Having problems with your Dirt Devil Reaction Twin Cyclone Upright Vacuum ?

Canister 1 canister not working

Answers :

The filters are not clean on both sides. Check the main filter at the top and the internal filters for each side, clear and brush cleanly and gently to remove all clogged dirt as well as checking the hose and inspection airways i.e. when the bin is taken off check the holes behind it and behind the beater bar for any clogging material.
Repair Help & Product Troubleshooting for Dirt Devil Reaction Twin Cyclone Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My wand on my canister began to spark and snap and smoke. The element was melting. and now I am stuck with only a working canister. the elememt or electrical hook up is burned up...and I guess I am gonna have to BUY ANOTHER wand or connection??? I don't know what to do... but this is a HUGE dissapointment. The canister still works... but no vacume head.

How's the hose?\015\012If it's only one wand, yes, you'll need to buy a new one. It depends on where it burnt out. If it was at a connection to the hose, the other wand, or the power nozzle, you need to check the connections thoroughly for di ... Electrolux Lux 5500 Canister Vacuum

I have a panasonic mc-ul975 vacuum that works great when working properly. the airflow through the canister seems to stops once the aero blast technology is done running which causes the vacuum to not function as it should (does not have as much suction and the hose/tool accessories do not work at all). if air is continually running through the canister everything seems fine. please help!

Hi there. In Panasonic vacuums, there is a thermostat protection on the motor. It will auto ... Panasonic MC-UL975 Upright Vacuum

Powerhead does not work and the light doesn't work. Canister does work

Some of these has a reset button to push on the powerhead. Check the plug at the end of the hose handle, is it pushed in, if you push on it and it goes further in, then the tube in the handle will have to be replaced, the holding tab broke off of th ... Kenmore 23313 Whispertone Bagged Canister Vacuum

Hello, I have an electrolux tweanclean EL7055A vacuum canister, and can't switch it on anymore. The cleaning system is working well (so the power is ok) but the command which is not directly in the canister seems not working. What I can do to test if the problem is here ?

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=636174\015\012Generic problem for all Vacuums\015\012Hello, I have an Electrolux (by 2 users)\015\012Po ... Vacuums

I have an older kenmore canister powermate 3.9 and the vacuum itself works fine but the powermate isn't sucking after a toy was sucked up last week. The toy is out but the powermate doesn't work. I assuming that is what it is called. The big long part that hooks to the canister that actually cleans the carpet. I would appreciate any help.

... Kenmore 25512/ 25513 Progressive Canister Vacuum

The problem has been getting worse. It works, then cuts off. Then works and cuts off. Making sure the canister is not full. Time b/w it working is getting longer and longer. Almost seems this time when I change the outlet it is plugged into it works. But then shuts off quicker than it was doing before. I'm getting very frustrated.

We had exactly the same problem with our Animal. After the motor was replaced under warranty a different engineer came out and diagnosed it as the cyclone chamber itself being clogged.(the bit with the purple cylinders on it). This is completely unse ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Nothing inn the canister after using,suctione working,bottom roller working,no air leaks from hoses.Also when running awhile it shuts off by itself,have to wait awhile to use again

I'm not sure what vacuum you have, but that sounds like a blockage to me. Thermal shut off kicks in, shutting the motor down, to prevent damage from overheating. After waiting like 1 hour it probably comes back on. Make sure hose, filters, bag (if an ... Vacuums

Kenmore canister vacuum model 116-25512506. It has a 2 stage switch on the handle, the vacuum motor will not work, the carpet beater attachment does work, the vacuum motor will not cut on at all with either stage, 1st stage is vac only, 2nd is vac a carpet attachment. Carpet attachment will work, vac does not.

Try to find the reset button. It should be somwhere near the bottom area. It looks like a red dot that you can push inward. If you can press and hold the reset button, it will restart your suction and solve your problem. ... Vacuums

I have an electrolux oxygen canister that's 4 yrs old and it just stop working. It just doesn't turn on and no lights display. I veryfied that the outlet works. I took it at my local Eletrolux store but they don't deal with this model. They told me that this model is made in Europe and they don't support it. Where can I take it to be looked at or do you have any ideas what the problem might be. Last time I used it it was working fine. Thanks, Rodi

... Electrolux Oxygen Z5540 Pet Lover Vacuum

My kenmore progressive canister vacuum turns on only if the hose is attached to the floorwand. It seems that the canister motor is not working because I can't hear anything coming from the caniste

