Having problems with your dyson animal upright ?

white blinking light on position

the deep white light is flashing

Answers :

Repair Help & Product Troubleshooting for dyson animal upright

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The white lights for my positions keeps blinking on dyson animal


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

After a brief power outage my Marantec 4700 garage door opener has problems opening/closing. When opening it stops at the fully open position and the lights blink, when closing it automatically reverses just as it fully closes and then the lights start to blink again. I checked for obstructions and tried to reset the limits of travel per the manual, it still does the same thing. Any ideas on what to try next?


This is not a sensor issue, I have a similar problem, sensors work fine, garage door is still fully functional, all operations, including safety sensors work properly, just the overhead lights flash. I suspect there was damage to the power board due ... Vacuums

On my dyson dc 28 the carpet cleaning bar turns easily by hand, but does not turn on when the cleaner is reclined from the upright position. The white light illuminates when preseed, but the red light does not illuminate even though the motor is running. Thanks


... Dyson DC28 Animal Bagless Upright Vacuum

THE WHITE LIGHTS BLINK THEN RED POWER SWITH STARTS TO BLINK.


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Shark navigator freestyle light is blinking - Shark Navigator Freestyle Stick Vacuum - White


... Shark Navigator Freestyle Stick Vacuum - White

The red light is blinking & I can't push the white buttons to set height & not sucking


... Dyson DC28 Animal Bagless Upright Vacuum

I have a Roomba 560 (it's still in warranty !!) and, after my summer vacation, it has a problem. When I'm charging Roomba, the orange light blinks (and this is normal!) but this orange blinking continues forever.... the light doesn't change to green. If I detach Roomba from the charger, the light become green and it works normally until the light changes to red and I have to charge it again. WHY, DURING THE CHARGING PHASE, THE LIGHT DOESN'T CHANGE FROM ORANGE-BLINKING TO GREEN? HAVE I


The problem is not with the charger itself but it is with the battery inside the Roomba. It sunds like one or more of the cells has gone bad so its not holding the same charge as it did. I would recomend sending it in while the warranty is still vali ... Roomba Robotic Floor Bagless Vacuum

The number 2 light is blinking and I can't get the machine to run. I know that when number 1 light blinks its because of the lid. What is the problem for the number 2 light on the island oasis machine?


... Vacuums

Oreck trouble I replaced the plug and switch. black from motor to pole 1, black from plug to pole 2, white tied to white with a wire nut. When I plug it in it is powered in the off position. I have high speed at the high speed position, low speed at the low and off positions. Any ideas?


... Oreck XL Ultra Bagged Upright Vacuum

Adding hampton bay light model #430-727 to ceiling fan. ceiling fan works but lights dont work. connected white to white wire & black to black wire. what else can we try?????


... Vacuums

I have a Palm Springs Ice Maker Model JS-ZBJ-10, and the Power Indicator Light blinks and tray does not fill up. I have had the water line clogged at one time and blew out the clogged line, but this is not the problem this time as I cleaned it and the light still blinks.


... Vacuums

We just purchased a bissell pro lite and when we run it just a little while, both lights start blinking and we can't turn it back on without unplugging it for a few seconds. The manual doesn't say anything about it. What do the blinking lights mean?


... Bissell SpotBot Robotic Wet/Dry Vacuum

I have a ge light switch receiver rf1023, with incandescent bulbs, and when I try to switch it on it just blinks once and goes out. if I hold the switch on the battery-operated wall remote, the lights keep blinking until I let go. It used to work fine, and now it doesn't. I've lost the intallation instructions, so I don't know if there was a trouble-shooting section that covered the problem.


... GE Vacuums

I have a Zenith ZD300 Dehumidifier. Bucket full light blinks. The water bucket was not completely full. Emptied the water bucket and re-inserted. The bucket full light continues to blink. The humidity setting LCD shows 1%. What is needs to be done to correct the problem?


... Vacuums

Andorra collection, withcommand system 2000 wall control. Light will not turn off by light switch, when light switch is depress light blinks is it the wall switch or the light?


I searched under the following search terms and did not find it on the Internet:\015\012'andorra collection withcommand system 2000 light control'\015\012\015\012and found:\015\012\015\012 ... Vacuums

I have a clarke bench grinder model 1002. I have a light that I would like to attach into the wiring though the grinder wiring in it's base. The light has two wires, and the grinder has a ground that is grounded to the base, a black that goes to a switch then to the motor. The white goes directly to the motor. where would I have to splice in the two wires from the light? I have a switch that I would like to put in for the light on off also.


Attach the white wire on your lamp to the white wire on the grinder.\012Attache the black wire on your lamp to the black wire on the motor side of the switch.\012This will give the lamp power any time the grinder is turned on.\012Yo ... Vacuums

I have a Dyson DC28 animal vacuum and the beater brush will not turn. It has one flashing white light and a red flashing light.


It appears that the drive belt is not adjusted properly or has stretched. THe gunk that vacuums pick up can also affect the belt in amking them too slippery to drive. Check it out. ... Vacuums

Trying to attatch the wires from the light kit to the fan but the blue and white wires from the fan have white caps on them covering the wire. Do these need to be removed in order to attach the wires with the wire nuts? If so, how are these white plastic caps removed?


They're called "wire nuts". Turn them counterclockwise to remove, lay the wires you need to join side by side with the ends of the bared sections even and screw the nut on. lp ... Vacuums

Royal vacuum cleaner model 4600 wiring diagram I have a Royal Vacumm Power Tank Model 4600. I replaced the switch (6 wire - 3 position) that is on the tank. One side of the switch control just the blower. The other side control the blower and the POWER head - wand with a variable control speed. The middkle position is off. After I installed the swith, the power head - wand is powered in either position. There are three wires comming out of the wand: White, Red and Black. I guess I wired somethin


... Vacuums

Euro-pro iron. red light on. green light blinks on but iron will not heat up. lights do not progress through yellow (does not go past green) purchased from walmart with warranty extention on 12/08. Never had a problem before--what is wrong.


The inner grid that heats up the iron has an open which will not give continuity to heat the iron up. These grids are not serviced so more than likely a replacement iron will be on your list to purchase ... Vacuums

I just plugged in my humidifier and the red light for power is blinking and now it is turning green and blinking and red and blinking! Is this normal?


Somethig is wrong in it check angian ... Vacuums

Roomba 540 red light blinking


... Vacuums

I have a Mr Coffee PSTX Series coffeemaker, the clean light came on and I started the cleaning process, about 20 minutes into it, an alarm went off, the cleaning light was blinking and I can not clear the alarm. It has not finished going through the cleaning cycle and is frozen on with the alarm. I can not clear it. Please advise.


... Vacuums

Delonghi Citiz Milk frother not working. After pressing button, red light comes on and heat starts, then after a few seconds red light starts to blink and nothing happens.


Please visit the link provided below :http://www.delonghi.com.au/support/instruction_manuals/EN265BAE_im.pdf ... DeLonghi Vacuums

Red light is on my bissell spot lifter when it is pluged in and switch is in the off position. When I switch it to the on possition red light goes out and the machine does nothing. What am I doing wrong?


... Bissell 1719 Spot Lifter 2X® Handheld Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0501 seconds