to step on the main switch on the canister, then the whole cycle of off and on starts again. I have replaced the entire power head and tested the continuity of all the wires in the hose and they are good. The repair shop says the PCB is bad but can not get one. What can I do ?


Not much. my only suggestion is to dig through the internet and try and find that pcb it may take awhile but it would be worth a shot. if you dont think you can make the repair take it to repair shop with new pcb and let them do it. ... Dyson Genuine DC-21 "Stowaway" Spare HEPA Filter, Dyson

My dirt devil ultra vision cyclonic power cord broke and needs replaced. i cannot access the motor to fix it


... Vacuums

We have a Russell hobbs power cyclonic pets 2000w vacum cleaner that seems to have lost quite a bit of suction, we have cleaned the filter and made sure there are no obstructions in the hose. We have only had the item for 2 months so would like some help with the problem. Regards Mrs D.Cook


... Vacuums

Cant remove top on vax power pet 2 to get access to belt


... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

Hi, how can I fit a new power cable. I cannot gain access to the switch area. thanks


... Dyson DC04 HEPA Bagless Upright Cyclonic Vacuum

Access motor on Bissell 3920 Pet Hair Eraser?


Hey Janalynn, you should contact one of BISSELL's Authorized Service Centers for assistance. Here's a quick link to locating one of Authorized Service Centers, please click on the following link: \015\012 ... Bissell 3920 Bagless Upright Vacuum

My Fantom Thunder upright has a blockage that sounds like it is directly above the dirt bin in the "head". I cannot access it from inside the bin chamber by going up the nozzle with a claw parts retriever. (This is the older model where the cyclone nozzle doesn't come off.) The wand, hose, rear inspection port, and front brush intake are all clear. How do I get the top of the vac off above the dirt bin? I don't see any screws or slots.


... LG Vacuums

Change fab belt on vax power pet 1 - VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum


... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

Vax power pet 9 which way up does pre motor filter go ?


... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

The Vacuum canister is working but the tip did not havesuction power. Should I change it? Where can I finf the repair shp in my vicinity. My area is Ravenna, Ohio 44266. My Vacuum cleaner is about 10 years old similar to Ultralux 2000.


Try checking for blockages first, turn the foot of the vaccuum over and check the inlet tube, there may be a little flap that needs to be pulled forward for you to see if there is a blockage. ... Electrolux Vacuums

I have a Harmony vacuum that's a couple years old. I recently sucked a fair amount of dog hair into it and was unaware something was amiss since the things so quiet. It just shut down and wouldn't come back on. 10 minutes or so later it came back on but now it's got no sucking power. I figure I torched the motor. Good guess? What are my options--I'm out in the middle of no where but can get it to a repair shop 250 miles away. Is it worth trying to salvage or am I going to pay as much to get it f


I cleaned the whole thing out, changed out all the filters again and cleaned out the motor compartment. Then I discovered a huge clog in the line. Once I got that all done--it's now working like a charm. Moral of the story: spend more time looking fo ... Electrolux Vacuums

Am i going mad? I've just brought an electrolux Cyclone Ultra 2000W hoover. I've got it out of the box and have tried to fix the cover to the unit (i.e the bag free area which collects the dust). It won't fit. I've tried everything and think it must be faulty. Has anyone ever come across this before? Grrrrrr.


Take it back to the store and compare it to another one, and possibly have a store manager help you, if they can't get it, then they should give you a different one and make sure that it will work before leaving ... Vacuums

Both drive and slave belts are intact and tight on the Bissell ProHeat 2x. The brushes will not turn. When last turned on, there was a loud snap noise and something is broken in the power head drive train. Can we repair this or is there a service center near the Hastings, MI area? We need this fixed ASAP. Thank you.


Sounds likely you should take it in your drive gears might have a problem ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have the same problem with intermitant power, however, it does not make sense that the problem is in the upper powerhead (which is what a repair guy told me) because-- when I use the other attachements it is fine. The problem only occurs when I use the carpet (big)attachment so that the roller will not turn. Couldn't it just be in the area where the bottom of the handle attaches into the carpet attachment?


You can test the auxiliary plug to the roller/beater attachment with a volt meter if you know how and take precautions. Check for 115-120 volts at the beater/roller attachment plug. If voltage is there and the beater/roller doesn't run, the proble ... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

I have a power drive baggless vacuum cleaner...it runs well, but suddenly it seems to have lost most of the suction coming through the hose and floor area. When I remove the dirt container, the suction below it seems strong. I have had it to repair twice--they have tuned it up and replaced all filters and belt. It still does not pick up well when I vacuum or use the hose. Can you help ?


There is something stopping it up,you will have to dissasemble the unit to find the blockage,this is the most likely problem. ... Hoover U6660-900 WindTunnel Bagless Upright Vacuum

Russell hobbs 17975 power cyclonic pet vacuum, has a red light on ,cant find manual can tell what it is


... Vacuums

Problem with bosch bsg71360 beater bar going in and out of operation / power


... Bosch BSG71360UC Bagged Canister Vacuum

Cord rewind The power cord is jammed and won't go in or out. I can't find a way to get the cover off to have a look at it. Any suggestions please? Power cord jammed won't go in or out. Can comeone tell me how to undo the casing to get to the power cord?


Which model do you have.. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0581 seconds