Having problems with your Dyson DC07 Bagless Upright Cyclonic Vacuum ?

No suction at base...

\015 Yup. Looks like several people had this problem.\015\012\015\012I have the animal (purple) version. I've cleaned the beater and it spins well also check the hoses - no obstructions (or holes). \015\012\015\012Works fine if I use the wand - but that's not too practical for the entire floor!\015\012\015\012At the cost of a replacement, I'm pretty frustrated about now.\015

Answers :

Take the sole plate off and check for blockages - where the transparrent hose connects to the beater compartment
\015\012Are the filters clean?
\015\012Make sure the bucket is properly aligned to the main body
\015\012Make sure the inspection covers are clear and properly fitted.
\015\012They has be a blockage between the beater bar and the main hose which works ok.
\015\012Still no good?
\015\012Come back to me
Repair Help & Product Troubleshooting for Dyson DC07 Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bissell 2x has suction coming out of the "base" part(when I put my had over the rubber ring that leads from base to the handle part there's suction), but there's no suction coming out of the hose. I'm not certain if there's a clog, 'cause I can't get the hose off.

... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

No suction. I have followed the detachable parts no suction. I have followed the detachable parts and it seems to have suction through to the base but doesn't pick up anything significant. I have looked through the hose connecting the base but I can not see anything obstructing it.

Poor suction can be caused by obstructions, poor air flow or a compomise in the air flow (hole in the hose). Since you have started with that I would next look at all filters and clean them. First check for suction at the motor, then at accessory hos ... Vacuums

Base suction and tool suction both have stopped working

On the top of the water reservoir (under the handle that you use to lift it off) is a large dial. The top says "hose" and the bottom says "floor". Turn it to where it says floor. If your brush is not working than you going to have to tak ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Lost suction my DCO7 lost suction in the hose I started taking it apart and cleaning it and looking for clogs (probably more than I should have) and when I put it back together it has awesome suction in the hose but no suction in the base. It just pulls the pine needles up (christmas tree) but they never appear in the "bag" compartment and when I look they are just all gathered in a clump in the bottom by the brush.

Hi.\015\012\015\012Remove the sole plate turn the 3 plastic screws to unlock & lift off.\015\012\015\012Now remove the blockages that have accumilated from the oppening of short clear hose.\015\012Check you can turn ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My eureka optima upright bagless vaccum has VERY low suction using the floor part. the hose has excellent suction. i removed the little translucent door underneath and there were no blockages, i cleaned the brushroll thoroughly and that hasnt helped either. i know this probably isnt recommended but i turned it on to the floor setting with the brushroll off and stuck my fingers up the intake as far as i could, the suction was good further up but it just seems to stop down at the base. because i s

I will try and help here. Is the sole plate on the bottom of the vacuum complety on and there are no visible cracks along the seam where it meets the body? This is the usual cause for this. Onc you take of the plate to access the roller and brushes, ... Eureka 431A Optima Bagless Upright Vacuum

My Bissell 9500's base suction stopped working, however the hand tool suction works.

I can tell you how, but I think if you look at this manual it will show you how to fix your problems...go here to download: http://www.bissell.com/images/UserGuides/9500_908.pdf ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

We have lost suction power from our dc07 but only from the base the hose still has decent suction

It sounds like a clog. I have had vacuum cleaners that i had to take almost all the way apart just to get the clog totally cleaned. Vacuums do need some maintenance due to the fact the amount of dust and hair they collect can easily clog them. You ca ... Dyson DC07 Allergy Blue/Turquoise Bagless Upright Cyclonic Vacuum

No suction The brushes spin as normal but there is little to no suction through the base of the unit.

Your Belt band probally broke. My is doing the same thing, I wonder if I could sew the belt back together? ... Bissell 6594 PowerForce Bagless Upright Vacuum

No suction when wand is used. Checked for all blockage. If you disconnect no suction at base

Hi there,Sorry to hear you're having difficulties with your DC24. Although I note you've already checked for blockages, you may wish to follow the steps shown in our support guide, to make sure you haven't missed anything: ... Dyson Ball DC24 Bagless Upright Vacuum

Suction power level drops to zero, need to constantly readjust suction power from zero to normal operating level Appears to be some type of loose connection between hose coupler and base unit

Ok, so where as both of the solutions above are good, they will not solve your problem with the hose cutting off to 0, then having to turn it back on. \015\012\015\012This problem is caused by the static electricity which causes the hose ... Miele s558 Silver Moon Vacuum

Hi, I have a Kenmore vacuum cleaner model number 20712008. There seems to be a problem with power getting to the suction base. There may be an electrical problem with the connector between the metal tube and the base.

