Having problems with your Dirt Devil SwivelGlide Bagged Upright Vacuum ?

I need help replacing the belt on my Dirt Devile Swivel Glide.

\015 I have it apart. I know have to attach it to the roller. \015\012But where does the other end hook in\015

Answers :

Look for a silver motor shaft behind the brush roll but in line with where the belt sits.
If the shaft is blackened with burned rubber or rusty, it should be polished with wet dry sand paper, XTRA Fine. Then install the correct belt onto the shaft and brush, using the brush to stretch the belt forward so the brush can drop into it`s housing. Buy belts 2 at a time. They only break when you need them most. I hide my spare inside the housing.
Repair Help & Product Troubleshooting for Dirt Devil SwivelGlide Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I need help replacing the belt on my Dirt Devile Swivel Glide.


Look for a silver motor shaft behind the brush roll but in line with where the belt sits. If the shaft is blackened with burned rubber or rusty, it should be polished with wet dry sand paper, XTRA Fine. Then install the correct belt onto the sh ... Dirt Devil SwivelGlide Bagged Upright Vacuum

Need to replace belt on Dirt Devil Swivel Glide Upright-no manual


... Dirt Devil SwivelGlide Bagged Upright Vacuum

I have a Dirt Devil Swivel Glide Vac with a broken belt. I have purchased the correct belt(#4).The bottom is off and I cannot tell where the belt connects to. Please help. Jann


It connects to the left side with the little metal rod sticking out.then connect to the wooden roller. in the space without the brush on it. roll the wooden piece to check if everything moves. then put back together. ... Dirt Devil Vacuums

How do I repalce the belt on Dirt Devil Swivel Glide upright vac?


Four screws hold the bottom plate in place. Turn the vac upside down and remove the screws that hold the cover(bottom plate) over the brush roll in place. Remove the plate and you are there. ... Dirt Devil M088910 Swivel Glide Vision Bagless Upright Vacuum

Replace belt i need to replace the belt on an upright dirt devil 086310 vaccume but do not have a manual and can not find how to open the assy to replace the belt


On the bottom, there should be a few screws to remove to remove the plate covering the brush roll. However some may have screws on the top housing to remove the top. ... Vacuums

How to replace wheel bracket on dirt devil. I have a dirt devil swivel glide and I took off the wheel bracket to clean out a clog and now I cant seem to get the wheel bracket back on.


... Dirt Devil SwivelGlide Bagged Upright Vacuum

Dirt Devil model: M086325, need help getting to the belt to


I have listed below a link to the manual and a link to the belt you need. Hope it helps!Devil Swivel Glide Vision Manual ... Dirt Devil Built-in Vacuum Systems Bagged Canister Vacuum

My Dirt Devil kurv no longer recharges. I think I need to replace the battery. Called the manufacturer and they can't help me.


Obtaining a battery will be difficult; I had a similar problem with my Kone model. Check that the plug you have has a fresh new fuse though as it may be the connection lead. \015\012\015\012Sadly because the batteries are built into the machine ... Dirt Devil Kurv Bagless Cordless Hand Vac - Spice

What belt do you get for dirt devil swivel glide MVP 086420?


... Dirt Devil SwivelGlide Bagged Upright Vacuum

Dirt devil envision wide glide. doesn't have much suction at suction hose end. will not vacuum up anything. Belt is good, hose has been cleaned out, all to no avail. Help !! : ) Ernie Bernard


... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

Need instructions on how to replace the belt on a hoover dirt finder model u5321-930


You can download the manual from the link below:\015\012\015\012http://www.hoover.com/Media/ModelPDF/U5468900.pdf\015\012\015\012Please update the question & let us know if the information given was useful to you - Good Luck! ... Hoover 5416-900 WindTunnel Bagged Upright Vacuum

My older Dyson DC14 (the purple one) early model with a clutch on the beater bar belt needs a clutch replacement. The bar has been cleaned and there are no worn or damaged parts so I conclude that the clutch at the motor end of the belt needs to be replaced. I can find the part online but no instructions on how to disassemble the vacuum to get to and replace it. Dysons only advice is to give me the address and phone of the nearest service center. Can you help me?


