Having problems with your Dyson DC17 Animal Bagless Upright Cyclonic Vacuum ?

I have Dyson animla and the wand stop working....no bloc anywhere

\015 Looked for blockage and couldn't find any. When you try to use the wand it is hard to get out as if the suction is pulling it back in the holder.\015

Answers :

The hose is getting twisted on the machine and that makes it difficult to pull it out.
\015\0121) Pull the wand out as far as you can - if you can pull it out completely, separate it from the hose and apply baby powder to the metal rod. Stretch out the hose and unwind it. In the future, separate the wand and unwind/stretch the hose after use.
\015\0122) If you can't pull the wand out all the way, remove the u-bend from the bottom of the machine - turn that plastic screw at the bottom next to the gray hose 45 degrees anti-clockwise and take the u-bend off.
\015\0123) Pull the hose out from the bottom (don't pull it out all the way - just enough to release the wand) and pull the wand at the same time - separate the wand from the hose and unwind the gray hose and stretch it out. Rub baby powder on the metal rod of the wand and in future, disconnect the wand from the hose and stretch/unwind the hose after every time you use the wand.
Repair Help & Product Troubleshooting for Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have Dyson animla and the wand stop working....no bloc anywhere


The hose is getting twisted on the machine and that makes it difficult to pull it out.\015\0121) Pull the wand out as far as you can - if you can pull it out completely, separate it from the hose and apply baby powder to the metal rod. Stretch ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Hi my dyson dc18 has great suction from wand but when you got to use the vac for floors little suction but wand still got suction even while vacuming floors is it suposed to stop suction from wand


My Dyson dc18 had the same symptoms. The wand worked well and the floor bar had no suction. After removing pieces & shoving my fingers into the machine (no blockage) I found the suction pipe rotates between two positions (floor and wand). It look ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

My dyson just stopped running while vacuuming with wand


You probably got a blockage in your wand which caused it to overheat and cut out. Check for blockages, use a brush stale down the tube to dislodge anything. Next, check your filters, refer to the tutorials here: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My dyson dc44 just stopped running in the middle of vacuuming, I checked the battery, cleaned the head, I emptied the bin. Is there a reset button anywhere for this machine?


... Dyson DC44 Animal Cordless Vacuum

Is there anywhere I can buy the little clip thats on the wand of upright dyson hovers which holds the cable in place?


You can get all spares from the link belowhttp://www.dysonpartsdirect.co.uk/dysonparts/dc07parts.shtml ... Vacuums

This is embarassing, but I have just looked at the Dyson DC07 manual and at my Dyson for about 20 minutes, and I can't for the life of me find the wand release button on my actual Dyson.....the manual pictures don't look like the parts on my Dyson....I don't have a hose with a wand release button....the hose just goes straight up inside the handle....Can someone help me? Thanks :)


Hi the wand release button is located directly above the the Cylinder release button. The wand release button looks like the picture below. In order to releease the wand you must firstly make sure the Electrical cable is not wrapped up for storage. S ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My Dyson DC17 has lost suction on the wand and is not picking up dirt as it should. I have taken the small part at bottom of the machine off to see if there is a blockage--none that I can see. The flexible tube on wand is very tight and won't extend very much. Dyson sent me a new cyclonic part in April but the machine still doesn't seem to be working properly. My serial number is 260-us-d11545. Is there somewhere I can take my Dyson to get it fixed. I'm very frustrated with it. Thank you.


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Pls Help! My Dyson DC05 (Yellow) needs a new wand. Am unsure whether it is the assembly wand or hand one found in spare parts. The wand I need to replace connects the two long hoses together, and NOT the wand which fits onto pickup head. M.thks if you can advise which one I need. Getty rather dusty in my pad!!


... Dyson DC05 Bagless Canister Cyclonic Vacuum

Dyson dc40 vacuum stopped working


... Dyson DC40 Animal Ball-Technology Upright Vacuum Cleaner

Have dyson 17 and will not **** up dirt cleaned filter and unit but will not **** up with wand or head pushing dirt out not sucking in


Hi Jerry,I am sorry to hear you are having difficulty with your DC17. Based on the details you provided we may be able to resolve this problem over the phone. Please call us at 1-866-693-9766 (US) or 0800 298 0298 (UK). We look forward to spe ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I have the dyson animal. There is something stuck in the wand tube and everyting is getting caught on it. There is very little suction from the wand. How do I get the wand apart or somehow get the object stuck out of the tube? Thanks


Yes, things stuck in vacuum hoses are not always as easy to remove as one might think. Trying to push it out with something can be counter-productive, and only get the thing stuck tighter! If you have a second vacuum, you can try sucking it out the w ... Vacuums

In my (almost new) Dyson DC31 Animal the rolling brush tends to stop like the bearing was kind of difficult to turn. I opened the side carter and removed the little belt. Without the belt the engine runs regularly. I cleaned the little knots of hairs trapped in the bearing but still the brush runs for a while then stops, tries for a bit then stops again. I even tryed putting a bit of synthetic lubricant with apparently no result. Could it be a defective bearing? Thanks for your help.


