Having problems with your Dyson DC17 Animal Bagless Upright Cyclonic Vacuum ?
I have a DC17 which is only one year old. Today I lost suction and called for assistance. A Dyson technician told me to pull off the wand and see if it is clear. It was clogged so cleared out the obstruction. My filter was cleaned more than 24 hours ago. The vacuum still has no suction. Is it dead, any other suggestions.
Take the hoses off and give them a good shaking.
\012or get a long piece of stiff wire and gently poke through the obstruction.
\012or get a long piece of stiff wire and gently poke through the obstruction.
Repair Help & Product Troubleshooting for Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
I have a DC17 which is only one year old. Today I lost suction and called for assistance. A Dyson technician told me to pull off the wand and see if it is clear. It was clogged so cleared out the obstruction. My filter was cleaned more than 24 hours ago. The vacuum still has no suction. Is it dead, any other suggestions. Please help.
Take the hoses off and give them a good shaking.\012or get a long piece of stiff wire and gently poke through the obstruction. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
Hoover Windtunnel is only cleaning (suction power) approx. 1/2 as powerful as it was when we purchased it approx. 4 years ago. I bought new Hepa filter and replaced the fileter on the side. I looked for possible build up of dust/dirt etc. and all channels are clear.
There is also a filter inside the drum fan, you didn't provide your model number, so i cannot tell you exactly how to remove it. ... Hoover Vacuums
Filters all seem clean and clear, suction is fine,but loud noise
Sounds to me it could be tha fan impellor.\015\012This is vac's etc... email us if you need to.\015\[email protected] ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum
I have a DC07 and the brush wasn't rotating and I had no suction at the brush but perfect suction through the hose. I noticed a large build up of dog hair around the brush so I took off the cover plate and removed all the hair, cleaned inside the floor/brush housing and cleaned out the hose. I also cleaned the filter and removed the other air access cover and made sure that they were clear. I put everything back and the brush still doesn't turn and there is still no suction through the bottom
Hi and welcome to FixYa. I am Kelly. \015\012\015\012Here is a link that can assist you in your quest for the missing suction: \015\012\015\012 ... Dyson DC07 Bagless Upright Cyclonic Vacuum
Poor suction We bought a model home about 11 years ago and it had the Cental M&S Cyclonic Cleaning system. The suction has steadily been weakening. Now it is almost non-existant. I clean the filter bag in the main unit, but how clean does it need to be. Could there be a clog in the wall lines. If yes, how does one unclogg them. Thank you. I liked the system and would hate to just give up on it. Jean
This page has useful tips for unclogging a central vac. https://www.centralvacuumstores.com/cvs/trouble_help.php ... M&S Systems FX-3000 Bagged Central System Vacuum
Bissell lift off vacuum about 4yrs old. Extremely noisy. OK until before Christmas but getting worse every time it's used. Washable filters washed, HEPA filter replaced. brush bar cleaned of every scrap, hose empty,everything that can be cleared has been. Noise high pitched, screeching and can only bear to use it for a few seconds at a time. Suction OK. Mine is so loud I can't use it very long-high pitch screech. Can this be fixed or does the whole vacuum need to be replaced? It still cleans gr
Sounds like a bad motor. Could be either foot motor or main motor either way cost will be more than half of the unit. ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum
My dyson DC24 has very poor suction - all filters clean and hoses seem to be clear. had it for just over a year
Hi there,I'm sorry to hear your DC24 doesn't seem to be picking up as well as it should be. From your description of the issue, it sounds as if there may be a blockage in the machine - to locate and remove this, please follow the steps shown ... Dyson Ball DC24 Bagless Upright Vacuum
Poor suction (new bag, clean filter, clear hose)
Check the impeller on the moter it may be missing a fin or two (question does it make any unusual noise or vibration ?) ... Vacuums
Low suction I have a Hoover central vacuum system. I've reset the fuse box, checked the fuses, all of the lines are clear and there are no holes for escaped air to travel out. The filter has been cleaned as well. The vac works well with high suction when hooked directly to the unit, however when using any of the indoor connections there is extremely low suction. The machine still turns on so I do not believe it is an electronic issue. I have troubleshooted the issue as best I could and would
... Hoover L2310 GUV Central System Vacuum
Dc07 problem I have a dc07 cyclonic vaccum and like this model,however, for some reason,it has been very dificult to push and pull for the past month or so. i have completely cleaned the brush assembly,cleared any obstructions in the hoses,and, cleaned the filter.I also checked the belt tension,wich i thought was fine but to no avail.Be advised that the brush assembly is spinning and suction is excellent. It just feels like the brush drags along the carpeting. this is a great vacuum cleaner and
The dyson uses two belts, one from the motor to a clutch and then from the clutch to the brush roller, the belts that they use are not much better then any other belt ( those you should change yearly ) but you cant just change the belts you have to c ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
My Hoover Windtunnel, 12-amp, UGG16-900 (or U6616-900 - hard to make out the "G"s from the "6"s) suddenly lost suction this morning. The dirt collection thing is completely clean (I always clean it out after using), the side filter is dirty but not destructively so, and I can see nor feel any obstructions in the hoses. Should I take it in (a real hassle in NYC) or get a new dyson? LOL.
Usually on this machine the door/valve assembly is to blame. if something gets caught in the door/valve assembly it can break this part. you can take it in to see what the est. would be. hope this helps ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum
Losing suction filter clean,hoses clear,output blower good,but very poor suction
If the blower is much stronger than the suction, you may have an air leakwhere the cover fits on tank or possibly a warped tank or cover. feel all around the unit for air being drawn in somewhere besides the hose. try it without the hose on and block ... Craftsman 17765 Canister Wet/Dry Vacuum
After using it to clean up construction project, I cleaned the tank, filter and cleared the hose, but I have lost good suction.
