Having problems with your Dyson DC11 All Floors Bagless Canister Cyclonic Vacuum ?

Where is the on / off switch located on a dc11 please?


Answers :

The button is located on the top left on the rear of the machine. It's a Yellow circular button with a circle and a vertical line in middle of it.

Here's a copy of the Owner's Manual for the DC11

Hope this helps
Repair Help & Product Troubleshooting for Dyson DC11 All Floors Bagless Canister Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where is the on / off switch located on a dc11 please?


The button is located on the top left on the rear of the machine. It's a Yellow circular button with a circle and a vertical line in middle of it.Here's a copy of the ... Dyson DC11 All Floors Bagless Canister Cyclonic Vacuum

Paul, I have samer problem with SEBO X4 height adjuster. Please can you explain to me where to locate the reed switch and magnet.


... Sebo X4 Bagged Upright Vacuum

I press the on/off switch on the Dyson DC05 and the vauum cleaner switches on unfortunately when I stop pressing it it switches off again. Please advise how I would need to repair this. Many thanks. Regards Michael Segal


If you can make it work by holding the switch down then it must be the switch or a bad connection on it. The only way to find out is unplug the machine from the mains and remove the switch to check it. A replacement should be cheap enough.pete ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

The switch on our Hoover Windtunnel vacuum cleaner is not working. I have located the replacement part on your website...part#Ho-28161067, I've removed the wires from the switch. Is there any trick to actually removing and replacing the switch itself? It seems to be in there rather tight.


No, follow the directions to replacing the switch and you should be good. if you got the kit then splice the wires and replace them with the wires profied and the wire nuts, you should be good. ... Vacuums

My Sebo X1 stopped working and my husband tested it and determined that the on off switch was not working. I purchased a replacement switch online but I cannot figure out how to remove the old switch. Please can you help?


Thanks for your question!I'm sorry that you haven't received an answer yet.The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:1. the question is unclear, incomplete, or poorly ... Sebo Automatic X1 Bagged Upright Vacuum

Bosch buc11700gb the motor that drives the brush doed not work, i havr checked the rest switch and the on off switch to no avail is there a 3rrd switch that operates when the handle is tilted back and where is it located?


Hiya Gotec..Standard UprightIf your upright vacuum cleaner is not picking up, but sounds ok when the motor is running, then the chances are you have one of the following problems.1: Belt. The belt which links the motor to the br ... Vacuums

Tafel Steam Iron Model 2820 3.12 104 - switch connections - can you please explain how this is works Iron stoped workin open the back and one of cales to the switch is hanging loose - but can not workout the obvious way to reconnect - can you help by showing me a diagram of the switch mechanism kind regrad


... Vacuums

My Sebo X1 stopped working and my husband tested it and determined that the on off switch was not working. I purchased a replacement switch online but I cannot figure out how to remove the old switch. Please can you help?


Www.manualnguide.com/manual/sebo-x1-repair/page/3/\015\012\015\012Above is your user manual, and below is an exploded diagram so you can see where it all goes. Find all the screws lock ... Sebo Automatic X1 Bagged Upright Vacuum

Vacuum off/on switch has play in it. when cleaning at time it will cutoff. lighty touching switch it come back on. if i keep my thumb in a certain location on handle and switch it run great it 6 months old.


You didn't say what the model is, but sounds like you need a new switch. But if less then one year old, then it is still under warranty, take it in for warranty rerpair. ... Hoover Vacuums

The solution stick inside the handle needs replaced and I would like a new face plate. I have the model numbers (38458-031 & 37275-011), but can not locate the replacement parts. This machine is more than 10 years old and works like brand new. I can not see throwing it out and want to fix it. Please help me locate these parts. Thank you!


... Hoover Steamvac F5860-900 Vacuum

Hoover windtunnel vaccum U6445-900 motor not turning on. I removed the screws and located the contacts inside. There is an on-off switch which seems to be stuck Is there a way to replace this switch


There are a number of Hoover vacuums that are subject to a recall due to an overheating on/off switch. Check out this web site to see if your is included. You'll need the model number and serial number from the back of the unit. The manufacturer w ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

My Kenmore canaster vacuum Mod# 116.25513506 runs continously when plugged in regardless of the on/off hand controlled switch.. Disconnecting the switch located on the hose assembly has no affect of the continous vacuum operation. What component in the electric motor circuit is at fault and what would be the cost of repair?


