Having problems with your Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum ?

WE HAVE A DIRT DEVIL ULTRA VISION TURBO VACUUM MOD 87800 AND ITS BREAKING BELTS AND THE MOTOR SMELLS WHEN WE RUN IT


Answers :

Repair Help & Product Troubleshooting for Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

WE HAVE A DIRT DEVIL ULTRA VISION TURBO VACUUM MOD 87800 AND ITS BREAKING BELTS AND THE MOTOR SMELLS WHEN WE RUN IT


... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

Belt keeps breaking on dirt devil 85335


Check and see if the brushroll still turns easy. if it doesnt, u may need a new brushroll which can be found on ebay, or dirt devil's website ... Dirt Devil M085580 Featherlite Plus Upright Vacuum

Replacement parts... I've got a 3594 Bissell and the belt has come completely off. In the process of breaking, it bent the metal guide inside the motor housing and melted the plastic that holds the guide and keeps the belt inline with the roller. I've got it running again by using a screw I filed all the threads off of, but it only works for 10 minutes at a time before breaking another belt. This process is getting expensive, as it usually takes 30 minutes to completely vacuum the house. Is ther


Most likely it is the top cover that needs to be replaced, part #2031238 and is around $30. It would have that guide on it. ... Bissell 3594 CleanView PowerTrak Bagless Upright Vacuum

We own a dirt devil model 088600, and are experiencing a problem with the belt wearing away a section between where the belt connects to the brushes and the motor. There is a lot of plastic/rubber residue coming out from the vacuum. We have tried new belts only to find the same problem occurs. I noticed that the source of the dust is coming from the section between the brushes and motor, where there appears to be a section that is misshapen and melted. I looked up the schematic online and can't


If you are certain that the belt is seated correctly and the beater bar is nested in its holder and the cover of the assembly has been properly installed and you still see a contact area between the belt and cover, you should either: return the vac ... Dirt Devil Vacuums

Dirt Devil Platinum Force Shampooer belt breaking.


... Dirt Devil M091400 Platinum Force Wet/Dry Vacuum

DIRT DEVIL BAGLESS VACCUUM BELT KEEPS BREAKING


... Dirt Devil M084600 Dynamite Bagless Upright Vacuum

Dirt Devil Jaguar Bagless Upright Burning Smell


Take the belt off again you will see burnt rubber from the old belt stuck to the motor shaft.you can take a fine piece of emery cloth and clean the shaft down to its polished finish.always good to do this after each belt.check the brush roller and se ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

Belt keeps breaking, but motor turns easily by hand on bissell powergroom, burnt rubber smell as well.....


Something is preventing the roller from spinning when in contact with the carpet. This causes the belt to stop turning and the motor shaft spinning in one spot causes the belt to burn and break. The protective guard could be damaged or not installed ... Bissell Powergroom Pet Vacuum

My kenmore vacuum model 116.36933502. It has no suction. I have cleaned out every spot,taken off the back and still nothing. The motor runs but doesnt seem to be at full power. The agitator brush works. When it broke i seemed to smell something and since it has no belt. Does this possibly have to motors?


... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

The belt is intact but the aggitator doesn't spin anymore. Had a horrible rubber smell, went to change belt. Not the problem. Anyone know what could be wrong? Dirt Devil bagless w/dirt indicator


It could also be a bearing problem in the roller brush. Take the belt\015\012off of the roller brush and see if the brush spins freely, if not, remove the\015\012roller brush and check both ends to see if one end is stuck. If so you ... Vacuums

I have a dirt devil featherlite plus and all of the sudden it started pushing hard and smells hot. I cleaned the roller, changed the bag, checked the belt. The belt is a little wore, but not bad.