Have a look at www.dysonmedic.com which has some very useful info on dismantling and repairing Dysons.\015\012\015\012Although this site doesnt actually cover the DC1 ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Dirt devil swivel glide - no suction


Check the filter gauze on the unsud of vack where bag is if this is blocke you will not have vacuum as there will not be ventilation thro this filter should be able to feel blow of air from this vent when vacuuming up hope this helps ... Vacuums

Dirt Devil MVP Swivel Glide turning off


... Windsor SR12 Sensor Bagged Upright Vacuum

Help!!!! i have an older model of the dirt devil bagless quick vac. and it has been working great, just last week i was vaccuming my bedroom and i accidentally sucked up a string belt that goes with one of my capris. and today i emtpied out the dirt cup but it seems the the string belt that was sucked up is not within my reach and whenever i start the vaccum i get this distinctive noise that i've never heard before. help.


It's likely wrapped around the brush\015\012pull out the roller and un tangle it ... Dirt Devil M084600 Dynamite Bagless Upright Vacuum

Dirt devil easy lite trouble shooting help needed! Our Dirt Devil doesn't pick up now and has dirt/dust kicking up as I vacuum. It behaves like a dirt devil spreader instead!


... Dirt Devil Easy Lite Quick Vacuum

Hi, The belt of our Dirt devil bagless vaccum broke and we got new belt and replaced it. Even after replacing the belt, the brush is not rotating. Any suggestions please ?


Did you check to see that the beater brush, the brush that the belt drives, is free of debris and moves freely?\015\012When they bind up they can cause the belt to break.\015\012Remove the beater brush just as you do when changing the belt and clean ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

Replacing belt on dirt devil featherlite vacuum


Did u check the owners manual ... Dirt Devil Reaction Twin Cyclone Upright Vacuum

I need please a belt for the brushes the larger one but may be better to replace the smaller one as well. I can see how to replace the small one very easily but not sure how to get the new one onto the end of the big sprocket. Please can you help I have the vac disassembled ok just waiting to get the belt to reassemble it. thank you Colin White SEBO AUTOMATIX X1


As you know, there are two belts - the pulley device between the motor and the brush roller is the sensor that measures the drag on the brushes and operates the automatic height adjuster to maintain constant drag. To the left of that double pul ... Sebo Automatic X1 Bagged Upright Vacuum

Dirt devil jaguar belt replacement - Dirt Devil M085580 Featherlite Plus Upright Vacuum


... Dirt Devil M085580 Featherlite Plus Upright Vacuum

I need the manual for a dirt devil hand held wet pickup vacum..dirt devil spot scrubber....model #SE2850...could you please help...that is messed up ..i will not pay for it


Follow the link below to download your manual. It's free!\015\012http://www.dirtdevil.com/manuals/?id=8d4f4999-67e5-47f1-a43a-77 ... Vacuums

Belt replacement How do I replace the belt on the dirt devil featherlight


On the bottom you will see 4 screws.take them out and the bottom plate will come off.before you put the new belt on look at the motor shaft.if you see old rubber on it you need to clean it off or your new belt won't last very long ... Dirt Devil Featherlight Bagless Upright Vacuum

How do I replace the drive belt on a kirby G4? Actually the belt is already replaced I just need to know how to reattach that front part back onto the main vacuum. HELP


Greetings from GoVacuum,\015\012\015\012Here's a video we shot showing you in detail how to install a belt properly, and how to reattach the head properly. I hope this helps you;\015\012\015\012 ... Kirby G4 Bagged Upright Vacuum

Need a replacement on/off switch for Dirt Devil Deluxe Model 8201 (more than 12 years old). We have the old one out. We just need a new one to replace it. Where can we get one?


... Dirt Devil Vacuums

Replace belt on dirt devil vision - Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum


... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0854 seconds