... Dyson DC31 Animal Bagless Handheld Cyclonic Vacuum

Wand in stowaway dyson is hard to extend. Seems like u have to pull 3 clips from grooves in 3 rings around wand to extend and shorten wand which is a struggle


Hi there, you should just be able to hold the telescopic wand in one hand, press the button and pull the whole length of the wand out to its fullest position. If the telescopic wand on your particular Dyosn is very stiff, you may need a r ... Dyson "Stowaway" Canister Vacuum Vacuum

My Dyson D23 Vacuum just stopped and it won't turn on no noise nothing stopped completely now what any suggestions?


... Dyson DC23 Bagless Canister Cyclonic Vacuum

Dyson DC 11 Broken Wand Clip


I have the same problem. I contacted Dyson and you have to buy the whole wand assembly ... Vacuums

Dyson upright My Dyson cleaner suddenly screemed at me and stopped with a puff of smoke and burning smell. I had just emptied the cylinder. It is five years old.


Hi this is an expensive repair and would probably be cheaper to buy new one the problem you have is with the motor bearings seizing its expensive to repair because when dyson made thes vacs they were made so you need special tool to take them apart s ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

How do you put the telescopic wand down? Just got a new dyson 17 and I cant use it cause I cant get the dang wand down..


Make sure your handle is snapped in all the way on to the machine, that will release the clip on the hose to allow for the wand to slide in. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Dyson My Dyson DC04 runs for a second or two then stops. I have checked the motor. The brushes are good but the commutator is a slightly pitted.Do I need a new motor?


Hi.\015\012\015\012Check mains lead where it enters machine very common for internal fracture.\015\012\015\012To prove this try waggling lead with machine switched on if it starts & stops this is the fault.\015\012 ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

My dyson won't stay on. I push the red power button and it begins to start but as soon as I stop pushing it, it stops. It will only work if I keep pushing down the start button the whole time I'm using it. HELP!!! I love my vacuum!


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

It stopped sucking @ brush stopped turning - Dyson DC14 Animal Bagless Upright Cyclonic Vacuum


Usually on this vacuum those two problems are not related, but if you got a lot of stuff stuck in the brushroll and in the suction tube at the same time it could happen. Check the belt to make sure it's not broken. If the vacuum is over a year old th ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I have a DC14 Animal Dyson. The wand was sticking, so I figured out the rubber gasket had stretched out. When I trimmed that it worked a lot better, but now the wand is locking up again.


Hi there, its Darran at Dyson.It would be worth contact us so that we can discuss the options available to you. you may need an engineer to visit to replace part of your machine to resolve this, however it may be a part we can send in th ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Sometime when I am vacuuming carpet or a large area rug, my Dyson starts making this loud, horrible, wrenching noise. It stops when I lift one of the wheels up. What is causing this? I have only used my Dyson 3-4 times.


You will need to have the clutch replaced. this is causing your problem. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson animal We bought a Dyson Animal from Sears a few years ago along with a service contract. We took it each year to be serviced. One year I took it because it lost it's suction. They sent it to the factory, but it came back still not working right. We did the same procedure over ands over many times than I can remember. I now have the cleaner in my garage and am using my old vacuum because I just can't seem to get anywhere with Sears. Please help me. We paid almost $600.00 and now it can't b


As someone who works for Sears, let me just say right now.. The service contract you bought sucks.. and does not really do anything for you. it was just a wast of money ( they have a new one now.. thats so much better because you get your money back ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My Dyson DC 18 has no suction in the wand. it is in the upright position and the wand and hose is cleared from debris.


... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

I cant remove my wand on my Dyson vacuum. - Dyson DC17 Animal Bagless Upright Cyclonic Vacuum


Hi its Darran at Dyson. It is possible that if the hose is blocked that the wand handle may become jammed. For help releasing this, please contact our Helpline on 0800 298 0298 (UK) or 1866MYDYSON (US) and one of our advisors can talk yo ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0571 seconds