Having problems with your Dyson Ball DC24 Bagless Upright Vacuum ?

My dyson dc 24 just stop picking up. There is a

\015 My dyson dc 24 just stop picking up. There is a tube on the side that's sucking in air. The vacuum is relativley new. Is there a reset button somewhere?\015

Answers :

Check to see if the brushes on the bottom are turning if not change the vacuum belt.
Repair Help & Product Troubleshooting for Dyson Ball DC24 Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dyson dc 24 just stop picking up. There is a


Check to see if the brushes on the bottom are turning if not change the vacuum belt. ... Dyson Ball DC24 Bagless Upright Vacuum

My dyson has stopped picking up from the bottom but still picks up using the hand held at the top


... Dyson DC25 All Floors Bagless Upright Vacuum

I have a dyson animal dc24. It is 7 months old and has stopped working. The hand tool is working fine but when I insert it to engage in normal vaccuming the suction stops. I can hear a strange air sound. Also the brush is spinning but it is not picking up. I have taken it apart and checked for a clog but I don't see one. Any advice?


Hi there,I'm sorry to hear your DC24 Animal isn't picking up as well as usual. Although I note you've already checked for blockages, it sounds as though this is likely to be the cause of the issue.To locate and remove any blockages, p ... Vacuums

My Dyson DC 04 has stopped picking up I have checked the belt it is ok and emptied the cylinder what can I do.? My product does not appear on your list but it is one of the original and it is Green


I guess you've also checked that the washable filter is clean. If not, do that first. Next place to look is underneath - you will see a short length of spiral-reinforced clear plastic tube. That tube is liable to split, and even quite a small split w ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My dyson animal is hard to push on carpet - the beater bar is still operational. When I turn off the beater bar and run the vacuum on hardwood the beater bar stops moving, but it still ''rolls'' on the hardwood - it doesn't pull up like it used to. It also seems to not be picking up as well as it used to, although no blockages are present and the filter is clean.


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My dyson DC04 started to **** a dog toy up the main bit with the brushes - stopped it immediately and removed the toy but since then the suction is still ok/strong with the extension hose picking up but no suction is getting to main scetion/brush area - sounds like a pipe is disconnected from the front area - nothing obvious on the surface....HELP! Thanks in anticipation........... Julie Price


Get a different brand vacuum. Dyson's are easily the worst vacuum I've ever owned. I've tried the DC14, DC25 and DC33 they are all heavy plastic POS's made in Malaysia. I've owned every kind of vacuum under the sun. Rainbow, Kirby, Oreck, Riccar, Seb ... Vacuums

Hi, I have a dyson dc24 which I purchased two years ago. It has suddenly stopped picking up after going over a thick pile carpet. I've cleaned the filters. Can you please advise what I should do


Your head is probably plugged with pieces from the thick pile carpet, open up the head and clear the blockage. ... Dyson Ball DC24 Bagless Upright Vacuum

My dyson seems to have lost its suction therefore is not picking up anything yet i have found that when my dyson is standing upright it has a little more suction but nothing like how it use to work. This has only happend in the last 2 weeks. I sanded a floor & though the sander picked up majority of the dust i did use the dyson to pick up the excess and it is since then that my dyson has not been working to its full potential.


Hi there,\015\012\015\012Sorry to hear you're having a problem with your DC07. You should be able to resolve the issue by following these simple steps: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have cleaned & cleaned this thing! It runs for about 2 mins & stops, says "Clean Brushes"! and now it's very noticeable it's not picking up well... but is picking up a bit. I take the dust bin out, and the brushes spin.... and it has much more power.... and is very clear it is working! But it's useless without the dust bin! LOL It's only 9 months old.... called customer service, but it was the one time it worked just fine! Of course, I thought I'd stop here first before calling again! Than


Ok, this is a "Brush Height Adjustment" issue. It will probably work great on a hard surface but on carpet the brushes bog. If you've taken the unit apart already...Sorry....do it again. When you do, you'll see a String which allows the brushes to " ... iRobot Roomba 560 Robotic Vacuum

My Dyson Animal is not picking up very well in the drive position. With the hose the pick up is still very good. I have had it for 2 yrs now with very little problems. I have cleaned out all areas etc pipes, the brush underneath and cant find any blockages. The noise of the dyson is the same as usual. Could you tell me if there is a part that it sounds like it needs?


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Took Roomba apart to clean and now the pick up brushes start and stop during cleaning. The vaccum is clean but will not constantly spin. Runs great but pick up brushes start and stop. Is there a number for Roomba? Warranty? This one is less than one year old.


