Having problems with your Dyson DC07 Bagless Upright Cyclonic Vacuum ?

Bottom of dirt container doesn't stay closed

\015 When I try to empty the dirt container, normally you squeeze the button to release the dirt. My does not stay closed. When I remove the container from the machine, the trap door opens and all the dirt falls all over the vacuum and floor. HELP. thank you.\015

Answers :

The catch/latch that is on the bottom of the bin button release has likely broken.  \015\012
\015\012If you take out the canister (as when you are dumping the bin), and flip it upside down and then squeeze the bin release button, you will see that it moves a rod inside the cyclone assembly.  At the end of this rod is a plastic (plastic.. redundant, as the entire Dyson is practically plastic) latch that catches onto the bin's lid and locks it in place.  A broken latch means it doesn't lock the lid in.\015\012
\015\012What you need is a replacement latch.  Note that the "Bin Release Button + Rod assembly" that are sometimes sold on ebay do *not* contain the latch at the end of the rod.  Also the bottom bin assembly does not contain the required parts.\015\012
\015\012The cyclone assembly should have the full bin release rod + latch, so if you can't find the latch, then a new cyclone assembly would work also (but will cost more, obviously).
New bin assembly req.We can supply this by post approx cost £20.00 ish +p&p
Repair Help & Product Troubleshooting for Dyson DC07 Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bottom of dirt container doesn't stay closed


The catch/latch that is on the bottom of the bin button release has likely broken.  \015\012\015\012If you take out the canister (as when you are dumping the bin), and flip it upside down and then squeeze the bin release button, you will s ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Bissell cleanview 11 bagless special edition model 3576-2 I took apart to clean the filters and don't remember howto put the bottom of the dirt container back. I thought I put the empty container back in place correctly but the dirt when vacuuming is flowing through another part of the vacuum.


... Bissell Vacuums

We have a beam Serenity plus home vacuum system and there is no longer sucks. I removed the dirt from the bottom plastic container, but I also notice a sack or bag connected to the unit when I removed the bottom container and inside that sack there appears to be lots of dust. How do I access that and remove that dust without damaging the unit. I don't know how to do that


Hello. Let's begin by getting that dust and dirt out of your permanent filter. To do this, get a big clear plastic bag and pull it up aroung your canister, with the dirt receptacle removed. Then Grasp the sewn in weight inside of the filter and sh ... Beam Industries 2900 Serenity Plus Central System Vacuum

My Dyson DC14 Animal doesn't have the suction it used to. The piece in the back on the bottom - a flap it appears - stays open now, causing the machine to make a louder noise than usual. At first, if I put my hand on the flap opening it would close, allowing for normal suction. Now, it stays "open" permanently", causing the loss of suction.


Hi its Darran at Dyson.Having had a look at a DC14 here, I am unsure as to the part you are referring to. So that we can help you further, please contact our Helpline free on 0800 298 0298, between the hours of 7am - 10pm, 7 days a week. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I have a Dirt Devil M088400 - Vision Turbo Vacuum. A spring fell from the bottom and the carpet height adjust isn't working. The rollers under the unit won't stay in place either. Can you tell me how to put the carpet height adjust back together?


The roller attaches to wheels. There is a spring that attaches from roller to hight adjustment selector which is a plastic peice with a little hook on bottom that spring attaches to. Both peices should have a hook that the spring ttaches to. ... Dirt Devil Vacuums

I cleaned it out but it still wont **** into the dirt container it all ends up getting cloged in the opening on the bottom


... Bissell 6594 PowerForce Bagless Upright Vacuum

We had to take the bottom of the vacuum apart to remove dirt that had plugged the hose. We cannot put it back together so that the smaller round belt stays tight. I need a diagram of how this belt is supposed to fit.


Most vacuum manufacturers avoid putting their shop manual in the public domain. There are various reasons for this, some good ones.\015\012But I did find this. Maybe it'll help.\015\012 ... Hoover U6441-940 WindTunnel Bagged Upright Vacuum

Canister problem When I lift the canister off to empty it, the flap at the bottom swings open, depositing 3 dog's worth of hair on my foot! The flap won't stay closed - even after I cleaned off the seal. HELP ME! Please.


