Having problems with your Dyson DC07 Animal Bagless Upright Cyclonic Vacuum ?

DC28 Clutch DC 28 Clutch made knocking noise after about 1 hr of use. Tried to take it apart and see it it had an obstruction but burned up the belt and damaged clutch. Yes, I know I should heave taken to the dealer or warranty service but thought it was something simple. Nothing inside is simple on a Dyson! Can the clutch be replaced and from what vendor?


Answers :

Repair Help & Product Troubleshooting for Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

DC28 Clutch DC 28 Clutch made knocking noise after about 1 hr of use. Tried to take it apart and see it it had an obstruction but burned up the belt and damaged clutch. Yes, I know I should heave taken to the dealer or warranty service but thought it was something simple. Nothing inside is simple on a Dyson! Can the clutch be replaced and from what vendor?


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My Dyson DC07 has recently been service and was making a clattering noise and very hard to push. We have taken it back and he has changed the clutch mechanism under the base which has solved the clattering, but it is still really hard to push because of the suction. It is even lifting the carpet in one room. Can you tell me what the possible reasons for this could be? One thought we had was that the little rubber wheels on the bottom cover could have worn so the hoover is closer to the floor


On the sole plate you should have 5 little wheels, these are prone to jamming after a while. You should make sure these are not jammed in anyway.\012\012You can release these with a screwdriver, but be careful not to prize too hard as you ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My older Dyson DC14 (the purple one) early model with a clutch on the beater bar belt needs a clutch replacement. The bar has been cleaned and there are no worn or damaged parts so I conclude that the clutch at the motor end of the belt needs to be replaced. I can find the part online but no instructions on how to disassemble the vacuum to get to and replace it. Dysons only advice is to give me the address and phone of the nearest service center. Can you help me?


Have a look at www.dysonmedic.com which has some very useful info on dismantling and repairing Dysons.\015\012\015\012Although this site doesnt actually cover the DC1 ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Oil leaks from my Cuisinart (past warranty) stand mixer SM-55 accessory power port. Can oil be added? Is there a repair part? Cuisinart customer service says that only Cuisinart repair service is capable of repairing the mixer.


Hi,Cuisinart are over packed with oil\015\012 If the motor sits idle, the oil may begin \015\012to drip from the gears and settle. Oil leakage may primarily be seen \015\012from around the beater shaft or p ... Vacuums

My VX550CC also shuts down after about 15-20 minutes. My problem is that I can't find my sales receipt. Nutone told me after contacting them several times that they will not honor their warranty unless I can produce the original sales receipt only. Tech assist person was very rude about whether I actually bought it myself. We bought this unit when we moved into a new house 4 years ago and can't find the slip anywhere. Totally bad customer service and they won't honor their warranty even for a p


Some People Hu...........Make sure that all filters are clean if need be renew..Sounds like overheating fault resulting in Thermal cut out operating....Good luck ... Broan-NuTone VX475 Bagged Central System Vacuum

My Hoover Windtunnel Ultra U6425-900 began shutting off after a few minutes of vacuuming. The time interval became shorter and shorter. If I leave it sit a while, it will start again. This does not happen when I used the attachments - only with the floor brushes. The switch has recently been replaced and the whole vacuum serviced by a Hoover dealer about a year ago. I have been told by a local repair shop(not a Hoover dealer) that it is the motor, there is nothing to do other than replace t


... Hoover Vacuums

Dyson Refuses to Honor Warranty


Hi.\015\012\015\012I have been repairing Dyson machines since they first came out.\015\012DO NOT PAY FOR A NEW CLUTCH.\015\012I can assure you that both clutch belts can be replaced.\015\012Its A tricky job & can take some time to do.\015\012Its more ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I recently put a call into dyson regarding a problem with my vaccuum and a supervisor was supposed to get back to me. no one has. back in august, we were on the phone with a technician regarding a problem with out machine. after trying a list of things, she said to take it to american vaccuum services and it would be covered by dyson. when i did, the man told me it was clogged and i would owe $45. i would not have taken it for that price! please advise as now i am stuck. i want my vaccuum and th


Unless you can Dyson to intervene and have this repair covered under their warranty, You are stuck to pay for the service. Clogs may not be covered under warranty, but I don't know how their warranty states. If it says that if you have a problem, t ... Vacuums

We bought our Kirby less than 5 years ago and lately are not happy with it....it keeps breaking. The warranty has expired and our biggest complaint is that it has lost it's suction power. All the contents stay in the hose when I vacuum out the car or upholstery and it does vacuum well at all. The Kirby store quoted us over $200 to fix/ service it. Apparently this is not covered in the free yearly maintenance which we just had done. Any suggestions?


\012 Hi there,\012Well I do have a suggestion though you may not like it use it as a boat anchor.....no no I am just kidding. I have sold vacuums for 20 years and Kirby has b ... Kirby Ultimate G Bagged Upright Vacuum

My filter queen needs servicing where is the closest dealer to new orleans


Go to this link: http://thevacuumcenter.com/filter-queen-c-151.html?gclid=CKLSuMHPhKQCFUf75wodWRDMHQ and call the numbe ... Filter Queen Majestic Canister Vacuum

I have a Bernina 153 QE Virtuosa. The bobbin carriage is noisy. When I notice that it is suddenly sounding smoother, I can be sure it has run out of bobbin thread. I have taken it in to my dealer for several regular checkups, but they don't even want to acknowledge the fact that it is noisier than it should be.


