Having problems with your Dyson DC05 Bagless Canister Cyclonic Vacuum ?

My dyson dc05 just stopped working,any idea what the fault could be? i,ve had it about 7 years

Answers :

Guessing that the power plug has broken wiring inside the plug--try replacing the plug with an aftermarket plug from the home center or hardware store. Another possibility is the power switch has gone bad--replace it with the proper part ordered from an appliance parts store. Another part that can go bad is the motor brushes, but that requires that the vacuum be fairly well disassembled. Good luck!
Repair Help & Product Troubleshooting for Dyson DC05 Bagless Canister Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dyson dc05 just stopped working,any idea what the fault could be? i,ve had it about 7 years

Guessing that the power plug has broken wiring inside the plug--try replacing the plug with an aftermarket plug from the home center or hardware store. Another possibility is the power switch has gone bad--replace it with the proper part ordered from ... Dyson DC05 Bagless Canister Cyclonic Vacuum

I bought one of these units last year and it worked great for about 9 months and then it stopped brewing coffee. Not sure what is wrong. It will not heat the water to make the coffee. Any idea as to what could be wrong?? Thank you. Pierre

Hi,Either the heating element is completely corroded with mineral from the water or the heating element has gone bad...If it is not heating at all there is some kind of electrical problem or the element is gone bad... ... Vacuums

I have a 5260D Baby Lock Serger, which I had tuned up a year ago. I haven't used it very much since. When I took it in, and again now, it sews fine for awhile, then starts slowing down until it is barely sewing, even with the foot all the way down. The hand wheel seems very tight. - it doesn't turn freely, but takes a some push, like it is resisting a bit. Any idea what could cause this slow down and the tight hand wheel? I appreciate any ideas. Thank you. Maura

Hi,Since you say that you didn't use it for many years then does it make noise?If so it need oiling on its parts.oil orifice and point of contact.Please do rate the solution if the issue is resolved or post a comme ... Vacuums

Passat 2000 W Reg Had the rear brakes and disks changed then a month later had a front tyre replaced and as I drove off something went tinkle tinkle on the road (like someone had left a spanner). Week later the ABS light and the brake light come on with the usual STOP Brake Fail Service Manual message. Had brakes checked but they could find no fault. I've tried the ABS under controlled conditions and it works. What could the problem be?? I've been running the car under these conditions and no pr

The ABS module has a history of wearing out on VWs. Nothing wrong with the brakes themselves, but the ABS module would need to be replaced to stop the lights coming on... but the problem is a new ABS module can be very expensive for a new one (~$900 ... Vacuums

Good evening, I have a Xio Z1010 electrolux vaacum cleaner and I hope you'll be able to give me some advice. The vacuum cannot be started. Last time it started for a few seconds and stopped suddenly. Something similar happened long time ago but that was due to overheating. Once cooled down in few hours it would start again. It is not the case now after 24 hours. Could you give me any idea what could be the reason? Your help would be much appreciated. Adorian

... Electrolux Vacuums

Same here... I have a DC-15 Animal, it was making a clogged type noise and before I had time to react, it stopped working and I smelled burning rubber. I also noticed that the ball was really hot. It's too late to call support, but I intend on doing so in the morning. I've only had my Dyson for a year, so I'm sure it's covered, however, I have no idea where my receipt is. Did they take care of your issue?

You sucked up something that stopped the brush from turning. This made the belt slip causing a burning smell. ... Dyson DC14 Bagless Upright Cyclonic Vacuum

While running my Kirby Generation 3 sweeper it just stopped. Any idea on what it could be. I checked the wall plug and it was that.

Cable needs replaced ... Kirby Generation 3 Bagged Upright Vacuum

The telescoping wand on my kenmore magic blue cannister vacuum stopped working shortly after I bought it a few years ago. After 10 minutes of pushing sometimes I get it to work. It gets longer easier than shorter. What could be causing this problem? Please help!

... Kenmore Magic Blue 24195 Bagged Canister Vacuum

My cleaner ( Oreck 40th Anniversary, XL2 Ultra) several years old, and I love it. My questin, is there a reset button? Vacuum just quit....no noise, sputtering, smell, nothing, just stopped while running cleaner. New bag, new belt. Any ideas?

... Oreck Vacuums

I have a Euro-Pro Shark Steam Pocket Mop. I used it twice last year, and then it stopped producing steam. Is there any way that I could easily fix this without dangerous chemicals? Everytime I call the company, I can't get anyone. The unit heats up, but doesn't produce steam. I've tried white vinegar to no avail. I am afried of using clr after reading that the unit blew up on somoone. I am visually impaired.

Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have had my RCA microwave model # RMW1108 for about 8 months now. It was working fine until yesturday evening. I went to warm up some food for 2 minutes, the microwave itself was on and everything appeared to be working except my food did not get warmed up. I plugged it out and checked all over it for any damage but i could not find anything wrong. What would cause it to just stop heating up the food? Is this type of problem covered in the 1 year manufacturer's warranty.

... Vacuums

My Miele Carina Vacuum stopped working. Does it have a fuse that can be replaced that could be at fault here?

Although it might have an internal fuse on this model, I dont think that will be the problem. \012\012The miele cord rewinder has been known to have a small fault in it where the cord winder that actually retracts the cord onto will come ... Miele Carina Vacuum Vacuum

I live in Kent UK i moved in this house a year ago now we feel quite strong dusty smell specially in two rooms upstairs we clean house on regular biases but smell is still there and we think its not a damp smell does any one have idea what that smell could be ?

Check your ductwork. It could be that they need to be cleaned. Also look for lady bugs because they clearly smell like dust. J. ... Oreck BB1100DB / BB1100DC Housekeeper Ultimate Bagged Canister Vacuum

After the dc16 is charged, I try using it but it only works for about 30 seconds and then it stops. I've had the vaccum for about 3 years. I need a solutions. Could it be the battery?

Almost certainly the battery. 3 years is pretty good for those batteries. Normally batteries can be changed by suitably "interested" people, but I don't know about that specific model. Check out the replacement price of the whole thing compared to th ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

My G4 tech dive has been jerking and began giving off blue sparks then stopped working altogether -any ideas what could have failed? moto? armature? carbon brushes? a fuse :)

Armature and carbons, 79.00 arm 14.99 carbons, should change carbons every 3-5 years or you will damage armature ... Kirby G4 Bagged Upright Vacuum

I was using my sharkvac Euro-Pro model EP033C on the inside of my car when it suddenly stopped and it will not start again. I have had the machine quite a while but had not used it before. Could you please give me an idea what I can do, please.

... Vacuums

The motorhead on my Dyson DC05 stopped working. I bought a replacement motorhead but it also does not work. Any ideas as to what the problem may be?

It could be the hose or the pipe electrics that are not working have you got any lights on the head at all ... Vacuums

The external sensor on my weather station has stopped working. is about 4 years old.changed batteries,checked connections but nothing. type- wo53-4. any ideas

... Vacuums

The reverse gear of my BMW 316 stopped engaging suddenly. Now I cannot reverse the vehicle. Could you let me know the possible fault and what should I do

... Brembo 2003 BMW 3-Series - 316 - Gran Turismo Drilled Brake Kit

I have a kenmore progressive 359235 vacuum with intelliclean. Has been great for about 3 years but now the brush bar has stopped turning. This is a direct drive unit with a circiut breaker reset button on top . The button is not tripped. Any ideas ?

... Kenmore Vacuums

Roomba 4270 stops too soon. my roomba got weird all of a sudden. it started not moving all over as it should. so I tore it all down as I had done before and cleaned all the hair and dirt out of every thing I could without getting down to the basic shell. it does work now and does move all over but stops after about 10 minutes. brand new battery so not a battery issue. could I have plugged some of the sensors in the wrong 'plug'

... iRobot Roomba 560 Robotic Vacuum

Dyson dc05 electrical fault

Hi Helen,I'm sorry to hear you're having difficulty with your DC05. From what you've described, it sounds as if the machine may have overheated in use - this will occur if the filter needs a wash, or if the machine has a blockage. You should ... Dyson DC05 Bagless Canister Cyclonic Vacuum

My Hoover sprint 1700w has stopped working. I thimnk it could be the fuse. How do i get the plug apart to get the fuse out? Can you give me other possible reasons it could have stopped working?

... Vacuums

Rainbow stops shortly after starting to vacuum

There is a thermal fuse on the motor field that sometimes fails. Sometimes the fuse does what it is supposed to do - prevents motor from ov ... Rainbow E series Canister Wet/Dry Vacuum

They just stopped working!

Hoover has a 1 year warranty on their vacuums, so the newer one will be under warranty. The other won't be. It could be bad switches, even tho they sound ok, they could still be bad, One side of the cord could be open, there is also a thermostat o ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0524 seconds