Having problems with your Dirt Devil M130000 ''i'' Dual Cyclonic Upright Vacuum Cleaner Vacuum ?

M1300 i dirt devil brushes wont roll

\015 Yes I have brush button on.I have reset several times.I believe belt(or motor) that turns brush has gotten hot.We had vacuum sitting on couch,using furniture attachment,brushes where turning vacuum got very warm smelled like a burnt belt\015

Answers :

The brush roller itself has crud jammed in it. it is not the belt. the smell however - is the belt being burnt as the small metal axle tries to turn the who unit - but the belt wont move - so the small axle spins and burns into the belt. this can burn the belt and melt it and can also stress the motor which is the real pricey repair and not worth it.

pop the roller out of the bottom and hold the very end 'cap' - now spin the roller with your hand - if it doesn't spin with next to no effort - there are probably hairs and threads inside that gumming it up so it wont spin. this is NOT referring to the outside of the roller which can be the issue - untangle any pet or human hairs - carpet strings etc etc - this can solve the issues as well. but regarding the inside turning swivel on the brushroll - some models the end caps come off - some they do not. i put a razor on the sides and cut up some hairs and strings till it was spinning again by hand but it was still not enough to allow the brush to spin on all settings. eventually i was forced to buy a new roller (i have jaguar upright - old model m085830t) - hope this helps -

a few more words of advice - when you buy a vac - once a month or so flip it over and cut out long hairs - threads - and strings - your vac will last forever - if you do this - if it smokes - turn it off right away parts are burning lol
Ok I would say the belt burnt into if you can turn it on and the motor runs it is the belt . I would pull it apart and replace the belt.
Repair Help & Product Troubleshooting for Dirt Devil M130000 ''i'' Dual Cyclonic Upright Vacuum Cleaner Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

M1300 i dirt devil brushes wont roll


The brush roller itself has crud jammed in it. it is not the belt. the smell however - is the belt being burnt as the small metal axle tries to turn the who unit - but the belt wont move - so the small axle spins and burns into the belt. this can bur ... Dirt Devil M130000 ''i'' Dual Cyclonic Upright Vacuum Cleaner Vacuum

Dirt devil plat.force brush roller wont roll on carpet


... Dirt Devil M091200 Platinum Force Upright Vacuum

Disassemble dirt devil brush roll - Dirt Devil UD40285 Breeze Bagless Upright Vacuum Cleaner, 12 Amp Motor, Stretch Hose,Bright Headlight,Microfresh Filtration,13" Cleaning Path,25 Cord


... Dirt Devil UD40285 Breeze Bagless Upright Vacuum Cleaner, 12 Amp Motor, Stretch Hose,Bright Headlight,Microfresh Filtration,13" Cleaning Path,25 Cord

My Dirt Devil Model 088520 has a brush assembly that wont spin. How can I either change the bearing or free it up somehow? I have been searching for a new brush assembly part number 2860145000 but it


Try this link > http://dirtdevil.com/parts/category/brushrolls-uprights/ ... Dirt Devil Vacuums

Vacuum brush roller wont turn - Dirt Devil Featherlite Bagless Vacuum M085845Vacuum


You dont say if you checked if the belt is still whole so my guess is the belt broke(it could've fallen off and not be there at all but you definately need a belt) check that and let us know ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

BRUSHES WONT TURN ON DIRT DEVIL FEATHERLIGHT CARPET SHAMPOOER


... Dirt Devil Featherlight Bagless Upright Vacuum

My brush roll is not moving - Dirt Devil Featherlite Bagless Vacuum M085845Vacuum


Check your belt or bearings. ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

Brush roll won't turn dirt devil 85845


... Hoover Vacuums

Dirt devil vacuum cleaner--trouble vacuuming dirt and pet hair on carpeting --is the problem with the spinning brush which contacts the floor,  not contacting the carpeting??  I thought (when I bought this vacuum) that the aforementioned brush was adjustable to various heights of carpeting.  Sometimes, it seems like nothing is being vacuumed up --unless I have just put a new bag on the vacuum... Do I need or can I replace the spinning brush on the bottom of the vacuum so it kicks up and vacuums


Try replacing the belt. Rubber belts stretch out after about a year. ... Dirt Devil CE6100 Featherlite Upright Vacuum

My dirt devil easy lite cyclonic does not suck up the dirt or anything on the floor anymore the rollers still roll. It stop sucking.


