Having problems with your Dyson DC07 Bagless Upright Cyclonic Vacuum ?

Armature sparking is visable

\015 Sparks/flashes can be see when running - no smoke / fire\015

Answers :

It probably will need a new motor, it maybe safest to take it to a professional.
Repair Help & Product Troubleshooting for Dyson DC07 Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Armature sparking is visable

It probably will need a new motor, it maybe safest to take it to a professional. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Armature sparking unit seems to work fine, i can see sparking from armature recently

... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

My riccar rc1100 needs a new motor. motor is a daewoo and the armature is now bad causing sparking. how can i get a replacement motor?

You can purchase one from www.acevacuums.com ... Riccar RC1100 Compact Vacuum

Bissell Powerwash Proheat. model 1698-j, 220-240v, 50/60Hz, 1200-1400w. Motor stopped suddenly (ident label specifies type Ametek 119464-02), supply inline fuse at motor ruptured, fuse replaced but motor sparks like an angle grinder at armature and blew replacement fuse. Where can I obtain a replacement carbon brush set for the motor. UK based

... Bissell Vacuums

I'm installing a new ignition module on a bc24w weedeater trimmer--the part has 2 screws holding it on-it is apparently adjustable--what gap setting should I use between it and the magnet (armature & rotor??) Also what is proper spark plug gap? Thanks

I usually use a match book cover between it and the magnet. this way the gap is about right and it will not hang on the magnets. put through both sides at once, then push it in and tighten it up. then take out guage. spark plug gap is .025, the armat ... Vacuums

My G4 tech dive has been jerking and began giving off blue sparks then stopped working altogether -any ideas what could have failed? moto? armature? carbon brushes? a fuse :)

Armature and carbons, 79.00 arm 14.99 carbons, should change carbons every 3-5 years or you will damage armature ... Kirby G4 Bagged Upright Vacuum

Sparks from the Kirby Motor

1. Do you think this may be the problem?YES\015\0122. How come it continues to rotate? ... Kirby Ultimate G Bagged Upright Vacuum

Good armature maybe needs new brushes

Hello,\015\012Carbon brushes wear over time and may need completely replaced...it doesn't cost a lot and i have guides available for the repair. Try my troubleshooting guide....\015\012\015\012 ... Kirby G4 Bagged Upright Vacuum

Noisy sparking james hoover

... Vacuums

I have a dirt devil that is only 2 years old, I used it and sparks began to shoot out from the front grill area. I called dirt devil's corporate office at 12noon today July 25th, and was told that with out my receipt there was nothing that could be done and since I only paid $39 for the cleaner I should just get another one. This product is a fire hazard!!!!!!!! I was vacuming near my bed when the sparks began, I find it unbelievable that this was taken so lightly. If my home had burned d

... Dirt Devil Vacuums

Motor is sparking and smells like burning rubber. When it first happened I thought the vacuum had something jamming the beater bar. That was the smell it had, like when the belt gets burned. But when we turned it over, it wasn't jamming. Took off the base plate and turned it on. The motor area is sparking and it makes a weird noise (I assume that is because the motor fails and restarts). I looked for loose wires, can't find any. I believe I need some sort of part replaced, maybe even a n

From sound and description most possible is motor is burnt up sparks usually mean metal on metal either bearing or bushings went on motor if u can jiggle the shaft thats bearing if u rotate the shaft by hand and feel and or hear rough grinding the br ... Oreck Vacuums

The Oreck vacuum motor sparks the stop running. Plugged to another outlet, the motor did the same things, run for few seconds with sparks and stopped again.

... Oreck XL2200 Bagged Upright Vacuum

My Ryobi 720r wont start. Absolutely no response at choke + engage lever. I checked the spark plug but no luck. Just test i put little gas in the spark plug chamber. It started only to burn what was in the chamber then stopped.

... Vacuums

My honda gx390 pressure washer is not starting. It is backfireing through the carb. Will run if I pull enough sputters them might kick in and run then will die. I have cleaned the carb & float bowl and changed the oit so it is up to leavel and seem to have spark but could be better spark. It was running (allthough not well ran out of gas and then I filled it up and this is what I have. Thanks for any help.

... Vacuums

Hello can you help me please? I have a Kirby G4 vacuum cleaner, It did work ok until it started to give off burning smell and lots of sparks from the brushes. I have changed these brushes, the motor still rotates but it still gives off sparks and burning smell. Do i have to change the motor as well? Can you help please? Thankyou Martin

Some debris, even sand or dirt, probably got into the motor, causing damage to the armature. If this is the case, you will need to replace the motor. The burning smell from the motor is generally a sure sign of a bad motor. ... Kirby G4 Bagged Upright Vacuum

How to remove a Kirby Heritage II Armature

The armature that holds the fan on is reverse threaded. It turns to the right to remove it. You can put a nail or nail punch in the hole on the armature and tap it gently to the right. this should loosen it enough to unscrew. There's a washer, ... Kirby Heritage II Vacuum

Dyson dc18 yellow sparks after Dolls hairnet got caught ironed brushes

... Vacuums

There are sparks coming from the underside of my oreck xl vacuum.

You probably need to take that in and have it serviced at a repair shop. They can check the motor to see if it needs to be replaced or just cleaned. The noise could be bad bearings or a fan problem as well. ... Oreck Vacuums

Sparks in the el. motor of Electrolux Canister.

How do you remove the vac motor from the electrolux vac model 8502 B? Looks like I removed all screws but I must be missing something??? ... Vacuums

Plugged in my vacuum and the outlet sparked

... Envirocare Hoover Windtunnel, Twin Chamber Bagless Vacuum Filter

Sparks came out of the area of the foot switch and

This is now a dangerous appliance and should be repaired by a qualified tec ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Sparking motor brushes

Sounds like your motor has had it, its possible to replace the carbon brushes, but probably wont last much longer.If you visit\012http://www.sparesaver.com/help-and-support/dyson-section/dyson-technical-advice-450/\012they have alot of in ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Sparking motor on Dyson assume motor brushes at fault?

Hi there,A replacement motor can be purchased direct from Dyson via our Helpline on 0800 298 0298 at a cost of £36.31. Alternatively we can arrange a service for £69 which includes parts, labour and VAT. This can ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Filter Queen motor brushes sparking??


Its spark at the back of the motor when its turn on.

Yep very common of dyson vacs you will have to get the motor replaced not an easy job to do you might if you dowant to give it a go go on to youtube n search for fit dyson motor that will show how its done good luck  ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0179 seconds