Having problems with your Dyson DC07 Bagless Upright Cyclonic Vacuum ?

Dyson dc rollerbrush is very weak

\015 Ok, the dyson hasn't been working very well for a little while, but I've dealt with it,, no i've figured the problem out. The roller brushes spin rapidly but I can stopped them easily with my hand,, this would be why it's not picking up anything, beacause as soon as they hit carpet they basically stop.. what is the solution?\015\012when I take the plate off the belt seems to be very tight.\015

Answers :

Hi.
\015\012
\015\012Can you follow the belt to where it goes around motor shaft or does it disapear through a hole in the casing ?
\015\012
\015\012If it does disapear then your machine has A clutch.
\015\012The clutched Dyson machines have 2 belts One is motor to clutch the 2nd is clutch to brush roller agitator.
\015\012
\015\012You will need to replace 0ne or both belts if you have the clutched machine.
\015\012
\015\012Now if you can see the belt going around the motor shaft you havent got the clutched type just replace this belt regardles of if you think its ok.
\015\012
\015\012If you need further help please look at this site has manuals.
\015\012
\015\012http://dysondc07.topcities.com
\015\012
Try taking the plate off again and make sure the roller is in it's proper slot. mine did the same thing when I took the plate off to clean hair and the roller came out of the slot on one side. it has to fit perfectly.
Repair Help & Product Troubleshooting for Dyson DC07 Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Poor Suction Heya! So I just picked up a used Dyson, but when I vacuum with it, the suction is pretty weak and it spits all kinds of stuff out the back and into my feet. When I pull the hose I have good suction, but in regular mode it hardly picks up anything. The brushes are spinning, and it eventually will clean an area if I go over it again and again. Maybe a clog somewhere? Please tell me that Dysons have better suction than my $50 Dirt Devil! Thanks!


I recently bought a second hand Dyson DC07. Its suction was poor. I removed all the un-clipable pipe bits and to remove any blockage but it all looked clear. The Final Sponge and hepper filter did have a lot of dust in it and the rotating brush was f ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson dc rollerbrush is very weak


Hi.\015\012\015\012Can you follow the belt to where it goes around motor shaft or does it disapear through a hole in the casing ?\015\012\015\012If it does disapear then your machine has A clutch.\015\012The clutched Dys ... Dyson DC07 Bagless Upright Cyclonic Vacuum

What is causing weak suction on my new Dyson DC24 animal vacuumed?


... Dyson DC24 Animal Bagless Upright Vacuum

Very weak suction despite clean filter etc - Dyson Stowaway DC23 Bagless Canister Cyclonic Vacuum


... Dyson Stowaway DC23 Bagless Canister Cyclonic Vacuum

My dc16 dyson root vacuum stopped working abruptly with no indication of a weak battery, the charger does not show a charge on battery. usually the vacuum slowed before it stopped with a dead battery, any suggestions


... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

DC08 Dyson bagless VC suction very weak any ideas to the solution


You have pet hair blockage in the hose line or in the piping to the bag or right at the bag entry its very common,remove the hose if possible and look thru it and see if theres blockage,then dismantle any of the unit going to the collection bag as mu ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

Dyson DC07: When I first got this vacuum, it was so powerful that it lifted my area rugs off the floor. It is so weak it barely works. I have removed and cleaned the filter, but I can?t seem to improve the suction. What am I doing wrong? How do I fix it?


Hello,\015\012\015\012If your vacuum runs but still leaves dirt behind, the culprit could be the drive belt or an obstruction. If the agitator brush slips or won't turn, the belt is bad and needs to be replaced. If suction is weak when yo ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Poor Suction My Dyson DC17 is having very weak suction. I have checked the areas that I can easily access and can't find a clog. What could be causing this?


The flexible hose between the beater bar housing and the connection to the dust bin might have come loose or has a hole in it. Check this hose for your low suction problem. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

The Dyson DC21 power head keeps tripping out. The carpets in the house are medium to low pile. It even trips out over hard surfaces. Could it be the resistor in the power head is to weak or faulty.


... Dyson DC21 Bagless Canister Cyclonic Vacuum

Weak suction on dyson dc05. The suction is not as good as usual


Hi its Darran at Dyson. Try washing your pre filter and checking the machine through for a blockage. These are the most likely causes. A full blockage procedure and filter washing instructions can be found at www.dyson.co.uk/ ... Dyson DC05 Bagless Canister Cyclonic Vacuum

My dyson doesn't pick up strong and I can feel dirt being thrown


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Dyson suction has lost power


You might try this for free:\015\012\015\012http://www.ehow.com/how_5870417_modify-dyson-prefilter-suction.html ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

My dyson seems to have lost its suction therefore is not picking up anything yet i have found that when my dyson is standing upright it has a little more suction but nothing like how it use to work. This has only happend in the last 2 weeks. I sanded a floor & though the sander picked up majority of the dust i did use the dyson to pick up the excess and it is since then that my dyson has not been working to its full potential.


