Having problems with your Dirt Devil Vacuums ?

How do I remove top of dirt canister on my Dirt Devil Model UD70010 Bagless Vacuum? Dirt is stuck inside canister and I cannot get it out.

Answers :

Repair Help & Product Troubleshooting for Dirt Devil Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I remove top of dirt canister on my Dirt Devil Model UD70010 Bagless Vacuum? Dirt is stuck inside canister and I cannot get it out.

... Dirt Devil Vacuums

My DC 17 is plugged. I can see through the small hole in the top blue "flower shaped" that the holes at the top of the canister are plugged with hair & dirt. I cannot see anyway to get to these small round holes. Is there a way to remove the top blue "flower shaped" piece? I have removed the inner cone from the clear canister but still cannot get up underneath.

Please kindly follow the steps below to clean your vaccum cleaner,1.) Remove the clear plastic handle. You\015\012will have to take out two screws and then unclip from the from the\015\012front. It's stiff, I gently used a flat head screw drive ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My Fantom Thunder upright has a blockage that sounds like it is directly above the dirt bin in the "head". I cannot access it from inside the bin chamber by going up the nozzle with a claw parts retriever. (This is the older model where the cyclone nozzle doesn't come off.) The wand, hose, rear inspection port, and front brush intake are all clear. How do I get the top of the vac off above the dirt bin? I don't see any screws or slots.

... LG Vacuums


There is a black gasket type thing that fits on the bottom of the cyclone part that is supposed to keep dirt and hair from getting down to that filter. Yours is probably missing - mine was. I called Dyson and they sent me a new cyclone for free. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My Dyson DC17 vacuumn system is stopped up, the clog is in the top part of the vacuum before it drops the dirt into the cylinder. Does the top part of the canister come off so that you can get into the tubes that are clogged.

... Dyson Vacuums

The main switch on my Henry will not stay down. How do I rectify this? I have undone the three screws inside the top but cannot get the top off to gain access to the switch.

... Henry Vacuums

I am trying to change the belt on a hoover legacy dirt finder. I cannot figure out how to get to the inside pully where the belt hooks

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=733898\015\012Generic problem for all Vacuums\015\012I am trying to change\015\012Posted by fuzzyplus1 ... Vacuums

I have an old Hoky Omni carpet sweeper. I took it apart to clean the inside. Now I cannot figure out how to get it reassembled.(specifically the two buttons that open the bottom to discard the dirt, and two small wires that go somewhere)

... Hoky Vacuums

I have an electrolux renaissance c104a model vacuum...I got a sock stuck in the hose and took the end of the vacuum where it attaches to the canister apart. There are 4 brass pins that I cannot get back in the correct sequence to operate the vacuum...please help.

... Electrolux Guardian Bagged Canister Vacuum

My infinity vac NV29 seems to have an extension wand stuck down in then tube and I am not able to get it out. We rented our winter home and evidently they found some type of extension that did not belong to it. Is there a way to take the handle apart in order to remove it? I am not able to use it with the handle and have to use the one on top of the canister, which is extremly difficult for me since I am disabled. Thank you.

... Euro-Pro Vacuums

Hi, The dirt does not **** into the canister. It looks like the cyclone system is not working. I think something is stuck inside. How do you recommend to fix it? Thank you for all your advice. Fiona

There is no vacuum action on your set. So as you mentiioned there is little or no suction available which means that the pump is not working correct. The two possibilities are either a large block of an object inside or the failure of the vacuuum pu ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

For Hoover canister cleaner model S1361, the power cord got stuck inside and cannot be pulled out or rewind, need help. What can we do? We live in Springfield Drive, Richmond BC V7E 1Z1. Thank You!

... Vacuums

Hello, I have the same model. And though it is three years old, starting from the last month, it does not clean anything anymore. Cannot even pick up one single thing from the floor. Every dirt gets stuck in the hose. I cleaned the hose and cleaned the filters but it still does not pick anything up. Is three years its normal lifetime or do I have the change the filters, instead of cleaning them? Thanks.

I know bissell vacuums are very cheap but they should last more than 3 years. there should be two parts to the dirt cup. remove the dirt cup and above it there should be a round plastic part. unscrew it and check that filter. ... Bissell 6594 PowerForce Bagless Upright Vacuum

Unable to remove round filter in bottom due to bolt not secure inside vacuum and it is just spinning so I can't remove nut holding on filter, but cannot see how to remove top of vacuum to get at other end of nut.

