Having problems with your Dyson DC07 Bagless Upright Cyclonic Vacuum ?

Less than normal or no pickup from cleanerhead

\015 My brush bar does not appear to be connecting with the carpet when I vacuum, thus leaving most of lint behind when I vacuum and not "fluffing up" the carpet. The brush control is set to carpet mode and brushes are rotating. I have had the vacuum since 5/08 and 3 days ago washed the filter and air dried it (even though it didn't appear dirty.) At that time there was a large amount of hair etc.on the brushbar. I followed directions, removed the soleplate and cut the threads, etc, from the brushbar. the soleplate is securely back in place. How do I get this cleanly rotating brushbar to connect with my carpet again?????\015

Answers :

These are not real powerfull vacuums (I know not what you have heard) but make sure bottom plate is fully sealed I see customers put these on wrong and the brush does not make good contact
Repair Help & Product Troubleshooting for Dyson DC07 Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Less than normal or no pickup from cleanerhead


These are not real powerfull vacuums (I know not what you have heard) but make sure bottom plate is fully sealed I see customers put these on wrong and the brush does not make good contact ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a Miele Vacuum cleaner MedicAir 5000 Plus. Recently the Dust Bag Indicator bar is full during normal cleaning and consequently the suction power is much less. I replaced the dust bag, engine pre-filter and Hepa filter but no change. When i remove the hose, the Indicator is normal, but when i attach the hose, wand, head, the indicator is full. I checked the hose, wand, head but can't see any blockage and when i blow with my mouth it seems fine. Can anybody help? thanks!


... Miele Vacuums

I have the top of the line kenmore canister vacuum. According to the bottom plate the model nimbler is 116.28015700 I was doing the normal vacuuming and the bag full light came on and the vacuum action stropped. There is still power to the mortorized handle and agitator attachment. Is there some type of circuit breaker reset button for the vacuum function? This unit is probably less that two years old and has had very little use


... Kenmore Vacuums

Model # zw5000y8 The air conditioner is less than 2 years old, and has leaking water from the from of the air conditioner. I contacted Home Depot where I purchased the item and the only advice they could offer was that there was something wrong. I purchased two of the same air conditioner and I havent had any issues with the other. Can someone please offer any advice on the reason that the air conditioner is leaking from the front and filling up with water, not the normal condensation,


... Vacuums

No suction I just replaced the bag, and normally after this I have a lot of suction. Now that I have changed the bag I have less suction that I had before. Not even enough to picj up dog hair. I snaked he hose and checked all of the connections. It seems to have an air leak but no amount of tape will fix this. I cleaned the filer as well with warm water and dried it and re installed but still absolutely no suction. I am ready to throw it out! Any suggestions would be appreciated


1, Does the blower (discharge) side blow bunches of air??Yes: Something is clogged from the bag to the hose end. Try blowing out the hose from the discharge side.Or: The bag is not properly seated. Make sure that the plastic piece is ... Kenmore 23313 Whispertone Bagged Canister Vacuum

The wet pickup and the dry pickup switch on my Hoover Floormate have stopped working. Only the scrub cycle works. Needless to say, it will not pick up wet or dry. Can you tell me what the problem may be and how to repair it?


... Hoover Floormate H3000 Upright Wet/Dry Vacuum

I have a VX3000C Broan vacuum and the motor sometimes runs lower and comes back to normal time and time. Plus, now it lamost stops before coming back to normal speed. Can someone explain to me what that might be or if it did happen to someone else? It doesn't stop, but runs at very low speed and come back. It is like if a connection is not made properly. But it does the same at my 3 connections and I did check the one on the vaccuum itselfs.


... Broan-NuTone VX475 Bagged Central System Vacuum

Had a burning smell and you could hear the power getting less and less before it totally cut out,im pretty sure its the motor but would hate to spend out when it might be something else


HAVE A LOOK UNDERNEATH ON THE RIGHT HAND SIDE AS YOU LOOK AT IT THERE IS A DRIVE BELT TRY THAT FIRST AS THEY BREAK VERY EASILY ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a hoover Core vacuum. The problem is that the blue light flashes (as normal) when it is plugged in and the power is turned on and the blue light stays on (as normal) when you turn it on at the button but it makes no noise and doesnt work. All of the filters are clean. Can you help please?


