Having problems with your Dyson DC07 Bagless Upright Cyclonic Vacuum ?
MY DYSON DCO7 DOES NOT PICK UP FUZZ AND HAIR FROM CARPETS
Check if brushroll still spins when it comes in contact with the carpet. Your belts could be so stretched that its just slipping on the brushroll.
Repair Help & Product Troubleshooting for Dyson DC07 Bagless Upright Cyclonic Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
MY DYSON DCO7 DOES NOT PICK UP FUZZ AND HAIR FROM CARPETS
Check if brushroll still spins when it comes in contact with the carpet. Your belts could be so stretched that its just slipping on the brushroll. ... Dyson DC07 Bagless Upright Cyclonic Vacuum
I have the Dyson animal upright vacuum. It's 2 years old and now it just isn't working as well as it once did. Suction seems to be lacking - it's not picking up pet hair or much else from the carpet. I have to go over the spot for a few minutes and still, the hair isn't picked up.
You might want to check and see if your cyclones are plugged with hair. this can happen and there is a great site to disassemble and clean the cyclone here: http://www.exonotes.com/content/node/4 ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
My Dyson Animal does not pick up on bare floors. It makes my wife crazy. I have checked the airways, etc. While the container fills up on carpet, I often see stuff on the carpet that it doesn't pick up, etc.
Check bottom Hose for Splits, Brush bar may be worn or set too high. check rubber seals. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
No suction i have a hoover supreme wind tunnel vac and its relatively new and the suction, well......sucks. It wont pick anything up! I am extremely frustrated! I picked up a ball of fuzz off the carpet and held it under the vacuum and it still wouldn't **** it up. I then shoved the fuzz up INTO the vacuum. It fell right back out. I may as well not even vacuum. Please help!
I have found more vacuums on the way to the dump because they were full. Check. Is it full?\015\012If not the air way is clogged. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
Dyson o7 animal pick up problems
Hi.\015\012\015\012If your machine is A few years old it may need new brush roller fitted.\015\012\015\012To check roller for wear lie machine on the floor & pull back head end as if vaccuming carpet.\015\012\0 ... Dyson DC07 Bagless Upright Cyclonic Vacuum
Carpet My Dyson Animal works fine on the ceramic tile floors, but hardly picks up anything from the carpeting. What is wrong?
Have a look at the brushes are they turning and if they are can you stop them turning if you tuch them with your hand??? if you can stop them turning the brush drive belt is slipping get a new belt and fit it,,\015\012problem sorted!!!! ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
My hose tools wont pick up. when hose tools unattached suction is fine and will **** my hand fiercely, but once tool attached no suction..... how am i gonna pick up cat hair from seats now?! its a dyson DC04 but it wouldnt let me choose that!
I have a DC04 and the hose tools are a open hole.The only reason they want pick up is they are blocked.If you say they are sucking your hand when not attached.Make sure the hose is not blocked by taking off the cover at the front.Allso check the cyli ... Dyson DC07 Allergy Blue/Turquoise Bagless Upright Cyclonic Vacuum
I have a DC07 which is not picking up very well. I've cleaned the pre motor filter, was not aware of the post motor and will check. However, do the Dyson brush rollers wear to the point of not picking up things from carpet?
Hi The filter is only part of the cleaning process with a Dyson.\012\012I would suggest you get a 2 p peice and unscrew the plastic screws on the base. You will likely find that this area has clogged up. Clean this area out and put solepl ... Dyson DC07 Bagless Upright Cyclonic Vacuum
I have a Royal 7910 extractor and even though I vacuum before cleaning the carpet, by black cocker spaniel's hair gets pulled into the plastic pick-up attachment and I cannot find an easy way to clean it out. I have tried taking the screws out to separate the halves, but it seems as though they might be glues together. I have run water from a sink sprayer though the openings with some degree of success, but it still is pretty cruddy. I have tried snaking pipe smokers pipe cleaners up the pick
One person wrote this in a review:\015\012Most home carpet extractors are very difficult to take apart for cleaning and maintenance. The Royal 7910 is the exception. No tools are needed to take the front housing off to clean out all the pet hai ... Royal CE7910 Wet/Dry Vacuum
No spin Vacuum's brush does not spin on (low) carpet unless switched to "high" but then roller does not pick up hair on carpet. Belts are in good condition. Maybe belts are loose?
