Having problems with your Dyson DC07 Bagless Upright Cyclonic Vacuum ?
Slight burning smell when dc07 is in use
\015 Mydc 07 brush turns and has suction but a slight burning smell is present when in use\015
Sounds like your belt can either be rubbing against something or its stretched out. Either way you should check into getting the belt changed.
Repair Help & Product Troubleshooting for Dyson DC07 Bagless Upright Cyclonic Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Slight burning smell when dc07 is in use
Sounds like your belt can either be rubbing against something or its stretched out. Either way you should check into getting the belt changed. ... Dyson DC07 Bagless Upright Cyclonic Vacuum
Belts Burning On our Ultimate G, belts are lasting about 2 uses and they smell and burn off. I am looking at the roller and I can see a slight grove where the belt rides. Is it time for a new roller. I am sick and tired of replacing belts and smelling up the house. Thanks Dusty
Yes, replace the brush roll, the ends or end is probably bad and causing the belt to slip and burn up. ... Kirby Ultimate G Bagged Upright Vacuum
A burning smell when in use - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
Martinsivyer: Turn the machine upside-down and see if you can turn the beater/brush bar with your hand. You should see the brush turning and feel the resistance from the motor. The brush/beater bar may be binding, and what you are smelling ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
Miele s4212 vacuum accidently used with no bag now making very loud noise and slight burning smell ,is the motor damaged beyond repair or is there a way of repairing this ?
... Miele S4212 Bagged Canister Vacuum
Burned smell hi, I have used my hoover 4 times and is starting to smell as something burned, I checked the troobleshouting part of the owner manual and it says that check the belt, I already did that and everything is ok I used the hoover again and still smelling bad and start to work very slow I better shut off it.. what could I do??
If the motor slowed down this would indicate a bad motor. not cost effective on this model to replace unless under warranty. it is not uncommon these days to see a motor go bad every now and then.\015\012\015\012What are the first 4 digit ... Hoover U5507900 Elite Rewind Bagless Upright Vacuum
I had used Dyson DC08 to **** out a wet car carpet. A few days later when using the V/C, there was a burning smell. Subsequently I washed the flexible hose, changed the pre-filter and post filter , but I wrongly put the pre-filter in the spot for the post filter. When the V/C was next used, there was again a burning smell and sparks. The filters were switched, but the V/C would not re-start. What shall I do?
Hi there,We'd strongly recommend against using your Dyson to pick up water. If you haven't already got in contact with us directly, I'd encourage you to do so. One of our experts will be happy to recommend the best course of action. You c ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum
I've got a Kenmore canister vacuum, Progressive 236123, and there's a burning smell from the belt side of the head--smells a lot like hot rubber. I've cleaned the agitator and changed the belt, but I still get the smell. It's stronger when I'm using "carpet" mode than when I'm using "bare floor" mode. Any ideas what the problem is?
... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum
Burning smell I have just noticed a slight burning smell and a whining noise when I turn the cleaner off. I keep the filters clean and can't see any obstructions. Any ideas please?
... Dyson DC25 Animal Bagless Upright Vacuum
Burning smell When using the vacuum there is a burning smell.
Replace the belt ... Sebo X4 Bagged Upright Vacuum
Smells like it is burning up when I use it!
You should unplug the machine, then remove the plate that covers the beater bar. Remove all debris from the beater bar, (strings, hair, etc.) and insure the belt is in proper position. If you have run it very long out of proper position, it may req ... Kenmore 23313 Whispertone Bagged Canister Vacuum
There has been a burning smell for some time, but we continued to use it as everything was in working order. Sometimes the smell was not even noticeable. Today, however, the smell was intense and the motor kicked off. As it did, it was draining electricity like crazy. The lights dimmed drastically.
It sounds to me like the brushes in the motor are worn out or the motor has gotten water in it (if you have been using it for wet pick-up). The way you described the situation, I am really surprized if it did not trip the circuit breaker for the cir ... Rainbow E series Canister Wet/Dry Vacuum
Eureka 4870: when using hose, brush still spins, vacuum gets hot and smells like it's burning.
... Eureka Smartvac 4870 Bagged Upright Vacuum
I have a Hoover SteamVac LS (several years old). I turned it on today and heard slight pop and then an off smell, not a burning smell though. Then after a few more minutes of operation, the SteamVac lost power and now it will not work.
