Having problems with your Dyson DC17 Animal Bagless Upright Cyclonic Vacuum ?

It was making a funny noise, then a burning smell, and smoke coming from under the cylinder which collects the dirt, then switched itself off. I have checked for blockages and can't see any


Answers :

Your motor is burned up. stop using the vacuum immediately due to possibility of fire. this is usually caused by the inner seal on the bottom of the cyclone lifts up or gets pinched and doesnt seal with the bottom lid.
Repair Help & Product Troubleshooting for Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover Alyx Pets 2000w Hoover Model TC1208 001 Virtually no suction, have checked for blockages but cant seem to see any, however i can't remove the hose to check it. Any ideas?


Did you check the HEPA filter? I have the same problem with mine if I don't clean the filter after using it. It's a dirty job but helps for a while. ... Vacuums

My dyson dc08 has a loss of suction. A flap valve operates within a few seconds of startup which appears to divert air. I have replaced both the hepa and sponge filters but the problem persists. If there is another blockage where might it be? I cant see how to dismantle the airways to check more than the very obvious. Suggestions gratefully accepted.


You have used your Dyson too long without thorough cleaning - Here's how. Obtain a torx screwdriver, or a set of torx bits, you will need to select the correct size when you come to remove the screws. They are all the same, so you will ne ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

It was making a funny noise, then a burning smell, and smoke coming from under the cylinder which collects the dirt, then switched itself off. I have checked for blockages and can't see any


Your motor is burned up. stop using the vacuum immediately due to possibility of fire. this is usually caused by the inner seal on the bottom of the cyclone lifts up or gets pinched and doesnt seal with the bottom lid. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Sudden loss of suction. Using a dirt devil upright. Checked the belts that were changed recently and working. Changed the half full bag. No change. Checked for blockages and as far as I can see there are none. The blower is working as much as it ever was I think but I;m stumped.


R u sure there is nothing cought in the hose? ... Dirt Devil Featherlite Bagged VacuumVacuum

Suction switch I used my new eureka optima once and now it has no suction. The suction only switch does not turn on. I've checked for blockage and can't find any


Leave the thing off for about 30 mins, let it cool. Take that time to clean out all of pieces. Its a pretty simple machine, but has many suction points. Mine killed around Christmas time. Flippin pine needles got caught everywhere,clogged the wh ... Eureka 431A Optima Bagless Upright Vacuum

I have a vec-101 vax bagless cylinder vacuum cleaner,only had it a week and the blockage light has stayed on.i have checked everything and cant find a blockage anywhere,what is the fault? thanks


... Vacuums

With cleaning carpets with the Stowaway when the head gets a blockage it makes a high pitched whining sound and requires unblocking - then works fine. Now when vacuuming the head always makes the same sound when the head is against the carpet. you can also see that the rollers are slow or stopped. We have pulled the Stowaway virtually completely apart and checked for blockages as well as washed the filter and no difference. Any ideas?


... Dyson "Stowaway" Canister Vacuum Vacuum

The belt wont turn...i cant get in to the inside to check to see if the belt isnt on the roller...how do i get up in there..i took the bottom plate off and you still cant get inside... thx Peggy


The following site has some great info on your machine:\015\012\015\012www.dysonmedic.com ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have the Dirt Devil Vibe model 084501v. It turns on but is not sucking anything up. I checked to see if there was any blockage but there is none that i can see.


... Vacuums

My Dyson DC17 beater bar motor works intermittedly. I have to almost whack it on the floor to turn it on and then shuts off again. I have checked the belt and it is fine, also have checked for blockages. The switch to turn the beater bar on or off will not work when the beater bar motor is off. the suction is fine though.


Buy a Kenmore for less money ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

On/off switch works but wont stay in on position unless you hold it down cant see how to get in to the switch this is on dc17 animal


This link will show you how to chonge the switch on your dc17\015\012http://www.videojug.com/webvideo/how-to-fix-the-lead-on-a-dyso ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Brushes stopped The brushes stopped turning while using the cleaner. I removed the brushes to see if the spindle was broken, it wasn't. I then removed the top plastic cover and checked the switch that engages the brushes; it didn't seem to be moving correctly. There's one spring on the switch - should there be two? Or do you think something has broken on the inside? Thanks for any help


Most likely the turbine is bad, it may just be clogged up, you can take it apart and clean it out real good. That may work, but it may not. Sometimes it is best to replace the turbine. ... Hoover F7431-900 SteamVac Vacuum

My 5200 hoover spin scrub all of a sudden stopped sucking in mid clean.i took the front clear cowling off and checked for blockage but couldnt see anything.there is nothing to these thiings,they are disposable it seems lol