Check and make sure that the pickup tube from the bottom of the sweeper to the waste cup does not have a clog anywhere you can use a metal coat hanger and straighten it out and carefully run that thru. ... Vacuums

Hoover Bagless Hello,      My Hoover bag less (Model U5280-900) is not picking up dirt like it should.  The brush roll is spinning fine, but the bristles on it are only about one quarter inch long.  I am wondering how long they should be.  The vacuum is quite a few years old.  Do you think it is time to replace the brush roll.  Could you email me at [email protected] about this topic.  The product bar below did not contain my model no.  The correct model no. is above in my message.  Thanks


If the belt is more than six months old then change it even if it is not broken. then replace your filters if that doesnt work than check the hoses for a clog drop a marble down them and make sure it comes out. ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

My Kirby Heritage II vacuum is not picking up dirt up out of the carpet like usual, and I have to keep setting it lower to pick anything up. I finally get it to such a low setting that it starts sucking the carpet up and makes a whirring noise, and starts smelling. Every time this happens, we find the belt has been burned. We are wondering if the brush roll inside with the brushes that pick up dirt are worn out and too short?


... Kirby Heritage II Vacuum

Dirt Devil Problems wont spray water - Dirt Devil Easy Steamer Deluxe - Model MCE6600


... Dirt Devil Easy Steamer Deluxe - Model MCE6600

Dirt devil total vision hose wont work - Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum


... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

My Dirt Devil ultra vision will not **** from base


Your belt is probably worn or broken. You need to replace the belt if you haven't recently. You can get the belts you need here:Dirt Devil Ultra V ... Vacuums

The brushroll on my dirt devil (vax X3) was caught o the curtain, and now the reset button will not reset the brush. the power comes on for the brush, but the brush will not rotate. What can i di to fix this problem


I didn't find the reset button until I took all the screws out and then couldn't separate it. Good luck! ... VAX Appliances Vax X3 Bagless Upright Vacuum

The brush stopped spinning on my dirt devil breeze, How can I repair it?


... Dirt Devil Breeze Bagless VacuumVacuum

My dirt devil bagged upright(swivel glide) wont turn on..light on


\015\012its clogged that is what the light shows is that if your vacuum is clogged then that light will come on and it will shut off, i have the same vacuum and mine does not come on cause its not clogged\015\01 ... Dirt Devil SwivelGlide Bagged Upright Vacuum

Dirt Devil Ultra: grinding noise, burning smell,brush not turning


This sounds like the motor went out ... Vacuums

I need a new brush bar, The end (plastic) brokeand the brush wont roll!


You can try your local vacuum shop or look online at either eBay or amazon.com. There are also websites like govacuum.com or vacpartswarehouse.com Here is a link: ... Dyson Ball DC24 Bagless Upright Vacuum

My sd40025 dirt devil ..it is not a upright. it is the follow along, bagless vacuum. has wonderful pick-up but the brush stopped spinning when i was vacumming my rug..i love this vacumm but it is only the third time i have used it. It is brand new. Why would the brush stop after maybe 20 minutes of total use?..please advise


... Dirt Devil SD40020 Bagged Canister Vacuum

My dirt devil breeze was rattling while on. I found that the one end of the brush roller had shifted off the sqaure ends. Is it bent inside? Can it be repaired or do I need a new brush roller


The ends are fastened to each end of a shaft that passes through the roller. If the brush has shifted, perhaps the nuts or other fasteners have loosened. You can try to tighten the nuts but be carefaul to avoid tightening too much, causing the roller ... Dirt Devil Breeze Bagless VacuumVacuum

I have a Dirt Devil Vision...wont **** up anything with hose...was plugged thought I cleaned everything out...any other ideas?? And when I do vacuum, it the dirt isnt going into the chamber.


... Dirt Devil Vacuums

I just purchased a Dirt Devil machine on Monday, I finally got it put together today and the brushes are not moving, dust is swirling around but no brush movement, I have changed all the nap settings, nothing, I am having company tomorrow and I threw my other vacuum cleaner away, HELP ME. Thank you.


Sounds like you may not have the belt attached or it is broke. ... Dirt Devil Vacuums

The beater brush wont spin because the brush roll is always in the off position. Moving the carpet/hard switch doesn't turn it on.


Hello : \015\012\015\012Try this please : \015\012\015\012 Switch the carpet/bare floor dial back & forth 5 times, ending on carpet. Tilt the handle back as if to vacuum upright & lay the vacuum on its side so it is resting ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0483 seconds