You should check the cord for any burnt marks or cuts, especially the plug, if you don't see any thing it is probably a bad motor. ... Hoover Vacuums
No action Hi: My brush roll won't budge. After we cleaned out all the hoses and replaced a badly worn belt (burned?) when I turn it on the smell of burning rubber and smoke has continued. What hurts is that I don't think I've used the vacuum a total of 10 times ... and I had such high hopes. Ideas?
I had the same problem with the belt breaking and the roller not spinning. I read about giving the roller a couple of revolutions to seat the belt, so I put another new belt on. It still didn't spin. I realized it was the end cap that was not spinnin ... Eureka 2961AVZ Bagless Upright Vacuum
The beater motor will not turn. Is there a fuse? I've tried the reset, but this still doen't work. My wife smelled a burning smell and quit using.
Sounds like you need a new belt.Turn it upside down and locate the screws on the bottom.Remove those screws,and then the plate they hold on(if there are no screws then the plate will be held by clips just pull it off,carefully.The brush now may be li ... Eureka Capture Upright Vacuum Vacuum
Burning smell i have a dyson 14 animal and it quits working after about 3 min of use and it smells like its smoking
Have you checked the the hoses are free of debris?\015\012Is the setting for floor on when you are vacuuming the carpet.\015\012\015\012Turn id on an see if it will **** up some pennies.\015\012Use the hose for that. \01 ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum
Vitamix 5000 stopped working. It stops working each time I use it; while blending I first smell a burning smell and then blender stops and will not start again. After sitting overnight it works again next morning and repeat same process. Any ideas how to repair?
It has an internal thermal shutdown. Let it sit for a while and it will reset itself. You can expedite by putting the motor base in the freezer for a few minutes, or by blowing a hair dryer into the base of the motor. ... Vacuums
Why does my dyson dc07 vacuum smell so bad when i use it? I have washed the filter so it is not that problem. The smell is of a dusty variety the suction is fine but I would like to eradicate the bad odour.
... Dyson DC07 Bagless Upright Cyclonic Vacuum
My dyson (not upright) is making a funny popping sound with a slight smell of burning. I've cleaning out the filter and its not cutting off. But worried about the sound and smell what could it be?
Mine did this too. It is the carbon brushes inside the motor that have gone out. Looking for replacements for the UDS1451VNR motor that is in it. Motors run about $95, brushes about $15 for te set if you can find them.\015\012\015\012 ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
I can smell a burning rubber type smell coming from my dc07 i. i've switched it off but what can the problem be and can I fix it myself?
More than likely it's coming from the belt in the power head. Due to some difficulty in taking the power head apart and reassembling, I do recommend taking it in to a shop. Getting the tension of the belt correctly is very important. Too tight and ... Dyson DC07i Bagless Upright Vacuum
Burning smell using vax classic rapide
DC07 Low Reach Vacuum smells like a belt is burning and is making
The lower brush has been jammed - turn off the power, unplug, take off the vacuum dust colletor, then turn the vaccum cleaner over.There are four wide plastic tab locks - use a coin to unlock and take off the foot plate.Take o ... Dyson DC07 Low Reach Bagless Upright Cyclonic Vacuum
Belt slipping Belt slips off and rubs causing burning smell from the belt over heating. Of course this puts an indent into the belt and has to be replaced. How do I keep the belt from slipping off? I see no place for a belt adjustment. Which I know would eliminate the problem. Really aggravating to have to replace belt only after two uses.
On the roller/brush where the belt sits if that is scarred up or grooved out that will cause the belt to slip if you can fix roller try but i suggest new roller ... Hoover Company Wind Tunnel U53019 Upright Vacuum
Proheat 8910, just used once, pump belt keeps breaking. I replaced it two times, there is a burning smell and then when I look at the pump belt, its broken.
... Bissell 8910 ProHeat Clear View Upright Vacuum
I have a dyson dc07 original that i bought used. Last owner was obviously a pet owner and the machine smells too bad to even turn on in the house...can I clean the canister with water? What other parts can get wet or is there a better way to remove the odor?
Put some vac freshner in the canister put the vac out side if its fine plug in and switch on leave runing for around 10 minutes that should solve the odour ... Dyson DC07 Bagless Upright Cyclonic Vacuum