Having problems with your Dyson DC07 Bagless Upright Cyclonic Vacuum ?

My vacume is the purple one

\015 The brush won't turn and it is hard to push.\015

Answers :

\015\012Ensure clutch selector knob front left lower side is in drive mode when you pull back the handle to vacuum.
Repair Help & Product Troubleshooting for Dyson DC07 Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My vacume is the purple one

Hi\015\012\015\012Ensure clutch selector knob front left lower side is in drive mode when you pull back the handle to vacuum.\015\012\015\012http://dysonmanu ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I need to change out the short hose on the underside of my older Dyson DC 07 Animal (Light Purple). It is the one less than a foot long on the underside which is attached on one end to the main body of the vacuum(I was able to remove this one) and the top of the upper soleplate. The latter one seems to be glued or otherwise permanently attached.Any assistance you could give me on this would be greatly appreciated....Thanks

Hello Cynthia,\015\012\015\012It's not glued, but it can be a little difficult to remove. You need to twist and pull at the same time and it should pull off. If it's being stubborn, squirt a little bit of WD40 / penetrating fluid where th ... Vacuums

I think its a hoover any way,i guess at one time some one vacumed up some moisture i can se it on the bottom of motor,on one of thewires theresa thermol senser and i see rust in the plastic,cause it good and thencuts out i think the senser out because of the rust in it???????

If mositure got on it, it could have damaged it and hopefully the motor didn't receive any moisture on the inside of it. ... Vacuums

I have a Electrolux , EL6988 Canister Vacum, howeveer the brushes and motor will not run when turned on. I have take the plates and cleaned around the brushes, but it will not come one. The vacum comes on but the motorized bushes do not activate. Thanks I have lost my owners manual, and have looked for the reset button and can't find or know where it is located. Any suggestions.

I need the molded wire harness inside the plastic wand ( one of the prongs is broke off) What is the part # or where can I buy it? Model EL6988 ... Electrolux UltraLux 2000 Bagged Canister Vacuum

My wife and I own 6 IRobots: 1 Scuba 1 Dirt Dog 4 House cleaning vacume models All of them are not working, so I decided to try and solve the problems with two of them: One is a dirt dog and the other a house cleaning vacume Rumba. Given: Battery is fully charged Reaction: I start both of them. They run for about 2 to 3 seconds They come to an abrupt stop as if there is a rock in the gears. Help

Both of them have identical issues? Can you please provide the actual part number of them? It should be on the bottom or inside the battery area somewhere.ThanksTim ... iRobot 1100 Dirt Dog Bagless Robotic Vacuum

I have one of the purple one and it is not pumping up very much anymore and making much steam. It's almost like a seal is blown. Can it be fixed or is it trash?

Hi,**** builds up inside and cuts the steam, no way to clean it...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

The question mark light on the canister of my Electrolux Epic 6500 series has come on and the vacum will not power one. This has never occurred before. It seems to be somethng with the bag but we checked that.

This indicates that the bag is full, but may be caused by other problems. If you have fine dust in your area, the bag may seem like it's not full, but the pores in the bag are clogged so the vacuum will shut off as if the bag is full. This can be p ... Electrolux Epic 6500 Vacuum

I havethe first generation purple Dyson Animal model. The brush rotates fine, but doesn't make sufficient contact with the floor/carpet, therefore does not pick up most items on carpets (suction still works however). If I put my foot on it and push down a little, it works. However, since I'm not an accomplished acrobat, this is not easy to do. :-) Any suggestions on whether this is fixable? Or should I just save up to buy a new one?

... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My older Dyson DC14 (the purple one) early model with a clutch on the beater bar belt needs a clutch replacement. The bar has been cleaned and there are no worn or damaged parts so I conclude that the clutch at the motor end of the belt needs to be replaced. I can find the part online but no instructions on how to disassemble the vacuum to get to and replace it. Dysons only advice is to give me the address and phone of the nearest service center. Can you help me?

Have a look at www.dysonmedic.com which has some very useful info on dismantling and repairing Dysons.\015\012\015\012Although this site doesnt actually cover the DC1 ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Battery needs to be replaced in eletrolux pronto 2 in 1 stick vacum,can i order one

The battery replacement for the PRONTO is not a consumer level maintenance procedure.\012\012However, I just replaced the 4 original EMX1600sS batteries by anotther \012model with the same specs and my PRONTO is working fine now. The battery\01 ... Electrolux Vacuums

My Animal Dyson (the purple one) is making strange noises. The ball will not roll. I've taken it apart and put back together and it works for a couple minutes and then it won't work again I think it's Model DC24 or 25. Pretty sure its 24.