Check that the plastic piece isn't broken. I had to replace my canister once because the little detent where the clip holds the base down was bent out of shape. It's too fragile to bend...just replace it. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

The dirt stays in bottom hose. i took the big top hose and checked for blockage...but wont suction to canister


Did you drop something down the hose to see if it would come out the other end? The dirt inlet down by the brush roll may have a clog in it. From what you say, there has to be a clog. ... Vacuums

I cleaned it out but it still wont **** into the dirt container it all ends up getting cloged in the opening on the bottom


Double check the elbow at the base on the right hand side (back facing you) of the vacuum for clogging. \015\012\015\012Many times it will appear free but be packed solid at the elbow just out of sight, there should be a screw on lower ri ... Bissell 6594 PowerForce Bagless Upright Vacuum

Keeps switching off It seems to overheat ,and for some reason the dirt collects and stays at the bottom of the cylinder. please help Alex


HIIts blocked up and overheats. Check in by the brush and the hoses. If all clear check filters ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Vacuum will not pick up dirt. plate in hose stays shut. It has a spring that goes to the plate assemily but will not open. What make it open and close. U6616-900 Hoover Vac Alex


Sounds like you have a valve arm not operating properly. The valve door sould spring open when you lower the handle and will shut when the handle is raised and pushes down on the rear valve arm. See a parts diagram and look at parts 39-41 and 19. ... Hoover U6616-900 WindTunnel Bagless Upright Vacuum

Picks up some of the dirt but does not send it to the canister it just stays in the base and clogs up the bottom hose. There is no suction on the detachable hand hose. Have cleaned out all filters and the belt is new. Cannot figure out the problem!


Have you checked all of hose,detatchable and fixed if it has any,for holes,kinks and blockages sounds like a lack of suction ... Vacuums

I have an eye vac professional that will not stay on to **** up the dirt. There is power to the outlet and the blue on/off light does stay on, but in Auto mode if I stick my hand near the dirt sensor it just pulses on and off. I can feel the suction, but it won't stay on. I've unplugged it, removed the dirt bin and filters and nothing works. Help!!!! This is brand new and I've only emptied the collection bin once and it hasn't worked since.


... Vacuums

I have a Everstar Central Vac CV303. I emtied the Dirt Container for the first time and tried to put the dirt container back on but the clamps are too loose and when we turn the vac on the dirt conta


... Vacuums

Embedded Dirt Finder green light won't come back on - stays red


... Hoover U6634-900 WindTunnel Bagless Upright Vacuum

Dirt is coming out the bottom of my Kenmore Progressive Upright Vacuum. My husband found a large dust bunny in the drive belt and removed it. He also changed the bag. Why is dirt coming out the bottom? Thanks.


Its still clogged, you gotta dig deeper ... Vacuums

Dyson DC07 bin trapdoor won't stay closed: The small plastic piece on the tip of the center rod on the cylone assembly broke off, so my trap door won't stay closed. Any idea how to find just that part, so I don't have to replace the entire cylone part?


You can buy that part here: Dyson DC07 Spares ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a Dyson Animal upright (purple). I took it apart to clean the cyclone chambers. When re-assembling the bottom closed before the opening rod was inserted. I can't get the opening rod installed with the bottom opening closed. How do I open it? Thanks.


I looked in our DC07. I would try removing the top again and getting a long dowel or the opening rod, insert it down into the unit and PUSH. The opening rod opens the latch by pushing it, not pulling it. Here are some pictures of the latch. Top pi ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have Vaporetto Lecoaspira 715. Its dirt container is broken. Anyone know the place where I can order a new dirt container with handle? Thank you.


... Vacuums

I need a manual on Kenmore Model 116 33720200. I am unable to get the container off that is full of the dirt. How do I remove the container?


... Kenmore Vacuums

It has no suction. It was fine yesterday. I washed the dirt container and the filter, let it dry and put it back in the vacuum. Today my vacuum isnt picking up any dirt and has no suction. When I took the hose out of the back, it started blowing dust and dirt out but still no suction.


Look for a place where the vacuum line has to turn in a near 90 degree turn. It's easy for it to get stopped up there. ... Vacuums

I recently ( approx. 2-3 months ago ) purchased a dirt devil. Now it is not picking up properly. When I push vacuum forward it picks dirt up a little bit, when I pull it back all the dirt falls out of the bottom. I replaced the filter today and it has not solved my problem. I dont know where my warranty is. Can you please help me?


Hi sounds like your line is stopped up somewhere , check ur suction an make sure your brushes are spinning, if they are try a wire clothes hanger to the hose at the bottom hose to dislodge anything that mite be stuck ... Dirt Devil Vacuums

Hoover steamvac when I use it it leaks out of bottom. when it off an water in tank leaks out of bottom,when its off an I pull the triggar it flows big time out of bottom. tank doesnt leak when off sitting with water in it


Let me start out with an apology. I did not ask my question very well - and you did not answer it as I needed.\015\012If you wish, we MAY be able to communicate in your native language. We can do most indian languages, Turkish, Ukranian and s ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Bissell Bag Powerforce vacumn is not picking up properly. Dirt stay on carpet or blows back out. I have removed the hose and got a lot of clogged dirt but can not get all the dirt out cause I can't reach it.


... Bissell 3522 PowerForce Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0459 seconds