There are actually two filters in the DC500. The big obvious one and the not so obvious one. Don't yank on the ball housing its screwed together. There is a filter above the ball just before the fan. Its blue and really easy to see if you turn the ma ... Dewalt DC500 Canister Wet/Dry Vacuum
Bissell lift off vacuum about 4yrs old. Extremely noisy. OK until before Christmas but getting worse every time it's used. Washable filters washed, HEPA filter replaced. brush bar cleaned of every scrap, hose empty,everything that can be cleared has been. Noise high pitched, screeching and can only bear to use it for a few seconds at a time. Suction OK.
Sounds like a bad motor bearing. If it is, then you would have to replace it. Could be the brush roll, did you check the ends to make sure they turn easily? ... Vacuums
We have two of these vacuums and both of them have experienced the same problems. First the floor heighth adjustment doesn't work and now neither one will pick up on either carpet or floor when in the brush/floor mode. They both seem to work with the suction hose function. We have removed the back panel to see if there was an obstruction but it was clear. We have changed the bag and the small filter (not the HEPA filter) all to no avail. What else can we do? We are desperate to use our vacu
Did you check the powerhead for obstructions? With a bend in the tube just below where the hose connects, this is a common spot for clogs. To check, detach hose and drop a coin in the hole. If it doesn't drop through, a blockage is present. Use t ... Electrolux Oxygen 3 Upright Vacuum Cleaner - EL5035 Vacuum
Dyson animal loses suction when I let the handle down from the upright position to use, I've cleaned the foam filter, and the plastic filter holder and dried thoroughly, removed and cleared the right side U-bend, and the center, rear U-bend access, also made sure nothing was in the way of the beater bar. Any thoughts? thanks. lorri
Is the noise a loud screaming or a grinding/vibration? The screaming is an air flow problem and you'll want to check your hoses are clear and all the seals are tight. The grinding is an issue with the roller/belt/clutch/motor/housing. From what I'm r ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
My eureka smartvac 4870 has no suction at hose or floor. all hoses are clear, filters clean and properly installed. bag not full and properly installed
Your eureka has no suction kuz the vacum hose needs cleaning ... Eureka Smartvac 4870 Bagged Upright Vacuum
The hose has no suction and shrinks up so that it can't even be put back on the vacuum w/o turning it off. I have checked everything that I can think of and don't see any blockage anywhere. I washed the filter about one month ago and I clear it at least once a week.
Just happened to me. Took everything apart. No blockage in the flexable tubing or connections then I looked down the hard, telescoping tube and saw that it was occluded. Everything's fine and dandy now. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
Dirt devil bagless will not ****. i have ensured entire suction path is clear. motor sounds normal. belt/brush are working fine. filter is clean. can i fix this myself? cost only $50 new so i probably won't take it anywhere for service.
If it is completely clean, no strain on the motor, no clog, check the fan on the motor - Intact? ... or is the center pulled out of the fan? ... Dirt Devil M086700 Vision Bagless Upright Vacuum
Suction has diminished since I purchased it a year ago. Hose is not blocked, Cannister is empty, and plastic filter above cannister is clean. What could be the problem?
Three possibilities I can think of:\0121. Leak/holes in the hose. \0122. The fan blade are worn down or broken. The more they're worn down, the less suction.\0123. The motor itself is dirty and/or wearing out. \012 ... Bissell Versus Bare Floor Vacuum
Bought a Kenmore Progressive canister vacuum at a garage sale that looked in better than average condition, filters clean, new bag, all accessories intact, some debris in roller brush. problem is no suction when turned on. There does not appear to be any obstruction in hose. did not have manual
Hello,Carnister vacuum cleaners are all built with the same principle in mind. A motor \015\012generates power which powers a vacuum which, in turn, creates suction to\015\012 lift debris. The most common areas of suction loss are within ... Kenmore 25512/ 25513 Progressive Canister Vacuum
We have a Russell hobbs power cyclonic pets 2000w vacum cleaner that seems to have lost quite a bit of suction, we have cleaned the filter and made sure there are no obstructions in the hose. We have only had the item for 2 months so would like some help with the problem. Regards Mrs D.Cook
What color is the air flow indicator supposed to be? Mine is yellow but I have no suction. I have read that some people have red, others yellow. I have cleared out all hoses and cleaned the filters with a shop vac, still cannot get it to pick up. Just keeps blowing the dirt out the back at me :(
Hi there, the unit may be experiencing something other than a blockage. Perhaps the dirt canister is not put back into place properly and the unit is sucking through there instead of through the hose.Check to see if the lid and the canist ... Hoover Elite Rewind Bagless Upright VacuumVacuum
I have a Russell Hobbs Power Cyclonic Pets 2000W vacuum and having cleaned out all the parts I can find the suction is almost nothing. It has happened once before but cleared after emptying out all the filter areas. This time it won't. I have only had the cleaner for approximately 4 months so pretty disappointed. can you suggest anything?
I have exactly the same problem, has anyone given you advice? ... Vacuums
My Bissel powerforce 6596 has suction but the dirt is not making it into the dirt cup. If I shut it off, the dirt drops to the floor. Also the motor seems to be over heating. All filters are clean. I can't find any obstruction.
Just because you cant see the obstruction doesnt mean theres not one. The hose could be stopped up somewhere not visible to your eyes. I have one and I have to take hose off and apart to clean it out. check the roller. Is it rolling? ... Bissell 6594 PowerForce Bagless Upright Vacuum