Having problems with your Dyson DC07 Animal Bagless Upright Cyclonic Vacuum ?

Stopped working, burning smell

\015 When switched on Dyson stopped working and there was a burning smell. Tried again and the smell worsened: not wanting to perhaps cause any more damage....\015

Answers :

Repair Help & Product Troubleshooting for Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Vitamix 5000 stopped working. It stops working each time I use it; while blending I first smell a burning smell and then blender stops and will not start again. After sitting overnight it works again next morning and repeat same process. Any ideas how to repair?

It has an internal thermal shutdown. Let it sit for a while and it will reset itself. You can expedite by putting the motor base in the freezer for a few minutes, or by blowing a hair dryer into the base of the motor. ... Vacuums

The brush roller stops turning and I can smell the belt burning, then it will catch and start working normal. I looked under the plate to check the belts and they looked okay and no hang ups of string or anything. The only thing that seemed weird was that the smaller belt that actually attaches and turns the roller is a bit loose. The larger belt is tight but looks like its the one that is burning and causing the smell.

Better to replace both belts the smaller one is stretched out thats whyits slipping ,be sure to clean the old rubber off the motor shaft before replacing the belts.it will cause the new belts to run unevevly and go bad before their time ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Stopped working Was working fine then it smelled like burning rubber, not the belt I checked. It sounds like the motor wants to run then it just stopped but the light is on. What do you think, go by a new one?? This has been a great vacuum cleaner and I can not seem to find a Sharp anywere. Thanks for your time.

Well it could be the motor, if it is it would cost around $80 or so for a motor. May be better to buy new, thre are a number of good brands out there. ... Sharp Twin Energy EC-12TWT4 Bagged Upright Vacuum

My hoover 2000w pets cyclonic stopped working, there is a burn smell coming out off it

... Hoover Vacuums

Stopped working, burning smell

... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My Miele Cat and Dog has stopped working. There was a slight burning smell and then it switched off completely. Also, the bag was a bit wet, so have replaced with a fresh one but still not working. Help!

... Miele Cat & Dog 326i Bagged Canister Vacuum

I have the Kenmore Model 116.36722600 Vacuum; while cleaning the carpets the vacuum all of the sudden stop working; I didn't smell anything burning; it was almost like someone unplugged it. I checked the rollers and I can move it forward and backwards with no problem. Do you think the motor just burned out? Does this vacuum have a fuse that I can reuse? I love this vacuum and would hate to toss it. thank you

... Vacuums

I was in the midst of vacuuming with my Dyson Animal when it stopped working. It smelled as though part of the motor burned up (there was hair and string wrapped around the brush so I stopped to remove it). Any ideas on an easy, quick, and inexpensive fix? Thank you!

Hi there,For guidance on clearing any remaining threads or hair from around the brushbar and resetting the machine, please follow the steps shown in the video below. Please note, the brushbar will never rotate when your machine is upright, so ... Vacuums

Dyson DC05 buring smell and stopped working. On quick inspection, tiny bits of copper wire inside air filter case. Motor windings possibly burned-out?

Scrapped it! ... Vacuums

My dyson has stopped working. There was a burning smell and then a strange noise and now it wont even switch on.

The Motor sounds like it has gone bad. Bagless machines like these always have motor problem. If it is under warranty then it will need to be shipped to Buffalo New York. I would trade in in on a Riccar vacuum. You can get 20 years out of those f ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

On turning on different noise then noticed smell of burning then just stopped working and no power since. DC 07 Dyson.

Unfortunately your motor had burnt up..most times this is due to not cleaning or replacing the filters...the filters get dirty and the motor gets no airflow to cool it....very common on dyson vacs ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Same here... I have a DC-15 Animal, it was making a clogged type noise and before I had time to react, it stopped working and I smelled burning rubber. I also noticed that the ball was really hot. It's too late to call support, but I intend on doing so in the morning. I've only had my Dyson for a year, so I'm sure it's covered, however, I have no idea where my receipt is. Did they take care of your issue?

You sucked up something that stopped the brush from turning. This made the belt slip causing a burning smell. ... Dyson DC14 Bagless Upright Cyclonic Vacuum


If it still powers on then check the belt. ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Dusty smoking smell, stops working, trips out power in house.

... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

We have a DC14 burning smell then not working

I am afraid that is ur motor that has blown this can be easily repaired by dyson ring the no. on the vac full service and repair only £60 ... Dyson DC14 Bagless Upright Cyclonic Vacuum

Vax rapide classic burning stopped working

... Vacuums

Burning smell There is a burning smell when I run my Kirby Ultimate G.  The smell seems to be coming from the belt.  I looked at the brushes and they are spinning so the belt is working.  the Post on the vacuum is getting very hot not sure if that is normal.  What is causing this?

Unlock the sweeper brushes and take them out. on each end is a cup bearing and should be free of debris.then check around and under the belt and likely there is debris wrapped around it.the post is getting hot as your pulling too much of ... Kirby Ultimate G Bagged Upright Vacuum

Burned smell hi, I have used my hoover 4 times and is starting to smell as something burned, I checked the troobleshouting part of the owner manual and it says that check the belt, I already did that and everything is ok I used the hoover again and still smelling bad and start to work very slow I better shut off it.. what could I do??

If the motor slowed down this would indicate a bad motor. not cost effective on this model to replace unless under warranty. it is not uncommon these days to see a motor go bad every now and then.\015\012\015\012What are the first 4 digit ... Hoover U5507900 Elite Rewind Bagless Upright Vacuum

Stopped working The cleaner stopped working when my wife was using it there was a noise like a 'phut' and it stopped. There is evidence of some smoke damage inside but I can't find any evidence of burning. Any ideas please?

This is a problem with your carbon brushes, remove old brushes, and check they have not become jammed in there brass sleaves, they are spring loaded.If they are not jammed but less than 20mm new brushes are required, available from most good vacu ... Numatics Numatic Harry Canister Vacuum

Hello can you help me please? I have a Kirby G4 vacuum cleaner, It did work ok until it started to give off burning smell and lots of sparks from the brushes. I have changed these brushes, the motor still rotates but it still gives off sparks and burning smell. Do i have to change the motor as well? Can you help please? Thankyou Martin

Some debris, even sand or dirt, probably got into the motor, causing damage to the armature. If this is the case, you will need to replace the motor. The burning smell from the motor is generally a sure sign of a bad motor. ... Kirby G4 Bagged Upright Vacuum

I just bought the LG200R vacuum. It is working wonderfully but i have only had it a week. I have already had to clean the agitator but this is due to my extremely long hair and apparently i shed a lot. I was wondering if i should be alarmed by the funny smell it leaves in the air. Its not like a burning rubber smell but more like a fresh plastic smell or sorta chemical like smell (hard to describe) and it doesn't need to be on to make this smell it seems to be permeating off the vacuum itself

... LG LUV200R Bagless Upright Vacuum

Kenmore progressive model 38812790 smelled like rubber burning then the brushes stopped turning. Does it have a belt, if so, how do I get to broken belt to replace?

... Kenmore Vacuums

There has been a burning smell for some time, but we continued to use it as everything was in working order. Sometimes the smell was not even noticeable. Today, however, the smell was intense and the motor kicked off. As it did, it was draining electricity like crazy. The lights dimmed drastically.

It sounds to me like the brushes in the motor are worn out or the motor has gotten water in it (if you have been using it for wet pick-up). The way you described the situation, I am really surprized if it did not trip the circuit breaker for the cir ... Rainbow E series Canister Wet/Dry Vacuum

I have a kenmore grab n go bagless and I need to know the exact size of the belt, I lost the manual, and I have burn several belts at the bigining of the problem the motor stops and burn the belts I open it and I think it was a little piece of plastic, that cause the problem, but when I put the new belt it looks like the motor works fine,but still burn the belt, I'm using UB-1 #5275 belt am I using the wrong one?

... Kenmore 34722 Grab-N-Go Upright Vacuum

Sewing machine Guru needed ;) Elna Grasshopper (new to me) circa 1950 The light works, but there was no hummm when knee pedal engaged. I have the motor out, and it is very stiff to turn. I'm at a total loss when it comes to motors and electricity. It doesn't smell burned, doesn't smell at all beyond normal machine smells. (Yes, I made detailed notes and diagrams as I took said motor out!) One other note. The long thing which my husband said might be a capacitor -- it looks like

I just purchased a fairly tidy Elna 'Grasshopper' sewing machine (1951) with the same leaking capacitor problem. I carefully removed the capacitor for examination. It is actually three capacitors in one - no chance of a direct modern replacement, but ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0456 seconds