Most likely your vent for the suction container is plugged or the suction hose can of or is broken at the connection to the tank nozzle (very common on these. Clean the machine thoroughly, and check that all hoses are tight and connected. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My dc 05 isnt working and i cant understand why , i have cleaned all filters etc and i also changed the fuse on the plug , which after i didi that it attempted to start but then jus cut out again so i thought the fuse had blown again , so i checked the fuse but its working fine could there still be a blockage somewhere in it or is it something electrical which means my dyson has to go to the dump :(


Most common cause of this problem is a wire broken inside the flex, usually either just where it leaves the plug (easy to fix) or at the other end (more of a problem). In either case, this is no reason to dump the machine - it can be fixed at a fract ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

I need to replace the cord on an older Hoover upright, model S660, about 1986 vintage. The cord broke where it enters handle. Handle comes apart easily. Just not sure how to pop the switch out without breaking it. Was looking for a manual online to see parts diagram and/or instruction on disassembly and cant seem to find one for that old of vacuum.


Check ebay. those vacuums are worth fixing. I loved them. they would **** the carpet off of the floor! those cords aren't hard to replace.just remember the way you got the old one out. ... Vacuums

Does the trivac 1100 have a fuse? My machine has suddenly stopped.I have checked the fuses in the plugs and also made sure that power is at the wall socket. I can see what loks like a fuse holder in the top of the machine near to the on/off switch but it is very tight so I want to be sure that it is a fuse before unscewing it. Thank you Jim


... Philips Vacuums

My dyson hoover keeps cutting out and smells of burning i cant see any obvious blockages does this mean the motor has gone


Hi, It definitely sounds like the motor is toasted.If you visit\012http://www.sparesaver.com/help-and-support/dyson-section/dyson-technical-advice-450/\012they have alot of info on repairing dyson cleaners AND they sell the\012parts, chea ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

When I use my Dyson in the upright position it does not **** up the dirt on the carpet. But if I attach a tool and use the hose it does. I have checked to see if there is a blockage any where and there does not seem to be


Hi its Darran at Dyson.I would recommend checking the brush bar to see if its spinning when you switch the machine on and release the head into the vacuuming position. If its not, check the brush control dial on the head of the cleaner to ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Carpet brush does not work.but if i lay it on its side it works. i think it a switch but i cant get the handle apart to check it bissell 6405 vacum


You need a new belt. ... Bissell 6594 PowerForce Bagless Upright Vacuum

My kenmore intuition vacuum seems to have lost suction and the check bag light comes on. the bag has just been changed (2x). cannot see if there is any type of blockage. any ideas? thanks. ps. only had this vacuum for 3 months.


If you bought it new then do not screw w it take it back to sears and demand a replacement or your money back Sears is very reasonable re this ... Vacuums

I have a rainbow vacuum and it just quit cant figure out how to get to switch to see if it is getting power


Follow the cord up into the vacum it;s probably in the arm. ... Vacuums

My floor mate won't spray out any of the cleaning solution. I took it apart to check for plugs but couldn't see any blockage


Sometimes the nozzle holes get plugged above the brushes. if you remove the solution tank you will see where the trigger rod connect to the resevoir to release solution. also you should see that a small amount of solution in the top of the resevoir i ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

I have a Miele Vacuum cleaner MedicAir 5000 Plus. Recently the Dust Bag Indicator bar is full during normal cleaning and consequently the suction power is much less. I replaced the dust bag, engine pre-filter and Hepa filter but no change. When i remove the hose, the Indicator is normal, but when i attach the hose, wand, head, the indicator is full. I checked the hose, wand, head but can't see any blockage and when i blow with my mouth it seems fine. Can anybody help? thanks!


... Miele Vacuums

My beater bar is not turning so the vaccuum is not picking up. The belt is not broken. The motor is working and I can see the cyclone effect in the canister. I have checked for blockages. I have cleaned the hair and string from the beater bar brushes. What should I do?


You need to replace the belt, it has probably broken. Your actually supposed to change them yearly. Here is a link to\015\012the belt you need and a manual with instrutions: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I've been vacuuming and my Dyson Animal (serial #112USE1564) keeps stopping. I checked for blockage, and none, should I have it looked at for a bad thermal cut-off switch? Please e-mail an answer to my e-mail address([email protected])ASAP!!


Hi there, I have experienced this myself and found it was the thermal cut off switch. Usual symptoms are running for a few minutes and then suddenly stopping, leave for a while and turn back on. I am sorry I cannot email to your personal addresas as ... Dyson DC07 Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0611 seconds