Having problems with your Dyson DC14 All floors Bagless Upright Cyclonic Vacuum ?

The beater bar on my Dyson DC14 All Floors Bagles vacuum cleaner doesn't turn. There is no hair or thread caught up in it. All air-flow areas have been checked and there are no blockages that we could find. Any suggestions?

Answers :

If it is not on the bare floor setting then you most likely have a belt issue it is not an easy fix I am sorry to say if your mechanically inclined I can tell you how to replace it.
The beater bar is supposed to turn freely on its shaft and is held in place by an end cap on each end. These end caps just slide on the beater bar shaft. On my DC07 All Floor model I found something had gotten between one of the end caps and the beater bar, which caused it to seize up and not rotate at all. The clutch slipped and it made a horrible noise like something had gotten caught up in it. I removed the beater bar from the housing, removed both end caps, cleaned everything out and reassembled. The bar turned freely by hand and this solved my problem.
Repair Help & Product Troubleshooting for Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The beater bar on my Dyson DC14 All Floors Bagles vacuum cleaner doesn't turn. There is no hair or thread caught up in it. All air-flow areas have been checked and there are no blockages that we could find. Any suggestions?

If it is not on the bare floor setting then you most likely have a belt issue it is not an easy fix I am sorry to say if your mechanically inclined I can tell you how to replace it. ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Eureka 4467AV overheats and shuts down after about 3 or 4 minutes of operation. I pulled all the filters to assure no blocked air flow. I assume the motor is not getting enough cooling air but i can't figure out why. checked bag for blockages as well as hoses. could the thermal protection have gone bad?

... Eureka 4467AV Upright Vacuum

I have a new bag in, checked the hoses for clogs have the motor cover off showing motor runs. Problem is vacuum has no suction in hose area, cover off where bag is and the air blows out of filter. hoses are clean no blockage.

Have you checked the filter? Many vacuums have a filter under or behind the bag to keep dust and dirt out of the motor. If this gets clogged the motor can't get any suction. Also look for holes in the hose or in the small segment between hose and bag ... Vacuums

I have an Aerus Guardian canister vacuum with a clogged hose. The tiny stuffed animal toy is lodged right below where the swivel handle meets the hose. Switching the air flow does not dislodge it. I would like to remove the handle from the hose. Any suggestions?

Consider this. If your vacuum is still under warranty, removing the hose will void the warranty on the hose. I strongly recommend calling an authorized dealer/consultant.\012Although it may seem to be fairly simple to remove the handle, there ... Electrolux Guardian Bagged Canister Vacuum

My vacuum's cyclonic action is not spinning and creating very little vacuum pressure through hose or floor brush area. I already checked, brushes are spinning, there is no apparent blockage in the canister, I took it completely apart and removed excess dust from the filter. Still no good vacuum. Any suggestions?

The following filter in your in your dump cup needs to be replaced. \015\012F24 Dirt Devil "I" Bagless Upright Vacuum Replacement Filter Style F24 ... Dirt Devil M130005 Bagless Upright Cyclonic Vacuum

Miele S7210 Has a blockage within motor area, rest of attachment clear

... Miele S7210 Bagged Upright Vacuum

My dyson dc08 has a loss of suction. A flap valve operates within a few seconds of startup which appears to divert air. I have replaced both the hepa and sponge filters but the problem persists. If there is another blockage where might it be? I cant see how to dismantle the airways to check more than the very obvious. Suggestions gratefully accepted.

You have used your Dyson too long without thorough cleaning - Here's how. Obtain a torx screwdriver, or a set of torx bits, you will need to select the correct size when you come to remove the screws. They are all the same, so you will ne ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

I have a Kenmore 116.36932 (upright-bagless vacuum) that the motor protector by-pass valve has opened. I've clean out the area between the agitator brush where the flexible extension hose starts. There was some blockage there. I checked the rest of the system (extenstion hose, back filter area, pipe area to canister and area to side filter. I took the 2 filters out and the by-pass valve is still open. Where else could there be a blockage that I can take apart to clean and put back together

... Vacuums

We have the Kenmore progressive direct drive (bagless) and have had it for about 3 years. We have taken good care of it, and paid quite a bit for it hoping that it would last for a good long time. It has started making a noise that seems to be an overflow air type of noise coming out of a bottom air outlet opening for when the air flow is blocked. We have looked into clogs, changed filters, and the whole works, to no avail! Quite Frustrating since I love this purple vacuum! The machine started

There has to be a clog or block somewhere - if the motor works, it should work did you try a wire coat hanger to go up in further where you cannot see?Bets regardsCk ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

I recently purchased a house with a Filter Queen Central cleaning system model FQ-7500. My problem is that instead of sucking air it blows the air out. How do I reverse the air flow?

Never seen this model but it is on of two things,the hose is hooked up wrong or the motor is either switched in reverse or the motor has been reversed with wire leads ... Filter Queen Majestic Canister Vacuum

Bonaire airtech professional Cordless Air Inflator. 300 psi. 12V power pack. This compressor's battery will not hold a charge and only a week air flow comes out.