... Kenmore Vacuums

My manual says it is DC07, but it is pink and silver in colour. I have 2 problems, firstly the brush has stopped spinning, but belt appears intact. Secondly there are tiny holes in suction pipe near brush i.e. the little section of suction pipe at base of vacuum cleaner.

Hi there, \015\012The DC07 came out in a few different variations so the colour only indicates that yours has a hepa filter. The first problem can be caused by a few different things\015\0121. the brush roller bearings are worn or siexed. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

The clip that connects the water base to the top of the suction area broke off..where can I get a replacement base (the part where you put the water in and has the bag where you also store the dirty water)? I have a Bissell proheat 2x

Here is the number for Bissell, they can tell you who to contact near you.\015\012Service Center Dept. Phone Number:(800) 457-1509Service Center Dept. Fax Number:(800) 517-9535Hours:M-F 8:0 ... Bissell Vacuums

Dyson dc28 animal has good wand suction, no base suction. How do we fix this?

... Dyson DC28 Animal Bagless Upright Vacuum

There is no suction from the bottom base where the roller brush are, but theres a lot of suction from the hose.

Check between the brush and the hose connection. It sounds like there's a blockage there. It can easily be pushed toward the brush using a wooden spoon handle, or similar blunt object. ... Dirt Devil 12 Amp HEPA Filter Vacuum Vacuum

I have a Dirt Devil MVP and it has no suction, I have checked all the hoses and they are NOT clogged, There is no suction at the 1st hose attachment at the base of the vacuum

... Dirt Devil SwivelGlide Bagged Upright Vacuum

Bissell lift off pet-no suction through base (hose is fine)

I had a similar problem with mine. When you take the collector container out, if you reach your hand up, you will fill a round, plastic piece. Gently turn it and the piece pulls out. On the outside of the piece is a foam filter that may be plugged ... Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum

Won't switch from hose to base suction

Hi There, Alec from VacuumSpot here. The problem is relatively common, there is a fault in the part that is called the undercarriage. It is a bit of a tricky one to fix bu ... Dyson Slim DC18 All Floors HEPA Bagless Upright Vacuum - Iron/Titanium/Yellow

Bissel lift off deep cleane pet no suction a base

... Bissell Lift-Off Pet Deep Cleaner

Dyson has lost suction and loud noise from base(?),

I had the same problem, from right out of the box. Now that I just threw mine out, I see this site that indicates there's a fix for it: ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Suction from base limited but not from handle.

Hello, \015\012\015\012This is a difficult repair to try and guess what may be the problem, but I will try and go over a few things that may be wrong with your vacuum.\015\012\015\0121. Filters. You should check the filter t ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Suction through hose but not base

Mine did the same when new, i checked all as above then i noticed that i could twist the round peice that will unplug) (right behind the carpet-bare floor knob) and then i got suction at the base to be able to vacuum the floors, then i notice that th ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson dc07 yellow/blue no suction at base

Sounds like you've **** up something which is obstructing the suction from the brush bar. There's a little section of curved grey pipe near the base which carries the dirt from the head up the vertical pipe at the back. This section can be removed, c ... Dyson DC07 Bagless Upright Cyclonic Vacuum

No suction from base or hose attachment

Hi, I had the same problem with my Eureka vacuum cleaner. I don't have the problem with the beater bar, but I had the problem with the attachment hose not getting any suction. I found out that I was putting attachment on the wrong end of the ho ... Eureka Smartvac 4870 Bagged Upright Vacuum

No suction when hose is removed from base

Most suction problems are caused by a clog from picking up something you probably didn't see or if you have pets an accumulation of pet hairs!To clear it out take a metal coat hanger and unbend it til it's straight, then bend the end and ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0483 seconds