Having problems with your Dyson DC07 Bagless Upright Cyclonic Vacuum ?

My dyson DC07 keeps cutting out. I have seperated the cyclone from the bin, how do I clean the cyclone as I think this may be the cause?

Answers :

HI there,
\012This is a tricky solution to describe so I have linked a video I made on how to clean the radix assembly of a Dyson DC07. Have a look at the video it should be pretty clear what you need to do. If you find you need parts for your Dyson check out Nelson Vacuums or VacuumSpot.
\012If this is a helpful video please take a quick moment to give me a thumbs up, a comment or a testimonial I like to hear back from you guys.
Repair Help & Product Troubleshooting for Dyson DC07 Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dyson DC07 keeps cutting out. I have seperated the cyclone from the bin, how do I clean the cyclone as I think this may be the cause?

HI there, \012This is a tricky solution to describe so I have linked a video I made on how to clean the radix assembly of a ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson DC07 My DC07 cuts out after 5 mins and I want to replace the thermal cutout. I have cleaned it thoroughly, including the cyclones but it still cuts out. How does the plastic moulding around the motor dismantle? I have started by removing the 4 torx screws but the upper grey housing does not want to detach and I am worried about breaking the plastic. Appreciate any advice.

Try this page: -http://www.fixya.com/support/t192124-overheating_dyson_dc07Regards Gualo ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I want to clean the cyclones on my DC07 Dyson How do get the yellow top off of the glass bin?

Hi there I have made a video to show you how to clean out the radix tubes on a Dyson DC07 vacuum cleaner. If it is helpful to you please take a moment to give me a thumbs up or even write a testimonial. If you need to get filters or other ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Cleaning! To clean the cyclonic cone Dyson say to use can-air? that may be ok for computers but not to blow out the dirt and dust from the cone in question. Someone else here suggested to use a real compressor! Well dahhh I knew that! Should I do the blowing in the living room? or may be in the bathroom? Seriously what I need is an assy. drawing to take it apart and washing it Any ideas where I can get one? Thank you John

Hi, we realy love our Dyson, but get frustrated when it gets clogged with pet fur (2 cats and 2 dogs). This takes a little effort but what we ended up doing was taking the vacuum apart into its major components and alternately blowing it out, filter ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Dc07 problem I have a dc07 cyclonic vaccum and like this model,however, for some reason,it has been very dificult to push and pull for the past month or so. i have completely cleaned the brush assembly,cleared any obstructions in the hoses,and, cleaned the filter.I also checked the belt tension,wich i thought was fine but to no avail.Be advised that the brush assembly is spinning and suction is excellent. It just feels like the brush drags along the carpeting. this is a great vacuum cleaner and

The dyson uses two belts, one from the motor to a clutch and then from the clutch to the brush roller, the belts that they use are not much better then any other belt ( those you should change yearly ) but you cant just change the belts you have to c ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

On the DC07, the entire cyclone assembly must be removed to empty the dust, debris, etc. collected when vacuuming. On the top of the cyclone is a "trigger" that you lift with your finger to release the bottom catch, which allows a clear flap to open on the "clear bin," thus letting all the debris fall out. My problem is when you lift the finger trigger, it does not release the catch on the bottom. Since the catch won't release, I cannot remove the entire clear bin either from the cyclone.Any sug

Beofre you go to the extent of buying a replacement canister, you can remove the top and using a straightened coat hanger type thing open that bottom lid. Then maybe you can clean the rim and possibly add some silicone spry to loosen things up. Here' ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My dyson d14 animal keeps cutting in and out. When it's on, the hole above where the filter is, keeps making a loud suction noise and it won't clean up hair and dirt.

Vacuum Cleaners require AIr-Flow. Your machine is not getting any air-flow. The noise you hear is a valve opening up to prevent your machine from overheating and burning out the motor. You probably have an obstruction somewhere in the machine. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Why does my dyson dc04 work for about 5 mins then cut out the wire on my dyson 04 needs replacin but i cant get the casing off. My DC04 cuts out after abou 5 minutes use. I think there may be a thermal cut-out somewhere?

Thermal cut out in coils of motor,you have not been keeping filers clea,I THINK.\015\012motor is avaliable ... Vacuums

Electrolux twin clean vacuum cleaner. After 5 minutes it keeps of thinking the filters need cleaning (and they don't). I re charge the power, and all seems fine and then it goes back to wanting the filters cleaned. The suction is also not working to full capacity.