... Dyson Ball DC24 Bagless Upright Vacuum

No power My Hoover S3765-040 WindTunnel Bagless Canister Vacuum does not seem to receive electricity to power the vacum. One day it worked and the next it did not. Any recommendations for a solution.

... Hoover S3765-040 WindTunnel Bagless Canister Vacuum

Dewalt 2gallon corded/cordless vacume...unsed one time brand new wont turn on. motor and switch both tested and work...any ideas

Check the battery contacts... a common problem on this model. they are easily bent and prone to corrosion. ... Dewalt Cordless/Corded Wet/Dry Vac 2 Gallon Vacuum

Need filter i need a filter for a wap vacum cleaner model # 28538 it is a paper filter so can you tell me were to find one thanks len

Check with www.ultimategarage.com or www.industrialvacs.com. They are both stocking dealers for Wap/Alto/Attix vacuums, now a part of Nilfisk of Denmark. Good luck ... Wap 28538 Wet/Dry Vacuum

Eureka bagless model 5893 Need to know which wires go where when installiing a new on/off switch. One wire is black and the other 2 are purple and blue.

... Eureka 5892AVZ Bagless Upright Cyclonic Vacuum

I have a dirt devil that is only 2 years old, I used it and sparks began to shoot out from the front grill area. I called dirt devil's corporate office at 12noon today July 25th, and was told that with out my receipt there was nothing that could be done and since I only paid $39 for the cleaner I should just get another one. This product is a fire hazard!!!!!!!! I was vacuming near my bed when the sparks began, I find it unbelievable that this was taken so lightly. If my home had burned d

... Dirt Devil Vacuums

I need to replace the hose and can't find one. the model #is 5893avz. this is a upright eureka vacum cleaner

I called the plant and they are sending me one. thamk you ... Eureka Vacuums

I broke the handle part of the shark steamer #53101. I don't have the book to try to tell you the parts I need. Can you send me a picture or a copy of the steamer. It is purple. The above number may not be the correct one. It is broken in the center part. It has a little small circular piece that joins the two pieces which are broken. The beginning of the handle at the bottom of the steamer and the next session which has the steam release. The top of the handle is okay . It the middle and bottom

Hi,Ann there are very few parts for these...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

The rollerbar keeps going on and off, depending on if you push it to one side or straight. If you push it straight it does not want to work and cuts off. the vacume is still on but the rollerbar does not spin

It could be that the belt is very worn or stretched to the point that it can't turn the brush against the carpet. If thats the case you can get replacement belts and view the manual here: ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I purchased a toastess vacum bag sealer at Canadain Tire two months ago. I only had it about a month when the sealing wire broke. I returned it to the store and they replaced. One month later the same thing happened again, but because it is more than 30 days I can not return it to the store this time. I have misplace my bill of sales. Where do I go from here. Carmel Whiffen Marystown NL AOE 2M0 (709)279-3149

Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=578564\015\012Generic problem for all Vacuums\015\012I purchased a toastess vacuum\015\012posted by carmelwhiffe ... Vacuums

Looking for the wand for the fantom lightin canister vacum, anybody know where I can find one.

They have gone out of business so I would check on craigs list and used vacuum stores. ... Fantom Vacums Lighting Canister Vacuum

Intele Clean It is constantly in the red. I changed my bag and still its in the red I vacumed in one spot for 20 min, Whats Wrong?

Every time you change the bag you should clean the eye. The eye\015\012is inside the tube behind the bag collar. Just use a lint free\015\012cloth and wipe all around inside the tube. That worked for me! ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

I have a shark vacum cleaner model sv736k 15.6v handheld and the charger cord shorted and corroded the contact. I need a replacement charger ka12d240015033u where / how can i get one?

... Vacuums

Hello, I am looking for a wiring diagram to install a touch/dimmer switch by "Comfort" mdl # RH-934B - Darjung Ind Ltd. It has a standard lampcord (two wires) coming from it as well as one white, one black and one yellow wire. The original touch/dimmer switch (no identification on it) had one white, one black, one red and one yellow - no lampcord. Thank you very much for your help!

The black and the white will go to the lamp ,eg,output.The yellow is the sensor wire which should be firmly attached to the metal base of the lamp ... Vacuums

Replacing broken handle on filter queen vacume

It is always best to have a cirtified & Authorized Service Tech or Center do the work and only with genuine Filter Queen parts and supplies. Both can be found at 800-344-1840 or in Iowa 888-637-4692\015\012\015\012If a Authorized Tech ... Filter Queen Majestic Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0313 seconds