Having problems with your Dyson DC14 All floors Bagless Upright Cyclonic Vacuum ?

Vacuum won't stay on. When I push the button to start it, the motor shuts off as soon as I let go of the button.


Answers :

You have a broken switch (replace) or hopefully something caught under the switch. Regards Billy
Repair Help & Product Troubleshooting for Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Vacuum won't stay on. When I push the button to start it, the motor shuts off as soon as I let go of the button.


You have a broken switch (replace) or hopefully something caught under the switch. Regards Billy ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

My vacuum won't stay on. Will start when I push on button but will shut off as soon as button is released.


... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

My dyson won't stay on. I push the red power button and it begins to start but as soon as I stop pushing it, it stops. It will only work if I keep pushing down the start button the whole time I'm using it. HELP!!! I love my vacuum!


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I push the button to turn it on and it doesnt stay on. if i hold it down i can vacumm but as soon as i let go it stops. how do i fix it.


Most likely the ratchet mechanism on the switch is faulty.Switches are available if you search on ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I can't get my dyson to stay on. If i push the purple button down it comes on but as soon as I take my finger off it shuts off


The actual power button mechanism has failed or become dislodged. It is a tiny little switch inside that purple button that has stopped working, or has slid down a tiny bit, far enough that the purple button isn't engaging it. I believe ... Dyson Vacuums

Canister vacuum keeps turning off, can push buttons on wand handle to restart but shuts off again as soon as you start to move handle


Its sounds like the problem is either the power head wire which when your using it and twisting it left and right, turns it off.. Or it could be in the hose where the connect meets with the unit.Here's a number to call to further assist y ... Miele S548 Bagged Canister Vacuum

Fantom vpw46h,house pressure washer.the motor runs,it was setting for sometime started,using it,but never had any pressure besides the house hose pressure, with the motor running,then the pressure startes to work great,while using it the wand hose came out of the pressure washer,i put it back in,now the motor will only run when i try to adjust the wand head but will not produce any pressure and will shut the motor off,it seem like as soon as the wand hose came out of the presure washer and after


... Vacuums

I love my dyson but it suddenly won't stay powered on! I push the on/off button and it works fine but only if I hold the button down. As soon as I take my hand away, it stops. I've had it and


Probably needs a new on/off switch here is video how to do it ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I press the start button and sometimes the motor won't continue running. As soon as I release the start button, it turns off. Sometimes, if I remove the cannister and replace it, then it will run correctly. Sometimes not.


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My Dyson DC-17 Absolute Animal does not stay running after I push start button. It will only run if I hold the start button down all the time.


Switches always fail on the dysons. its a pretty simple fix though. let me know if you need parts and/or instructions on repairing it. ... Dyson DC28 Animal Bagless Upright Vacuum

GE Spacemaker Microwave PVM1870 fan keeps running after door closed and won't shut off. Have to open door or unplug. As soon as door is closed and plug is back in, fan starts up. If door handle is pressed downward, microwave starts! If door handle is raised, fan shuts off but light stays on.


... Vacuums

When i push on the power button on it runs only as long as my foot stays on the on/off power switch once i move my foot it immediately shuts off?


... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

Push the button and it will start but won't stay


You will need to change the on/ off switch. the part number is 901181-06. I have a vacuum store, I can send you the part if needed. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

The motorized wand attachment keeps shutting down after 10 to 15 seconds after pushing the red reset button. I've thoroughly cleaned dirt/debris from around motor. Do I need a new reset switch? Thanks, Tom


Either the reset is bad or the motor is drawing too many amps and tripping the reset. Do you have an amp meter? Check the amps being pulled by the wand attatchment against the load recommended by the manufature, this is usually located on a plate som ... Rainbow E series Canister Wet/Dry Vacuum

When I push the start button, unit lights up and as soon as it starts, the gfci pug trips. any suggestions


1)you must test the c. board, can be faulty. by that reason all this phenomenon appear. Any component can be in short, such diodes, capacitor, resistor, triacs, SCR. etc or IC.2) you must call you supplier for get help ONLINE chat with them. ... Vacuums

While vacuuming the beater bar shuts off all by itself, the main power source stays on. I touch the power button on the beater bar to start it again and it shortly after shuts off again. why is this happening?


