Having problems with your Dyson DC07 Animal Bagless Upright Cyclonic Vacuum ?

DC 17 animal, how to get it clean

\015 Should have done a better job of cleaning my dyson, I am cleaning it now and can see lots of dog hair and some carpet threads in the main part, the part that comes off the vacuum when your going to dump it. I can see it but can't flush it out and it doesn't appear to come apart. \015\012\015\012What should I do? I don't seem to have the manuel.\015

Answers :

The container does not come apart but it can be cleaned out by using a knitting needle Ok it sounds wrong but it works
Repair Help & Product Troubleshooting for Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dyson Animal .. how to get to Chyclone chambers for cleaning??


The cyclone assembly is glued and cannot be taken apart. The best way of cleaning it , is to remove the top held on with three hex screws , the bottom collecting vessel and the perforated filter. Then blast the cyclones from above with either a press ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

DC 17 animal, how to get it clean


The container does not come apart but it can be cleaned out by using a knitting needle Ok it sounds wrong but it works ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My dyson animal just cuts out mid vacuming ,the motor gets quiet hot ,and wont start again for an hour or so when i expect the motor cools down .all filters cleaned no blockages etc.. any suggestions?????


This is a feature so that the motor does not burn up check all tubes ... Vacuums

The motor on my Dyson Animal DC07 is getting very hot. I've always kept the filters and such clean. Is there any maintenance I am to be doing with the motor?


Hi its Darran at Dyson.From your description of the problem, it sounds as though there is a lack of airflow to the motor which is caused by a blockage in the machine or a dirty filter. To check your machine for a blockage, ple ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I would like to disassemble my "Animal" for a good internal cleaning. Is there info available that will assist me in finding and knowing how to remove the parts that need to be to get at the internals?


Hi kimler55,The user manual of Dyson DC14 Animal Bagless will be a great help for you in disassembling the machine. Please click the link below for the user manua ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

DYSON DC07 ANIMAL VAC: IT SHUTS OFF INTERMITTENTLY, GETTING WORSE SURE ITS AN OVERLOAD PROTECTOR IN MOTOR. HAVE THOROUGHLY CLEANED THE UNIT TO NO AVAIL. HELP ???


The circuit tracks should be getting cut somewhere in between some where so it leeds to this problem. ... Vacuums

My dyson animal works for a while then shuts off...i guess it's getting hot and automatically turning off to keep damage from occuring. i have cleaned the filter and all the collection basket, but am still ahving problems. it was just services a year ago and a new switch installed. please help!!!


The belt that drives the beater bar may be broken or stretched, causing the motor to turn more freely, therefore causing the motor to rev beyond it's design.Jim ... Vacuums

I have a Animal Dyson DC07. While cleaning the filter I laid the vacuum down . Now I can not get it to stand upright


Have a look at the following link:\015\012\015\012http://www.dysonmedic.com/DC04%20Folder/DC04%20upright%20fix.html\015\ ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have a Dyson Animal upright (purple). I took it apart to clean the cyclone chambers. When re-assembling the bottom closed before the opening rod was inserted. I can't get the opening rod installed with the bottom opening closed. How do I open it? Thanks.


I looked in our DC07. I would try removing the top again and getting a long dowel or the opening rod, insert it down into the unit and PUSH. The opening rod opens the latch by pushing it, not pulling it. Here are some pictures of the latch. Top pi ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Animal vac gets dog hair in the HEPSA filter,


No id try call Dyson\015\012Customer Service - 866-693-9766 ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My shark steam mop has stop producing the steam to clean. I only get a little water to come out to wet the cleaning pad. Is it stopped up and if so how do I get the steam and water flow back


Dear Sir/Madam\012\012Good day.\012\012We're Auto-parts manufacturer from China. We are able to supply Axles & Axle tubes , Grease Nipple,Brake hose , Auto Springs, and some other fittings. If you have any requirements about auto- ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Thanks! Awesome tip to get into the gear box. My roomba would start up but would move very sluggishly. Looked up the beep code and it was the brushes. Brushes are cleaned regularly so it was something internal. Did your solution of getting into & cleaning the gear box and viola! He's back!


... Roomba Robotic Floor Bagless Vacuum

How do I get to my Bissell ProHheat 2x 9500 water heater to clean it? I've cleaned the front nozzles but just can't figure out how to get the bottom open so I can reach the heater. Thank you!


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Keep getting message 'please remove and clean Roomba's brushes'. Have removed and cleaned brushes and even fitted new one's but still getting message. Also brushes sometimes rotate, sometimes not and not picking up very well at all. Help!