... Vacuums

My vacuum isn't working. The red light indicator comes on seconds after I start it, yet there is no blockage and the brush area is free of debris. I checked all the filters and no sign of blockage there either. The brushes don't turn and there is no suction. How can I fix it?

Brush motor not working. ... Fantom Vacums Cyclone XT Upright Vacuum

I have a dyson dc21. All the sudden the hose is hardly suctioning up anything. If I take the canaster off, the top air hole suctions extrememly well, but when I place that canister back on, the suction is not going thru the hose and picking anything up. I have squeezed the hose, I feel no air leaking and do not feel any blockages...what could be wrong. It worked fine the other day and today, it won't pick up a piece of lint!

... Dyson DC21 All Floors Stowaway HEPA Bagless Canister Vacuum - Iron/Titanium/Yellow

Suction centralux vacuum two years old doesn't have the volume air movement it once had. Unit will still quickly reach an extremely high head of suction so no broken pipes. ran napkins thru no blockage, overode filter safety switch ran with out filter no difference. just don't move air like it used to

Hi!!! clean motor blower blades ,they collect alot of duct and the air in chopped,Good luck.Clean blower fan blades.. ... Electrolux Centralux Vacuum

On my M&S Air Vac AV425 central vaccuum system, the system usually turns on by inserting the vaccuum hose into one of the vaccuum outlets. However, it now runs continuously. I am able to turn it off only by unplugging the vaccuum from the electrical outlet. I would like to know how to trouble shoot the problem or how to find someone who services Air Vac systems in the Bridgewater, New jersey area.

We are a central vacuum service company and we service all of new jersey. sounds like you have a short some where that keeps your unit running or it could be your relay module thats stuck our number is 908-721-7595 its j&j central vacuum services ... Vacuums

I replaced the motor in my 6500SR Epic vacuum cleaner. Now I have 3 clear plastic hoses for air flow. I know where two of them go, Im not sure where the third air hose goes? Jan

All three are connected to the control valve assembly.\015\012The long one goes through the hole in the bag container and to the door and inside.\015\012One goes to the bottom of the bag container.\015\012The last one goes to...I ca ... Electrolux Vacuums

Why does my dyson slim dc18 keep shutting down, even though i keep it clean. Filters area is clean and all others have been properly blown out with air from a air compressor. It will work for about 5-10 minutes and then shuts down. Smells like ****, check the belt and a bit later it restarts again. It's seems to be almost over heating.

Maybe your motor is going. Here's a link to a site that talks about motor failure and replacement in a DC07 (not DC18). I don't know exactly what the odor smells like but maybe you can see if you have any of the other symptoms. Good luck! ... Dyson Slim DC18 All Floors HEPA Bagless Upright Vacuum - Iron/Titanium/Yellow

My Filter Queen just started making noise from the motor area, it was very hot. Upon removing the top thing that covers the area where the air blows out, there were sparks and it smelled pretty bad. My guess is the motor is shot. Is this difficult to change?

The motor will need either a rebuild with new bearing, or replacement. Parts should be no more than $100 .EASY project. 20 minutes max fro a pro shop. If you can tie your shoes you can do this one yourself. If replacing, upgrade to a ball/ ball ... Filter Queen Majestic Canister Vacuum

I'm trying to use the reverse flow hole on my Miele s712 to blow up an air mattres. None of my fitting appear to fit so I can use the hose. Is there something I'm missing? Is there a trick of the trade? Or am i missing some gear. It's new, out of the box but I just can't get the hose onto the reverse flow. The Poduct is a Miele S712 vacuum dispite what this system has allowed me to enter. ; )


I have a Tatung AllerFree Supra air purifying system (model AC-1200WH) I am looking for a replacement Hepa filter cartridge that will work in my discontinued advance air cleaner. I would appreciate any suggestion or help you could offer. Thank you, Barb

You can get filters from "New Vitality" $25 a filter if you sign up to get them every 3 months. ... Vacuums

Suction stopped. Roller and belt working-in fine order. Checked hoses have not found any blockage. Blowing out air or sucking so little can't feel it with hand on hose end. Help!

Either a blockage or the main air filter is blocked , some it can be washed and others it must be replaced I would check the owner manual and look at the filter, foam ones can and usually have instructions where they install to wash them. ... Hoover Tempo Widepath Upright Vacuum - Blue

The filter housing on my bissell lift-off does not seal, and the air flows around the filter. How do I fix?

You may need to order a new HEPA Media filter door. Here's the link to purchasing a new door.\015\012http://www.bissell.com/par ... Hoover Bissell LiftOff MultiCyclonic Pet Vacuum

My infinity vacuum has an air flow restriction/no suction

... Vacuums

I have suction in the hose but there is no suction in the head area and there are no blockages

I have the same problem with dyson did u ever figure out hoe to fix it?? ... Sharper Image Dyson Slim DC18 All Floors Vacuum

My hoover f5805 is not sucking any water up in the filter area any suggestion

... Hoover Steamvac F5805 Upright Wet Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0331 seconds