You can go to www.iRobot.com . This is the roomba website. You should be able to find replacement parts, customer support, videos or the Roomba product, and more.\015\012When y ... iRobot Roomba 530 Robotic Vacuum

Poor Suction Heya! So I just picked up a used Dyson, but when I vacuum with it, the suction is pretty weak and it spits all kinds of stuff out the back and into my feet. When I pull the hose I have good suction, but in regular mode it hardly picks up anything. The brushes are spinning, and it eventually will clean an area if I go over it again and again. Maybe a clog somewhere? Please tell me that Dysons have better suction than my $50 Dirt Devil! Thanks!


I recently bought a second hand Dyson DC07. Its suction was poor. I removed all the un-clipable pipe bits and to remove any blockage but it all looked clear. The Final Sponge and hepper filter did have a lot of dust in it and the rotating brush was f ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My dyson 07 has suddenly stopped suctioning.


Could also be the clutch. I just had the same problem. Before buying a new clutch assembly, I took the out the clutch just to make sure I could do it (the link previously mentioned is great: ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dyson DC25 is barely picking up, but what it is picking up is not going into the cannister,


Your problem is posted in the wrong category, so probably no-one reading here (Telescopes and Binoculars etc) will have the solution. I do know that Dyson maintains Tech Advice lines worldwide. Look here ... Dyson DC25 Ball All-Floors Upright Vacuum Cleaner

My vax has suddenly stopped picking up and the brushes are spinning so fast that what is being picked up is being spat back out also the hose has suction but won't pick up


... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

In my (almost new) Dyson DC31 Animal the rolling brush tends to stop like the bearing was kind of difficult to turn. I opened the side carter and removed the little belt. Without the belt the engine runs regularly. I cleaned the little knots of hairs trapped in the bearing but still the brush runs for a while then stops, tries for a bit then stops again. I even tryed putting a bit of synthetic lubricant with apparently no result. Could it be a defective bearing? Thanks for your help.


... Dyson DC31 Animal Bagless Handheld Cyclonic Vacuum

My Dyson DC17 has lost suction on the wand and is not picking up dirt as it should. I have taken the small part at bottom of the machine off to see if there is a blockage--none that I can see. The flexible tube on wand is very tight and won't extend very much. Dyson sent me a new cyclonic part in April but the machine still doesn't seem to be working properly. My serial number is 260-us-d11545. Is there somewhere I can take my Dyson to get it fixed. I'm very frustrated with it. Thank you.


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My Dyson D23 Vacuum just stopped and it won't turn on no noise nothing stopped completely now what any suggestions?


... Dyson DC23 Bagless Canister Cyclonic Vacuum

Dyson won't pick up heavier particles -


Check the hose line from the base to inlet of the canister, there may be a blockage, like hair or plastic (i had a lego block and hair)\015\012\015\012clear obstruction, and check the belt. \015\012hope this works ! ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson My dyson stopped working, and now I cant get it to come on at all, I have cleaned everything.


Proberly fauly cable ,switch,or motor req,all parts can be supplied ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Stops just got dyson 07 off ebay and it only goes for couple of minutes then stops.


You're walking too far from the outlet so the plug keeps getting pulled out of the wall ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Bissell bagless sweeper sucks up dirt but will not put dirt in the canister cup. It will pickup until it clogs, then it will stop picking up dirt. It will really hold quite a bit of dirt before it stops completely up. Thanks for any help.


I had the same problem, called Bissell over 10 times! They send me 3 plastic inserts for the dirt chamber, not the problem. I solved it by throwing the Bissell away and buying a Eureka bagged vacuum, no more problems. ... Bissell 6594 PowerForce Bagless Upright Vacuum

Brushes only work when Dust Bin is removed!! I have cleaned & cleaned this thing! It runs for about 2 mins & stops, says "Clean Brushes"! and now it's very noticeable it's not picking up well... but is picking up a bit. I take the dust bin out, and the brushes spin.... and it has much more power.... and is very clear it is working! But it's useless without the dust bin! LOL It's only 9 months old.... called customer service, but it was the one time it worked just fine! Of course, I thought I'


HI, If the brushes work , without the bin, the problem , the problem could be caused , due the failure at the bin lock mechanism. There is a sensor that checks if the BIN is connected properly or not. This problem is best resolved by getting ... iRobot Roomba 560 Robotic Vacuum

Sometime when I am vacuuming carpet or a large area rug, my Dyson starts making this loud, horrible, wrenching noise. It stops when I lift one of the wheels up. What is causing this? I have only used my Dyson 3-4 times.


You will need to have the clutch replaced. this is causing your problem. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

HI my mothers dyson, doesn't seem to be sucking up fluff that i could pick up, it does seem to pick up but not a lot.


Try cleaning all .............. ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0473 seconds