Having problems with your Dyson DC17 Animal Bagless Upright Cyclonic Vacuum ?

My dyson dc17 won't turn on and stay on unless you hold the red button on?


Answers :

My vacuum had this exact same problem, but was out of warranty because \015\012it was remanufactured. Thankfully, it's a very quick, five-minute fix.
\015\012
    \015\012
  1. UNPLUG The Vacuum!
  2. \015\012
  3. Remove the cannister.
  4. \015\012
  5. Extend the handle and remove it.
  6. \015\012
  7. Remove the two torx (T-15) screws behind the power button, where the handle normally stows.
  8. \015\012
  9. There are four tabs holding the front plate containing the power button on; use your screwdriver to release them.
  10. \015\012
  11. Gently pull the front plate off.
  12. \015\012
  13. The switch on the right is the power button. Remove it,\015\012 try clicking it a few times; if it sticks, great! Replace it and \015\012reassemble, otherwise you'll need to replace it.
f63f46e.jpg
d693574.jpg
e62d6ab.jpg
Thank you so much! I just needed to get the t15 at home depot.
I was able to fix it.
Repair Help & Product Troubleshooting for Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dyson dc17 won't turn on and stay on unless you hold the red button on?


My vacuum had this exact same problem, but was out of warranty because \015\012it was remanufactured. Thankfully, it's a very quick, five-minute fix.\015\012\015\012UNPLUG The Vacuum!\015\012Remo ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My dyson wont stay on unless i hold button down


... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Power nozzle on E-series won't start when cold unless the red 'reset' button is pressed multiple times while also holding the trigger to 'warm it up'...this is w/the power nozzle off the floor - no restriction on it turning. Once it's been running and then turned off the button must be pressed w/the trigger to get it to run - again w/the nozzle off the floor. It also seems to shut off too easily while vacuuming. I replaced the motor,which didn't fix it. Is the reset switch next on my list? T


... Rainbow E series Canister Wet/Dry Vacuum

Dyson vaccum, it will not stay on, it turns itself off and I have to hold down the start button to continue vacuuming.


... Dyson DC07 Bagless Upright Cyclonic Vacuum

My dyson dc14 wont stay running. if you hold power button down it runs. cleaned filters and brush and the belt is not broke. any advice on solving the problem?


... Dyson DC07 Bagless Upright Cyclonic Vacuum

On/off switch works but wont stay in on position unless you hold it down cant see how to get in to the switch this is on dc17 animal


This link will show you how to chonge the switch on your dc17\015\012http://www.videojug.com/webvideo/how-to-fix-the-lead-on-a-dyso ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Switch wont stay on unless you hold it in - Dyson Vacuums


Hi there,I'm sorry to hear you're having difficulties with your Dyson's on/off switch. If you haven't already got in contact with us directly, I'd strongly encourage you to do so. One of our experts will be happy to recommend the best cou ... Dyson Vacuums

Our Dyson DC15 animal is supposed to self adjust, and turn the roller on or off as needed, but isn't. We can hold the red button to


Hi Lisa,I am sorry to hear you are having difficulty with your DC15. Based on your description of the problem we would appreciate the opportunity to trouble shoot with you over the phone to determine the best solution for the issue you having wit ... Dyson DC15 Animal Bagless Upright Cyclonic Vacuum

Dyson Animal on button wont stay on.


That's the problem with dyson. They work for the first few months then start to break down. Your switch might need replacing or your cord connection is lose and causing it to short out and turn off. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I have a DC14. About a wk ago it was making loud sound and bar stopped turning. i unclogged everything....now the suction works great. However, the bar still wont turn. The belt inside is still intact and isnt loose. Several solutions suggested resetting the "Red" button...i have searched the vacuum over and over. there is NO red or any other color reset button. The bar is set down perfectly in there, the cover plate is installed properly. What other problems could there be? Or do i just need to


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Err5 When charging the battery, it starts out flashing amber, but after several minutes it turns red and the err button flashes five times. The troubleshooting says to hold the buttons above and below the power button for ten seconds and this may resolve some software issues. I tried that but it goes back to the amber light then red again. I replaced the battery hoping that was the issue, but it still does the same thing.