Hi there,\015\012\015\012Sorry to hear you're having a problem with your DC07. You should be able to resolve the issue by following these simple steps: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I need to replace the brushbaron my DC17 Animal model Dyson. It's almost four years old. I can't find the correct part number on the Dyson Website and I can't seem to find a Dyson repair center in Albuquerque, NM. What are my alternatives? If I can't service this machine without returning it to Dyson, I won't ever buy another one.


Hi,\015\012\015\012The original Dyson part number for the brush bar (often called brush roll) is: 911961-01\015\012\015\012If you type the above part number into Google Products (click link below) you will get a list of suppli ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

This is embarassing, but I have just looked at the Dyson DC07 manual and at my Dyson for about 20 minutes, and I can't for the life of me find the wand release button on my actual Dyson.....the manual pictures don't look like the parts on my Dyson....I don't have a hose with a wand release button....the hose just goes straight up inside the handle....Can someone help me? Thanks :)


Hi the wand release button is located directly above the the Cylinder release button. The wand release button looks like the picture below. In order to releease the wand you must firstly make sure the Electrical cable is not wrapped up for storage. S ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson won't vacuum after sucking up water


... Dyson DC28 Animal Bagless Upright Vacuum

I have an animal dyson. The front nose dives into the carpet when moving the dyson in the forward motion, fine when pulling back. A huge amount of effort is required to move it forward. Took it to a technician and he said he could find nothing wrong. He had only short nap carpet for test. Works fine on short nap, if the carpet nap has any lenght to it like shag, the dyson severly nose dives. It's like the nose is sucked into the carpet. This problem just occured after the wife used the ho


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have the same problem as steve967 The dyson dc16 is fully charged, runs well for 5-10 seconds and shuts down. I wait for a second or 2 and it runs again for 5-10 seconds. This will continue for numerous cycles, until I am finished cleaning. I have cleaned all the filters, and the power is good, The system will just not stay on. It is just over 2 years old. A friend of mine had the same problem with his Dyson DC16 after just a couple of months and has replaced his Dyson with a Black N De


Dear Michael_Stad,I am going to sound like a broken record but here is my same answer to another person with the same problem.I have I had the same problem with my Dyson DC16, where it only runs for a few\015\012seconds at a t ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

My Dyson DC17 has lost suction on the wand and is not picking up dirt as it should. I have taken the small part at bottom of the machine off to see if there is a blockage--none that I can see. The flexible tube on wand is very tight and won't extend very much. Dyson sent me a new cyclonic part in April but the machine still doesn't seem to be working properly. My serial number is 260-us-d11545. Is there somewhere I can take my Dyson to get it fixed. I'm very frustrated with it. Thank you.


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Broken Dyson DC07 part that Dyson doesn't make


... Dyson DC07 Bagless Upright Cyclonic Vacuum

Where can I find a dyson service center. my dyson


On the side of the machine somewhere should be the telephone number for the Dyson Helpline.\015\012\015\012Give them a call and they'll point you in the right direction. ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

Dyson upright My Dyson cleaner suddenly screemed at me and stopped with a puff of smoke and burning smell. I had just emptied the cylinder. It is five years old.


Hi this is an expensive repair and would probably be cheaper to buy new one the problem you have is with the motor bearings seizing its expensive to repair because when dyson made thes vacs they were made so you need special tool to take them apart s ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Cleaning or dissasembling cyclonic cone on Dyson DC 17. Dyson advises using air-dust cans usualy for computers Keyboards????? It will not work not powerful enough! Thanks [email protected]


I would use an air compressor then, if you don't have one, see if a friend has one or possible you can rent one if you really can't find one, that is what we use ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Dyson Quits My Dyson quits after running a few minutes. Than starts back up after a bit.


Cut out switch on the motor needs replacing this overheats and cuts of the motor when the motor cools down it will start again you have to keep both filters and cyclone clean and free of dust or after replacement the same will happen again ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson DC07 hi My dyson dc07 wont power up, any thoughts on what could be causing the fault. ie does it need new motor.


First, check your outlet for power...plug something else in. Then, inspect the cord and check the power switch. You can use a multimeter to test across the power plug of the vacuum in the ohms position. Turn the switch off and on. If it does not ... Dyson DC07 Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0295 seconds