Must be your inbox is full, Delete old / unwanted messages. It should resolve the problem ... iRobot Roomba 500 Series Virtual Wall Lighthouse 80201 Robotic Vacuum

How to clean the unit? The clear suction part in the front gets filled with fibers and other **** and I don't know how to get it cleaned out without breaking it. Any suggestions?


I use a knife blade or nail file (metal ones you get at any drug store) to get the fibers out. With new carpets it's a mess - have to clean the bottom of the unit as well as the brushes and up inside the area where the brushes are housed. Otherwise ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

When I was putting my new rug shampooer together and the directions said to press the trigger and the clean surge button until I heard a snap, I did just that many times and never did hear a snap so I thought it had likely happened and I didn't hear it so I proceeded to fill the solution tank and get busy but no solution came out so I used the clean surge button instead and got the job done (I think). Can I continue to use it that way or is there a way I can get it to snap and use it the way it


My husband figured it out and it now works great! Thank you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I have a window fan with two fans in it & I cannot get the cover or back off so I can clean it. I* have taken all the screws out that I can get to , but there are two clamps that I can't get off, I'm not sure why the clamps are there but they are on the side with the accordian extention. Please tell me how to get it apart - after 2 years it is really filthy!! Thank you, Janet


Remove all the screws, pry clips off that hold on the extensions, than fan will pull apart. The clips must be pried off. They will not break. Then remove screws holding in the fans and remove them as well. Fairly simple process. ... Vacuums

Dosenot seem to clean the carpets as good as before, we have cleaned the filter and keep the canister cleaned. What else might it be; I bought it for the express purpose to clean animal hair off my carpet?


Hi there,I'm sorry to hear you're having difficulties with your DC17. This machine should have no problem dealing with animal hair, so if it doesn't seem to be picking up as well as usual, this may be due to a blockage. The easiest way to che ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Hello, I have the same model. And though it is three years old, starting from the last month, it does not clean anything anymore. Cannot even pick up one single thing from the floor. Every dirt gets stuck in the hose. I cleaned the hose and cleaned the filters but it still does not pick anything up. Is three years its normal lifetime or do I have the change the filters, instead of cleaning them? Thanks.


I know bissell vacuums are very cheap but they should last more than 3 years. there should be two parts to the dirt cup. remove the dirt cup and above it there should be a round plastic part. unscrew it and check that filter. ... Bissell 6594 PowerForce Bagless Upright Vacuum

I have a Bissell 3920 and the beater bar only turns when I'm pulling the vacuum.How do you get the end caps off of the beater bar to clean it out? This has happened before when it was under warranty and I was told to remove caps and clean frequently.I am afraid prying them off will break the vacuum.It also has very low suction and I have cleaned the filters and the belt is fine.Will cleaning the inside of the beater bar fix my problem?


... Bissell 3920 Cyclonic Pet Hair Eraser Vacuum

Hoover Max Extract LS F6056900 Hand Tool not working / Cleaning Solution I need to know what I need to get in order to have the hand tool work on this model. Also, what cleaning solution is best for pet stains? Tried cleaning, pre-treating with Spot Shot and towel and/or scrub brush, then cleaning, still doesn't work. PLEASE HELP!!


... Vacuums

Need to get to the motor to clean it and cannot get the cover off


... Eureka 6984A Bagged Canister Vacuum

How do I get the end caps off the Dyson 07 animal beater brush


Dc04 is the same ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have a hoover 3000 i have not used in awhile, and since I removed a large rug, I would like to use it again on my slate floor. HOWEVER, I cannot get it to pick up ANY water in the water recovery unit......it is dry, dry, dry. I have put in a new filter, cleaned the nozzle unit, the scrubber , and reconnected both the recovery unit and the water unit several times, but to no avail. I would like to get a graut attachment a well as replacement part, but since I can't get the basic unit to work, I


Have you made sure the plastic filter cover with the round hole in it that covers the filter is in place ( part # 59177096 ). This piece seems to get lost, and without it there is no pick-up. The other common problem is that the wheel assembly has be ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

My Roomba 560 is making a clunking noise when it is on and it keeps stopping saying that I need to clean the brushes. I've thoroughly cleaned the brushes and I've cleaned lint from other small crevices but I'm still getting the error. Any suggestions?


I'm having the same problem with my 560 after a day of use. For me, it's caused by the little yellow spacer that's clipped onto each side of the bristly brush. When the brush assembly is closed, it wedges rather tightly next to that yellow spacer on ... iRobot Roomba 560 Robotic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0561 seconds