If it is pushing hard then you still have a belt problem. It may not be broken but the belt is stretched out too long and will not turn the roller brush fast enough to make it push easy. ... Dirt Devil M085500 Featherlite Plus Bagged Upright Vacuum

When I sart to run my bagless vacuum, it runs for a second and then shuts off. I replaced the belt and the filter. The repairman told me that on bagless vaccuums, the motor and bearings get clogged w


Take the brush roller off and on the ends are the bearing caps.try to take those off and clean the bearings ,carpet strands and hair will cause that.after you do that make sure the roller turns freely if not then the bearings might be bad and if that ... Vacuums

I replaced the belt on my Dirt Devil Featherlite Bagless Vacuum and the brush roller rubs and makes a very loud noise when turned on. I have gone exactly by the manual instructions and made sure the belt and end caps were on correctly, but the bristles still rub the back and it makes a very loud noise. Without the brush roller in the vacuum, it sounds and runs normal. What could the problem be?


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=561283\015\012Generic problem for all Vacuums\015\012I replaced the belt on\015\012Posted by piggyt ... Vacuums

My Dirt Devil Vibe bagless vacuum started giving off a burning smell. The brush roller was jammed with hair. I immediately shut it off and cut the hair out of the rollers with scissors until it turned freely. When I turned it back on, the smell was gone but there's no suction now. Did I ruin the belt or something else?


It's more likely there's a clog in the hose somewhere, possibly where it connects to the power nozzle. Detach hose and check the PN. \015\012If there's no clog in the PN, detach hose completely from machine and try to drop a marble or coin th ... Windsor SR12 Sensor Bagged Upright Vacuum

My belt keeps breaking on my dirt devil classic ten amp vacuum 086600


... Dirt Devil Royal Plastic Brush Roll For Model 086600 Part 2620035600

Dirt Devil Spot Scrubber Motor not running


... Dirt Devil SE2800 Spot Scrubber Handheld Wet/Dry Vacuum

Dirt Devil vacuum M85845 broken belts. Can't get


Call all-type vacuum &janitorial supply.lisa can help you.314-275-8006 ... Dirt Devil M085850 Featherlite Bagless Upright VacuumVacuum

How do you replace belt on dirt devil self propelled vision vacuum - can't find the motor shaft


You can download the manual from here > http://dirtdevil.com/search/?q=self+prepeld ... Vacuums

The motor completely died in my dirt devil d2. When I try to turn it on, absolutely nothing happens. The belt is intact.


In my experience, the units get operated without a filter and the motor gets jammed up with dirt. Unless you are up to armature turning and brush replacement, it might be best to call it a day and get a new device. ... Dirt Devil Vacuums

Dirt devil breaks belts - Vacuums


Dont buy dirt devil, really this vac is **** ... Vacuums

Dyson dc 14 the belt keeps breaking with the smell of burning rubber looks like the motor spindle does not turn any solutions


... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Belt keeps breaking on vacuum. - Dirt Devil M085580 Featherlite Plus Upright Vacuum


Clean the hair off the bearings. Remove the brush. Pry off the end caps and remove the hair under and around the bearings. I used a kitchen fork. ... Dirt Devil M085580 Featherlite Plus Upright Vacuum

I have the dirt devil Hepa Media dyna power 26.0 and the motor is running and will **** up shoe strings but nothing on my carpet


... Dirt Devil Vacuums

Is the motor shaft that you put the belt on the dirt devil bagless upright that silver bar. My vacumm now makes a screaming noise and doesn't pick up. the directions are very poor


... Dirt Devil M086700 Vision Bagless Upright Vacuum

I have a Dirt Devil Vision and when I put a clean canister back in place the suction at the bottom of the filter clogs up and very rarely go into the canister. Also where the air blows out of the motor, I will get particals that will blow out. I have checked where the belt is and also the suction tube. Do you have any ideas how to fix this problem?


Yes your intake hose is clogged thats the clear hose you can see it on the bottom from the back.disconnect the upper hose from your intake hose and try to push a coat hanger through with the end of the coat hangers end bent till its rounded so you do ... Dirt Devil M086700 Vision Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1136 seconds