If the floor wand is powered, there may be an electrical connection that is broken when the wand is disconnected. This is part of the design, not necessarily a fault ... Vacuums

My electrolux ambassador power wand quit working. I replaced the switch that shuts it off when the roller stops, but it wasn't the problem. The on/off switch is fine, the motor is fine. We have traced the problem to the wires inside the canister by opening the inside cover to the bag container. We see the power cords going into the canister but we're not able to get to anything. We can't find any screws to undo that would open it up in order to follow the wires deep into the canister. We've bypa

... Electrolux Vacuums

Brush works intermittedly - I've looked at the common solutions listed but none seem to work...shaking it & reseating the canister will get it working again sometimes but obviously that doesn't seem to be a very good solution. Can you help?

I just had the same problem. I would turn on the vac, and it worked fine. When I turned on the brush it would work for a few seconds then shut off. Through troubleshooting I found out it had nothing to do with a bad power connection. By chance I took ... Bissell Healthy Home HEPA Bagless Upright Vacuum - Metallic Blue

Kenmore whispertone evpc 2045 canister not working

... Kenmore Vacuums

The LC5100 canister type vacuum used to work

... Fantom Vacums Lighting Canister Vacuum

Hi, I have a older electrolux canister vacuum that doesn't work. I have power but no succion at all. It worked fine last time I used it...what's wrong with it?

You may have a colg in your hose, try blowing it out.\015\012\015\012Bob\015\012http://evacuumstore.com/ ... Electrolux Lux 5500 Canister Vacuum

The brushed roller on my Hoover Upright Canister has quit turning. Is this a broken belt? A friend recommended a "reset" button--is there such a thing?? Everything else works fine; power, suction, headlight. That belt just doesn't work anymore since we accidentally caugght the edge of a throw rug.

Belt. There is no reset on this model. ... Hoover U5507900 Elite Rewind Bagless Upright Vacuum

Very little suction. if I lift up canister, works fine. is there supposed to be a gasket between the canister and unit?

Someone threw away the separator cone/gasket assemble. Check with you nearest AERUS store for a replacement. Should be about $20. ... Electrolux Central Vacuum

Vacuum head stopped working, unresponsive to on/off switch and light bulb is out. Canister otherwise works fine. Help!>?

Power head on/off switch could be faulty, Wires running through hose may be broken, electrical connections may be burnt.Motor in Powerhead could be dead. ... Vacuums

I have a Bissell lift-off revolution. The power won't turn on at all. Tried different outlets. It doesn't work whether the lift-off canister is out of the frame or in the frame. The manual refers to a reset switch but can't find it, even when I took the cover off the main canister unit. Where is the reset button and/or fuse?

I have the same issue too. Brush motor is working and brush is turning on but the vaccum motor is not working. If I take the canister out of the frame then it wont turn on at all. Any help? ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

Wiring the switch for a kenmore vacuum cleaner I need to know where teh different colored wires go. It had a short in it so I replaced the plug but think I wired it incorrectly. Its a Whispertone 300 model 116.28612790 The canister works but the beater bar doesn't.( it worked before a rewired the switch. Thanks

... Kenmore 23313 Whispertone Bagged Canister Vacuum

Hoover windtunnel bagless canister not turning on at all. we mistakenly dropped it after the first time it happened and it started working again. after using it the next time, it has stopped working once again. help!

... Hoover S3755 WindTunnel Bagless Canister Vacuum

The powerhead stop working followed by the entire canister not working. There are no lights and nothing funtions.

This unit is made by eureka \015\012just carrys eletrolux name \015\012the original electrolux is now called aerus ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Beater brushes don't work, what to do? They only work when the canister is in about an 85 degree up position.

This appears to be a loose connection. The below post was answered by highntools a while ago. It probably is related to you problem.\015\012\015\012I have finally fixed my sister's dyson dc 15 beater bar \015\012problem. It w ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

The power head on my kenmore 22822 Canister Vacuum won't work? the power upholstery head works fine.

I have the kenmore whisper belt and i have a reset button on mine ... Kenmore 22822 Canister Vacuum

Hi we have a central vacum system (canister). Sometimes when you plug in the hose it works fine othertimes it doesn't work?

There are two types of coupling that plug in. One has a solid metal ring. There are two metal electrical **** inside of the inlet. When you press the coupling into the inlet the metal ring completes the circuit. If the ring or the **** are badly ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.5636 seconds