Because the suction is not working fully it feels that the bags must be full and the air cannot be pulled through the bags. It could be due to 1) bags not being of correct quality. The air has to pass through them to allow all the dust to reach there ... Vacuums

Dyson DC07 keeps cutting out and smells of

Does it smell like an electrical burning smell? sounds like your motor has went bad. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Stuck Roller Same problem here. I think in our case, the accumulation of hair and the increasing resistance the hair created over time caused the hair to start melting, and eventually the end cap was stuck to the roller, which prevented the roller from turning. I cleaned out the melted hair(?) as best I could, but I think I need to order a new roller and end caps.

Befrore you plunk your $ down ...\015\012\015\012I dont now that you melted the hair so much as you may have an accululation of gunk and hair. If there is a good (not 'fast food' type) auto parts store near you, go there and ask the cou ... Electrolux 1910 Bagless Upright Vacuum

High pitch My Hoover fusion vacuum cleaner began making a high pitch sound that makes it very annoying to vacuum. I cleaned all the things I could clean. I even cut out all the hair that was entangled in the brushes. Any idea what is causing the sound. It sounds like an siren is going off.

The Hoover Fusion has design flaws in the motor, including a metal plate that is too thin to contain the forces acting on the motor, particularly the constant strong tension from the drive belt, and a plastic plate that is attached to the metal plate ... Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum

I have a Panasonic MCE6003 vacuum cleaner. I regretfully leant it to a neighbour and it came back full of dog hair and keeps cutting out. I cleaned out the dust container and the main filter but it still kept cutting out after 5 minutes. I decided to unscrew the part with the motor and wash the filter inside.It was all going well until a large rubber washer bit, a piece that looks like the thermostat and a little white button attached to two black wires fell out and now I have no idea how to put

... Panasonic Vacuums

Got a Electrolux twin clean vacuum cleaner still keeps cutting out every 20 seconds even after cleaning and turning filters around

... Electrolux Vacuums

Dyson DC07 cyclone release catch will not click (lock) back into position after removing the clear bin assembly to empty the bin.

... Dyson DC07 Bagless Upright Cyclonic Vacuum

My Dyson DC07 stops working after a few minutes. It works again after a further 10 minutes and then cuts out again. I have cleaned the filter and checked for blockages but is still cutting out. Can anyone help?

Have you tried calling Dyson? I had a problem with my Animal, and their tech department talked me though the fix. Worth trying them first. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I noticed that the little side brush doesn't turn anymore and the Dirt Dog stops about every minute now so I have to keep turning it back on! I have dismantled the brushes and cleaned everything out but that didn't help at all. It doesn't really come apart any more than that for cleaning. Any suggestions as to where my problems may lie?

... iRobot 1100 Dirt Dog Bagless Robotic Vacuum

Want to clean shroud of DC07, have done it before, but this time (and following users manual directions) the bin release catch doesn't seem to be enough to get the clear bin off. It's so stuck together! Help?

... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson dc07 cuts out after a few minutes ? - Dyson DC07 Bagless Upright Cyclonic Vacuum

There is a cut-out device on the motor which senses when too much current is being drawn, which in your case sounds like it is tripping because the motor is developing a fault and will likely fail completely soon.\015\012\015\012New motor ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson cleaner keeps cutting out, no blockage found, filter clean.

1. Check the on/off button these can also be troublesome and if you've stood on the cable once or twice you could have a break in the wire and it's shorting, check by turning on and wiggle cable around where it enters machine.\015\0122. Faulty ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

DC07 cutting out

This may help!http://www.fixya.com/support/t192124-overheating_dyson_dc07 ... Dyson DC07 Bagless Upright Cyclonic Vacuum

How do you clean hepa filter on dyson dc05 - Dyson DC07 Bagless Upright Cyclonic Vacuum

You can use compressed air to blow it out ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I own a Hoover Steam Vac V2 deep cleaner with Auto Rinse feature. The Model Number is not available ex: was on the bottom of the machine and the sticker is completely worn off the machine. I am having a problem with the bottle you fill with detergent ex: this bottle is seperate from the main clean water tank. THE PROBLEM: The little plastic part that goes in the bottom of the bottle has an "O" ring ex: cone shaped with a spring.....it keeps falling out. Can you supply a part number for this

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=641300\015\012Generic problem for all Vacuums\015\012I own a Hoover Steam\015\012Posted by w_brennan on ... Vacuums

How to clean filter on dyson vaccums - Dyson DC07 Bagless Upright Cyclonic Vacuum

The filter on the side of the of the unit can be washed out with warm soapy water leave for 24hours to dry somewhere warm do not tumble dry the filter under the bin just replace as the cannot be washed. ... Dyson DC07 Bagless Upright Cyclonic Vacuum


You can get Eureka replacement belts here:Eureka Vacuum Betls ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0735 seconds