... Hoover Vacuums

Pickup water wont pickup the water after putting it down very little comes up into the tank .it worked fine when we baught it but after not useing it for some time it worked now it wont **** water up at all can anybody help.


The clear shroud covering the front of "hood" has two sheet metal type screws at the bottom in front of the brushes, these two screws also hold the little straight brushes ( one on each side) in place. I found one of these screws had broken it's plas ... Hoover F6020-900 SteamVac Upright Vacuum

I have a Roomba 560 (it's still in warranty !!) and, after my summer vacation, it has a problem. When I'm charging Roomba, the orange light blinks (and this is normal!) but this orange blinking continues forever.... the light doesn't change to green. If I detach Roomba from the charger, the light become green and it works normally until the light changes to red and I have to charge it again. WHY, DURING THE CHARGING PHASE, THE LIGHT DOESN'T CHANGE FROM ORANGE-BLINKING TO GREEN? HAVE I


The problem is not with the charger itself but it is with the battery inside the Roomba. It sunds like one or more of the cells has gone bad so its not holding the same charge as it did. I would recomend sending it in while the warranty is still vali ... Roomba Robotic Floor Bagless Vacuum

My scooba when switched on starts to spray water then spins round faster than normal then starts to go backwards quite quickly then stops then continues to reverse more then stops & with the nor


... iRobot 5800 Scooba Vacuum

It wont let me sew,because it wont pickup the bobbin thread


... Singer 7462 30 Stitch Touch & Sew Machine

Dyson vacume repair in ri seems to not pickup as


... Dyson DC07 Bagless Upright Cyclonic Vacuum

Won't pickup water on rug


I may have already given my best advice but, check the hose line to the extraction tank and make sure there are no cracks in it. This will allow it to **** in air, and therefore reduce the vacuum pressure at the head of the machin ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Wont pickup wet


Either some dirt and grime is causing the lever mech. to jam or inside the noozle asm. it came out of place or broke, either way you will have to dis-asemble it to find out. You maybe able to really push on it and it may unjam if that is the problem ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Bissell doesn't work after less than 2 years-no suction power.


Replace belt clean / replace the filters especially the one on the front just below the tank and there's another inside the upper tank it twists off ... Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum

NEED WATER PICKUP HOSE ASSEMBLY FOR FH40000


All availble Hoover parts for the FH40000 can be found on usavacuum.comFollow the link below to the sitehttp://www.usavacuum.com/catego ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Hoover steam cleaner wont pickup water


In the front on top the cover that curves down to the floor is where the suction is .it should be plastic you can see into.its probably clogged with hair and dirt.you need tro take that top off and it comes apart in two sections .the middle seperates ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Vacuums normally but no suction through the wand


Keep cleaning ... there is a clog somewhere.\015\012\015\012Thanks for your intrest in FixYa.com ... Fantom Vacums XT450K Upright Vacuum

When I turn on mt dyson is sounds normal. once I


With the DC14 in its upright position, and looking from the back, there is an access hatch just to the right and bottom of the dust canister. Remove this and check for any obstruction. With the hatch still removed, tilt the handle back (as if vacuu ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Whiny motor, less suction


Its not unheard of that the lifetime filtration filter may need replacing and dust can work itself into the main motor chamber even though Dyson claim their models have sealed motors. Whiny motors however can happen for a number of reasons such as: ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My vaccuum seems to clean, but makes a louder noise than normal


Hello,\015\012\015\012I would check and clean any of the filters also check the pipes for any blockages etc.\015\012\015\012Regards\015\012Alan Hood\015\012ami-man ... Dyson Vacuums

Why would my dyson dc 17 brush motor be extremely loud, but sound normal when brush is not spinning?


Could be the bearings on the end of brushbar need replacing,or it may be the clutch needs setting , lower the handle down to the floor then up again do this about three time to reset clutch.... ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I bought a vacuum for my daughter and it worked a week before the switch went on it. how can i get a switch C2006B 31cx E306773 these are all of the numbers that are on it. Like I said she used it less then one week and it has sat since then. THank you Klynn1979 Kay


If this was new when you bought it, it should have a years warranty on it. Otherwise you will have to find a repair shop that will order it for you. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0134 seconds