... Kenmore Vacuums

I HAVE A BISSELL PROHEAT CARPET CLEANER I DISSEMBLY IT TO CLEAN IT. I DON'T KNOW IF I PUT THE HOSES BACK IN THE RIGHT LOCATION BECAUSE AFTER I PUT IT BACK TOGETHER IT'S LEAKING WATER ALL OVER THE FLOOR BUT IT WILL RECOVER THE WATER FROM THE FLOOR AND THE SOLUTION WON'T SPARY OUT I THINK THE HOSES ARE NOT IN THEIR RIGHT LOCATION TO STOP THE FLOW WHEN IT'S NOT SUPPOSE TO BE COMING OUT CONSTANTLY HELP PLEASE IS THEIR A HOSE DIAGRAM FOR THE HOSES INSIDE THE CARPET CLEANER


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Hoover Alpina 2 1300 cleaner. I need to split the upper and lower casings to check that the switch is working. I have removed the screwa in the area around the bag, but now need to remove the switch and cable rewind covers, as I assume there are more securing screws under them. Can you advise how to do it please?


Move covers (forcibly !) away from the centreline of cleaner then move to rear until released. The covers are held by slide catches on inner edges. ... Vacuums

I just purchased an Electrolux Epic 6500 SR, Model #C102G. I found that inside the cover over the bag. But where is the Serial number? I can't seem to locate that anywhere. Also, in case it breaks, I will need a light gray color on/off switch button located near the front of the canister.rnThanks.


The serial number is on the bottom of the machine. I believe near the front wheels, but can't remember for sure.\015\012Parts can be purchased at any authorized Aerus Electrolux store. You can locate the one nearest you using the below link. ... Electrolux Vacuums

Led lights, no steam. seems thermal switch is open. what is the temp of this switch? If a part number is available please let me know. Thanks Bob Howery


Hi,No part available...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Eu ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I HAVE A BISSELL PROHEAT CARPET CLEANER 7920 I DISSEMBLY IT TO CLEAN IT. I DON'T KNOW IF I PUT THE HOSES BACK IN THE RIGHT LOCATION BECAUSE AFTER I PUT IT BACK TOGETHER IT'S LEAKING WATER ALL OVER THE FLOOR BUT IT WILL RECOVER THE WATER FROM THE FLOOR AND THE SOLUTION WON'T SPARY OUT I THINK THE HOSES ARE NOT IN THEIR RIGHT LOCATION TO STOP THE FLOW WHEN IT'S NOT SUPPOSE TO BE COMING OUT CONSTANTLY HELP PLEASE IS THEIR A HOSE DIAGRAM FOR THE HOSES INSIDE THE CARPET CLEANER


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

The ON/OFF switch does not work. Unable to turn off vacuum without unplugging from wall. After removing handle, the ON/OFF switch is in ON position, but cannot be toggled to OFF position. Please assist. Thank you.


Replace the switch. Part number 28161067 ... Vacuums

Keeps switching off It seems to overheat ,and for some reason the dirt collects and stays at the bottom of the cylinder. please help Alex


HIIts blocked up and overheats. Check in by the brush and the hoses. If all clear check filters ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Need replacement drive belt for tempest Z178 cannot locate a supplier. any assistance please?


... Electrolux Vacuums

My vacuum starts but stops immidiately I replaced on/off switch & belt but it didn't help me its still doing the same thing. Please help me out


It could be the power source .e.g. The lead or plug with a broken wire making intermittent contact. ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Heritage 2 - black wire pulled out from motor assembly, comes from power switch. Where does it go? Need wiring pictorial and schematic/wiring diagram. Can anyone please help? Many thanks, Malcolm


... Kirby Heritage II Vacuum

In my lg cyking vacuum cleaner, red light appears and the cleaner switches off. Can you please help in what is the problem and in resolution?


... LG Vacuums

I have a whole in my hose can you please tell me how I can fix it. It is located where attaches so duk tape does not hold. tnx.


There isn't anything you can do about it. If it was in the middle of the hose then you can tape it up for a temporary solution, but you're going to have to get a new hose. There's no two ways around it. ... Electrolux Epic 6500 Vacuum

My NEW dirt devil with hepa made for animal hair will NOT turn off as the switch is stuck. I hate this vacuum. Help please


Take it back. Usually when this happens it means the switch has shorted out, which can be a big fire hazard. If you feel like performing a repair; a switch replacement is relatively simple: but if it's truly "new" it should be covered under warranty, ... Dirt Devil Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0618 seconds