Having problems with your Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum ?

Runs 10 - 20 seconds then quits-restarts on next trigger pull

\015 I leave my handheld in the charger all the time. When I go to use it, it will run for a few seconds, then quite, I re-squeeze the trigger, and it starts again...sounds like full volume..but quits again...Have to do this about 10 times to clean my car mat.\015

Answers :

Check battery maybe is old or not correctly charged.
Repair Help & Product Troubleshooting for Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Runs 10 - 20 seconds then quits-restarts on next trigger pull


Check battery maybe is old or not correctly charged. ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

Your DC16 RUNS FOR 2-3 SECONDS THEN STOPS,PULL THE TRIGGER AND IT RUNS FOR 2-3 SECONDS,ON AND ON


... Dyson Vacuums

My Bissell model 8910 pro heat will pump solution or water for like the first couple times you pull the trigger as you can see the mixture window spinning. After that it stops spinning and nothing else will come out until you turn the machine off, and restart. Then again same process works for a couple trigger pulls then quits.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 8910 ProHeat Clear View Upright Vacuum

My DC 16 will only run for a second each trigger pull. The battery is fully charged, it has plenty of suction, just wont run for more than a second. I cleaned the filters.


I had the same problem with my Dyson DC16, where it only runs for a few seconds at a time with each trigger pull. My husband called Dyson (Canada) and without hassle they shipped us a replacement part which I just received this morning. The replace ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

My dyson dc31 will not hold a charge and only runs for about two seconds then you have to release the trigger then it runs for another 2 seconds and so on.


... Dyson DC31 Animal Bagless Handheld Cyclonic Vacuum

Our miele red star(s314i) vacuum was running great and quit suddenly. It had not been running for a very long time and just quit. Newish bag, no clogs in hose and doesn't seem overly hot. the over heated warning light did not come on. I've waited 30 plus minutes to try to restart and no luck. Any ideas


Ok, so if the cord test didn't fix the problem, then it sounds like either the plug has gone bad, or the switch. The plug is a very common problem to go bad, and can be caused by just simply yanking the plug out of the wall, or putting too much tens ... Miele Red Star Bagged Canister Vacuum

Power nozzle on E-series won't start when cold unless the red 'reset' button is pressed multiple times while also holding the trigger to 'warm it up'...this is w/the power nozzle off the floor - no restriction on it turning. Once it's been running and then turned off the button must be pressed w/the trigger to get it to run - again w/the nozzle off the floor. It also seems to shut off too easily while vacuuming. I replaced the motor,which didn't fix it. Is the reset switch next on my list? T


... Rainbow E series Canister Wet/Dry Vacuum

When squeezing trigger, vacuum runs for 10 seconds then stops.


... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

It runs for a couple of minutes shuts off then restarts 30 seconds later runs a couple of minutes and does this over and over


Most vacuum motors are protected from overheating by a thermal switch that resets after cooling down. Check for blockage in the hose,\015\012power head or a full bag that would block cooling air from cooling the motor.\015\012\015\ ... Tristar Vacuums

I have a karcher 350 water blaster that has suddenly lost water pressure. the motor still works but no pressure. If i give it 10 or more seconds it builds up a bit of pressure but when i pull the trigger the high pressure only lasts for a 1/2 second blast then just normal tap pressure. Can anyone offer advice . thanks


... Vacuums

Bissell Proheat model 8930 stops dispensing liquid after about 30-45 seconds when trigger is operated...occurs both with hose and upright modes. When shut down and restarted, dispensing resumes and again stops after another 30 seconds.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

I have a remington hc 822 it does not cut at all.if i try cut it pulls my hair.i tryd taking it apart but it still doesnt work.and i want to also knw how 2 reassemble it cos i am quite confused .i got it second hand so i dont have a manuel.ue assistance would be very much appreciated .


... Vacuums

My Dyson DC44 is charging on the wall mount, and when I go to use it it wont run:( it has worked because its basically new. when i pull red trigger a green light comes on where it says max and on top.


... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

My Oreck xl makes really loud sound and starts to smell hot when running still picks up but I am afraid I will damage something if I use it. The loud sounds gets very loud then quits for a few seconds then starts again.


... Oreck XL Ultra Bagged Upright Vacuum

My Sears 919.152340 compressor runs for a few seconds when I plug it in then quits. If I unplug it and plug it back in it does the same thing. Don't know what happenned. The last time I usesd it it worked great.


... Vacuums

Dyson 16 runs 1-2 seconds quits - Vacuums


Hi Dana,I'm sorry to hear you're having difficulties with your DC16. In order to determine what is causing the machine to shut off, we'll need to run through some troubleshooting over the phone with you. You can reach on 0800 298 0298 (UK), o ... Vacuums

Miele S318i worked ok till I took it apart to blow really fine ceiling "popcorn" dust that got sucked by the filters. When I plugged back in started for a milli second and quit. At this point I believe the circuit board might be the fault, but I want to test motor before I go and buy the part. Can I simply run 110 to the two moter contacts to bench test? Steve


Yes, you can. ... Miele S318 Bagged Canister Vacuum

I have a dc28 and the brush bar will run for a second and then quit have talked to Dyson and no help


Hello, I have a similar unit and had to have a brush transmission put in mine. I did not get any diagrams about the internals for mine and the contraption was overly complicated. There is a gearbox and you have to buy the entire thing, "Sorry no b ... Dyson DC28 Animal Bagless Upright Vacuum

Bissell 9200-T ProHeat 2X will not spray I have gone through the priming process it will work for a few seconds and quit. I have had it open and checked a few tubes but not sure what to do next. This occurs with both the Upholstery attachment as well as the bottom sprayers.


\012ARE THE TANKS SEATED PROPERLY AND THE AUTO-LOAD GASKETS \012IN PLACE? \012Check the bottom of the Water Tank and the Formula Bottle to make \012sure each has a red (or black) auto-load gasket attached and facing outwards ... Bissell 9200 Upright Vacuum

Dyson rechargable runs but keeps cutting out but if you pull the trigger it works again. Just keeps doing the same.?


... Dyson DC35 Handheld Vacuum

I have an Electrolux Commercial Upright vacuum Model U129C. It has a device which turns off the motor driving the beater bar if something gets stuck in it. There is a simple reset button to restart the beater after clearing the obstruction. Just recently on flat dense low pile surfaces the switch cuts in after just a few seconds and turns the beater bar off. This doesn't happen on high pile carpet but the motor doesn't quite sound normal. There is no obstruction - the beater bar can spin freely


The motor is having a problem.There might be two reasons...either the coils inside it got heated up which will be needing rewinding or you can buy a new motor or there r capacitors attached sometimes u can make a check on that also if that's gone Kap ... Vacuums

I have the same problem as steve967 The dyson dc16 is fully charged, runs well for 5-10 seconds and shuts down. I wait for a second or 2 and it runs again for 5-10 seconds. This will continue for numerous cycles, until I am finished cleaning. I have cleaned all the filters, and the power is good, The system will just not stay on. It is just over 2 years old. A friend of mine had the same problem with his Dyson DC16 after just a couple of months and has replaced his Dyson with a Black N De


Dear Michael_Stad,I am going to sound like a broken record but here is my same answer to another person with the same problem.I have I had the same problem with my Dyson DC16, where it only runs for a few\015\012seconds at a t ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

New battery!, roomba runs for 5 - 10 seconds, stops, starts running, stops, runs, stops, then beeps and low battery flashes. Have taken battery out, held start button 20 seconds, replaced battery and directly connect to charger, 72 hours min., still same problem.


... iRobot Roomba Discovery SE Bagless Robotic Vacuum

DC-16 battery vacuum runs for 10 seconds then cuts out. After waiting 30 seconds, it runs for about 10 seconds then cuts out again


... Dyson DC07 Bagless Upright Cyclonic Vacuum

Water and shampoo run out with the trigger in the off position


From your description, you have a problem with your one of the solenoids that may be stuck open. this would require a shop repair. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0498 seconds