... Vacuums

Started taking vacuflo turbocat (turbine powerhead) of my vacuflo central vac. apart to service it...have taken out all the screws ..got it part of the bottom loose but it is still caught on something and I can not find what is holding it!.... nor can I put it back together! HELP


... Vacuums

I have a Hoover, Steam spin scrub, Model F5897-900. Only used it a couple times and the motor gave out. First started being noisy then a bad smell. It did seem noisier that what I would expect from the start but I didn't realize it was a problem with the shaft of the motor. I took it apart and found the motor shaft wasn't true and causing sparks. The motor looks like it can not be taken apart and repaired. This seems like a default from the beginning but it is past warranty. Also noti


You will have to replace the motor and the hose asm. thehooverstore.com may be able to help, or you should be able to find a repair shop that can order them for you. ... Vacuums

Panasonic MC-V5258 Upright has been turning off after about 5 minutes of use for several months. It has been taken into the shop where it was bought at least one time and evidently it wasn't fixed. I think the warranty is out. I paid $438.00 for it! Linda in San Antonio Texas


Lind a, I don't recall if this unit has an overheat sensor. Try it again and if it shuts off see if the vac feels very hot, but do not touch the switch, leave it in the on position, to cool down. When a vac overheats it will generally restart on its ... Vacuums

HI, I HAVE ELECTROLUX LE(similar to 2000). I HAVE TAKEN IT APART, CLEANED IT, AND PUT BACK TOGETHER. IT SEEMS I GOT THE WIRING WRONG. CAN ANYONE GIVE ME A SIMPLE WIRING DIAGRAM FOR THIS VAC? THIS MODEL HAS NO CONTROL KNOB. IT'S NOT COMPICATED BUT I MUST HAVE CROSSED SOMETHING BECAUSE IT SHORTS OUT NOW. HAVE CHECKED ALMOST EVERYTHING ELSE. THANKS.


... Electrolux UltraLux 2000 Bagged Canister Vacuum

Loud noise when engaged for carpet cleaning. I believe it needs a new clutch? Is this under warranty?


Yes it is if your unit is under 1 year or your mite be lucky and it mite the 2 years on it  ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Pfaff 2140 Getting an error code that reads: error in read parameters, and if this error occurs several times contact your dealer. -then you have to hold a crosshair on the screen push the scissor trim button and reverse button to get back to the main menu. I just had it in for service a month or so ago...?so there should not be any major issues, what does this error code refer to?


... Vacuums

Hoover Model U8185-900 beater bar part keeps smoking and burning up We've replaced the part Hoover PCB Display Bridge U8172 three times and the vac beater bar works for about a minute then the part starts to smoke and burns out again. I've taken everything apart but cannot locate anything that would cause this part to burn up. I think if I did not disconnet immediately, he vac would catch my rug on fire. Help? I didn't send back the warranty card, so I can't get any help from Hoover. Any suggest


I'm not sure why this is happening. Perhaps if you would contact Hoover and explain the problem to them such that it appears that there is a safety issue with their product, they might be more cooperative. If that fails, I have had luck writing let ... Hoover U8185-900 Upright Vacuum

Have DC07 that won't come on. Wife said this started happening a few weeks ago. Would come on and then other times would not come on. Now will not come on at all. Believe I have a lose wire. Have taken off star screw by on off switch, but cannot find how to get plastic parts apart to get into electrical connections. How do I do this? I am sure I am missing something simple?


... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a WindTunnel Hoover vacuumn that is less than 1 year old. The on-off switch is worn out and the carpet height adjuster does not connect. Where is my closest service center? (So I can use my warranty) My zipcode is 58203. My phone number is: 1-201-791-3492. My email address is: [email protected] Of course, I need help as soon as possible. Thank you, Audrey Cooper


According to Hoover's web site the closest service center is \015\012\015\012\015\012\015\012MJB MAYTAG HOME APPL CENTER \015\012418 BELTRAMI AVE NWBEMIDJI MN 56601 218-751-2420\015\012which appears to be over 100 miles from you. I have ... Hoover Vacuums

Vacuum faulty power PCB, Need service manual/schematic


No schematic found. The Q1 transistor is a 2N3904, D3 was replaced with a 1N4000 series.\015\012Root cause still Unknown, but Q1 is an exact match and D3 is an acceptible replacement.\015\012Hoovers solution is to replace the whole PCB no ... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

Riccar 8850 Vacuum - Need parts diagram or SERVICE manual


... Vacuums

Service code 1


A red 1 is a pump malfuntion ... iRobot 5800 Scooba Vacuum

I have a dyson dc07 with a malfuncitoning clutch diagnosed here on fixya. I've replaced the clutch and the grinding noise when the clutch is engaged for carpet and non rotating brush problem presists. This is after replacement of the clutch with a new part. Install of the new part went well and there are no otehr apparent problems with the unit. Ideas? The unit is only a couple years old and not used that much on carpet. For an expensive vacuum I'm not that impressed with it at this point.


Greetings from GoVacuum,\015\012\015\012If you have replaced the clutch already, then this can really only be one other problem, and that is the roller brush. If the roller brush's bearing have locked up, and the brush is no longer spinn ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Clutch? How do I know if my DC14 has a clutch? Older unit, 8 yrs. Replacement belts offered choice between clutch or non clutch.


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0334 seconds