Having problems with your Dyson DC17 Animal Bagless Upright Cyclonic Vacuum ?

The brush on my Dyson DC17 Animal does not turn

\015 Something wrapped aroung the brush and I turned it off as soon as it\015\012happened. Now the brush does not turn. What do I do?\015

Answers :

Remove the plate over the brushbar. Gently clean out debris. Put plate back on,plug in and turn on vac and press brush bar button to reset.
Sounds like in both cases that your belt has broken. You'll need to go to www.dyson.com and select the local Dyson for your country, and contect them for spare parts and assistance.
\015\012
\015\012p.s. I'm not a Dyson Service Center, but anything getting stuck in the roller of an upright may cause the pulley driving the belt to burn a hole in the belt.
Repair Help & Product Troubleshooting for Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The brush on my Dyson DC17 Animal does not turn


Remove the plate over the brushbar. Gently clean out debris. Put plate back on,plug in and turn on vac and press brush bar button to reset. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Dyson DC17 Animal Brushes turn but won't ****


My wife had precisely the same problem. I did what dskurth said above and instantly fixed it. Awesome! Found a 6" long eyeliner thingy wedged in there. Just WAIT till the daughter comes home!! 8-)Thanks dskurth! ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

The brush bar on my Dyson DC17 stopped turning.


If this model has a brush control - i.e a roller at the side of the model which controls brush to spin or not, then its a protected brush model - therefore even if the drive belt is intact the Dyson would have to be repaired by a service personnel or ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Dyson dc15 animal brush won't turn - Dyson DC15 Animal Bagless Upright Cyclonic Vacuum


Hi there,Your DC15 is equipped with a sensor which shuts off the brushbar if something jams it. Once you've checked the cleaner head for obstructions and removed any threads or hair from the brushbar, you should be able to reset the machine. ... Dyson DC15 Animal Bagless Upright Cyclonic Vacuum

Dyson Animal handheld brush not turning - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum


Hi its Darran at Dyson.We would recommend checking it for a blockage and a removing any hair or fibres from the brush bar. As the brush bar relies on the suction power of your machine, it would be worth cleaning the filter and ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

DC17 Animal Bagless Upright Cyclonic Vacuum: dyson animal wont turn off...


Dyson has switch problems, needs new switch. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My Dyson Animal 14 beater brush will not turn.


It MAY be a clutch issue. I had a similar problem with my DC07 Animal recently a posted a solution elsewhere on this site, but here's the summary. To reset the clutch on my model, recline the vacuum, turn it on it's side and slowly change the carpet/ ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Dyson dc17 animal stopped sucking. brush still


Make sure the flexible hose that connects the beater brush housing up to the connection up by the dust bin is still connected. It could also have a hole in it so check for that as well. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I have a Dyson DC17 that has started making a loud noise when on carpet when the brush is engaged but not on hard wood when the brush is not turning. I have remove all the material (hair,lint, etc.) wrapped around the brush itself, but it is still making the noise


You need to replace the belt. Here is the belt you need and a manual you can view which has instructions:\015\012\015\012Dyson DC17 Belt and Manual ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson dc23 animal brushes won't turn


Check for blockageshttp://media.dyson.com/downloads/UK/floorcare/Manuals/DC23_origin_uk.pdf ... Dyson Vacuums

Dyson dc25 beater bar wont turn - Dyson DC17 Animal Bagless Upright Cyclonic Vacuum


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

In my (almost new) Dyson DC31 Animal the rolling brush tends to stop like the bearing was kind of difficult to turn. I opened the side carter and removed the little belt. Without the belt the engine runs regularly. I cleaned the little knots of hairs trapped in the bearing but still the brush runs for a while then stops, tries for a bit then stops again. I even tryed putting a bit of synthetic lubricant with apparently no result. Could it be a defective bearing? Thanks for your help.


... Dyson DC31 Animal Bagless Handheld Cyclonic Vacuum

My Dyson brush will not turn - Dyson DC39 Animal Canister Vacuum


... Dyson DC39 Animal Canister Vacuum

My purple Dyson Animal (without the ball) isn't working correctly. When I turn it on, the red power light, as well as the medium pile buttons flashes. When I first turn it on, the brush rotates for 3 to 5 seconds, then once I start moving the vacuum, it stops and that's when the lights start flashing. I've checked the filters, they are dry and installed correctly. What could be the problem?


I need help repairing my Dyson. I cannot push the buttons down to select Short pile/Medium pile or bare floor. The buttons will not push down at all. It will not allow me to select anything. I have very short pile carpet so it does not pick up that w ... Dyson DC28 Animal Bagless Upright Vacuum

Dyson DC14 animal vacuum does not turn on however the roller brush does come on.The hose was clogged and that was cleared but vacuum still will not turn on.


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

DYSON VACUUM BRUSH WON'T TURN - Dyson DC15 Animal Bagless Upright Cyclonic Vacuum


The problem will most likely be either with the PCB under a panel on the side of the chassis, or the small wires from it that feed the front brush motor. \012\012If you are technically inclined, you can ask for more detail on the repair here: ... Dyson DC15 Animal Bagless Upright Cyclonic Vacuum

Hi my dyson dc07 animal has suction but the brush bar wont turn. If I turn it on there is a horrible noise. The belt is still fine


The belt is probably worn or stretched. When this happens the belt won't turn\015\012the roller brush when it is against the carpet. Here is a link for the\015\012manual and links for the belt ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Brush stopped turning on my animal dyson-only 3 weeks old. I already took off the brush and put it back on


Brush stopped turning on my dc07 ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Better bar isnt turning on the animal - Dyson DC17 Animal Bagless Upright Cyclonic Vacuum


I would say that the belt is broken or the switch was hit and the contacts got misaligned (wife is a little rough on things). If you hit the switch on top with the vac in the use position, do you here the motor turn on? If you are not Mechanically ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Dyson blueprint beater bar won't turn - Dyson DC17 Animal Bagless Upright Cyclonic Vacuum


The Dyson DC 17 has a rug / floor switch on the head of the vacuum. Please check to make sure the switch is in the Rug position. If the brush roller still does not turn then you have broken the belt and need the following part.\015\012 ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My Dyson dc15 animal roller brush will not turn off when I push the on/off switch....changed the fuse but still will not turn off. Help!


... Dyson DC15 Animal Bagless Upright Cyclonic Vacuum

The brush wont turn on my dyson DC 14 - Dyson DC14 Animal Bagless Upright Cyclonic Vacuum


Sounds\015\012 as if you need to replace the brush belt.JimLet me know if this helps. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I have dyson dc28 animal brush not turning how to fix


... Dyson DC28 Animal Bagless Upright Vacuum

I have a Dyson DC28 animal vacuum and the beater brush will not turn. It has one flashing white light and a red flashing light.


It appears that the drive belt is not adjusted properly or has stretched. THe gunk that vacuums pick up can also affect the belt in amking them too slippery to drive. Check it out. ... Vacuums

Dyson Animal 17 - brush stopped turning


The belt will stop itself from spinning if you accidentally picked up a shoestring or vacuumed the edged of a carpet and the carpet got caught. To have the brush spinning again, simply step on the front of the machine, pull back the handle, turn the ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0646 seconds