Having problems with your Dyson DC07 Bagless Upright Cyclonic Vacuum ?

Loss of suction when upright

\015 When upright or trying to use the handle attachment we are loosing suction. How can this be fixed?\015

Answers :

Check the Rubber Air seals and bottom Hose for splits.
Repair Help & Product Troubleshooting for Dyson DC07 Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loss of suction when using upright. Suction remains for samll tools no suction when in upright position makes funny noise but ok when not used in that position kindest regards louis


U can remove the flexi pipe by pressing the inset button,it may be bit stiff if it had not being removed before.may be something is stuck at the bottom,also remove u bend where most of the stuff get stuck. i just posted how i fixed the suction and ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

When using my vacum upright its very low in suction, it used to be so powerfull that it lifted my carpet slightly....when using the tools section its as strong as it should be please help, ive cleaned it out but still loss of suction in upright position, from mrs richmond


Check the following items:\015\012\015\012* The bag and connection - change it if it's full\015\012\015\012* Turn the vacuum over and inspect the beater bar area for any clogging. You may have to remove the bottom plate to ... Vacuums

Suction perfect when in upright position, but when tilted to actually clean there is total loss of suction - cannot see blockage anywhere. Thanks for your help.


If you are confident there are no blockages, look underneath, where the brush is, and you will see a short length of reinforced clear plastic hose. This often develops a split which results in loss of suction. You can pull the hose off at the motor e ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Loss of suction when using upright. Suction remains for samll tools


Over 21 years repairing vacuum cleaners, I have removed yards of duct tape,surgical tape and package tape from hoses.wands and cords. I have found the best repair method for torn hoses is a product called "Stretch and Seal". This is a silicone-based ... Vacuums

Loss of suction when upright


Check the Rubber Air seals and bottom Hose for splits. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

M084600 Dynamite Bagless Upright Vacuum: loss of suction...


A few weeks ago I ran into the same problem, virtually no suction. First I replaced the bad belt (make sure you fit it right or it'll destroy the belt, luckily I bought 2!) and while the vacuum sounded more "alive" it didn't seem to pick up anythi ... Dirt Devil M084600 Dynamite Bagless Upright Vacuum

Loss of suction in my Hoover Windtunnel bagless selfpropelled upright


There's also the possibility that the fan/impeller has stripped loose from the motor shaft and is basically sitting there while the motor turns. Also, you may have broken vanes on the fan/impeller that will drastically reduce the suction. Replacemen ... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

Loss of suction Dyson Absolute dc17 - Dyson DC17 Animal Bagless Upright Cyclonic Vacuum


More than likely the sole plate on the botom of the cleaner is plugged, take the bottom plate off and clean it out, also make sure your brush is clean and not full of hair. This is common on this vacuum ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Loss of suction on a bissell proheat pet - Bissell 1699 ProHeat Clear View Upright Steam Vacuum


... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Loss of suction - Dyson DC07 Bagless Upright Cyclonic Vacuum


... Dyson DC07 Bagless Upright Cyclonic Vacuum

Cleaner not picking up loss of suction - Dyson DC14 Animal Bagless Upright Cyclonic Vacuum


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Loss of suction - Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum


Check the hose and plugged filters. ... Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum

Loss of suction on dyson animal hose - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum


There may be an obstruction in the hose. Hold it up to the light then I use a long thin broom handle to push the clogged hair through it, being careful not to split the hose. This always does the trick for me. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Loss of suction on hand tools (DC07) - Dyson DC07 Bagless Upright Cyclonic Vacuum


It sounds like there's probably a clog in the hose. Drop a small coin or marble down the hose and see if it falls through. There's going to be a loss of suction in the power nozzle too, just not as noticeable when vacuuming carpet.\015\012The ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Loss of suction via the tube. - Dyson DC07 Bagless Upright Cyclonic Vacuum


Hello,It sounds like you have a clog or dirty filter. Here is a link to download the manual for your model. The download link is on the right side of page. About half way down the page you'll see the Download Manual link. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Lossing suction, especially hand held - Eureka Smartvac 4870 Bagged Upright Vacuum


Did you check the hose to see if there is a slice in it somewhere. Alot of times you can get caught on something or bend it the wrong way and it will crack the hose causing suction loss. The other possibility is a clogged filter somewhere in the syst ... Eureka Smartvac 4870 Bagged Upright Vacuum

Loss of suction with hoss & wand with my Dyson Animal bagless - will only work as an upright.


It sounds like you have a clog through the hose. Take the entire hose off of the unit and stick a broomstick through, if it comes out the other end without anything coming with it. The clog is in the sweep below the unit. If your mechanically incline ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Loss of suction - Kenmore Progressive 35922 Bagged Upright Vacuum


You may have a colg in the power nozzle of hose. Disconnect the hose and drop a quarter through it.\015\012\015\012Bob\015\012http://evacuumstore.com/ ... Kenmore Progressive 35922 Bagged Upright Vacuum

Loss of suction after a burning smell - Eureka Whirlwind 4496 Bagless Upright Cyclonic Vacuum


The belt of the brush roller could of come off and could be causing the smell. Check the belt/brush roller ... Eureka Whirlwind 4496 Bagless Upright Cyclonic Vacuum

Sudden loss of suction. Using a dirt devil upright. Checked the belts that were changed recently and working. Changed the half full bag. No change. Checked for blockages and as far as I can see there are none. The blower is working as much as it ever was I think but I;m stumped.


R u sure there is nothing cought in the hose? ... Dirt Devil Featherlite Bagged VacuumVacuum

Loss of suction - Dyson Slim DC18 All Floors HEPA Bagless Upright Vacuum - Iron/Titanium/Yellow


... Dyson Slim DC18 All Floors HEPA Bagless Upright Vacuum - Iron/Titanium/Yellow

When I engage the vacuum cleaner by going from the upright position to the slanted position there is loss of suction.


... Dyson DC07 Bagless Upright Cyclonic Vacuum

Vax vx2 loss of suction - VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum


... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

Loss of suction - Dyson DC28 Animal Bagless Upright Vacuum


... Dyson DC28 Animal Bagless Upright Vacuum

Loss of suction in hose - Dyson Ball DC24 Bagless Upright Vacuum


Hi there,I'm sorry to hear you're having difficulty with your DC24. If there doesn't seem to be as much suction as usual through the hose, there may be a blockage in the wand or hose. You may also need to give the filters a wash.To lo ... Dyson Ball DC24 Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0518 seconds