... iRobot Roomba 530 Robotic Vacuum

Dyson 24. I just bought a new Dyson ball 24 and the brush won't turn on, I tried to follow instruction and push the red button to reset it also next to the power button but doesn't do anything. Any suggestion.? Thanks Sam


IT COULD BE STICKING TRY WD 4O OIL EACH SIDE OF ROLLER\011 ... Vacuums

Power button wont stay on. have to hold the power button manually for it to stay on.


Most likely you have to replace ON/OFF switch. look at detail instructions how to do it on our website:http://www.goodvac.com/kb_results.asp?ID=18 ... Kirby Ultimate G Bagged Upright Vacuum

My dyson animal vacuum (~9 years old) will not stay on. I press the on/off button and it will only stay on as long as I am holding the button down. Help please!


Hi it sounds like you need a new switch ... Vacuums

Tried pressing in red button and switch next to on button to get roller working but not made any difference - still wont turn (any no suction)


Hi there,I'm sorry to hear you're having difficulty with your DC24. If you haven't been able to reset the brushbar using the reset switch on the cleaner head, I'd encourage you to get in touch with us directly so we can provide further assist ... Dyson Ball DC24 Bagless Upright Vacuum

DC17 Animal Bagless Upright Cyclonic Vacuum: dyson animal wont turn off...


Dyson has switch problems, needs new switch. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Dyson dc25 beater bar wont turn - Dyson DC17 Animal Bagless Upright Cyclonic Vacuum


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My dyson dc17 turns off when its upright, so when I go to use the attachments it doesnt turn on unless I go to vaccume the floor. whats going on?


Hi there,I'm sorry to hear you're having difficulties with your DC17. Your issue sounds unusual, and we'd appreciate the opportunity to help resolve it. Please call our Helpline free on 1-866-693-9766 - or if you'd prefer, you can email your ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I love my dyson but it suddenly won't stay powered on! I push the on/off button and it works fine but only if I hold the button down. As soon as I take my hand away, it stops. I've had it and


Probably needs a new on/off switch here is video how to do it ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

The Dyson Animal won't turn on or off. The red power button doesn't control the on/off for this machine any longer. Once plugged in, the vacuum will work and the power cord must be unplugged to turn it off. Any help would be appreciated.


The machine needs a new switch. The switch is stuck to the "on" position. ... Dyson DC05 Bagless Canister Cyclonic Vacuum

4870 Boss Smartvac. The vacuum tipped over and now the brush control lever will not stay in the carpet position. I can't get the brush to turn unless I push down and hold the lever. As soon as I let up on the lever the brush stops turning. Any ideas. The vacuum is only a month old.


The Boss has a slide lever on the top of the power nozzle with two position choices. One position is "Carpet" and the other is "hard/bare Floor". The power nozzle brush roll is activated when the lever is in the Carpet position, and it is t ... Eureka Smartvac 4870 Bagged Upright Vacuum

My dyson won't stay on. I push the red power button and it begins to start but as soon as I stop pushing it, it stops. It will only work if I keep pushing down the start button the whole time I'm using it. HELP!!! I love my vacuum!


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My Dyson DC-17 Absolute Animal does not stay running after I push start button. It will only run if I hold the start button down all the time.


Switches always fail on the dysons. its a pretty simple fix though. let me know if you need parts and/or instructions on repairing it. ... Dyson DC28 Animal Bagless Upright Vacuum

I have had a dyson vaccuum cleaner for three months and it does a great job, but the red on/off power switch won't stay on now. As soon as you press it down to turn on, it comes right back up and turns off. What can be done?


Hi its Darran at Dyson.Call our Helpline on 1866MYDYSON and one of our advisors will be able to arrange for this to be reparied. As your machine in only 3 months old, this should be covered by the warranty. Kind regardsD ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My purple Dyson Animal (without the ball) isn't working correctly. When I turn it on, the red power light, as well as the medium pile buttons flashes. When I first turn it on, the brush rotates for 3 to 5 seconds, then once I start moving the vacuum, it stops and that's when the lights start flashing. I've checked the filters, they are dry and installed correctly. What could be the problem?


I need help repairing my Dyson. I cannot push the buttons down to select Short pile/Medium pile or bare floor. The buttons will not push down at all. It will not allow me to select anything. I have very short pile carpet so it does not pick up that w ... Dyson DC28 Animal Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0743 seconds