If you are talking about the acorn nut that secures the separator to the motor shaft, it can be removed with a small (or even a big, for that matter) air or electric impact wrench with the proper sized socket. Find a mechanic friend who has one, make ... Rainbow E series Canister Wet/Dry Vacuum

My Kenmore Quick Clean vac clogs at the top of cannister and does not let dirt to go to canister. After vacuum for few minutes have to stop empty before continuing to get rug clean. Is there anything that I can do to solve problem.

You need to own an air compressor,and blow out all vacuums ,after each use. ... Kenmore Vacuums

My electrolux ambassador power wand quit working. I replaced the switch that shuts it off when the roller stops, but it wasn't the problem. The on/off switch is fine, the motor is fine. We have traced the problem to the wires inside the canister by opening the inside cover to the bag container. We see the power cords going into the canister but we're not able to get to anything. We can't find any screws to undo that would open it up in order to follow the wires deep into the canister. We've bypa

... Electrolux Vacuums

Dirt devil ud20020 plastic piece at top of dirt cup broke off.whole dirt cup canister will not fasten to vacumn.

... Dirt Devil Vacuums

How to disassemble the brush to empty anything that might be stuck inside of the brush? The motor seems to be overheating, all belts have been checked, all airways are clear and the filter is clean. The vacuum is vibrating and releasing a burning smell, but still sucking up dirt. There is nothing stuck on the outside of the brush, but is there a way to check inside of it to see if that is where a clog is occuring?

If there's a burning smell and the belts are fine, the problem is going to be hot wires causing the insulation to melt, or the motor going bad. Discontinue use and have it checked at a repair shop. ... Bissell 6594 PowerForce Bagless Upright Vacuum

How do I clean the dirt from inside the vacuum cleaner, brand name panasonic mce6003. I bought it without the manual and I cant get the dirt out from inside it since it is bagless. Please help :-(

... Panasonic MC-UG371 PLATINUM LINE Bagged Upright Vacuum

Frozen top The top of my Shark sc505 is on so tight that I cannot get it off even with heavy duty tools. It appears to be frozen and will not move. How can I get it off so I can use it again?

I just bought one from a thrift store we were able to get the top off! We used wd 40 and vice grips and it came off. The machine looks like it was only used once and someone left the water in it. I immediately put white vinegar in it and rinsed it ou ... Euro-Pro Shark SC-505 Handheld Steam Vacuum

We have a Singer 626 sewing machine. It's an old mechanical machine with heavy metal parts. The stitch selector was stuck, I removed the top and helped the selector to move. when I had to move the selector again, it was stuck and I pushed too hard and broke a component. I can fix the machine if I had a repair manual. I need to buy a repair manual. How and where can I get one? Thankjs Charlie PS. Im pretty mechanicly inclined and I was able to clean the machine and get it to work after

... Vacuums

Am attempting to get 'inside' the vacuum to troubleshoot why it suddenly stopped running. Suspect it may electrical, and have already checked the obvious (visible cord and plug.) However, there doesn't seem to be an obvious way to get inside the canister without destroying something. Thanks!

Hi There,\015\012\015\012Here's a link to a repair solution that I've done explaining how to diagnosis the cord reel, and open up the machine. The model this is done on is not the same exact model as yours, but the repair will be almost ... Miele S251 Flamenco II Bagged Canister Vacuum

My dyson DC07 animal does not have the suction it once had I saw a dyson program that showed a filter in the top of the canister I was just aware of the filter around the wheel. Is there one on top of the canister and how do you get to it

Hi\012\012The DC04 Dyson has a filter at the top, but the DC07 has one at the side on the bottom and one underneath the cylender.\012\012Take all the parts off your dyson and throw them in the washing machine and then put them ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I just purchased a Sebo Airbelt D canister vacuum. I plugged it in and used it for ten seconds then turned it off, retracted the power cord and now cannot get the power cord out of the machine. Did I not spend enough money to get a quality product? Does anyone have any idea how to get the power cord out without breaking the machine?

... Vacuums

The screw that holds the handle to the top of the canister came completely loose. How do I get to it to reattach?

Buy a epoxy cement and fill the hole with it, then drill a hole a little smaller than the screw, and finally insert screw. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0965 seconds