... Dyson Stowaway DC23 Bagless Canister Cyclonic Vacuum

I was using my easy flow central vacuum, and shut it off. When I went to start it up again 5 min later, it would not turn on. I emptied out the filter, and reset the switch. When the reset button was pushed, it started up the vacuum, but the vacuum was not turned on in the house. It can only be turned on from in the garage and not on the actual hose. What is going on?


... Easy Flo EF2300 Central System Vacuum

Power nozzle on E-series won't start when cold unless the red 'reset' button is pressed multiple times while also holding the trigger to 'warm it up'...this is w/the power nozzle off the floor - no restriction on it turning. Once it's been running and then turned off the button must be pressed w/the trigger to get it to run - again w/the nozzle off the floor. It also seems to shut off too easily while vacuuming. I replaced the motor,which didn't fix it. Is the reset switch next on my list? T


... Rainbow E series Canister Wet/Dry Vacuum

My lux 7000 has a new bag but when i start to use it with the power unit or without the unit shut's it self off i can reset the lites or the motor if you will by clicking the on off switch 4or 5 times and i'm ready to go again untill you start to work and off it goes you can repeat the switch thing as long as u want, it just won't let u vacuum ,it turn's it self off .I blew it all out but found nothing in it. if u don't try to vacuum it will run as long as u want to listen to it. Can you


Have you replace the afterfilter? It may also cause this if rather dirty. It's located under the tool caddy/air diffuser on the back half of the machine.\015\012Try this: Disconnect hose, turn on vacuum. Does it continue running? If so, pl ... Electrolux Lux 7000 Bagged Canister Vacuum

We all of the sudden have to hold the power button down to turn it on. As soon as we let go of the power button, the vacuum shuts off.


It sounds like the actual switch in the unit has failed. The switch has a spring in it that keeps it in the on position then pushes it to the off position when it is hit again. If you can get to it, you'll be able to check it out yourself and Bisse ... Bissell Healthy Home HEPA Bagless Upright Vacuum - Metallic Blue

The motor in the power head ran at a higher pitch for a for 8 to 10 seconds then stopped. If I push the reset button the powerhead may or may not start or it may start and run for a few seconds. The brush is not caught.


Did you check the belt? A broken belt results in lower strain on the motor, causing it to run faster resulting in the faster speed and higher pitch. This could result in overheating, which will cause the motor to shut off.\015\012If this isn' ... Electrolux C101 Bagged Canister Vacuum

I pushed the on button and kirby g5 starts but when releasing button motor stops


Hello,\015\012You can replace your own Kirby switch with my guide. Here's the link...\015\012\015\012 ... Kirby Ultimate G Bagged Upright Vacuum

I have a miele S712 (2 yrs old worked fine yesterday) - I had been doing some diy work inside and had the vac on just to reduce some of the dust in the air - after a while the vacuum fizzled out. I guessed it had overheated and took it outside to cool down - when I tried to turn it back on pressing the power button gives it power and it starts to **** but it won't STAY on, soon as you release the power button it stops, and the orange bag indicator is showing full. As I have a compressor I took


You have got dust in the micro switch and it is not latching on, if you look at this and clean it, that will solve your problem, however blowing the motir has probably wrecked the motor bearings. ... Miele Vacuums

Why does the motor start, then shut off?


Check for a stuck or binding float switch ... Porter Cable 7812 Wet/Dry Vacuum

Have an e-series rainbow. Belt and brush bar have been replaced in power head. But the red reset button can still be pushed and it is not staying going like it should. May it be the motor?


... Rainbow E series Canister Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0590 seconds