Having problems with your Dyson DC07 Bagless Upright Cyclonic Vacuum ?

DC07 cutting out

\015 Hi,\015\012I have a standard DC07 upright which after half an hours use cuts out out and will not start for a good forty five mins, all filters are clean and i suspect there is somewhere a thermal cut out switch. I was wondering if you can tell me where it is situated as im thinking of bypassing it until i purchase a replacement, I take it is possible for one of these switches to develop a fault or is it the motor ?\015\012\015\012Many thanks\015\012Shaun\015

Answers :

This may help!
http://www.fixya.com/support/t192124-overheating_dyson_dc07

Hello,
\015\012 I sounds that your thermal fuse is cutting out. By no means try to bypass this thermal fuse. It protects your product from catching on fire. Replace the thermal fuse at a service center. How old is this product?
\015\012Okay,
\015\012Spurs21
Repair Help & Product Troubleshooting for Dyson DC07 Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dyson DC07 My DC07 cuts out after 5 mins and I want to replace the thermal cutout. I have cleaned it thoroughly, including the cyclones but it still cuts out. How does the plastic moulding around the motor dismantle? I have started by removing the 4 torx screws but the upper grey housing does not want to detach and I am worried about breaking the plastic. Appreciate any advice.


Try this page: -http://www.fixya.com/support/t192124-overheating_dyson_dc07Regards Gualo ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My Dyson DC07 stops working after a few minutes. It works again after a further 10 minutes and then cuts out again. I have cleaned the filter and checked for blockages but is still cutting out. Can anyone help?


Have you tried calling Dyson? I had a problem with my Animal, and their tech department talked me though the fix. Worth trying them first. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dyson dc07 cuts out after a few minutes ? - Dyson DC07 Bagless Upright Cyclonic Vacuum


There is a cut-out device on the motor which senses when too much current is being drawn, which in your case sounds like it is tripping because the motor is developing a fault and will likely fail completely soon.\015\012\015\012New motor ... Dyson DC07 Bagless Upright Cyclonic Vacuum

DC07 cutting out


This may help!http://www.fixya.com/support/t192124-overheating_dyson_dc07 ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson DC07 keeps cutting out and smells of


Does it smell like an electrical burning smell? sounds like your motor has went bad. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dc07 cuts out


Hi!  This is the sign of a machine that is overheating, and almost certainly is caused by a partial blockage.  You need to check all the pipework and make sure the washable filter is clean (if you wash the filter, use only clean cold ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My dyson DC07 keeps cutting out. I have seperated the cyclone from the bin, how do I clean the cyclone as I think this may be the cause?


HI there, \012This is a tricky solution to describe so I have linked a video I made on how to clean the radix assembly of a ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Thermal cut out on dyson - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

DYson DC07 not sucking properly when in upright mode. I have tried cleaning out pipes etc and even tried an old motor section I had in garage (replaced once under warranty as kept cutting out and they left old motor section here). Even the old motor section had same prob so this suggests its something in the rest of the vacuum cleaner (whats left after you have lifted off the green motor section and dust collection area if you see what I mean? Any advice weclome please.


Blocked filters ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson DC07. Problem:- switch the hoover on and it cuts out after approximately 1 second. Any ideas please?


The motor has a built in over-current trip to protect itself (and you if it seriously overheated and caught fire). This normally automatically resets itself, however if the motor has just about had it, the moment it is switched on, it just trips agai ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have two dyson dc07 and they work but cut after a short while


After they sit for a while do they work again? This is the same thing mine is doing and I am trying to find out if there is a thermostat or switch that can be replaced. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Will be using my dc07 for about 10 mins then it cuts out i leave it to cool then it goes for about 5 mins and carries on like this


There is a thermal cutout on the motor causing this problem because it is overheating. Either it needs the filter replacing and a good blowout with compressed air or the thermal switch is faulty. Try replacing the filters first and if the problem p ... Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum

Moter cuts out after a few minutes - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum


The motors have a "trip" to protect them, and you if a serious problem caused a fire, which can be tripped if the filters are blocked and causing the motor to overheat.\015\012The filter at the top of the cyclone (the bit on top of the dust con ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

DC07 cuts out and stops after about 1 minute's use. It will restart after being left for c. 5 minutes. It seems, therefore that it must be overheating, but an independent electrician could not find any problem.


... Dyson Vacuums

Dyson dc07 keeps cutting out after few minutes


This is a sure sign of a blockage. The motor cuts out because it gets too hot and will start again when it has cooled. Follow the instructions in your user manual for clearing blockages (you can download a copy from the Dyson website if necessa ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Bypass thermal cut out - Dyson DC07 Bagless Upright Cyclonic Vacuum


Hi Pam,If your machine seems to be overheating and cutting out during use, this is likely to be due to a blockage - the filter may also need a wash. The easiest way to locate and remove any blockages is to follow the steps shown in our online ... Dyson DC07 Bagless Upright Cyclonic Vacuum

DC07 Animal Bagless Upright turned on and then just cut out. I tried to plug into another outlet that I knew was


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have two dyson DC07 which both cut out after a few minutes, why??


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dyson DC07 motor overheats


The motor brushes are worn down and can be expensive to get someone to fit them for you so i think its time for a new cleaner ... Dyson DC07 Allergy Blue/Turquoise Bagless Upright Cyclonic Vacuum

Vacuum cuts off when using it


Is there any nicks or cuts in the cord? The on/off switches also frequently fail, but usually just wont stay in the on position. try flexing all parts of the cord while running it and see if you can cause the problem to happen. if not move on to the ... Dyson DC07 Bagless Upright Cyclonic Vacuum

CUTS OUT MOTOR OVERHEAT?


Hi,\015\012\015\012Try this site for help.\015\012\015\012http://dc07.atspace.com/\015\012\015\012Chris.. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Motor cut out - overheated


Should reset after an hour or so, clean filters and make sure dry first ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson animal dc07 does it have a reset button?


The reset button is incorporated into the on/off switch for the brushroller which is the grey button next to the red power button. Try hitting that button separately. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dyson Animal DC07 making a horrible noise!


Ensure plug is not in the socket.\015\012\015\012remove the guard from around the roller on base of Dyson by turning 3 screws 90 Deg anti clock wise.\015\012unclip belt from the metal spindle from the motor.\015\012\015\ ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My Andis Easy Clip does not cut the hair very good any more. I greased/ sprayed the blade even bought a new blade but it only cuts for a couple of dogs and then just pulles the hair rather then cut it.


U might need a new belt check it out ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0249 seconds