Having problems with your Dyson DC07 Animal Bagless Upright Cyclonic Vacuum ?

I vacuum seems not to have any suction; for a while the attachment had suction; now it does not.


Answers :

If you have checked for the obvious clogs and obstructions, be sure the belt is working properly and if necessary, attach a new belt to the unit.\015\012At the same time, clean the beater brush and lubricate the ends between the brush and the hard rubber holders.\015\012
\015\012I would also check the hose for any potential leakage.\015\012
\015\012Paul
Repair Help & Product Troubleshooting for Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dyson vacuum cleaner doesn't seem to have the same suction power it used to. I have cleaned out the canister and have taken apart the vacuum head (for cleaning carpets) and it doesn't seem to be blocked but it seems to lose suction by the time it reaches the head. The suction is strong at the end of the hose (where you attach the telescopic attachment with vacuum head) Any ideas? Thanks, Irene


... Vacuums

My DC07 Animal Bagless Upright Cyclonic Vacuum has a small attachment for vacuuming carpeted stairs. This attachment is currently not spinning its internal brush necessary to pickup the dirt on the stairs. The rest of the vaccum is working fine. The suction cap on this attachment is pulled out, as it should be. I have checked the vacuum over thoroguhly and there are no bloackages anywhere.


Make sure to extend the wand straight up and completely out of the handle and watch that you don't kink the hose. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I was vacuuming and my electrolux 2100 accidentally suctioned the string attached to a balloon. I turned off the vacuum and unwrapped the string from the head of my vacuum. On the hose i have plenty of suction but the head isn't working. i flipped on and off the emergency shutoff switch but it is not working. what happened? what can i do?


... Electrolux UltraLux 2000 Bagged Canister Vacuum

My vacuum has suction with the long tube assembly but not any significant suction down by the rollers. I assume there is a clog or a problem between where the hose attaches to the machine and the rollers but I can't figure out where to look for it. HELP. I've only had this vacuum for a few months and I'm really dissapointed!


Go to the bottom of the machine and to the rhs of the rollers you can see the pipe - also remove hex panel on back and remove hose from elbow , i also found that a filter cx did wonders ... Miele S7210 Bagged Upright Vacuum

Smell/suction I have a Eureka Altima Model 2991 Type AVZ. I have suction when I use the power paw and attachments. I have all hoses clear. My brush is spinning and belt is not broken (I opened it up and checked), but I have no suction when I turn it on to vacuum my living room carpet. I also have a burning smell to go with it after about 30 seconds. I've never had a problem with this vacuum cleaner before.


Ours started smelling too, and it seems that the plastic end on the roller brush was melting. In process of finding rollerbrush for it now ... Eureka 2971AV EZ Kleen Bagless Upright Vacuum

The vacuum has suction but the floor attachment does not. I have cleaned the clogs from the attachments and it still has no suction. What is wrong?


The hose may have one or more leaks or bad connection. The most common place for a large leak is at the connections to the machine and the connection to the handle.\015\012I've seen some reviews that mention little or no suction when using the ... Black & Decker Black Decker Bagless Canister Pet VacVacuum

No I did not my hose on the dirt devil does not have much suction on it I took everything apart and found nothing wrong no clogs anywhere but when I add an attachment to the hose it loses all suction...I looked for a switch to change from regular vacuuming to attachment found nothing why is this??????? Need a manual where can I find some information and a download on line manual??????


Try this. There should be a little filter unerneath the tank. just clean that filter or replace it. (9 times 10) thats the problem.\015\012\015\012good luck. ... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

Dyson dc17 My dc17 has great suction with the attachment but when i try to vacuum my carpet it hardly has any suction. I just bought this on ebay and the seller told me to pull the pole all the way out but it doesn't seem to completely come out. am i doing something wrong? Is the metal pole suppose to come all the way out unless you are using the attachment?


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I was vacuuming with an attachment, the vacuum began to loose suction and the hose collapsed, then the vacuum stopped running. I have turned it off and continue to plug it in off and on, using different plugs. It will not turn back on.


Hi there VacuumGuru for www.vacuumspot.com.au here. You have got yourself a blockage in the hose is all. The reason it wont turn on is because that machine has a thermal cut o ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

No suction My vacuum does not seem to have much suction when in use. The agitator brush is rotating but I'm not able to get much off the carpet. The suction is fine when I use the attached wand.


If the belt is stretched, then it can't turn the brush rol under load, if you haven't chenged it in the last 6 months, then I would put a new one one. Also check the dirt inlet by the brush roll for a blockage. ... Riccar 8955 Upright Vacuum

Tristar vacuum, power head carpet attachment very little suction


... Vacuums

I had to empty the canister and when I put it back on and turned on the vacuum, the suction does not turn on. The brushes are rolling and the attachment suction works fine. Any suggestions?


... Eureka 431A Optima Bagless Upright Vacuum

I own a Eureka Whirlwind Life Speed 12 amps 15" wide. I have suction thru the attachments but no suction from the main vacuum.


... Eureka Whirlwind Litespeed 5840 Bagless Upright Cyclonic Vacuum

I vacuum seems not to have any suction; for a while the attachment had suction; now it does not.


If you have checked for the obvious clogs and obstructions, be sure the belt is working properly and if necessary, attach a new belt to the unit.\015\012At the same time, clean the beater brush and lubricate the ends between the brush and the hard ru ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My vacuum does not have suction power through the beater bar attachment. It feels as if it is "blowing" out of the bottom of the filter basket, but no suction power.


... Dyson Ball DC24 Bagless Upright Vacuum

My filter queen just had the motor rebuilt last year and was basically a brand new unit when I got it back. It is not picking anything up now when I vacuum. The beater bar on the carpet attachment is turning fine and when I take all the attachments off the hose I can feel the suction being created like it should be picking up debris just fine. I have emptied the canister even when it did not have much in it; however, it still will not pick anything up off the carpet. It picks up debris tempo


It sounds as if you have a clog inside the "Power Nozzel". They mention that there are "no user serviceable parts within the Majestic® Power Nozzle" My advice would be to see if you can see a clog with in reachable distance and try to remove the ... Filter Queen Vacuums

Have a Centralux Aerus about 5 years old. Don't see a model number. There is suction but beater brush quit working. Was using for a few minutes, shut it off for a few minutes, turned it back on and suction only. Tried the reset button also. Tried the sidekick attachment and it works fine. There was no smell like something was hot. Belt is fine. Are there any fuses or anything else to try? This vacuum cleaner has not really been used that much, it is hard to believe the motor would need replaced


There probably is a loose wire in the handle near the switch or a wire off near the swivel elbow near the vac power head. With the right fastener tool to remove some screws you can fix it yourself ... Electrolux Centralux Vacuum

My brand new Hoover upright vacuum cleaner, model Hoover Tempo Widepath U5140-900 delivers no suction from the hose attachment. I have attached it exactly as illustrated in the manual. Any help is much appreciated! R. Gardner


Sometimes there is a physical switch to move the air ducts that connect to the suction motor. I'm not sure about your model, but here's what I would do. First, read the manual and instructions thoroughly, to see if there's some switch to activat ... Hoover Vacuums

I have a Dirt Devil MVP and it has no suction, I have checked all the hoses and they are NOT clogged, There is no suction at the 1st hose attachment at the base of the vacuum


... Dirt Devil SwivelGlide Bagged Upright Vacuum

My Kirby vacuum lost most of its suction. .. The hose attachment is clear, the brush attachment the same.


... Kirby G6 Bagged Upright Vacuum

I have an electrolux renaisence vacuum. the brush in the floor attachment turns but I have no suction. When I change to bare floor option on the handle the brush stops turning (correct) but I still have no suction. The lights on the handle showing --floor,carpet, high and low all work.


Sounds like you have a clog, either in the hose or the inlet by the brush roll. ... Vacuums

My Bissell cleanview is NOT suctioning well, all filters, nozzles, attachements, canisters and belts are clean and in good repair. We've pretty much made sure everything that I can get to without completely dismantling the vacuum is super clean and/or new... still poor suction


Did u check the filter above the dirt cup?\015\012\015\012twist the yellow piece and wash the filter ... Bissell 3594 CleanView PowerTrak Bagless Upright Vacuum

When I disconnect the hose attachment from the vacuum to use it, the dust shoots up from the hole. Where is there something to make the hose have suction instead of the base of the vacuum?


Da house is stop up ... Vacuums

Suction problems My Hoover elite vacuum (which is less than a year old) is not sucking up properly. Also, when I detach the tube that goes to the vacuum cleaner so I can add my attachments, it blows OUT dirt through that opening. HELP!


Sounds like a clog right near the front ... Hoover Elite U5061-900 Bagged Upright Vacuum

My eureka vacuum model 4341 has no suction. The belt still turns the beater bar and the power still turns on but there is no suction both underneath and when using the attachment.


... Eureka 4341 Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0642 seconds