Http://geeksquad.fixya.com/ThreadView.aspx?prdid=40485&thid=782631\015\012No spin\015\012Posted by erin_david on Jul 14, 2008\015\012Vacuum's brush does no ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
Dyson Vacuum picking up fuzz but not dirt - Dyson Vacuums
... Dyson Vacuums
My Dyson is not picking up on the carpet as good as it use to. The brush doesn't seem to engage on the carpet unless I hold the angle upright. It's very uncomfortable to hold it at that angle. What would correct this problem?
Brushes do wear out. Compare the length of the bristles on you brush with a new one. ... Dyson DC07 Bagless Upright Cyclonic Vacuum
I have a Dyson 17, the Absolute Brand special for pet hair. I think I have a blockage in the hose. Symptoms are: spewing out fuzz balls and small particles. I have checked all the blockage sites recommended by Dyson and all are clear except a small flexible transparent hose, 6 or 7 inches long, curled up underneath the cleaner head/brush bar unit. Any ideas? I've tried to pull out the stuff stuck in there, but I'm afraid to perforate the hose and I don't know any way to disconnect it.
Try dropping something like marbles into the hose and shake it up and down, may loosen it up enough to draw through.hope this helps you out. ... Vacuums
Does not pick up loose lint or fuzz from carpet.
Sounds like the belt is loose or it's not on at all. Make sure the belt is wrapped around the brush and is locked in by the metal. ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum
Miele salsa rips up my carpet then won't pick up fuzz
... Miele Vacuums
I bought a Hoover Wind Tunnel in January 2008. At first it worked great though very noisy. Now it will not pick up small fuzz on medium shag carpeting. I have checked the bag, the filter, the belt, and obstructions and there are none. Plus the noise level has increased. What is wrong? I am very dissatisfied.
Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=563001 Generic problem for all Vacuums I bought a Hoover Wind posted by smithcarolj1 on May 01, 2008 I bought a Hoover Wind Tunnel in January 2008. At first it wo ... Vacuums
My vacuum will not pick up even fuzz on the carpet
If the suction is strong through the hose and its still not picking up, then something is definately clogged despite the strong suction and rolle brush. Check all inspection tubes including the main dirt channel behind the roller brush. You may find ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum
I have a dyson dco7 it just recently started making a horribly load noise if i run it in carpet mode but not in hard floor mode what can i do?
Change the belt(s). Here are the belts you need:Dyson DC07 Belts ... Dyson DC07 Bagless Upright Cyclonic Vacuum
I have a dyson dc07 upright which no longer picks up lent and hair. The roller brush is not spinning when the vacuum is turned on. How can I tell if it is the belt that needs to be replaced or the clutch and belts?
Need replaced Clutch Assy and Brushbar \015\012\015\012Clutch Assy part no:900252-04\015\012\015\012Brushbar Assy part no:904174-01\015\012\015\012try cleaning all Hose\015\012 ... Dyson DC07 Bagless Upright Cyclonic Vacuum
Hoover U5046 not picking up cat hair in carpet any longer - Just bought new bags - would like to get this to work
Please check the flat rubber belt from the motor shaft to the brush roll to assure it is not broken, or severely stretched. ... Hoover U5046-930 Turbopower Bagged Upright Vacuum
My dyson is not sucking well or picking up on carpet i have cleaned all the filters and checked connections can i do anymore
The motor is probably clogged or it is damaged. try taking it apart and cleaning it or take it back to where you bought it ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
Dyson pulling up carpet fuzz by the container--when does it stop
Hi there SmartAlec from NelsonVacuums.com.au here. Firstly the cyclone action of a dyson artificially accentuates the amount of fluff you are removing basically the cyclone ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
I have a dyson and it isnt picking up the large items on the carpets. such as string.
Check for blockage in hose or underneath. Check for blocked filters and lastly check the belt isnt broken or stretched ... Dyson DC07 Bagless Upright Cyclonic Vacuum
I have a Dyson DC17 that has started making a loud noise when on carpet when the brush is engaged but not on hard wood when the brush is not turning. I have remove all the material (hair,lint, etc.) wrapped around the brush itself, but it is still making the noise
You need to replace the belt. Here is the belt you need and a manual you can view which has instructions:\015\012\015\012Dyson DC17 Belt and Manual ... Dyson DC07 Bagless Upright Cyclonic Vacuum
My dyson animal is hard to push on carpet - the beater bar is still operational. When I turn off the beater bar and run the vacuum on hardwood the beater bar stops moving, but it still ''rolls'' on the hardwood - it doesn't pull up like it used to. It also seems to not be picking up as well as it used to, although no blockages are present and the filter is clean.
... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum