Having problems with your Dyson DC07 Animal Bagless Upright Cyclonic Vacuum ?

My Dyson DC07 just stopped running during operation

\015 After noticing it had poor suction I cleaned the filter. I began vacuming again and it totally stopped running altogether. No sound at all.\015

Answers :

It's most likely got a blockage in the pipes this video will show you where to look..
http://www.youtube.com/watch?v=mwcLnjpn9Tg&feature=endscreen
Hi there, it's Jack at Dyson.

Our machines are designed to shut off if they begin to overheat, and it sounds like that's what may have happened. This could be due to a blockage, or because the filter needs a wash. To resolve this, please follow the steps shown in our online Support guide:

http://content.dyson.com/support/help.asp?article=51&product=DC07-SY-HEPA_US

I hope this helps, but if you'd like any further assistance, please give our Helpline a call so one of our advisors can run through some troubleshooting checks with you. Our UK Helpline number is 0800 298 0298. If you're based in the US, the number is 1-866-693-9766.

Best wishes,

Jack
Dyson Online Customer Support
Repair Help & Product Troubleshooting for Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Dyson DC07 just stopped running during operation


It's most likely got a blockage in the pipes this video will show you where to look..http://www.youtube.com/watch?v=mwcLnjpn9Tg&feature=endscreen ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My Dyson DC07 vacuum started to run slower after being on for a little while and then would run normally again. I have switched on today and it has just stopped. When I push the start button, on occasions it almost starts and then doesn't. I am wondering if there is a problem with the switch and if so how can it be fixed? Thankyou.


The motor running slower was the motor starting to burn out. The "almost start" is the brushes making intermittent contact with the armature in the motor. \015\012\015\012Your machine needs a new motor Pam. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My dyson animal is hard to push on carpet - the beater bar is still operational. When I turn off the beater bar and run the vacuum on hardwood the beater bar stops moving, but it still ''rolls'' on the hardwood - it doesn't pull up like it used to. It also seems to not be picking up as well as it used to, although no blockages are present and the filter is clean.


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Stopped running. won't turn on - Dyson DC07 Allergy Blue/Turquoise Bagless Upright Cyclonic Vacuum


Check power cord or replaced Powercord Assy part no : 905449-04\015\012check power switch or replaced power switch part no : 910971-01 ... Dyson DC07 Allergy Blue/Turquoise Bagless Upright Cyclonic Vacuum

In my (almost new) Dyson DC31 Animal the rolling brush tends to stop like the bearing was kind of difficult to turn. I opened the side carter and removed the little belt. Without the belt the engine runs regularly. I cleaned the little knots of hairs trapped in the bearing but still the brush runs for a while then stops, tries for a bit then stops again. I even tryed putting a bit of synthetic lubricant with apparently no result. Could it be a defective bearing? Thanks for your help.


... Dyson DC31 Animal Bagless Handheld Cyclonic Vacuum

Kenmore Progressive canister model 116.27514700 Problem: Vacuum motor won't turn on. The power head operates, but nothing from the vacuum. Have checked all areas of airflow: hose, bag, motor filter and hepa filter. All are fine. Have checked and rechecked all electrical connections, all seem to be in working order. Vacuum hasn't run for a week or so, so it's not the thermal protector, unless it's defective. Vacuum was running fine last week. Didn't stop operating when using. Went to v


Hello! The culprit is the PCB Assembly; Part # KC86WBZR3000...Cost is $6.99. I would remove and inspect for burnt components, or broken wires...Then clean connections both male/female using an eraser, toothbrush and alcohol...Using a bright ... Vacuums

Flashing green light on dyson hand held stopped running


... Dyson DC35 Handheld Vacuum

Dyson stopped working - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dyson dc16 stops running - Dyson DC16 Bagless Handheld Cyclonic Vacuum


... Dyson DC16 Bagless Handheld Cyclonic Vacuum

Dyson My Dyson DC04 runs for a second or two then stops. I have checked the motor. The brushes are good but the commutator is a slightly pitted.Do I need a new motor?


Hi.\015\012\015\012Check mains lead where it enters machine very common for internal fracture.\015\012\015\012To prove this try waggling lead with machine switched on if it starts & stops this is the fault.\015\012 ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

My Dyson Root 6 made a loud banging sound, and now its motor emits a strong burning smell every time it's switched on. It runs for a second or two, making a lot of noise, and then stops. (Just bought a new battery for it, too - what a drag...) It's off warranty, and Dyson wants almost as much to fix it as a new one would cost. Is my Root 6 e-waste, or is there anything that can be done for it?


... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

My beater bar will run for a few seconds then stop on my dyson dc28


... Dyson DC28 Animal Bagless Upright Vacuum

My dyson animal sweeper just stopped running


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My dyson DC07 has no suction. motor runs, brush spins, just no suction.


Hi..the reason to this problem may be the bottom pieces \015\012might not have been fully seated.Take it apart and put it \015\012carefully back together.This will solve the issue.\015\012check it out..\015\012thank u..\ ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dyson dc07 will not tilted into operate position. It feels like soemthing is keeping it from tilting. Any help would be great


Hi.\015\012\015\012Your problem will be with the manifold on the front left hand side this is the part that slides back & forth as you pull handle back & up.\015\012\015\012remove instection port from the manifold. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

DC07 stops after short time using and will not start until it has rested for a while. Is it running out of steam like it's owner?


You could try washing the blue filter. This happened to mine and when I washed the filter according to instructions I found on the Dyson website it was fine! ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson dc07 suction when upright but no suction when tilted in operate position


I had the same issue and solved it easily.My experience is the same as the March 6th response/ When you push your foot onto\015\012the base and then recline the handle, use your toe to gently push the\015\012very front of the base down closer to the ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson DC07 switched off whilst hoovering, It would not turn on, 1st it stopped rotating brush and than tuned off completly.. I tried ttoi change the fuse but still not turn on. Motor not runnung either.


Hi its Darran at Dyson.Our machines are fitted with a thermal cutout switch. This will activate if the motor on your machine becomes too hot. This is caused by a lack of airflow to the motor, which is caused by a dirty filter or a blockag ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My dyson just stopped running while vacuuming with wand


You probably got a blockage in your wand which caused it to overheat and cut out. Check for blockages, use a brush stale down the tube to dislodge anything. Next, check your filters, refer to the tutorials here: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My Riccar 8850 stopped running. Changed the bag and cleared all hoses. Light comes on but the motor doesn't operate. I can turn the brush freely by hand.


Greetings from GoVacuum,\015\012\015\012If the light on your Riccar 8850 is coming on, but the motor is not coming on, this indicates that your motor has gone bad. There is a reset switch on the back of the vacuum cleaner that sometimes ... Riccar 8850 Vacuum

The beater bar on my Dyson won't turn. The vacuum runs and suctions but the bar won't turn and the belt is not broke. The beater bar did get a carpet fiber caught and wrapped around it which stopped the bar and I removed the bar to cut the fiber loose and replaced it and now it won't turn


The belt doesn't have to be broken to make the vacuum not work correctly. If the belt is stretched the vacuum won't operate the way it is supposed to. You can get replacement Dyson Belts here: ... Vacuums

Brushes won't turn but vacume runs - Dyson DC07 Bagless Upright Cyclonic Vacuum


I suggest you check the drive belt, located under a cover on the bottom of the unit. It may appear to be good (tight and not worn) but 9 times out of 10 that is the problem. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

No power Our dyson DC07 was working fine, then we pushed the button to turn it on. It started to run then shut off and now it is like the power is no longer there. I have checked outlets and they all work. Is there a fuse of some kind in this unit?? If so, how would I get to it?


The motor will have a thermal cut out,however chech your plug fuse and the cable as it enters into the off on switch. its known to snap here within insulation..... ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Powerhead won't run - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum


Hi its Darran at Dyson.So that we can help you further with this problem, please contact our Helpline on 0800 298 0298 (UK) or 1866MYDYSON (US). www.dyson.comMany thanksDarran Dyson Customer Service ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Have a sour odor when the vaccum is running. What could be the problem? Best way to describe the smell is that is smells like dirty feet. I have the dyson dc07 Pink


Either something you have pulled into the vacuum or perhaps the drive belt is not turning the beater brush.\015\012Remove the beater brush and clean as best you can paying particular attention to the end pieces. If possible, squirt a bit of WD40 bet ... Dyson DC07 Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0833 seconds